5. It is desired to divert 5.1 m'/s water from a pool whose water surface elevation is 45 m, to an adjacent pond whose water surface elevation is 42 m by means of a short concrete culvert 8 m long and with both ends submerged. What size of culvert shown below is needed assuming C-0.58? E. 45 m Pool Pond Youvert, D= Thi module is a property of Technalogical University of the Philippines Visayas and intended for EDUCATIONAL. PURPOSES ONLY and is NOT FOR SALE NORFOR REPRODUCTION.

5. It is desired to divert 5.1 m'/s water from a pool whose water surface elevation is 45 m, to an adjacent pond whose water surface elevation is 42 m by means of a short concrete culvert 8 m long and with both ends submerged. What size of culvert shown below is needed assuming C-0.58? E. 45 m Pool Pond Youvert, D= Thi module is a property of Technalogical University of the Philippines Visayas and intended for EDUCATIONAL. PURPOSES ONLY and is NOT FOR SALE NORFOR REPRODUCTION.

Elementary Geometry For College Students, 7e

7th Edition

ISBN:9781337614085

Author:Alexander, Daniel C.; Koeberlein, Geralyn M.

Publisher:Alexander, Daniel C.; Koeberlein, Geralyn M.

Chapter9: Surfaces And Solids

Section9.3: Cylinders And Cones

Problem 6E: Suppose that r=12 cm and h=15 cm in the right circular cylinder. Find the exact and approximate a...

See similar textbooks

Similar questions

Suppose that r=12 cm and h=15 cm in the right circular cylinder. Find the exact and approximate a lateral area. b total area. c volume.
4) the base radius and height of a right circular cone are measured as 10 cm and 25 cm, respectively, with a possible error in measurement of as much as o.1 cm in each. Use differentials to estimate the error and %error in the calculated volume of the cone.
Calculate the time for 10 per cent of the sites on a (100) tungsten surface with a bec unit cell and a lattice constant of 316 pm to be covered with nitrogen at 298K when the pressure is 2 x 10 mmHg and the sticking probability is 0.55
A manufacturer produces a triangular lamina with a standard base andheight of 30 cm and 12 cm, respectively. However, due to errors in measurements, thebase and height measurements can be off by at most 0.1 cm. Use differentials to estimatethe maximum error in the calculated area of the triangle.
If a ball is thrown vertically upward and with an initial velocity of 10 m/s, it’s velocity at the highest point reached by the stone is?
the width and length of rectangle are measure in cm as 6 and 18 respectively with an error of at most 0.2 cm in each. using differentials and estimate maximum possible error in the calculated area of the rectangle is ?
first and second derrivative of: y=Arccos(e^2x)
A mass of 1 kgkg is attached to the end of a spring whose restoring force is 180 NmNm. The mass is in a medium that exerts a viscous resistance of 156 NN when the mass has a velocity of 6 msms. The viscous resistance is proportional to the speed of the object. Suppose the spring is stretched 0.07 mm beyond the its natural position and released. Let positive displacements indicate a stretched spring, and suppose that external vibrations act on the mass with a force of 7sin(3t)7sin(3t) NN at time tt seconds. Find an function to express the steady-state component of the object's displacement from the spring's natural position, in mm after tt seconds. (Note: This spring-mass system is not "hanging", so there is no gravitational force included in the model.)
Suppose the side length of a cube is measured to be 5 cm with an accuracy of 0.1 cm. a. Use differentials to estimate the error in the computed volume of the cube. b. Compute the volume of the cube if the side length is (i) 4.9 cm and (ii) 5.1 cm to compare the estimated error with the actual potential error.
A bucket that weighs 4 lb and a rope of negligible weightare used to draw water from a well that is 80 ft deep. Thebucket is filled with 40 lb of water and is pulled up at a rateof 2 ft /s , but water leaks out of a hole in the bucket at a rateof 0.2 lb / s . Find the work done in pulling the bucket to thetop of the well.
An industrial food-manufacturing operation wishes to expand, and it requires an improved water supply. They propose to construct a fully penetrating well in an infinite, horizontal, confined, homogeneous, isotropic aquifer, and they plan to pump at a constant rate of 20 L/s. If T = 1.3 x 10-2 m2/s, and S is 2.0 x 10-4, make the following calculations. a. Calculate the drawdown that would occur in an observation well 60 m from a pumping well at times of 1, 5, 10, 50 and 210 min after the start of pumping. The environmental regulator has imposed a limitation on the drawdown from the well in order to prevent impacts to surrounding groundwater users. If the drawdown limit is set to a maximum of 1.5 m at a distance of 250 m, after ten days of pumping, is this well likely to be in compliance with the regulation?
Suppose that 2J of work are needed to stretch a spring from its natural length to a length 1m beyond its natural length. How much work is needed to stretch it from its natural length to a length 5m beyond its natural length?