6) A person on a dock is pulling in at the rate of 1 m/sec a boat by means of a rope. The man's hands are 5 ft above the level of the point where the rope is attached to the boat. How fast is the measure of the angle of depression of the rope changing when there are still 10 m of rope out?

6) A person on a dock is pulling in at the rate of 1 m/sec a boat by means of a rope. The man's hands are 5 ft above the level of the point where the rope is attached to the boat. How fast is the measure of the angle of depression of the rope changing when there are still 10 m of rope out?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Two locomotives on opposite banks of a canal pull a vessel moving parallel to the banks by means of two horizontal ropes. The tensions in these ropes are 2000 N and 1500 N while the angle between them is 700. Find the resultant pull on the vessel and the angle between each rope and the canal.
A body weighing 2225 N is being dragged along a rough horizontal plane by a force of P=445 N. If the coefficient of friction is 1/12 and the line of the pull makes an angle of 18° above the horizontal what are the velocities acquired from rest in the first 3.65m and in the first 5.50m?
A car is being towed up on an incline with an angle of 15ᵒ with the horizontal. Find the force (parallel to the incline) needed to pull the car with an acceleration of 1.2 m/s2. The car weighs 20 kN. Neglect friction. A. 5.18 kNB. 8.36 kNC. 2.45 kN D. 7.62 kN
Q2/ You want to move a 400-N crate across a level floor by pulling upward on the rope at an angle of 30° above the horizontal. How hard must you pull to keep it moving with an acceleration of a = 0.5 m/s² ? Assume that µ = 0.30.
1. A tennis ball was dropped from point A to point B. The distance between A and B is 10 m the coefficient of restitution is 0.8. If the point B is located on a plane sloped at 30 degrees with the horizontal what will be the direction of travel of the tennis ball and how high from point B will it rise.
an open rectangular tank mounted on a truck is 7 meters long and 1 meters wide. It is filled with water to a depth of 3.37 meters. If it is accelerated at 8.47 m/s2 along its length, determine the required height (in meters) of the tank to prevent any water from spilling. Round off to two decimal places.
A volleyball player throws the ball with an initial velocity that makes an angle ?= 35º with the horizontal. Determine: The magnitude of minimum initial velocity with which the ball must be thrown in order to pass the net of height h. More data: h= 2.40 m Y= 2.15 m L= 12 m
You throw a ball straight up with an initial velocity of 18.0 m/s. It passes a tree branch on the way up at a height of 6.0m. How much additional time elapses before the ball passes the tree branch on the way back down?
A rope is attached to a boat at water level, and a woman on the dock is pulling on the rope at the rate of 50 ft/min. If her hands is 16 ft above the water level, how fast is the boat approaching the dock when the amount of rope out is 20 ft.
A boy slides down a water chute starting from rest at A. Neglecting friction. a. which of the following gives the velocity at the end of the chute at B in ft/s. b. which of the following gives the velocity on entering the water at C in ft/s. C. which of the following gives the horizontal distance of C from B in miles.
A 500 N block is resting on an inclined plane and is subjected to a constant force of 600N acting parallel to the inclined plane. After the block has moved 3 m from rest along the inclined plane the force 600N is removed. The inclined plane has a slope of three vertical to four horizontal. Coefficient of friction is 0.20 a. Which is the following gives the distance that the black will move further along the inclined plane until it will stop? b. Which of the following gives the velocity of the block when this for 600 Newton was removed? c. Which of the following gives the velocity of the block when it returns to its initial position?
To unload a tied pile of plywood from a truck, the driver first tilts the truck bed and then accelerates from rest. Knowing that friction coefficients between the bottom plywood layer and the bucket floor are s 0.40 and k 0.30, determine (a) the smallest acceleration of the truck that will cause the plywood pile to slide and (b) the acceleration of the truck that makes corner A of the plywood pile reach the end of the bucket in 0.9 s. I need the calculations and a detailed description substantiated and explaining each step of the calculations. Please. (If you have any way to make it easier to translate, I appreciate it. I can't read very well in english)