52. This is ordinary telephone twisted pair wire, one of several physical media specified in the IEEE 802.3 standard for Ethernet local area networks (LANs). a. 10BASE-T b. 10BASE-F c. 5BASE-T d. 100BASE-T

52. This is ordinary telephone twisted pair wire, one of several physical media specified in the IEEE 802.3 standard for Ethernet local area networks (LANs). a. 10BASE-T b. 10BASE-F c. 5BASE-T d. 100BASE-T

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter9: Supporting Network Hardware

Section: Chapter Questions

Problem 6RB

See similar textbooks

Related questions

Q: 209. In data over cable system interface specification, the downstream communication has only one a.…

A: In data over cable system interface specification, the downstream communication has only one

Q: 1. The destination address field of an Ethernet frame packet has bytes, which is represented by hex…

A: The standard ethernet frame format is : Ethernet operates in data link layer. As it pass from data…

Q: In _________, autonegotiation allows two devices to negotiate the mode or data rate of operation. a.…

A: Given DAta:- In _________, autonegotiation allows two devices to negotiate the mode or data rate of…

Q: Low-power wide area networks (LPWAN) have both licensed and unlicensed spectral versions for…

A: Solution Difference between Licensed and Unlicensed LPWAN is : Licensed LPWAN Infrastructure…

Q: A Cat5e network cable has a specific color code pinout. In which color specification order would you…

A: The 568A and 568B principles were created to give more compelling interchanges to longer distances…

Q: The cable modem for data transmission, is similar to a. high-bit-rate digital subscriber b.…

A: Asymmetric DSL modem is a category of digital subscriber line(DSL) technology, are used for faster…

Q: 33. Standard Ethernet (10-Mbps) uses _______ encoding. a. NRZ b. AMI c. Manchester d. differential…

A: Please see the next step for answer.

Q: Assume there are one million books in your campus library. Approximate (to the nearest order of…

A: a. With the given problem, it is already mentioned that there are one million books in the campus…

Q: Select the correct statement(s) regarding 802.15 Bluetooth piconets and scatternets. a. A device in…

A: We need to find the correct option regarding Bluetooth.

Q: Mobile networks are absolutely free of wires and cables when it comes to the air interface that…

A: Introduction: Data processing is another term for data storage. Data processing is the technique of…

Q: ll of these are benefits of unshielded twisted pair (UTP) except

A: Option B could be the answer thick

Q: ) All of these are popular wireless standards except a) 802.11a b) 802.11b c) 802.11ac d) 802.11ab

A: The list of valid wireless standards: IEEE 802.11 IEEE 802.11a IEEE 802.11b IEEE 802.11g IEEE…

Q: networking chart with port numbers. I'm a bit unsure of what the sections mean. Can anyone help…

A: Ports are software constructs that allow applications to receive the required data from the network…

Q: Describe how the data link layer (such as Ethernet) handles multicasting.This entails detailing what…

A: Data Link Layer Among the seven layers of the OSI model, the second layer is the data link layer…

Q: 99. A three-layer switch is a kind of ________. a. repeater b. bridge c. router d. none of the above

A: I have provided solution in step2

Q: Suppose there is a shared link (e.g. Ethernet bus) of 1 Mbps. How much time is needed (in…

A: The all-embracing Ethernet LAN protocol has now been analysed in detail. Today's Ethernet consumer…

Q: Answer the questions below about wired LANs: i) Fill in the missing words in the gaps of the…

A: Computer Networks is the one which refers to the set of the computers or the devices that are…

Q: B. Name the acronym for the following: 1- OSI: 2- WAN: 3- IP:

A: Name the acronym are as follows:

Q: With the exception of one, all of them are widely used wireless standards. 802.11a, 802.11b,…

A: Wireless standards are a set of services and protocols that dictate how your wireless network acts.…

Q: What are the distinctions between the following network devices: switches and routers, and what…

A: Introduction A router is a networking device that connects numerous switches and networks together…

Q: Which statement is true about media access control? Select one or more: a. Ethernet uses CSMA/CD.…

A: A MAC address is a unique address which distinguishes different interface .

Q: 2. Select the correct RJ45 pin-to-signal assignment for a 4-wire ethernet LAN cable. Choices are on…

A: Solution: Given, Select the correct RJ45 pin-to-signal assignment for a 4-wire ethernet LAN…

Q: 10.a. Ethernet networks are normally designed using a _______ topology. A. ring B. star C. linear D.…

A: 10.a. Ethernet networks are normally designed using a _______ topology.A. ringB. starC. linearD.…

Q: EEE has defined the specifications for a wireless LAN, called _______, which covers the physical and…

A: IEEE 802.3 :- defines the group of working characteristics of Ethernet . IEEE 802.5 :- defined the…

Q: i- Minimum frame time, Maximum length of the network, ili- ii- If frame change is available as…

A: Ethernet IEEE 802.3: The frame formats or frame structures produced inside the MAC layer of the…

Q: Diagram of frame format on 802.1q encapsulation Configuration of Router and Switches Snapshot of…

A: VLAN: Before VLANs, separate networks were supposed to be created such as LAN1 and LAN2. And the…

Q: QUESTION 4 The Ethernet protocol is classified as which category? O none of these O a turn-taking…

A: 4.The ethernet protocol is classified as which category

Q: Ethernet or Wi-Fi technology includes the specification of these two OSI layers: Group of answer…

A: Ethernet or Wi-Fi technology includes the specification of Physical and Data link layers. Physical…

Q: 1-Explain the essential hardware devices used in a simple LAN (Explain the hardware devices used in…

A: Part(1) Following are the basic hardware devices which are used in the simple LAN: Network cables:…

Q: Question 2 (a) Ethernet uses CSMA/CD as it's medium access mechanism. Can you explain how the…

A: Given: Question 2 (a) Ethernet uses CSMA/CD as it's medium access mechanism. Can you explain how…

Q: 64. The standard for data transmission over an HFC network is called _______. a. MCNS b. DOCSIS…

A: Answer : - option B) DOCSIS

Q: What is the maximum size of payload field in Ethernet frame

A: payload field is the data part which is transferred between source and destination

Q: The wireless LAN specification is defined by IEEE, called, _______which covers the data link and…

A: Dear Student, The IEEE 802.11 specification defined by IEEE covers the data link and physical layer.…

Q: 41. A transceiver cable is used in ......................... Ethernet. a. 10Base 5 b. 10Base 2 c.…

A: given data A transceiver cable is used in ......................... Ethernet.

Q: What are the most popular frequency reuse factors for 1G FDMA, 2G TDMA, and 3G CDMA

A: As The Name Says FDMA, TDMA, CDMA all of these techniques used in 1G, 2G, and 3G Respectively FDMA…

Q: Consider the following destination address of standard Ethernet 42:10:1B:2D:06:EE What is the type…

A: The given destination address of standard Ethernet is : 42:10:1B:2D:06:EE

Q: 1. Ethernet uses a ______ physical address that is imprinted on the network interface card (NIC). a.…

A: Refer to step 2 for the answer.

Q: Which of the following IEEE standards represent Ethernet? Select one: O a. 802.11 O b. 802.16 O c.…

A: As per our guidelines we can answer only one question. please post other question as another…

Q: 79. To use a cable network for data transmission, we need two key devices: a ______ and a…

A: Answer : - option C) CM; CMTS

Q: Question 4 Cable media physically link computers and other devices in a network. State THREE (3)…

A: cable media is used to connect between computer device and network . Which act as an physical layer…

Q: causes more ray collisions, so you have to transmit slower Select one: a. Twisted pair

A: Twister pair cables have more electro magnetic compatibility and more immune to noise Coaxial cables…

Q: The Ethernet standard 802.3cc introduced in 2017, can reach speed _____ Gbit/s over Single Mode…

A: Solution :- 25Gb/s

Q: 1.Explain the architecture of IEEE 802.11 Wireless LAN. Briefly explain the various variants and…

A: 1.Wireless LANs are those Local Area Networks that use current high frequency radio waves instead of…

Q: Shared or hub based Ethernet is conceptually describe

A: An Ethernet hub, active hub, network hub, repeater hub, multiport repeater, or simply hub is a…

Q: Which function enables the switch to automatically configure an interface for a straight-through or…

A: In this question, we have to choose one out of four option.

Q: Write the procedures of active and passive scanning in IEEE 802.11

A: According to the Bartelby Guidelines we are allowed to answer one question at a time. So kindly…

Q: Discussion:- 5- What is the main purpose behind making a cross UTP cat5e cable. 6- The maximum…

A: Here i explain the answer:…

Q: Standard Ethernet, Fast Ethernet, Gigabit Ethernet, and Ten-Gigabit Ethernet data rates should be…

A: Standard Ethernet, Fast Ethernet, Gigabit Ethernet, and Ten-Gigabit Ethernet data rates should be…

Q: explain and mention the difference between the following packet-switching using data gram and…

A: In datagram, the packets are routed independently and it might follow different routes to reach the…

Q: The physical layer, in reference to the OSI model, defines a. the virtual circuit interface to…

A: X.25 is an interface between data terminal equipment (DTE) and data circuit terminating equipment…

Concept explainers

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.

Question

52.	This is ordinary telephone twisted pair wire, one of several physical media specified in the IEEE 802.3 standard for Ethernet local area networks (LANs).
a.	10BASE-T
b.	10BASE-F
c.	5BASE-T
d.	100BASE-T

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

SDN is an acronym that stands for "software-defined networking," and it refers to a collection of standards for digital transmission via conventional copper wire telephone lines, in addition to other forms of media.a. CCITT b. ITU c. Both a and b and d. None of the options presented.None of the things listed above
42. The protocol used in ETHERNET? a. ALOHA b. Binary Count down c. CSMA/CD d. Multiple Access Protocol
SDN stands for "software-defined networking," and it refers to a set of standards for digital transmission via traditional copper wire telephone lines, in addition to other types of media. CCITT b. ITU c. Both a & b d. None of the above.None of the preceding
5. How many bits are there in the Ethernet address? a. 64 bits b. 48 bits c. 32 bits d. 16 bits
The acronym SDN stands for "software-defined networking," and it refers to a set of standards for digital transmission via conventional copper wire telephone lines, in addition to other forms of media.a. CCITT b. ITU c. A, B, and D, respectively. None of the aforementioned.None of the aforementioned
2. In the Ethernet packet, the "Data" part is used to contain data send from source to destination and vice versa. The minimum number of data bytes is 46; what if the data is less by 2 bytes
31. In the Ethernet, the _______field is actually added at the physical layer and is not (formally) part of the frame. a. CRC b. preamble c. address d. none of the above
What is the Ethernet LAN transfer rate?
62. Ethernet and Token-Ring are the two most commonly used network architectures in the world. Jim has heard of the different topologies for networks and wants to choose the architecture that will provide him with the most options. Which of the following would that be? Choose the most correct answer. a. Token-Ring, because it uses a MAU b. Ethernet, because it can be set up with most topologies and can use multiple transfer speeds c. Neither Token-Ring nor Ethernet is the proper choice. Only ARCnet can be used in all topologies d. Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can be used in any topology
Standard Ethernet, Fast Ethernet, Gigabit Ethernet, and Ten-Gigabit Ethernet data rates should be compared?
91. A _______ is a device that operates only in the physical layer. a. passive hub b. repeater c. bridge d. router
Describe the differences between Wi-Fi 5 (802.11ac) and Wi-Fi 6 (802.11ax) in terms of speed, range, and other features.