5. How many different letter arrangements can be made from the letters in the word STATISTICS?

Q: - DATA AND RESULTS 1. OBSERVED DATA OBSERVED DISTANCE OBSERVED BEARING LATITUDE DEPARTURE LINE (m) (...

A: 1.

Q: A water system is subjected to disinfection. Total applied chlorine is 12 mg/1. At break point, chlo...

A:

Q: a uniform cross-sectional area, what will be the resistance of this length?

A: Electrical resistance:  

Q: A westbound section of freeway currently has three 12-ft wide lanes, a 6-ft right shoulder, and no r...

A: LOS: LOS is referred to as the Level of Service in Highway. It explains the quality of the traffic w...

Q: At a site, Static Cone Penetration Test was carried out. The measured point (tip) resistance q. was ...

A: Given-Cone tip resistance, qc=1000 kPaFriction ratio, Rf=1%=1100

Q: Determine the value of poisson ratio is lateral strain -0.355 and longitudinal strain is 0.45

A:

Q: Determine degree of static indeterminacy

A: To find degree of static indeterminacy for the given beam. There is no loading given so assuming the...

Q: Number of road accident on a road in a month follows Poisson's distribution with mean 0.27. The prob...

A:

Q: 6 m 4 m D A E 4 m 3 m 3 m 300 kN 120 kN B.

A:

Q: A compound beam (see figure) has an shearrelease just to the left of C and a moment release just tot...

A: Given:- compound beam To find:- reactions  

Q: 11. A soil has an angle of internal friction of 25°. The Rankine active earth pressure coefficient i...

A:

Q: Determine acceleration Initial velocity=8 m/s Final velocity=D16 m/s time3D5 s

A: Given Initial velocity, u =8 m/s Final velocity, v =16 m/s time=5 s To Determine Acceleration, a

Q: Determine the shear flow for a closed box beam, with t = 1 mm and F = 2000 N F= 2000 N 48t 60t

A:

Q: Compute the rate of flow in pipeline 1. Compute the rate of flow in pipeline 2. Compute the total ra...

A:

Q: Cueston- Calculote min sD Deawined to ovoiol b heod on Oollision Of fwo Cars oPProhing from the oppo...

A:

Q: A rigid cantilever frame ABC is fixed at A and carries a couple M at the free end Cas shown in the g...

A:   Given arrangement

Q: 3. A 500 mm diameter pipe conducts water from reservoir A at elev. 70m to a pressure turbine, which ...

A: step 1-

Q: Oueston- Calulote min sD auinad to ovoiolo heod on Collision Of fwo Cars oPoching from the opposite ...

A: Given-V=90 kmph and 60 kmphReaction time t=2.5sCoefficient of friction, f=0.7Brake efficiency, n=50%...

Q: A hydraulic ram 320 mm in diameter and 1.4 m long moves wholly within a concentric cylinder 320.4 mm...

A:

Q: A simply supported wood beam having a span length L = 12 ft is subjected to unsymmetrical point load...

A: Select a suitable size for the beam from the table in Appendix G.

Q: The tapered cantilever beam AB shown in thefigure has a solid circular cross section. The diametersa...

A: Given:-  d=(dA/L)(L+x) I = (πd4/64) = (πd4A/64L4)(L+x)4 = (IA/L4)(L+x)4 To find:- The equation of th...

Q: A ball is struck with a velocity of 80 ft/s as shown. Determine the speed at which it strikes the gr...

A: Given data  Velocity = 80 ft/s To find - Determine the speed at which it strikes the ground at B an...

Q: A hydraulic ram 320 mm in diameter and 1.4 m long moves wholly within a concentric cylinder 320.4 mm...

A: Determine viscous force F resisting the motion

Q: Please

A:

Q: 11. A soil has an angle of internal friction of 25°, The Rankine active earth pressure coefficient i...

A: Given data : Angle of internal friction=ϕ ϕ=25∘   To find : Rankine active earth pressure coefficien...

Q: An infinitely long slope having an inclination of 26° in an area is underlain by firm cohesive soil ...

A: Given data.,

Q: A rigid bar of weight W = 800 N hangs from three equally spaced vertical wires (length L =150 mm, sp...

A: Given:- W=800N Es = 210 GPa and Ea = 70 GPa da = 4 mm L =150 mm, spacing a = 50 mm To find:- (a) Wha...

Q: The particle size characteristics of a soil are given in the table. Using USDA method, determine: Si...

A:

Q: A 30 cm diameter concrete pile is driven into a homogeneous consolidated clay deposit (C, = 40 kPa, ...

A:

Q: Research for the following question. Should be more than 10 sentences and attach formulas:   1.) W...

A: Brief concept introduction- Bernoulli's equation- It is applicable to a complete, non-abrasive, non-...

Q: Draw HGL and EGL for the pipe shown in fig. Then Calculate the rate of flow through this pipeline an...

A: We have to determine the value of rate of flow through this pipeline and the pressure at A, B, C, D ...

Q: The activity-on-arrow network of activities for a construction project is shown in the figure. The d...

A: Given AON diagram, TO find the critical duration for the project

Q: Situation 1. As shown, a service live load of 150kN is to be carried by an A36 threaded steel rod (F...

A:

Q: What's the importance of determining the soundness of cement to civil/structural engineers in the fi...

A:

Q: Consider particles in suspension and their settling behaviour at different concentrations select the...

A: Plain sedimentation removes suspended coarser particles which tend to settle down under gravity when...

Q: A rectangular beam of width 375 mm is reinforced with 3-32 mm bars at the bottom in a single layer. ...

A:

Q: Maximum ordinate in a mass diagram occurs O all of the these none of these O at the end of a cut whe...

A:

Q: Problem 15.15 Determine the required spacing of #13 closed O stirrups at a distance d from the face ...

A: INTRODUCTION: This question deals with torsion as well as moment due to total load i.e dead and live...

Q: What will be max. height that the water tank that may become full if the max. tangential stress is S...

A:

Q: The Iron Triangle of project management shows the objectives of time (delivery), quality and cost. E...

A: The Main Components in the Triangle of a Project is,    

Q: A hydraulic jump occurred in a rectangular channel of 5 m bottom width and flow rate of Q=21.5 m3/se...

A:

Q: What is the depth of water in a trapezoidal channel with z=2 and carrying a 2.5 m3/s water flow? The...

A:

Q: OBSERVED DISTANCE OBSERVED BEARING LATITUDE DEPARTURE LINE (m) (**") (m) (m) AB 229.70 N 82° 12' E +...

A: Given : Closed compass traverse with latitude and departure are given Compass rule adjustments Area ...

Q: What is the value of PCU (Passenger Car Unit) of the vehicle A using the following given parameters?...

A: Given data,

Q: The DO in the wastewater of a tannery is 1.0 mg/L and the corresponding wastewater flow is 0.280 m3/...

A: DOmix=DO1×Q1+DO2×Q2Q1+Q2  

Q: Determine degree of static indeterminacy

A:

Q: A solid 1.375-in.-diameter steel [G = 12,000 ksi] shaft is subjected to torques Tg = 260 lb-ft and T...

A: Given :                                              Torque at point D, TD = 145 lb-ft = 145×12 = 17...

Q: b 2 m 3 m 12 kN 4@4 m = 16 m %3D

A:

Q: An RCC square footing of side length 3 m and uniform effective depth 250 mm is provided for a 300 mm...

A:

Q: A solid shaft of diameter 150 mm and 10 m long can be maximum stressed to 80 MPa. The maximum power ...

A: Given data, Diameter of shaft=150 mm Length=10 m Maximum stress= 80MPa Maximum power transmitted by ...

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.