6. The original electrical information signal to be transmitted is called * Modulating Signal Carrier Baseband Signal Source Signal 7. The Process of modifying a high frequency carrier with the information to be transmitted is called * Multiplexing Telemetry Detection Modulation

Q: Explain frequency hopping acquisition scheme using a simple PN sequence. Assume that the length of…

A: Frequency hopping acquisition scheme using a simple PN sequence. In a frequency hopping, the…

Q: What is the purpose of the limiter circuit in the FM system? to remove the variation in the FM…

A:

Q: Wavelength division multiplexing, to put it briefly.

A: Wavelength division multiplexing:- A fiber-optic transmission method called wavelength division…

Q: 4. Does the frequency deviation depend on the frcquency of the information signal?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Draw a block diagram of a typical digital communications system (both transmit and receive paths)…

A: Given  We need to draw the block diagram of digital communications system and explain source encoder…

Q: When the modulation index is (1) means that the amplitude of the message signal is ......... the…

A: A brief about Modulation Index   Modulation Index tells about the level of  modulation that…

Q: What are the entire DISADVANTAGES of FREQUENCY DIVISION MULTIPLEXING? 1:10 PM

A: i)all the channels of FDM are affected by wideband channel fading. ii)large number of filters and…

Q: Q1// A carrier signal given by 10cos10000t volt is AM/DSB-LC modulated by the message signal…

A:

Q: layman's term, explain super heterodyne receiver.

A: The explanation is as follows.

Q: In a delta modulation system, how many bits per sample are transmitted by the transmitter?

A: The solution is provided in the following section.

Q: b) Draw a block diagram of a typical digital communications system (both transmit and receive paths)…

A: Communication System:  A communications system, often known as a communications network, is a…

Q: Q7) What are the orbital characteristics of GPS satellites? Q8) What is the full form of PRN code?

A: The orbital characteristics of GPS satellites are: There are a total of 24 satellites which rotates…

Q: Explain why using double side band with suppressed carrier (DSB-SC) in a communication system is…

A:

Q: Discuss how the original signal can be recovered perfectly from the output of the decoder. What are…

A: At the decoder side, various signal reconstruction devices are used to recover the original message…

Q: Explain the advantages of non-linear quantisation (or equivalently companding) over linear…

A: According to the question, we need to discuss the advantage of nonlinear quantization and A law…

Q: State modulation of signals, and distinguish different modulation techniques, thereon identify which…

A:

Q: 41. Noise is typically narrow spikes of voltage with high frequencies. Group of answer choices…

A: Note: Since you have not specified any question to be answered, as per our honor code, we are…

Q: In data transmission, both periodic analogue signals and non-periodic digital signals are used. Why

A: In this question we will write why in data transmission , both periodic and non periodic signal is…

Q: FM DEMODULATION Why is it necessary to recover the original information signal from the carrier?

A: By using modulation we sent our original signal from transmitter to receiver with the help of…

Q: In your own words, Explain each principles of signal communications in Military.

A: Given that principles of communications in military needs to be explained. Do like my answer. Please…

Q: What information can be obtained by result and analysis of  "Enhance AM radio signal broadcasting"

A: AM broadcasting is radio broadcasting using amplitude modulation (AM) transmission . It was the…

Q: a)Draw the block diagram of communication system with all details from microphone to the antenna? B)…

A: A) we have to draw block diagram that shows different stages of communication system. B. types of…

Q: Determine the permissible range in maximum modulation index for (ii) narrowband FM system which…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: Consider the amplitude modulated signal below, what is the ratio of the power of the message signal…

A: Given: vam=cos(2000πt)+4cos(2400πt)+cos(2800πt)

Q: Discuss in detail the role of each component to enhance effective communication. *Transmitter…

A: Transmitter :- The transmitter modifies the baseband signal for efficient transmission. The…

Q: 1. The maximum frequency deviation of the carrier is + 15 kHz and the maximum modulating frequency…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Determine the Emmision Classification 2. Single sideband full carrier single analog channel…

A: Given: Single sideband full carrier single analog channel telephony. To find: Determine the Emission…

Q: Question 3: What are the similarities and differences between the information signal m (t) obtained…

A: Difference between modulated signal and demodulated signal- In modulation process original signal…

Q: 1) What is selectivity? Explain how you can increase selectivity of a receiver. ( 2) How does type…

A: Selectivity is defined as the measure of the performance of the radio receiver to respond only the…

Q: a) Using a well-label block diagram, explain the basic analog communication system b) What is the…

A: Communication is the process of establishing connection between two points for information exchange.…

Q: Give one advantage and one potential disadvantage of using licensed spectrum in wireless…

A: to give one advantage and one potential disadvantage of licensed spectrum in wireless communications

Q: c) The superheterodyne receiver (SuperHet) is an architecture that enables the same receiver to…

A: Introduction - Superheterodyne receiver - A superheterodyne receiver, also known as a superhet, is a…

Q: What is the maximum transmission efficiency of an AM signal?

A: The solution is provided in the following section.

Q: A) What does the Modulation term mean in Communication?

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Describe the difficulties in listening to a receiver without AGC.

A: AGC is stands for automatic gain control which is used in television system to control the gain of…

Q: What are some disadvantages of designing a global communication system with a LEO constellation that…

A: The disadvantages of designing a global communication system with an LEO constellation that requires…

Q: How much BW would be required to transmit a DS-1 signal (1.544Mbps) using a four level code? (a)…

A:

Q: For GSM 900, mention the uplink and downlink frequency bands

A: In the following section, the uplink and the downlink frequency bands for GSM 900 is provided.

Q: 01: (A): What are the functional elements of the communication system, draw the block diagram and…

A: 1 (A) Communication system: Basically, it is the process of exchanging information between the two…

Q: What did mean the term analog communications? a- A method in which one of the properties of a…

A: Analog communication is a means to transfer data through channels or computers for long and short…

Q: 3. What are the differences between homodyne and super heterodyne receivers

A: differences between homo-dyne and super heterodyne receivers?

Q: Describe how the principles of the RAID organization may be used in a broadcast-data environment…

A: A basic introduction to RAID Raid generally stands for  (Redundant array of independent disk). In…

Q: 3. What are the differences between homodyne and super heterodyne receivers.

A: A radio receiver is a wireless radio component which converts the information carried by radio waves…

Q: What is the basic working principle of wavelength division multiplexing?

A: Using a technology called wavelength division multiplexing (WDM), several optical carrier signals…

Q: In data communications, we use periodic analog signals and  Non periodic digital signals explain

A: The explanation is given in the following section.

Q: For a delta modulator system, the following number of bits are getting transmitted per sample: 1. 4…

A: The delta modulator (DM) is a modified version of a pulse code modulated (PCM) system. The main…

Q: For a communication link what are the different forms of modulation?

A: Given :    Modulation is a method which is used in the communication system for the following…