6. The root mean-square(effective) voltage V. =√√√√²& 2 dt rms . Find the value of rms if where T is the period of the sine wave. maximum V rms of sine wave is defined by: positive peak -F effective or RMS average A TIME VOLTAGE V = 10 sin- www negative 2лt T and us. I F 1 T == 50.

Q: In RL series circuit, voltage across resistor is 6V and voltage across inductor is 8V. Power factor…

A: Given data, Voltage across resistor VR=6 V. Voltage across inductor VL=8 V.

Q: Design a two-pole high pass Butterworth active filter with curoff frequency of 10 kHzand a unity…

A:

Q: Compute for the inverse laplace of [(s2 - 1)3] / s6 without having a delta function, or δ(t), in the…

A:

Q: 32. f(x)= 2 2 0<x<1 - x, 1≤x<2

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: What is Operational amplifier as differential amplifier, kindly add real life examples and its…

A: Given:

Q: Example 3. The switch in the circuit of Figure 7 has been closed for a long time, and it is opened…

A:

Q: Calculate the coefficient a. Calculate the coefficient wo. Select the type of response for this…

A: The given circuit is a series RLC circuit and the required parameters can be calculated with the…

Q: 1. (7.15) Find io(t) for t> 0 in the circuit below. 10 V Μ 2 ΚΩ 15 με 5 ΚΩ Μ io I=0 2 ΚΩ

A:

Q: If the signal power at a certain point in a system is 5 watts and the noise power is 50 mili-watts,…

A: Given: In this question, the given details are, If the signal power at a certain point in a system…

Q: Formulas of Colpitt’s Oscillator:-   Calculate C2 from AV > C1/C2 Calculate C from f=1/(2П…

A: The Colpitts oscillator is given as According to the question, here we need to calculate the value…

Q: How many octaves are there between 1280 Hz and 20 Hz?

A: The octave is nothing but the doubling of frequency. The higher note frequency will have double than…

Q: D8.7 A three-phase, 30-hp, 480-V, four-pole, 60-Hz induction motor has the following equivalent…

A: Given: Power,P=30 HP Voltage, V=480V, Pole, P=4, Frequency, f=60Hz. Parameters:

Q: Design a 2-bit 5 operations ALU which can perform the following operations: a) Addition b)…

A: According to the question, we need to design 2-bit 5 operations ALU which can perform the following…

Q: A 25 pC charge is uniformly distributed over conductive sphere of radius 5cm, the electric field…

A: Given- Uniformly distributed charge, Q = 25 pC Conductive sphere radius, R=5 cm     To find- The…

Q: 1. when using busbar and cable to main Power? 2.what the meaning of parallel transformer?

A: What are Busbar and Cable?   Busbars are rigid pieces of copper or aluminium that are bolted to or…

Q: What are the advantages of using polling in the main loop of microcontroller firmware? What are the…

A: Microcontroller Firmware The embedded software that is stored in the MCU's programme memory is…

Q: Example 2. Find i and vẪ in the circuit of Figure 11. Let i(0)=5A.

A: The current i in the given source free RL circuit can be calculated by using the ohms law and also…

Q: In a certain 50 KVA transformer, the number of turns on the primary and secondary windings is 834…

A: Secondary voltage = primary voltage×Number of Secondary winding turns Number of Primary winding…

Q: V2 V1 VO R www 2R ww 4R www R ww Vout

A: Operational amplifier is differential amplifier.  Ideal op amp have infinite input resistance.  It…

Q: 3. Find the logical function of the following static CMOS circuit (OUT=?) Jp-c D THE [ урн OUT

A: CMOS circuit consists of different pmos and nmos are given we are asked to find the output

Q: Determine the inductor current i(t) for both t= 0 and t> 0 for the given circuit. Assume V 26 V. 352…

A:

Q: Determine the values of the resistances, series connected inductances or capacitances of the…

A: In this question we have to find the values of the resistances, series connected inductances or…

Q: 3. The telephone line has a bandwidth of 12.5kHz and a signal-to- noise ratio of 42dB. A signal is…

A: Given data Bandwidth, B=12.5 kHz Signal-to-noise ratio, SNdB=42 dB We need to calculate the maximum…

Q: Write the assumptions about Thevenin and Norton and prove these theorems with a proper examples.

A: Thevenin and Norton Theorem is used to convert a large complex network into a single source network…

Q: Q- In 11 kV, 50 Hz system, the value of reactance and capacitance up to the location of circuit…

A: Given data- 11 kV, 50 Hz system, Frequency f=50 Hz, Reactance XL=6 Ω, Capacitance C = 0.05…

Q: Current: I1 = 2 A, I2 = 1 A, and I3 = 3 A &  d = 10 cm. 1.Draw representative magnetic field…

A: The given diagram is shown below. The given values of currents are written below. I1=2 A. I2=1 A.…

Q: 1) Design (Find R₁, RF, and R) the sawtooth-wave generator to have an output frequency fo= 6kHz.…

A: We have to deign parameters for sawtooth generator Given f0 =6 kHz Vth =5 V Vsat  =14 V V ref =-9 V…

Q: Calculate the complex power S for all the four circuit elements. 652 Vs=18√240v rms value aj6sz -j3n…

A:

Q: 9.2 Determine Vo in the network below. 24/0°V(+ 3 Ω 6ΩΣ -j2 Ω 4 Ω j1Ω 10> 20 j4 Ω 1Ω; Τα

A:

Q: What resistor draws a current of 5 A when connected across terminals a and b of the circuit shown.…

A:

Q: 2. Calculate the energy of the following signals. a) g(t)=e-0.5|t| b) g(t): 2cos(200лt), 0≤ t ≤ 0.1…

A: Given data,  g(t) = e-0.5t g(t)  =     2cos200πt         0≤t≤0.1s                    0…

Q: 6. For the air core transformer circuit shown below, determine the currents la and Ib in the…

A: Given: Circuit diagram:

Q: Compute the current in the 27-ohm resistor by applying the superposition principle. With the 200-V…

A:

Q: Determine the reading of the meters connected in the circuit below. 24V A1 I + + V1 m 5Ω A2 + 12Q A3…

A:

Q: A negative unity-feedback LTI system has a forward element consisting of an amplifier with…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: What major RF band does 108 MHz belong? Answer in acronym.

A: We need to write  the major RF band  (in acronym form)does 108MHz belong

Q: Find transfer function G(s)-X₂(s)/F(s)

A: The required transfer function can be obtained by writing the differential equations for both the…

Q: 101 000 11 a) unsigned b) signed integer in sign and magnitude form C) Signed integer in one's…

A: Given,  Binary equivalent number is  B = 10100011 We need to represent it in the following forms a)…

Q: b) Laplace transform of f(t)=8 (1-3)

A: In this question we have to find a Laplace transform of the given signal

Q: roblem [16] etermine il, i2, and i3 using mesh analysis #2V( 4Ω www ww 6Ω 10 V (+→ ΖΩ

A:

Q: 2. For the circuit in Figure 7-42, determine the following: (a) the power dissipated in the…

A: Given circuit,

Q: If 173x10¹2 kW of light from the Sun hits the Earth and the total amount of electrical energy the…

A:

Q: a) Inverse Laplace of the following s function: 1 i) ii) F(s) = e-ss те SA F(s) = 1 (s+3)³ لاد e

A:

Q: Lectore S. Nedal Analysur V₁ 2₁ 22 in ↑ Vy V₁: Vy-V₁ 22 2, vilt) ↑ = - V₁-Vg + V₂-V₁. ZI Z3 U3:…

A:

Q: X О YIQ* * О 01 10 | | | Set Q' toggle о по скиде а по спанде a) derive a characteristic equation b…

A:

Q: Find the current IA, IB, IC, ID and IE in Figure 1b below using Mesh analysis.

A: The required parameters can be calculated by using the mesh current. The mesh equation can be…

Q: 3) For the following circuit, the switch is initially closed and has been for a long time. Find the…

A:

Q: Find the current 1₂ Α R₁ + E = 8 V / 20° ( 2 1Ω moo X = 2 Ω XL = Xc —— 8 Ω Ry' HI 4Ω Ε2 + XL Χ = 10…

A:

Q: 1. Determine the dc level of the output if ideal diode is used (in V). 2. Determine the dc level of…

A: Given: In this question, the given details are, Here, the given diagram is, 1. To find the value of…

Q: Consider a series RLC circuit with a resistor R = 43.0 ohms, an inductor L = 3.83 mH, a capacitor C…

A: Given: In this question, the given details are, Consider a series RLC circuit with a resistor R=43.0…