Answered: 7) The circuit shown uses a 36 V mains…

7) The circuit shown uses a 36 V mains supply. 12 C 36 Và 242 Calculate the reading in A1 and A2 when: a) switch S is open. switch S is closed. b)

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter7: Luminaires, Ballasts, And Lamps

Section: Chapter Questions

Problem 15R: A good rule-of-thumb to estimate the expected life of a motor, a ballast, or other electrical...

See similar textbooks

Related questions

Q: resistor

A: Note- “Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: 10. A coil consists of 2000 turns of copper wire having a cross-sectional area ofO.8 mm^2. The mean ...

A: Resistance R = Resistivity ρ×length (L)Area(A)power obsorbed P = voltage2Resistance R

Q: resistor. 0.3 A upward 0.5 A upward 0.5 A downward 0.3 A downward

A: Answer of question no. 35 We find current in every branch by using nodal analysis. Nodal analysis st...

Q: 2-The function of the impact sign given in the s(t) = rect(t/7) find the power spectral density of t...

A: Given function st=rectT

Q: *34. Determine v, for each network of Fig. 2.178 for the input shown. 20 V Ideal 2.2 ka -5 V (b)

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

A: Given, Input to RF amplifier (I) = 25dBu Gain of RF amplifier (Gr) = 30 dB gain Loss of mixer (Lm) =...

Q: Please Answer: Itotal I2 I1 Vtotal

Q: 21. Insulators have temperature co-efficient of resistance. * O positive zero O negative none of the...

A: Brief description : In semiconductor devices we have 3 type of materials such as conductor, insulato...

Q: Find the force on a conductor 90 cm long, carrying a current of 2 A and is situated perpendicular to...

A: We know that whenever a current carrying conductor placed in a magnetic field some force exerts on i...

Q: 17. If in the circuit shown in below, the reading on the voltmeter is 5 V and the reading on the amm...

A: Answer of question number 17 from given circuit voltmeter reading or voltage across the resistance =...

Q: 3. Refer to the graphic A. Answer the following questions based on the total power dissipated by the...

Q: 2ag – ay + az r2 = ag +3ay – 2az r3 -2ar + ay – 3az If r1 r4 = 3ax + 2ay + 5az find scalars a, b and...

Q: volume charge in a form of a cube, 2m on an edge, parallel to the axes and centered at the origin is...

A: We need to find charge enclosed by given surface .

Q: F. Use this graphic for Question 17 11 V2 0.03A = 9V R5 $4kQ R6 S2kQ R4 2kQ R7 5000 Hi

A: Using superposition theorem, to find the total current through R5 In superposition theorem , the c...

Q: The following forces act on the particle P: Fi = 2a, + 3a, – 5az. F2 %3D — 5а, + а, + За, Fз — а, — ...

A: We need to find resultant vector and we need to find out magnitude of resultant vector

Q: Express the unit vector a, in spherical components at the point: (a) r = 2,0 = 1 rad, ø = 0.8 rad (b...

Q: benefits of organic light-emitting diode (OLED) screens over LCD panels

A: THE BENEFITS OF OLED OVER LCD ARE 1)LOW POWER CONSUMPTION THE OLED CONSUMES LESS POWER COMPARED TO L...

Q: 5. In a Haynes-Shockley experiment, maximum amplitude of minority carriers at ti = 100 µs and at t2 ...

Q: The position vectors of points P and Q are given by: ri = 2ax + 3ay – az and r2 = : 4a – 3ay + 2az. ...

A: Brief description : From the given question we come to know that they have mentioned two position ve...

Q: F1 2а, + Зау — 5а,, The following forces act on the particle P: F2 = -5a, + ay + 3a, F3 = ag - 2ay +...

A: F1 = 2ax +3ay - 5az F2 = −5ax + ay + 3az F3 = ax - 2ay + 4az F4 = 4ax - 3ay – 2az

Q: (a) In a 3-phase balanced system shown in Figure 3(a), two wattmeters are used to measure the power ...

A: (a) The load is delta connected and line current in each phase is given as: Ia=Ib=Ic=15A as the load...

Q: Describe with the aid of a diagram how LVDT transducer may be used to measure pressure using bellows

A: A linear variable differential transformer is an electrical transformer that is used to measure line...

Q: Three vectors extending from the origin are given as r, = (7,3,–2), r2 = (-2,7,–3), and r3 = (0,2,3)...

Q: Suppose there are 6 digits [0,1,2,3,4,5], please tell me there are how many combinations for 3-digit...

A: Given, The 6- digits are [0,1,2,3,4,5] Number of combinations of a 3-digit number with distinct digi...

Q: 5. A causal, length M = 4, FIR filter with real coefficients achieves the frequency response H(w), w...

A: Finite impulse response of a filter is define as the filter which shows its impulse response for the...

Q: Determine the value of K for stability of unity feedback system whose open loop transfer function is...

A: In this question we will find range of gain K for stability of system...

Q: The lead storage batteries A and B are connected in parallel. Battery A has an open circuit voltage ...

A: Brief description : They wish to know the value of current IA passing through resistance rA in the a...

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

A: Given data: A DC series generator has, Rated power, P = 20 kW Terminal voltage, V=400 V Armature res...

Q: +9V 1 MN Q2 1 MN () 50 μΑ ) Rin 5 mA

A: GIVEN: R1=1MΩR2=1MΩβ1=50β2=100VBE=0.7V FIND: transmission of the base of Q1 and vb1/v...

Q: R1 1k R2 R3 3.3k 5.6k R4 VS1 VS2 2.2k 15V 5V

A: The give circuit diagram is shown below:

Q: is te) - 5 cosfi00t +40] 0-18 FIMF 200

Q: With reference to the network shown in Fig. 10.19, find the input impedance Zin that would be measur...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Determine the currents and voltages across all the resistances indicated in the circuit shown below.

A: It is given that:

Q: In Example 1.1, the relative permeability of the core material for the magnetic circuit of Fig. 1.2 ...

Q: An infinitely long straight conductor located in air is carrying a current of 100 A. Find the flux d...

Q: Find out the Laplace Transform of the following function: z(1) = e'u(1) -551 n.

A: In this case, the Laplace transform of the following function is to be determined: zt=e-55tut

Q: A coil having a resistance of 30 ohms and an inductance L is connected in parallel with a resistor h...

A: This question belongs to circuit theory . It is based on the concept of power consumption in the cir...

Q: Analyze the circuit of Figure 2 using superposition to determine the voltage across R3. Analyze the ...

Q: G. Use this graphic for Questions 18 and 19 R2 R1 6kQ 2kQ R3 RL 2kQ V1 80V

Q: Obtain the magnitude and phase of the transfer function and draw the bode plot

A: In this question, We need to Obtain the magnitude and phase of the transfer function and draw the ...

Q: A three phase, 4 - pole, 50 Hz induction motor has full load speed of 1455 rpm. What will be the fre...

Q: For the given circuit, what is the angle by which I leads V? 10a 5V 100UF 60HZ

Q: 2. A balanced, three-phase circuit is characterized as follows: a. Y-A connected b. Source voltage V...

Q: b) The following digital signal was encoded using NRZ-Invert. What is the digital data? (Fill in the...

A: What is the digital data for the given NRZ - Inverted output ?

Q: Find out the Laplace Transform of the following function: z(1) = e **u(t) -551

Q: D1 1 V1 R1 15V 2502 3

Q: Determine the resonance frequency (kHz) for the circuit shown below: 10UF 0.5mH Vs

Q: A three phase, 4 - pole, 50 Hz induction motor has full load speed of 1455 rpm. What will be the fre...

Q: A uniform sheet charge, infinite in extent, is located at x=2 m. Given that the charge density is 5 ...

A: charge density = 5 nC/m^2 at x= 2 E at origin = ?

Q: a) For the network shown in the below figure, the value of current needs to be measured in the 10002...

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

7) The circuit shown uses a 36 V mains supply.
12 C
36 Và
242
Calculate the reading in A1 and A2 when:
a) switch S is open.
switch S is closed.
b)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

he Ivanpah Solar Electric Generating System is the largest solar thermal power-tower facility in the world.It collects 1321 MW of solar thermal energy to heat special collectors to 566 °C. The thermal energy is then used to make steam tooperate an electric generator. (a) What is the maximum efficiencyof the power plant, taking the cold reservoir to be the surroundingenvironment at 12 °C.
An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at 30 deg C. Assuming 10%loss of heat from the boiler, find how long after switching on the heater circuit, will the water boil a atmospheric pressure if the two elements of the heaters are in series.
An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at 30 deg C. Assuming 10%loss of heat from the boiler, find how long after switching on the heater circuit, will the water boil a atmospheric pressure if the two elements of the heaters are in parallel
Based from the circuit above, the voltage at the armature is Blank 1 V when it supplies a load of 19.734kW.
120 volt battery is connected at the terminals with the positive terminal at point A and the negative terminal is at point B. Find the current in the resistors(I1,I2,I3,I4) if the value of R is 13 ohms
The dwelling unit has a floor area of 145 square meters. It has the typical household appliance including one 8 kW electrical range, two 1 hp room air conditioning unit, one 1.5 hp room air conditioning unit and one 1 hp water pump. find a.) Short Circuit current, b.) Voltage drop
A 25 HP motor located 400 ft from a 240V source is supplied through a copper feeder. it is desired to limit the voltage drop on the feeder to 2%. What is the resistance of the feeder cable
Which of the following is not considered when finalizing the location of substation? A)availability of space B)nearness to load center C)cost of the land D)cost of the substation
19/ The Impedance in a Circuit determines the amount of Current flowing in the Circuit for any given amount of Voltage according to Ohm's Law. Select one: True False
What is the voltage VA with the following conditions? a. SW1 = open; VA = ?b. SW1 = closed; VA =?
A uniform 2-wire d.c. distributor 63 meters long is loaded with 0.067 resistance/ meter and is fed at one end. If the maximum permissible voltage drop is not to exceed 34 V, find the current/meter.
Which of the following are used by scientist and electricians for ease of work? a. circuit diagrams b. circuit organizers c. Circuit breaker d. circuit architectures EXPLAIN ty.