400 Ω 50 Ε HE 10 MF 5 ΚΩ Vo

Q: Lecture: Combinational Circuits Implement the given Boolean function using inverted decoder.…

A: The given Boolean function have 3 input so the 3 to 8 decoder can be used to implement the given…

Q: Find y(n) using the three methods of digital convolution if the input sequence is x (n) = {1, 2, -2}…

A:

Q: 1. (a) The input voltage, v-(t)=20 sin(500m) V is connected to a silicon diade, with Vr=0.7 V in the…

A: To determine the output voltages of the given below circuits:

Q: (b) Three identical LEDs are connected to three resistors of the same value as shown in Figure 3b.…

A: Note: For the safe operation of LED, LED current should be less than or equal to the Rated current…

Q: Power in a three-phase delta system with balanced load is equal to a) √√3 x VL x IL x power factor…

A: A three-phase voltage source and a three-phase load are connected in a three-phase system via…

Q: 8. The following plant is given: X(S) x(s) == Wo(s) y(s) y(s) =. ²/ S output signal W.(s) With input…

A: We need to find out the transfer function and we need to draw input and output .

Q: 6.5 The transfer function of a linear-phase H(z)=0.1+0.5z¹+z²+z³ +0.5z +0.1z-5 Draw the linear-phase…

A:

Q: Find, from the definition, &{cos wit} Jo ej(w-wit= and (w-w₂) Use <-02

A: here we have to find the fourier transform of cos w0t   we know that ∫-∞∞ e -j  w - w 0  t dt = 2 π…

Q: Solve the following using Kirchhoff’s Laws Find V1, V2, and V3 in the following circuit

A: Given: To find: V1, V2 and V3 using Kirchhoff's law.

Q: Q4: Need Asap please 0. Write Boolean expression For each Row in Table. 1. Draw a k-map table based…

A: Solution of subpart (Q4.0): The given truth table is shown below. We need to write Boolean…

Q: A 3-phase full-wave bridge rectifier is built using six power diodes numbered 1 to 6. The phase…

A: Based on the given information, Rectifier circuit is drawn as shown below   Vab=208 V Van…

Q: An internally compensated op-amp has a DC open loop gain of 106 dB and a unity-gain frequency of 3…

A:

Q: Minimize the logic function  Y(A,B,C,D) =  ∑(0,1,2,3,5,7,8,9,11,14) . Use Karnaugh map. Draw logic…

A:

Q: 6. A delta - connected alternator is connected a wye-connected resistive load, the alternator…

A: It is given that:

Q: AA-A three transformer bank, each of 10 KVA SL transformer become, disable and hence the circuit…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: You are working for a company that manufactures motors and generators. At the end of your first day…

A: Given data Magnetic flux density, B=0.865 T Generated voltage, E=29.0 V Radius of the disk, r=0.415…

Q: Problem 09.030 - Find current when a resistor and capacitor are in parallel A voltage (t) = 100…

A:

Q: The following questions use the per phase circuit model of the 3 phase syn- chronous machine that is…

A: Given: In this question, the given details are, A 3 phase synchronous generator has a synchronous…

Q: orange-violet-red-silver = 37k Ω ± 10% 370k Ω ± 5% 37k Ω ± 10% 3.7k Ω ± 10% ±

A:

Q: A coil with impedance 8 + j6 Q is connected in series with a capacitive reactance X. The series…

A: The impedance of the coil is: 8+j6 ohm The equivalent impedance of the circuit is: 2∠0°

Q: Each resistor has a resistance value of 10 ohms. Determine the resistance across A and B terminals…

A: Given each resistance R=10 ohm

Q: The response of a servo mechanism when subjected to a unit step input is c(t) = 1 + 0.2 e-60t - 1.2…

A:

Q: Solve the following using Kirchhoff’s Laws. 1. Find the current through a 20Ω resistance, and…

A: In this question We need to determine the current through  the resistances 20 ohm and 40ohm. We are…

Q: explain insulation coordination and write method of insulation coordination

A: We have to explain insulation coordination and write method of insulation coordination.

Q: 6. Please consider the following circuit. If f= 159.15kHz, V1 = 12230° and V2 = 620°, determine the…

A: The given circuit is shown below. The given values of the voltage sources are written below.…

Q: What is the pitch of the thread called out by the thread note illustrated below? 9/16 -9/16-12UNC-2A…

A: Thread note is given it is asked to find the pitch of the thread

Q: Determine R₁ to R₁0, V₁ to V₁0, l₁ to l₁0, total resistance, and total current from the circuit…

A:

Q: Calculate the ground reflection amplitude factor for communication at 5 GHz between a transmitter…

A: Given data, Height of the transmitter ht=20 m Height of the receiver hr=5 m Distance between the two…

Q: Problem 5. For the following transfer function of the plant and differential equations, derive the…

A: it is asked to find the state space representation of given transfer functions and differential…

Q: AO A F 0 1 1 1 B 0 0 0 1 1 0 1 1 TABLE 1. F = (A, B) O Required: 1. Draw a k-map table based on the…

A:

Q: For resistance and inductance circuit connected in series, has the following values: Vsupply = 120…

A:

Q: For R1=202, R2=430, R3-185, R4-480, R5=455, R6-170, V1-8 V & I1=2 A in the shown circuit, using the…

A:

Q: A I1 R₁ = 40 M IT + B 12 12V +-- 13 R₂ = 652 M с R3 = 1202 MD D

A: given circuit. we have to calculate total current

Q: 2. Find the transfer function of the system shown in Fig.2 with Mason's gain formula R(S) O G₁ H₂ H…

A: In this question We need to determine the transfer function using the Mason gain formula.  C/R = Pi…

Q: What is Resistance and inductance.

A: Definition of Resistance and Inductance.

Q: • If a circuit has R= 1022, X₁ =1002 and Xc =1002, what will be the effective impedance (Z) for this…

A: .Given: R=10Ω XL=10Ω XC=10Ω Need to calculate total impedance.

Q: A coil with impedance 8 + j6 2 is connected in series with a capacitive reactance X. The series…

A: It is given that: R'+jXL=8+j6 ΩR'=8XL=6XC=X=capacitive reactanceZeq=2∠0° Ω=2+j0 Ω

Q: Problem 6. For the following transfer function of the plant and differential equations, convert them…

A: it is asked to convert the given transfer functions and differential equation into frequency…

Q: A group of single phase loads: 5 x1.8 kW, required to be supplied via 70° C PVC cables Knowing that…

A: Given data, Power P=5×1.8 kW The cross-sectional size of the core determines the single-phase copper…

Q: A circuit with series and parallel connection has, Vsupply = 24 Volt, resistors, R₁= 600 , and two…

A:

Q: An approximate method is used to measure unknown inductances when commercial bridges are not…

A: The given circuit is shown below. We need to prove the value of the unknown inductance can be…

Q: 02. The input voltage, Vin(t) = 25 sin(200mt) V is connected to four germanium diodes with VF = 0.3…

A: “Since you have posted multiple sub parts, we will provide the solution only to the first three sub…

Q: Find the poles and zeros of the transfer function H(z) = 1 + 2Z−¹+2Z-² +Z-3

A: We need to find out the poles and zero for given transfer function .

Q: B A I1 R₁ = 2.402 R₂ = 1.752 12 m IT C IT +|+|+ 132V 13 14 R3 = 6052 Is R4 = 2052 R5 = 3052 M D E F

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Q: Solve the following using Maxwell’s Mesh Method Find the current i in the circuit shown below

A: In this question We need to determine the current i in the shown the circuit using the mesh…

Q: a) Buses are conductive routes in a microprocessor's circuitry. This means that there is potential…

A: A bus is an internal, quick link. Buses are used to carry data and control signals and connect the…

Q: 7) Compute the total eat u (t) energy of the signal in both the time-domain and frequency domain.

A: In this question We need to determine the total energy of the signal using the time domain and…

Q: Express decimal number -15 as a 5 digit 2's complement binary number.

A: it is asked to express decimal number -15 as 5 digit 2's complement binary number

Q: 4) The resistance of a copper wire is 65 2. Its length is 3.048 x 10³cm and its resistivity p=1.723…

A: Given data, Resistance is given R=65 Ω. Length of wire L=3.048×103 cm. Resistivity ρ=1.723×104 Ω-cm.

Q: In the circuit shown find v(t) and current i (t) for t> 0 and the what percentage of the initial…

A: We need to find out the current for inductor and voltage for resistor for given circuit.

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.