4PH3-> P4+6H2 The rate of decomposition of PH3 was studied at 921.00 °C. The rate constant was found to be 0.0965 s-1. If the initial PH3 concentration of 0.75 M, what will be the concentration of after 7.00 s?

Q: 4-41 A steel cylinder 10 cm in diameter and 10 cm long is initially at 300°C. It is suddenly immerse...

A:

Q: The chemical oxidation demand (COD) is usually reported in units of

A: It is the measure of quality of water.  

Q: An aqueous solution of 500 mg/L Hg(NO3)2 has leaked from a ruptured 208 L (55 gal) drum. Visual insp...

A: The concentration of a solution is a measure of the amount of solute that has been dissolved in a gi...

Q: molar percentage mixture, 28-0149- Calculate for C Hy Cz Hg in

A:

Q: Wine making involves a series of very complex reactions most of which are performed by microorganism...

A:

Q: 13. Using the following information, calculate the AH°ffor CO(g). Give your answer to three signific...

A: Given that, Fe2O3 (s) + 3CO (g) → 2Fe (s) + 3CO2 (g)     ∆Hrxno = -28.4 kJ ∆Hfo Fe2O3 (s) = -824.2 k...

Q: Water is flowing through a 2.067-in ID pipe with a velocity of 1m/s. Calculate: (a) Mass flowrate (b...

A: Given: ID = 2.067in = 0.0525m V = 1 m/s Density = 1000 kg/m3  

Q: 1- How can the slope of the operating line be changed?

A: Since you have posted multiple independent questions in the same request, we will solve the first qu...

Q: Chemical Engineering Question

A: Liquid Level tank ( first-order response system) This system consists of a tank of uniform cross-sec...

Q: Q3) Steam at a pressure of 20 bar and 250°C enters a turbine and leaves it finally at a pressure of ...

A: As per guidelines I am answering first three sub part (I), (ii) and (iii)  Consider this chart

Q: dx Find xY if = y sin x %3D dy I+y

A: The equation given is; xyx + y = ysinx Required: Derivative of x with respect to y i.e. dxdy =?    

Q: Air is used to heat a room. The flow rate of the entering air to the heating unit is(2.50 m3 /s) at ...

A: Heat lost by a system will be equal to the heat gained by surroundings. This says that the heat or t...

Q: What does a HYSYS fluids package represent thermodynamically

A: In chemical engineering, there are many calculations that can be done manually. But some are very co...

Q: 4. What is the pereentage purity of a sample of Al, (SO4)3 if a 0.5000-g sample produced a precipita...

A: Amount of BaSO4 formed=1g Amount of sample=0.5g To find: % purity of sample

Q: Could you give me two examples that can be considered as CSTR (Continuous-Flow Stirred Tank) and PF ...

A: CSTR (Continuous stirred tank reactor):  CSTR is continuously stirred tank reactor which almost alwa...

Q: 5. Calculate the latent heat of vaporization of ammonia at 320 K: a) Using Riedel equation and Watso...

A: Given: Ammonia at T = 320 K  (a) Riedel Equation, It is used for estimating a liquid heat of vaporiz...

Q: Biodiesel from a palm oil has an approximate formula of CxHyOz. Excess air is supplied at 30°C, 100k...

A: Supplied excess air specifications: Temperature, Tair = 30°C Pressure, Pair = 100 kPa Relative humid...

Q: (b) Some scientists argue that all form of renewable energy can be attributed to solar energy. The e...

A: Lumped parameter system: Lumped parameter system considers distribution of parameter uniform through...

Q: Q1/ Answer the following questions: 1- How can the slope of the operating line be changed? 2- What i...

A: Hello Subscriber! There are multiple questions posted. As per our policy, we have solved the first o...

Q: The cost of a chemical plant was 5 million dollars produces a product at a rate of 20 millions kilog...

A: Cost of chemical plant= 5000000 $Amount of product produced by plant=20000000 kg/yearSelling price p...

Q: Calculate by (a) % weight and (b) % mole each of the elements present in ethyl alcohol.

A: The molecular formula of ethyl alcohol is C2H5OHMolecular weight of ethyl alcohol=2×C+6×H+O=2×12+6+1...

Q: Tutorial Sheet No.5 Fluid Dynamics Q1: By using the Hagen-Poiseuille equation, Calculate the viscosi...

A: Write the expression for Hagen-Poiseuille as follows: ∆P= 8μLQπR4ρgh =8μLQπR4     .....1   Given, De...

Q: Q3) For the reaction A P, the following results are obtained: CAo (mol/lit) t12 (hr) 0.5 2 1.0 0.435...

A: Given that, Data of initial concentration and half lifetime CA0 (mol/lit) 0.5 2 6 t1/2 (hr) 1.0...

Q: (2) What is the degree of polymerization of each of the following? (a) with molecular weight 100,000...

A: Degree of polymerization:(DP) Divide the molecular weight of the polymer (Mw) by the molecular weigh...

Q: Three hundred gallons of a mixture containing 75.0 wt% ethanol (ethyl alcohol) and 25% water (mixtur...

A: Here Given dataVolume of entering mixture = 300 galHence Volume in m^3= 1.1355 m^3 Let first talk ab...

Q: The plots below were taken from the same reaction at different temperatures. The left plot was at 81...

A: The given plots for a reaction at 81°C and 25°C are:

Q: Q1/ Air containing 5% vol CO, is flowing at the rate of 0.30 m'/s at 27c° and total pressure P 1.2 a...

A: NOTE: Because you have posted multiple questions, we will solve the first one for you. If you want t...

Q: Crude oil containing 5.0 mole per cent of gasoline is stripped by running the crude down a columnup ...

A:   Let basis be 1 hour of strippon operation of crudeso that L=100 kmolsolute content =5%solute free ...

Q: b) Design the rotor radius for a multi-blade wind turbine that operates in a wind speed of 36 km/h t...

A: Given data: Speed of wind = 36 km/h Flow rate of water = 6 m3/h Lift = 6 m Density of water = 100 kg...

Q: 1- Invert the following system to the time domain using partial fraction: 6 (s): s(s+2)(s+4)

A: Note: Since we are entitled to answer only 1 question, we will answer the first one as it is not men...

Q: Entropy change for constant pressure processes. One kilogram of water at temperature 20 degree Celsi...

A: Entropy is a system property that is the ratio of the system, thermal energy to the unit temperature...

Q: Convert the temperatures in Parts (a) and (b) and temperature intervals in Parts (c) and (d): a) T= ...

A: Since you have posted multiple independent questions in the same request, we will solve the first qu...

Q: Q2: Determine the pressure drop across a pipeline carries 2.5 kg/s of crude oil to a storage tank th...

A: Given: mass flow rate of crude oil m = 2.5 kg/s Tank diameter d = 80 mm = 0.08 m L = 100 m mean surf...

Q: Q) Two liquid storage systems are shown in the figure below .Each tank is 4 feet in diameter.For sys...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Q5) Wine making involves a series of very complex reactions most of which are performed by microorga...

A: The initial specific gravity of the solution, SG1 = 1.075 The weight percentage of sugar in the init...

Q: The heat changes that take place in chemical reactions or physical state transitions can be measured...

A: Heat is the transfer of energy to/from a body by the virtue of a temperature difference. Enthalpy is...

Q: 1) C,H, is burned in an engine with a rich fuel-air ratio. Dry analysis of the exhaust gives the fol...

A: Given: In Product, YCO2 = .1495, YC4H8 = .0075, YCO = 0, YO2 = 0 and YN2 = .843    Basis: Product ga...

Q: Just worried about the simulink.

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Thermodynamics Question

A: the complete table is given below 

Q: A solution containing 2g KOH , 5g H2SO4 and 85 water, Calculate the mole fraction of each component ...

A:

Q: At high temperatures, dinitrogen tetroxide gas decomposes to nitrogen dioxide gas.  At 500 oC, a sea...

A: At 500 oC Dinitrogen tetroxide gas decomposes to nitrogen dioxide gas Equilibrium Concentration of d...

Q: A cylinder of glass under Vaccum of air weights air at 27-9214 go when filled with dry p=latm. T 252...

A:

Q: how to solve these question?

A: Hi and thanks for the question. Since you have posted a question with multiple sub parts, we will an...

Q: Q2-A straight fin of triangular profile is constructed of copper with a thickness of 2.1 mm. The fin...

A: Given: A straight copper fin of triangular profile. Thickness of the fin, t = 2.1 mm = 0.0021 m Conv...

Q: Q1/ methanol (CH;OH) is burned with (1.2) excess air, determine the stoichiometric air/fuel ratio an...

A: Reaction of CH3OH with O2 will beCH3OH + 32O2 → CO2+ 2H2O

Q: Q2) Steam at 4000 kPa and 550°C expands at constant enthalpy (as in a throttling process) to 150 kPa...

A: Given: At initial state, P1 = 4000kPa, T1 = 550oC At final state, P2 = 150kPa, T2 = ?  

Q: When we take a section into an equipment used for absorption of the solute A in a liquid, the bulk g...

A: Given data: We have an equipment for the absorption of solute A. Bulk gas phase contains 12 mol% A a...

Q: Air is used to heat a room. The flow rate of the entering air to the heating unit is(2.50 m³ /s) at ...

A: Given data: Flow rate of air entering the heating unit = 2.5 m3/s Temperature of entering air = 17 0...

Q: Three hundred gallons of a mixture containing 75.0 wt% ethanol (ethyl alcohol) and 25% water (mixtur...

A:

Q: Please help me

A: