5. Find I in the circuit of Fig.? 20 Ω 15Ω I, 4Ω 15Ω 50 15Ω 48 V 50 24 Ω 8Ω

Q: 6. In a transformer the core loss is found to be 60W at 30Hz and 90W at 40Hz, measured at the same m...

A:

Q: If the memory chip below is used in a system with a 16-bit address bus, then address lines A13 – A15...

A: According to the question, we need to find the address range.

Q: Three Inductive loads each of resistance R = 28 ohms and %3D inductance L = 0.03 H are connected in ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Analyse the circuit ( write all necessary steps and formulae required and upload the answer sheet) 4...

A:

Q: Find the angle between A = 5.8ay + 1.55az and B = - 6.93ay + 4az..

A:

Q: 2. Find the transfer function X2(s)F(s) of the circuit. 2 N/m 1 N/m 1 Kg 2 Kg 1 N-s/m 1 N-s/m

A: In this question,  We need to determine the transfer function.  Transfer function is define the rati...

Q: A no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per...

A: To find the power loss if the current flowing through the 0 AWG wire is 18 amp  And wire is 100 m lo...

Q: Design a 0-9 up counter sequential circuit

A:

Q: AY connected three phase 60 Hz induction motor has six poles. Find the speed of the motor given that...

A: Given: A star connected three phase induction motor Frequency, f=60 Hz Poles, P=6 Rotor frequency, f...

Q: In the figure the capacitances are C, = 1.1 µF and C2 = 3.0 µF, and both capacitors are charged to a...

A: This probelm belongs to circuit theory . It is based on relationship in capacitor , voltage and stor...

Q: Question 2 Use mesh analysis to find the mesh currents in the circuit given in Figure 2 Hint: Apply ...

A: Here we have given a circuit, which consists of no. of resistors, voltage source and current source....

Q: (a) Figure Ql shows the Zener diode act as a regulator and having variable input, Vin values. Given ...

A:

Q: For the given network diagram find the complex power and power factor supplied by the source. 0.1Ω /...

A:

Q: Q4: Draw the sketch of the following signal: a) u(t +4) u(-t +4) b) r(t) – 2r(t – 1) + r(t – 2)

A:

Q: Determine a frequency ω that will cause the input x(t) = cos(ωt) to produce a strong response when a...

A:

Q: A series RC circuit is connected to a 230V 60hz source. If the power taken by the circuit is 4,800W ...

A:

Q: What will be the branch voltage when RX is adjusted to 16Ω? What is the magnitude and direction of t...

A:

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...

A: Given: Maximum amplitude of sinusoidal voltage, Vm=680 V Load resistance, R=65 Ω  

Q: Consider the object shown in Fig. 1(b). Calculate: i. The length of CD ii. The surface area ABCD ii....

A: Use differential length,  differential surface and differential volume formula in cylindrical coordi...

Q: Determine if the DIODE is forward bias or reverse bias And approximate the output voltage Vo Determi...

A: In this question,  Given the circuit,  Check which diode is forward bias and which is reverse bias. ...

Q: With suitable sketch ,explain in detail the calibration procedure of differential pressure transmitt...

A: Differential Pressure Transmitter- Differential pressure transmitter is a device which is used measu...

Q: Problem 4: (~. 1 radius of 0.25 m. What is the electrostatic potential a distance of 0.10 m above th...

A:

Q: Demonstrate the output of the given program below if the inputted value is 'Y. If there is a bug in ...

A: #include<conio.h> #include<stdio.h> #define p printf #define s scanf void main() {      ...

Q: Evaluate the following and write it in rectangular form a.) j7 (-5+j2)  b.) (1-j5)(-9+j2) c.) (4+...

A:

Q: A load of 145 MW at a power factor of 0.9 lagging can be delivered by a 3-phase transmission line. T...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: A series circuit consists of three identical lamps are connected to a battery as shown in Figure bel...

A:

Q: A 60 W power transistor is to be cooled by attaching it to a heat sink. Calculate the maximum therma...

A: Thermal resistance = (temperature difference)/ power loss. Use above formula to find maximum thermal...

Q: Given the following circuit, solve for Vo. Must use mesh Analysis. 12 mA 6 ΚΩ ww 3 k. 6 mA 12 V $12 ...

A: This question belongs to circuit theory . It is based on the concept of mesh analysis . Mesh analysi...

Q: 5. A long copper wire carries a current of 20A which is evenly distributed in each cross-section of ...

A: It is given that: I=20 AD=4mmr=2mmresistance per unit length=5Ωkm=5×10-3Ωm

Q: 2. Find the inverse z transform of the following а. x(2) %3D z-1 z2-2z+1 1+2z-1+z-2 b. X(z) = %3D 1-...

A: In this question,  Find the inverse Z transform.  We know  u(n) ---ZT--> 1/(1-Z-1 )   

Q: nary number 1101101.101010 is ______.

A: Solution:- From the above question, (1101101.101010)2= (             )8 In octal we can take pair of...

Q: The two loads shown below can be described as follows: load 1 absorbs an average power of 60kW and d...

A:

Q: Figure 2 illustrates the example use of FET using common-gate configuration. For the given circuit c...

A:

Q: A load resistance of 250 £2 needs to be supplied with 12V. A 45V voltage source and a resistor of an...

A: The available supply voltage is 45 Volts.  The voltage across the load resistance is 12 Volts.  The ...

Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1...

A: In this question AWG wire is given...We have to find out power loss due to current and due to this p...

Q: The simplest electric circuit (2 * contains only parts Two Three Four Five None of the above The res...

A:

Q: Will a 6HP power rated equipment work if it is connected to a wire size no. 8? Voltage source= 240 v...

A: Will a 6HP power rated equipment work if it is connected to a wire size no. 8? Given, Voltage source...

Q: 3- phase,60hz induction has 2 poles. If the slip is 2 percentage at certain laod determine the synch...

A: Here, we have given the information related to the induction motor.  So, we have to calculate the sy...

Q: If the canonical sum of an n-input logic function is itself a minimal sum, how many literals are in ...

A: We know, Canonical form is sum of products when it is the sum of min terms or we can say it is minim...

Q: Consider the following two ports network below. Calculate the Z-parameters following these instructi...

A:

Q: From the given technical description of the lot. Bearings N 48° 20' E Lines Distances AB 529.60 m 59...

A:

Q: Consider the sinusoidal voltage     v(t)=100cos(1000nt-65°)V.     A. What is the period in millise...

A: The solution is given below 

Q: A 400V, 3-phase Induction motor has input power of 16 KW and operates at power factor of 0.87 laggin...

A: Given: A 400 V, 3 phase induction motor having Input power, Pin=16 kW Power factor, cosϕ=0.87 laggin...

Q: Ex. 1615. See Fig. 1615. Rf=100.0 kOhms, Ri= 5 kOhms, V=13 volts, R.L=10k ohms. If Vin=130 mVpp, fin...

A:

Q: What is the maximum electric and magnetic fields you would expect to tind under a 165KV transmission...

A:

Q: A long straight co-axial cable with two coaxial conductors of negligible resistance lies along the z...

A:

Q: 1. A point charge, -3µC is placed at the point (0,2) m while a charge +2µC is placed at (2,0) m. Fin...

A: Brief description: In the given question they have mentioned two point charges of having charge 2 u ...

Q: (a) Refeming to a mechanical rotational system shown in Figure Q.2a (O Draw the free body diagrams a...

A: a) 

Q: 4. Find the transfer function Vo(s)/V(s) of the circuit. voo 1F 1 F 1 Ohm Ohm

A:

Q: A series circuit consists of a ( 4.7k , 5.6k2, 9k2 and 10k2 ) resistor. Which esistor has the most v...

A: In this question,  4 resistances are connected in the series.  Which resistance have maximum voltage...

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.