50 V Xc = 120 2 R=40022

Q: A resistor and inductor are connected in parallel in a simple circuit. If the resistor has a current…

A: The objective of this question is to find the total current in a parallel circuit consisting of a…

Q: 552 E = Ao cos (lot-kz) ap V/m 5- In free space a) Find H b) Find Fd c) Find k

A:

Q: The rms value of the resultant current in a wire which carries a dc current of 20 A and a sinusoidal…

A: Given information is shown below:D.C. current or average current Peak value of sinusoidal current To…

Q: Explain more please

A: The given circuit isWe need to determine the transfer function Vo(s)Vi(s).

Q: A 16340v circuit is drawing 100kW and 82kVARS find the apparent power in kva

A: The voltage, The active power, The reactive power,

Q: Common- emitter resistance To = 35 Kur with Ic = 20mA and VCE= 6V. amplifier has a Small-signal…

A: In this question, we need to determine the voltage VA  as shown in the circuit.

Q: Find the inductor current for t>0 for the circuit below step by step

A: According to questions we need to calculate the inductor current.

Q: Problem 2: Consider the following RCL circuit when R = 4 N, L = 1 H, C = 3.33 mF. Determine the…

A: Note: Since MATLAB simulation part is asked to solve, so we will solve according to that.The given…

Q: Problem 1 A sinusoidally modulated ordinary AM waveform is shown below. 9 3 0 -3 Determine the…

A:

Q: Through circuit analysis, if its determined that S = |SI = P The power factor of this network is…

A: S=|S|=P

Q: In the circuit shown on the right the switch S has been open for a long time. What is the current…

A: The circuit is given as

Q: (b) If the toroid has a circular cross section as in Figure 7.15, show that M.№²q² 2po where Po » a.…

A: If the toroid has a circular cross section , show that

Q: F ) (a) When the two waves with an equal intensity is incident on a surface with the incident angles…

A:

Q: QUESTION 20 R For the circuit shown above, what is the magnitude of the equivalent impedance as seen…

A: Given:A circuit, with, we need to find:Magnitude of the equivalent impedance seen from a-b terminal.…

Q: The steel rod is supported by an aluminum plate of 8 mm thickness. Force P pulls down the rod…

A: The objective of this question is to calculate the allowable value of force P that can be applied to…

Q: A closed loop control system shown in figure below uses a PID controller. K R(s) C(s) 10+ 10k, S +…

A:

Q: What is the current through the inductor if the frequency is 159.2 kHz? E = 5 V L0° OIL 392 μA L-90°…

A: In this question, we need to determine the current in the inductor L.Frequency f= 159.2 kHzwe solve…

Q: Please draw clear schematic and step by step explaiantion

A: In this question, we need to draw a schematic diagram.

Q: In single transistor amplifier design, it is observed that the voltage gain will always decrease as…

A: The first statement is False. In a single transistor amplifier design, the voltage gain is given by…

Q: Question 3 Find the total impedance phase in the below circuit. R = 75 Q, L= 11 mH, C = 12 nF, [Vs]…

A:

Q: B 1) Given circuit. 2) Simplified circuit. B T Represent the circuit using logic notation. Then…

A: Given:a circuit, a) we need to represent the circuit using logic notation. b) we need to simplify…

Q: 5 Ving@ Run www. вс Vec Vout CE Consider the BUT Circuit Shown with Rc = 2: 2142, BB = 100 and RE =…

A:

Q: Given the circuit below with vs(t) = 20cos(220t +30°), determine v, (t). Vs(t) 300 www 50Q www 50 μF…

A: In this question, we need to determine the output voltage Vo(t).we solve this problem using voltage…

Q: 1. In tracking control system the control effort must is: a. Minimum value b. Zero value c. Maximum…

A: According to the question, we need to select the correct option for the given questions

Q: A silicon semiconductor material is to be designed such that the majority carrier electron…

A:

Q: Two signals, mi(t) and m2(1) (both band-limited to 10,000 Hz) are to be transmitted simultaneously…

A: Given:A communication system,we need to do:(i) Sketch the spectrum at point (a) and (b) of the…

Q: 7. Solve for the following circuit: (Final answers here, show your work on next page)

A: Given circuit is shown below:To find:

Q: The scattering parameters of a certain two-port network is measured to be 0.3 0.6 using 50 ohms…

A: According to the question, for the given S-matrix as shown belowThe characteristic impedance of the…

Q: typing format E = ABCD + ACD+AC+C Onestion 4 Use a K-map to simplify the Boolean expression

A: The given Boolean expression needs to be simplified by using the k-map and the same can be obtained…

Q: For the circuit to the right, what is value of the voltage v? a 1,57 b) IN c) d) N e) None of the…

A:

Q: Consider the model selection procedure where we choose the degree of polynomial, d, using a cross…

A: The correct answer is:An extra parameter, d, has been fit to the cross validation set.Cross…

Q: 13. For the figure above, a half ring located at z=0 possesses a charge density and induces E onto a…

A: According to the question, , a half ring located at z = 0 possesses a charge density and induces E…

Q: Table 1 2. Calculate the "synchronous speed" in machines with a rated frequency of 50 Hz, designed…

A: The following quantities are desired to be calculated for the given number of poles (2, 4, 6, 8, 12)…

Q: semiconductors

A: Semiconductors are a key component in electronic devices. There are mainly two types of…

Q: Drill Problems: Inductive Switched Circuits R₁ V₂ 1+ R3 www Submit Answer Retry Question Hide Answer…

A: Given Data:An RL transient circuit with,Supply voltage To Find:The output voltage

Q: Find equivalent impedance of below circuit.

A: Given circuit is shown below:To find:

Q: 1. In the figure, the magnetic flux through the loop increases according 6t² + 7t, where Pg is in…

A: The given figure is shown below,Where,the magnetic flux is 6t2+7t.

Q: Obtain the time-domain waveforms for -3 + 4j at angular frequency w = 30000 rad/s. The amplitude of…

A:

Q: Use the multiplexer to implement the truth table’s function.

A: Since you have posted the multiple questions so we are supposed to answer 1st one. According to…

Q: Matematiksel gösterimi aşağıda verilen düzgün düzlem dalganın Circularly polarized (CP) olması için…

A: We need to find out value of unknown for given electric field waveform.

Q: A 100 kHz ac voltage source with Vs(t) = 3 Cos (27 100e3 t) V, is connected across the plates of a…

A: The voltage across a capacitor with lossy dielectric (ϵr=6, σ=10−10 S/m) is a sinusoidal source…

Q: Example: A source has six messages with probabilities [0.3, 0.25, 0.15,0.12, 0.1, 0.08]. Construct…

A: To construct a 4-ary (quaternary) Huffman code for the given probabilities, follow these steps:1.…

Q: The current I in the circuit shown is

A: Given circuit is shown below:To find:

Q: LUMEN METHOD An office has length of 30m, width = 12m and a clear height of 3.5m. Mounting Height =…

A:

Q: Problem 11.062 - Computation of source voltage in circuit For the given circuit, find Vs Assume R₁…

A:

Q: the loop gain of closed loop system is given by k/s(s+2)(s+4).the value of k for which the system…

A: Given:The loop gain GH of a closed loop system is,,

Q: Q = 1 mC (0, 0, 1) P₁-2 mc/m 4 Calculate E at (0, 0, 1) due to the 1 mC point charge located at (2,…

A: A point charge of 1mC is located at the co-ordinate (2,0,0)Surface charge density of line charge is…

Q: An impulse turbine is used for a. Low head of water b. High head of water c. Medium head of water d.…

A: we need to select the correct option for the given statement.

Q: f a transformer has a primary voltage of 480V and draws 5A of current, what is the secondary amperes…

A: The primary voltage, The secondary voltage, The primary current,

Q: P 9.5-4 Reconsider Problem P 9.4-1 when L = 640 mH and the other parameters and conditions remain…

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.