5. Find the mean precipitation for the area shown by Thiessen polygon method. The area is composed of a square plus an equilateral triangular plot of side 2 km. Rainfall readings are in cm at the various stations indicated. 2 km 2 km E 2 km 2 km 43 cm

5. Find the mean precipitation for the area shown by Thiessen polygon method. The area is composed of a square plus an equilateral triangular plot of side 2 km. Rainfall readings are in cm at the various stations indicated. 2 km 2 km E 2 km 2 km 43 cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: SITUATION 1 Built-up column 10m long consists of W350X90 with two plates welded to form a box sectio...

A: NOTE: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: A 50-yr flood typhoon occurred in Metro Manila, started from 12:00AM of Dec 14 to 12:00PM of Dec16. ...

A: According to Horton, the infiltration rate of soil is maximum at the initial time of precipitation a...

Q: e drawdown in the observation wells on wells from the center of the test we

Q: A liquid limit test conducted on a soil sample in the cup device gave the following results: N 10 19...

A: As we know that plastic limit is corresponding water content of 25 blows For given questions For 2...

Q: 1. Calculate the tension in each cable in kilo-Newtons. 4 m 3 m 3 m A В 2.5 KN 5000 N 3 m 30°

Q: 10,000 lb Cylinder Plunger AA2 = 10 IN A=500 in? 15" Oil (0.78)

Q: 3. Factor Method: The frame shown is subjected to lateral loads as shown. Supports S, T, U V, W and ...

Q: Given that the angle of friction is 20°at all contact surfaces, determine: a. the resultant of the...

Q: 34. The plastic limit and liquid limit of a soil are 36% and 54% respectively. The percentage volume...

Q: roblem Solving (Show the corresponding solution) In a closed traverse ABCDE running anti-clockwise, ...

Q: Explain three mitigation measures or technologies that can be used to solve the pollution that occur...

A: The introduction of dangerous items into the environment is referred to as pollution. Pollutants can...

Q: connects two tangents that intersect the PC which is at station 0 + 168.150 is to be retained and a ...

A: Given:- radius=6 degree curve PC which is at station =0 + 168.150 To find:- PCC newPT

Q: From the table below, compute the catchment volume from the total data of precipitation, runoff, gro...

A: Given, Event Jan Feb March April May June July Sept Oct Nov Dec Precipitation 1003 2500 1800 40...

Q: A WT 8x13 of A992 steel is used as a tension member. The connection is with 7/8-in. diameter bolts a...

Q: Proctor Test in English unit Method A

A: For Standard proctor test :Compaction effort :E=number of BlowsPer layer×Hammer Weight×Number of Lay...

Q: Q.2) A page of a level book with some missing readings is reproduces below. Fill in the missing entr...

A: Station BS IS FS Rise Fall RL Remarks 1 3.650 108.260 2 0.9 2.750 111.01 3 ...

Q: Determine support reaction

Q: An embankment with a total volume of 50000cu.m is to be constructed as a part of highway project. Th...

Q: 1. Calculate the tension in each cable in kilo-Newtons. 4 m 3m 3 m 2.5 KN 5000 N 3 m 30°

Q: M 7 m 5m 5 m 7m

Q: determine the force reaction in kn at the hinged support.

A: ##Calculation for reaction force at hinge support ##

Q: 1. Which properties of soil (e.g. air content, water content, void ratio, etc) can be changed or alt...

A: Various properties of soil - Like air content, water content, void ratio etc. There are properties w...

Q: a. Compute the undrained angle of friction. b. Compute the value of undrained cohesion. c. Compute t...

A: ## calculation of a consolidated undrained test results of part a,b,c,d##

Q: The spacing of the cars moving along the same lane of an expressway is 40 m center to center. If the...

A: Given data in question Spacing between center to center cars Average velocity To find out Volume ...

Q: Problem 6. The table shows the result of consolidated undrained tri-axial tests with pore water meas...

Q: A Channel C6x13 is used as a tension member. The holes are for 5/8 inch in diameter of bolts. Using ...

Q: An A36 Steel Cantilever Beam is shown below, also showing its cross section. Determine the following...

A: We will use parallel axis theorem

Q: uniform

Q: Compute the rate of flow in vehicles per hour (two-decimal places) if the space mean speed is 30 mph...

Q: Assume you are observing traffic in a single lane of MCArthur Highway at a specific location. You me...

Q: Which of the following statements is NOT true, when checking the emergency breakaway system on a tru...

A: Detailed explanation for every statement is provided

Q: Topic: Elements of a Horizontal Simple Circular Curve Question: Sketch a simple horizontal curve de...

Q: 2. A cable supports two concentrated loads at B and C, as shown. Determine the sag at B, the tension...

A: Determine the sag at B, the tension in the cable, and the length of the cable.

Q: The rigid bar ABC shown is hinged at A and supported by a steel rod at B. Determine the load P that ...

Q: In the subtropics the latent heat loss Qe at the sea surface is typically -125 W/m?. How many meters...

Q: mum positive mon ut the beam. OS

Q: 173.4" 82.98' 328.51 What is the area in square feet?

A: Given data- To Find- It is needed to find out the area of the figure.

Q: sult of the particle-size analysis of a soil are as follows: Sieve No. % Passing 10 40 100 80

A: iAs Passing through 200 = 58>35%Silt-clay -materialiiLL=30≤40PI=10≤10Belongs to A-4

Q: 2.4 The section through a long cofferdam is shown in Figure 2.24, the coefficient of permeability of...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any ...

Q: The following values were determined in a series of tape measurements of a line: 1256.66, 1256.35, 1...

A: Given series of tape measurements of a line: 1256.66, 1256.35, 1256.32, 1256.55, 1256.50, and 1256.7...

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange P...

A: NOTE : as per our guidelines we are supposed to answer only one question. Kindly repost the another...

Q: Hydrology/ Engineering Hydrology is concern of the following except A assessment of environmental co...

Q: 20KN€ 20KN 50m2

A: σ=normal stressP= force = 20 KNA= area = 50 m2σ=PA

Q: Determine the compaction effort of Standard Proctor Test in English unit Method A. (ft – lb/ft³ 56 2...

A: For Standard proctor test :Compaction effort :E=number of BlowsPer layer×Hammer Weight×Number of Lay...

Q: Determine support reaction

A: To find : We have to find support reaction Explanation : We took help of three known equilibrium co...

Q: 1.) For the given simply supported beam AB, determine the following: a. The Shear and Moment Diagram...

A: Draw moment area method

Q: 10KN/m A В D 4m 2m 3m Draw Shear and Moment Diagram of the Beam

Q: Determine the location of the Neutral axis (mm) from the top of the beam shown using the transformed...

A: Determine the location of the Neutral axis (mm) from the top of the beam shown using the transformed...

Q: For the beam and loading shown design the cross section of the beam, knowing that the grade of timbe...

Q: Suppose that the projected road vehicle traffic flow in a corridor is 5000 vehicle-trips per hour in...

A: According to given data Traffic flow in a corridor is 5000 vehicle trips per hour in one directionT...

Concept explainers

Precipitation

Precipitation forms the basis of the water cycle on the Earth. The air is packed with water molecules in the form of moisture or water vapor. This water vapor usually rises to the atmosphere due to density differences. Precipitation represents any form of water, in liquid form or frozen form that forms in the earth's atmosphere. The water vapor up in the atmosphere condenses due to low temperature and it leads to the formation of clouds. The water vapor that forms clouds on account of condensation, is preferably known as cloud droplet. These cloud droplets when become heavy and can no longer sustain the weight of condensed water droplets, they come to the Earth in the form of rain, snow, ice pellets, and hail. Precipitation patterns, evaporation, and condensation are the three parameters that decide the global water cycle, climate change, and weather. Additionally, smoke and dust particles are equally important parameters for precipitation, as they provide the surface area for the water vapors to get condensed and to form water droplets. So they are known as condensation nuclei. The presence of other pollutants in the air also serves as condensation nuclei. Precipitation always results in the pure water supply to earth, as the salt from the seawater does not evaporate with the water.

Question

5. Find the mean precipitation for the area shown by Thiessen polygon method. The area is
composed of a square plus an equilateral triangular plot of side 2 km. Rainfall readings are
in cm at the various stations indicated.
B
2 km
2 km
10 cm
68 am
15 am
2 km
38cm
2 km
20 am
43 co
D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

solve problem 29 and 30
Determine the most probable value of the elevation BM2. Route A: Distance from BM1 = 6.32 km andElevation of BM2 = 140.742, Route B: Distance from BM1 = 8.46 km and Elevation of BM2 = 140.825,and Route C: Distance from BM1 = 10.53 km and Elevation of BM2 = 140.863.
A square island have 3 installed rainfall station on each of the corner with these records: A=1350mm, B=1850mm, and C=2450mm. What is the areal precipitation in mm using distance weighting method?
The total annual precipitation for a region is approximately normally distributed with a mean of 848 mm and a standard deviation of 124 mm. What is the probability of an annual precipitation greater than 500 mm but less than 700 mm? Answr = 0.1145
Elementary Surveying: Measurement of Horizontal Distances, Show the proper and right solution 1. A steel tape known to be of standard length at 20°C, is used in layingout a runway 3,895.70m long. If its coefficient of linear expansion is0.0000116/1°C, determine the temperature correction and the correctlength to be laid out when the temperature is 34°C.
A catchment is idealized as a 30km × 30km square. It has four rain gauges as . During a month, the precipitation at these gauges is measured as A=(309) mm, B=(292) mm, C=(279) mm and D=(297) mm. Compute the average precipitation (in mm, up to one decimal place) over the catchment during this month by using the Thiessen polygon method. [11]A BD C
In the two-peg test of a dummy level, the following observations are taken. On point A On point B INSTRUMENT SET UP at M 2.682 1.239 INSTRUMENT SET UP at P 1.876 0.565 Point M is equidistance from both A and B with 92 meters, while P is 2.50m away from A along the extension of line AB. Requirements: Determine the true difference in elevation between point A and B. With the level still set up at P, determine the rod reading on A and B to which the line of sight should be adjusted. If the instrument needs to be adjusted, determine the following false difference in elevation inclination of the line of sight and the error in the reading of far rod A and B instrument set up at P.
The table shows stadia readings taken by a transit set point A between two points X and Y with stadia Interval factor of 100.80 and stadia constant of 0.381 Find the length of line XY. Determine the elevation at point A if elevation Y is 100m and HI=1m. Determine the difference in elevation between points X and Y.
A dumpy level with an internal focusing telescope was set up on the left bank of the river and the rod readings tabulated below were taken on a stadia rod held successively at the left and right water edges. If the stadia interval factor is 100, determine the width of the river. Draw the diagram
Velocity Area Method. At certain section of a river, the left and right water edges are 3.0m and 23.0m respectively from an initial reference point. Verticals are located at distances 7.0m, 12.0m, 16.5m, 19.5m, and 23.0m, from the initial point. Depths of verticals are 1.8, 3.5, 4.6, 3.4, and 5.8m. Mean velocities in the verticals are 0.15, 0.30, 0.45, 0.50, and 0.48m. Sketch the cross section of the river using the data given and solve for the average velocity of the flow of the river.
Compute the elevation of reservoir C. CHOICES: a.835.06, b. 538.06, c. 853.60, d. 583.60.
Convert 227 ft/min to meters/sec