7 8. A three-phase balanced load is supplied by VCB = 300 sin (wt - 25°) V, CAB circuit where the phase A line -5.5 cos (wt + 25"), what is the power drawn by the load and impedance of current is balanced delta connected load?

7 8. A three-phase balanced load is supplied by VCB = 300 sin (wt - 25°) V, CAB circuit where the phase A line -5.5 cos (wt + 25"), what is the power drawn by the load and impedance of current is balanced delta connected load?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.40P: A balanced three-phase 240-V source supplies a balanced three-phase Load. If the line current IA is...

See similar textbooks

Related questions

Q: Analyze the circuit to determine the voltage aM + 5V all nodes and the curents deough all tranches.…

A: IE=IB+IC

Q: what is the use of DC/DC tension converter DC/DC booster MT3608

A: Types of mostly used DC DC Converter Step up Converter ( Boost converter) Step Down Converter (…

Q: 7. Three parallel three phase loads, wye connected are supplied from 208 Vrms, 60 Hz three phase…

A: The solution is given below

Q: Vcc 2.2 k2 Rs VCE = 7.2 Ig = 20 HA IE = 4 ma FIG. 120

Q: In the reverse-bias region the saturation current of a silicon diode is about 0.1 A (T …

Q: Short Circuit T-L, sketch the SW Pattern for Ed sketch the Variation of Zd with distance ,d%3D0, 8.…

A: Impedance at lambda/4 distance from receiving end is infinite

Q: 4. Sketch the drain characteristics of the JFET from the obtained data.

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3. The insulation used in high voltage circuit breakers of large power rating is (a) air (b) vacuum…

A: In this question, We need to determine the insulation used in high voltage circuit breaker of…

Q: The figure represents the equivalent circuit of a single-phase transformer, if after doing the…

Q: Consider an a.c circuit supplied by 220V at 50HZ. The circuit consists of only two inductors, L1 and…

Q: he following amplifier, calculate the output voltage, Vo, in V. .3 mA 1V OV 3.8 kQ 3.5 k2 32 kQ 57…

Q: If the maximum reverse voltage that can be applied across the silicon diode of a half-wave rectifier…

A: We need to find out output voltage waveform and dc value of output for half wave rectifier

Q: V at a frequency of 500 Hz. Determine the following: a. current b. power consumed and c. equation…

Q: provide the diagram of the h-parameter model and solve for the h- parameters of the given ce…

A: The circuit is as shown below,

Q: Design an ideal non-inverting op amp with a closed-loop gain of Av=10. When vi =0.8V, the current in…

Q: Example25/ T-L with Zo=6000, ZR = 100 Q. Find the length and location of the %3D single stub…

Q: Please draw

A: The D flip flop, according to the given question, is a negative edge-triggered flip-flop. In the…

Q: 2. Consider the switching oscillator shown below built from a threshold-controlled inverting Schmitt…

A: Oscillator: An oscillator is an electronic device that consists of an op-amp with a positive…

Q: 6 Find V, in the circuit

Q: Vs E 7.

A: Made it

Q: ninisa no g lsinn ob 20nsinslit col supaun sup VdO sibomberslled obiboqded H teA og 39 P(0,0, h) Tob…

A: Magnetic scalar potential: It is analogous to the electric potential and is used to find the…

Q: When Binary number A=1010 and B=1010, what is the output x in the following diagram? A,A,A, В, В, В,…

Q: The deep well pump can discharge a water at a flow rate of 150 cfm against a total head of 50m. If…

A: Given data Q=150cfm H=50m Pump efficiency=85% Motor efficiency=90%

Q: 2 A 42 R 5 A ) 42 4 V O10 O22 42

Q: Find the value of RL for maximum power transfer in the network and the maximum power that can be…

Q: 2 The magnetic vector potential of two parallel infinite straight current filaments in free space…

A: Magnetic Flux Density: Magnetic Flux Density is the quantity of magnetic flux per unit area measured…

Q: Out To. Vi, Viz non- in verting ampl.

Q: Calculate the reactance, Xc, (in Ohms to three decimal places) of a 81 µF capacitor at a frequency…

Q: T-L with Zo=600 2 ,ZR = 100 N. Find the length and location of the %3D single stub terminated by…

Q: T-L with Zo=600 0,ZR = 100 O. Find the length and location of the single stub terminated by short…

A: Given,Zo = 600 ΩZR = 100 Ωf=100 MHz

Q: The settling time of an underdamped system is 4 seconds, the time constant is, 2 points O a. 16 sec…

Q: (a) A4 pole, 380 V, 50 Hz, three-phase induction motor delivers an output power of 15 kW when the…

A: In this question, We need to determine the slip, motor speed, and motor input power? And also…

Q: What is the voltage Vin the following circuit? + 1V – - + 5 V + 5 A A (V 4Ω. -

Q: Example23/ Two transformers (4) are designed to match a line having a Z. 3002, ZR : 750 find Stable…

Q: Determine the equivalent capacitance between points a and b. 8 µF 6 µF a 6 µF 3 µF: 12 μF bo 10 µF

A: When two capacitor connected in series Ceq=( C1*C2)/(C1+C2) When capacitor connected in parallel…

Q: Using Kirchoff's law, find the current that goes through the capacitor in the circuit below.

A: In this question we will find current going through capacitor using mesh analysis...

Q: Determine the DC currents (B. Ic and le) and de juncion voltages (VBE, VCE and Vca) mA. Ic ma, E mA…

A: In this question, We need to determine the base current, collector current and emitter current?…

Q: (c) Refer to the circuit in Fig 7.2 for this part of the question: (i) Given Vs = 10 V, Ip = 15 mA,…

A: Brief description : In the above given question they want to know the DC parameters and small signal…

Q: (A) Explain the difference between series and parallel resistor circuits in terms of (1) the…

A: Resistor: Electronic components with a constant electrical resistance are known as resistors. A…

Q: t is supplied to the load Z' at 240 V, 6 kVA, with a power factor of 0.85 lagging at nominal…

Q: IM

Q: it is the non-stationary part of an AC motor.

A: Given: AC motor

Q: 4. A single phase load draws a current of 30 / 35 deg A. The voltage across the load is 220 /75 deg…

Q: Si IR +12 V o red 680

Q: Example23/ Two transformers (4) are designed to match a line having a Z, = %D 3002 , ZR = 75N find…

Q: An electric field in free space is E = (5z²/e0) â_ V/m. Find the total charge contained within a…

A: We need to find out charge contained in cube for given electric field .

Q: jen -jir

Q: A 40Hp, 230V, 10pole, 50Hz three-phase induction motor is running at 585 rpm at rated load. If the…

Q: For the following circuit, answer the questions below and upload your work in order to receive…

A: The solution is given below

Q: What is i in the following circuit? 2Ω 1Ω 2Ω 5 A A ( 5 V 3 H +

Question

100%

Subject: Electrical Circuit (EE2)

***Need asap pls. Thank you.

7
8. A three-phase balanced load is supplied by VCB = 300 sin (wt -25°) V, CAB circuit where the phase A line
-5.5 cos (wt + 25"), what is the power drawn by the load and impedance of
current is
balanced delta connected load?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A set of balanced three-phase transmission lines with line-to-line voltages of 13 kV is connected to a balanced wye load with phase impedance of 8 + j3 Ohms. What is the real power delivered to the three-phase load?
20/ For balanced three phase star connected load, the phase angle difference between VR and VY is 30 degrees. Select one: True False
In a three-phase, three-wire circuit, find the phasor line currents to a balanced Y load in which each phase impedance is ?? = 20 ∠ 300, ??? = 120 ∠ 200 and the phase sequence is ABC.
Three identical impedances of 10∠ − 15° Ω to a line voltage of 208 V in star connectedconnected to a balanced source. We accept all line and phase voltages and currents as Vca as reference.Calculate in the form (Assume positive order).
A balanced delta-connected lood with impedance per phase of 30<30 ohms is connected to an abc-sequence balanced three-phase source with eAC = -120√2 cos (120πt + π/6) V through conductors with negligible impedances. Determine the line currents, load phase currents and the total complex power drawn by the lood. Write your values in polar form.
A balanced three-phase source with grounded neutral has line-to-line voltages of 208 volts with ab-bc-ca sequence. It supplies power to an unbalanced three-phase wye, neutral grounded, load with impedances: Zan = 18-j10; Zbn = 15+j25; Zcn = 20+j30 ohms. What is the magnitude of the overall total apparent power of the system in va?
Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line currents as well as the neutral current are always zero. (a) True (b) False
A balanced three-phase 240-V source supplies a balanced three-phase Load. If the line current IA is measured to be 15 A and is in phase with the line-to-line voltage, VBC, find the per-phase load impedance if the load is (a) Y-connected, (b) -conneeted.
A three-phase line with an impedance of (0.2+j1.0)/ phase feeds three balanced three-phase loads connected in parallel. Load 1: Absorbs a total of 150 kW and 120 kvar. Load 2: Delta connected with an impedance of (150j48)/phase. Load 3: 120 kVA at 0.6 PF leading. If the line-to-neutral voltage at the load end of the line is 2000 v (rms), determine the magnitude of the line-to-line voltage at the source end of the line.
A balanced load consists of three coils with each coil having a resistance of 10 Ω and an induction reactance of 15 Ω The load is conneted as star to a 420 V, three-phase, 50 Hz supply as shown in the Figure For abc phase sequence, find (i) the line currents, and (ii) power factor.
Consider the balanced 3-phase circuit shown below (a) Sketch the single phase equivalent circuit. Show all values on the sketch. (b) Calculate the following: the total complex power absorbed by the wye connected load. the phase current, ICA.
A three phase Y‐connected balanced load having phase impedance of 40 + j30, The neutral is grounded through a 10 resistor. Find the sequence impedance matrix. Using symmetrical components, determine the phase currents when connected to unbalanced supply of voltages Va=380∠0 ̊V, Vb=280∠‐140 ̊ V and Vc=160∠90 ̊ V.