7. Given that ā•b = -6,||||= 4.3 and the angle between a and 5 is 0= determine if bis a unit vector or not. 8. Given p=(5,-2.1) and = (0.4.8) compute projā. 9. Given ā= i +3j-2k and b=-31-4j+7k compute proj; b. 10. Determine the direction cosines and direction angles for 7 = (5.2₁-7).

Q: There are compressed 11.33 m3/min of air from 103.42 kPa, 26.7°C to 827.36 kPa. All clearances are…

A:

Q: Consider a Carnot refrigerator and a Carnot heat pump operating between the same two thermal energy…

A: As given in question, Coefficient of Performance (COP) of refrigerator = COPR = 3.4   COP of…

Q: Problems 1 and 2. Locate the centroid of the shaded area y r = 100 mm x 50 mm -180 mm 1. 2. 100 mm…

A:

Q: A 12' 1500 lb D 2000 lb E/ 10' 48' Figure 1-63 150 lb/ft G F 2000 lb B

A: Let us consider the given figure 1-63.tan θ=1024      θ=22.6°CA=12cos 22.6=13.6°FB=AD=ACcosθ…

Q: Consider (Figure 1). For a short period of time, the motor turns gear A with a constant angular…

A: Find the velocity of cylinder and distance travelled by the cylinder in three seconds.

Q: Given are 4 points in space: (x,y,z) A (3,2,3)   B (0,1,4)   C(2,4,1)   D(0,5,4) The line of…

A:

Q: 3. Steam at 140 bar and 400°C enters the high pressure turbine and expands to 3 bar. 5 400 kg/hr of…

A:

Q: In a steam condition of 1123 psia and 1124 °F, find the following (a) superheat (b) specific…

A: Given data:

Q: y-centroid? k 1.2 in |↔| 5 in. 5 in. 1 in. ref.

A:

Q: A manufacturing plant of 5500 square meters has 3.8 m high ceilings and changes its inside air three…

A:

Q: Shown below is the water jet flow from a pressurized closed tank. The vertical distance between free…

A: Given data:- h1 =13 m h2 = 15 m Y=9.81 kN/m^3 Find the pressure at 1.

Q: Q2/ At average temperature 333 °K and pressure 13789.5 kpa, a gas well is producing at a rate of 625…

A:

Q: (a) A uniform picture of mass 10 kg hangs vertically as shown in Fig.2. Each of the two wires…

A: Given data Mass of picture =10 kgLength of wire = 0.5 mCross-sectional area of wire = 1 mm2Young's…

Q: Section 5-3: Dot Product For problems 1-2 determine the dot product, ā.b. 1. a = 97 -8k, b =(3,-2,1)…

A: as per guideline i have to solve only three subpart of your question

Q: 3. Steam at 140 bar and 400°C enters the high pressure turbine and expands to 3 bar. 5 400 kg/hr of…

A: Given that, Pressure of steam, P1=140 bar,Temperature of steam, T1=T3=400 °C,m˙=5400 kg/hr,Pressure…

Q: Consider a conduction in a plane composite wall as shown. The outer hotter air temperature at 60 C…

A:

Q: A heat engine absorbs 20 kJ of heat from a source at 500°C and rejects 10 kJ of heat to a sink at…

A:

Q: Determine the total machining time for a workpiece 30mm in diameter and the required length is 145…

A: Given: Initial length of the material→X=149 mm Initial Diameter of the material→D=38 mm Depth of cut…

Q: Consider a 2-dimensional incompressible flow field. The vertical component of velocity for the flow…

A: We can answer up to 3 subparts so we will answer first 3. Please resubmit the question by specifying…

Q: An incompressible fluid flows between two infinite stationary parallel plates. The velocity profile…

A:

Q: Φ2 25 . 30¹ 35 5 65 25

A: According to the details provided in the question, we need to draw three views.

Q: 2 A prototype car is designed for cold weather operation in Denver (-10°C, 83 kPa, altitude 1600m, µ…

A: Given DataTP=-10°C=263KPp=83000PaμP=1.741×10-5Pas

Q: The 10-kg block shown in Fig. 14-6a rests on the smooth incline. If the spring is originally…

A:

Q: 4. Determine the force in members BD,BE, and CE of the Howe roof truss shown. State whether each…

A:

Q: Each of the four links in Figure 3 has an 8x36mm uniform rectangular cross section and each of the…

A:

Q: -5 ft- 400 lb 200 lb/ft -21₁1-1₁- -2 ft- FIG. P5.17 4 ft D 2 in.

A: Calculate the reaction at the support, RA+RC=400+200×5+2+4RA+RC=2600  ............ 1Taking moment…

Q: 1. If the ratio of vapor mass to liquid mass in a mixture is 0.85. What is the quality of the…

A: (1) The quality of the mixture can be determined as shown below. Therefore, the correct option is…

Q: The rigid bar in (Figure 1) is pinned at A and supported by two aluminum rods, each having a…

A:

Q: Table 2A Mass of the crate= 50 kg Friction = ON Applied Sum of Force, Fapp (N) Forces, Fnet (N) 100…

A: Given : 2 Tables and their respective graphs To find : 1. Based on your obtained results, discuss…

Q: Given that P = 37 N, Q = 31 N and R = 56 N. Replace the three couples shown with a single equivalent…

A: Find the magnitude and direction of single equivalent couple.

Q: a) The details of travel time and capacity of different links in a portion of a city road network is…

A: given; travel time in minute;A-B                    2A-C                    2A-D…

Q: Consider a beam with circular cross-section of diameter d. The ratio of the second moment of area…

A: For the beam with circular cross-section of diameter d, the second moment of area is given by, I = π…

Q: ACTIVITY #3 - COMBINED CONDUCTION CONVECTION ON CYLINDRICAL WALL A hot-water pipe (k = 60 W/m K) in…

A:

Q: No. 2. as shown, determine the ff: (a) maximum tensile and compressive elastic bending For the…

A:

Q: Question 8 Let z = g(x, y) = x³ + xy³ + y² - 6x - 2y + 4, where x = r cos (0) and y = r sin(0). Use…

A: Find the value of dz/dthetha.

Q: Sketch a plot that contains a lateral strain for a material undergoing a temperature change which…

A: Given : Same temperature change for 2 materials one results in elastic deformation and another…

Q: How much entropy of 5 kJ of ice will change as it melts into water at the same temperature (O°C) ?…

A:

Q: The 16 foot long hollow steel shaft experiences a maximum shear stress of 8000 psi due to the torque…

A:

Q: In the open-circuit steam plant, boiler feed water at atmospheric pressure 1 bar and 35oC is pumped…

A:

Q: Electrical Engineering 12 ksi 8 ksi + For the given plane state of stress, determine: a) the main…

A: Find the main plans and main stresses.

Q: Problem 1. Use the differential equation method (either second, third or fourth order) to find a)…

A: given; lets take reaction force at A=RAlets take reaction force at B=RB

Q: Q2. An object moves from rest in a straight path with acceleration 2 m/s² until it travels a…

A:

Q: Figure below shows a siphon that is used to draw water from a tank. The siphon tube has an inside…

A: Find the simplified bernoulli's equation for the point A and D.

Q: A closed system containing 1 kg of air at 10 bar and 227°C expand adiabatically to pressure of 1…

A: A closed system containing 1 kilogramme of air, 10 bar, and 227oC expands adiabatically to a…

Q: The disk in (Figure 1) is originally rotating at ω0 = 14 rad/s. It is subjected to a constant…

A:

Q: What are the examples of Centrifugal Fans that can be use in the industry or everyday living?

A: Examples of Centrifugal Fans that can be use in the industry or everyday living

Q: c. Find the homologous temperature (or the percent homologous) of Material A with a melting point of…

A: Given

Q: What exactly does the inability to resolve the stopping problem mean?

A: given; What exactly does the inability to resolve the stopping problem mean?

Q: The Russian army fires a ballistic missile toward the Ukrainian army with an initial value uR at an…

A:

Q: The compression ratio and the cut-off ratio of a particular diesel engine which is running on a…

A: Givenr=11rc=3k=1.32Q=12345.6kJ/kWh