8. A 30.0 mH inductor with a resistance of 422 is connected to a 12.0 V battery. Find the current after 12.5 ms?
Q: Evaluate 8/10° +62-20° 9280°-4250° O 0.50 +j2.24 O -0.50-12.24 O 50-j224 O -50-j224 and express the…
A:
Q: 13. Given the information provided in Fig. 4.81, determine: (a) Ic (b) VE. (c) VB. (d) R₁. R₁ 3.6 k…
A: BJT is a current controlled device in which base current control the mode of operation of BJT Mode…
Q: 1. A 30-ampere, 120-volt, UF cable circuit is buried outbuilding. The minimum depth of this cable is…
A: it is asked to find minimum depth of 30A,120V UF cable circuit buried from a dwelling unit to…
Q: When using the transtor as a key The question is to explain briefly how the current of the collector…
A: The above question is based on the operation of a BJT. In the active mode of operation, the…
Q: Calculate v, in the circuit 10 cos (10t+ 75°) (+) 0.5 H 10 Q2 -18 F 10+
A:
Q: Question 18 A 2 millicoulomb positive charge is located in vacuum at P₁ (3,-2,-4) and a 5…
A:
Q: For the electric network shown below: 8 Ohm ww 60 V 1.1.1.1. 5 Ohm www www 1 Ohm Ohm 4 Ohm www 4 Ohm…
A: We need to do following 1) write the loop equations 2) solve the loop equations using Cramer rule 3)…
Q: Q5. Figure Q4 How does the electrostatic force between two charges is affected when the distance…
A:
Q: Y = RV R₂ Vief We wish to have Vref = (4 ± 4%) V. We choose R₁ = (2210 ± 1%). 1. With the help of…
A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: GIVEN THE NETWORK BELOW, DERIVE THE TRANSFER FUNCTION BY FILLING ALL VALUES BELOW 10 ka 1kQ + 100 kQ…
A:
Q: Exercise 5 We consider a germanium crystal of type P, resistivity 0.01 2. cm at 27 °C. We recall…
A:
Q: What is the simple operational amplifier circuit for a constant current source? How does one set the…
A: An Ideal operational amplifier has a very high Common mode rejection ratio, Very high input…
Q: Two loads A and B are connected in parallel across a 2000 V-rms 60 Hz source with the specified…
A: Note Only active power will be available in purely R Load Only Reactive power will be available in…
Q: The phasor form of 240sin(wt +25¹) is O 240/25° O 2402-25° O 2402-115° O 240Z-65°
A: Given: The equation is 240sin(ωt+25°).
Q: load of 500 kVA operates on 1100 V, 50 Hz mains with power factor of 0.6 lagging. It is required to…
A:
Q: the absence of current A low pass filter is a circuit that performs the following function O the…
A:
Q: 7) If the analog signal has amplitudes that varies between-3 and 3 volts And maximum frequency of 10…
A: The given signal is shown below, Where,Amplitude range = -3 to +3 VMaximum frequency=10 kHzn=3 bits
Q: The diodes in Figure 1 both have Von=0.7 V. By using mesh analysis or otherwise, show that Di is…
A: We will find out which diode will be on or which diode will be off.
Q: Exercise 3 Let's consider the system with the open loop transfer function given by G(p)=- close loop…
A: given here a open loop transfer function and asked to find the closed loop transfer function.
Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalize radiation…
A: Since you have posted multiple questions we will provide the solution to the first three questions…
Q: If you have a small internet station with high 20m, its maximum rang 2000m, the station work with an…
A: A 360-degree radiation pattern produced by an Omni-directional antenna, which equally transmits and…
Q: Consider the circuit below, with C₁ = 2F, C₂ = 3F and L=3H, calculate the mesh currents 1₁ and 12.…
A:
Q: Example 4. The switch in Figure 16 is closed at t=0. Find i(t) and v(t) for all time. Note that…
A:
Q: Give the network determine the input voltage Vs.
A:
Q: 3. For the network of Fig. 8.66: (a) Calculate IB. Io and re Determine Z, and Z. (c) Calculate A,…
A: Given circuit,
Q: If you have a small internet station with high 20m, its maximum rang 2000m, the station work with an…
A: Given: Transmitter height=hT=20 m, maximum transmitter range=2000m.Maximum distance between…
Q: Given B=99 and V, = 25mV, and VBE=0.7V calculate the following The currents I,II and voltages VB,VE…
A: This question is based on BJT analysis in the active region. This is because ac parameters like gm…
Q: A LC circuit in a radio tuned to 1080 kHz has an inductor with an inductance value of 60 μH and a…
A: The given information about a LC circuit in a radio is written below. Tuned frequency is fT=1080…
Q: Compute the current through and voltage across each resistor using superposition theorem
A:
Q: A microwave link includes two sites that are 10 km apart and uses a center frequency of 9 GHz. On…
A:
Q: Determine the %r at the output. 9:1 120V 60 Hz 인포시 V2 470 UF 1k2
A:
Q: What are the types of signal degradations that may be encountered in transmission over the channel ?
A: The objective is to determine the the types of signal degradation
Q: A transformer, circuit breaker is equipped with 500/5 A CTS connected to a induction type over…
A: Given- A transformer, circuit breaker is equipped with 500/5 A CTs connected to a induction type…
Q: In the network in the below figure, find I using superposition. 6 ΚΩ 6 ΚΩ 12V 6 ΚΩ 6 mA 6ΚΩ
A: In this question we need to find the current Io by using superposition theorem.
Q: Questions Consider a Si p-n diode working at 300k at a current If = 2mA with the forward voltage…
A:
Q: 3. The phase displacement between phasors in polyphase system is always a) 90 degrees b) 120 degrees…
A: We need to select correct option for given statement .
Q: TIME BEFORE CLOSING AT too. FIND (а) U (0); (b) U(); OT; (d) Vlt) For tzo. 10k2 20mA t=o 220 ka и…
A: We need to analyse the capacitor and resistor circuit .
Q: Compute the current through and voltage across each resistor using Source Transformation or Mesh…
A: in this problem they are asked to solve using source transformation or mesh analysis. so we are…
Q: unidirectional controllers and bidirectional controller. b) Define the synchronous tap changer. C)…
A:
Q: Using a multimeter, what is VOUT Blank 1? (in Volts, up to 2 decimal places) 110 VRMS 60 Hz Sine…
A: In this question We need to determine the value of voltage of thr multimeter We know In transformer…
Q: 8. Power in a three-phase delta system with balanced load is equal to a) x VL x IL x power factor b)…
A:
Q: The figure shows two coaxial solenoids, the inner one has radius a y with n_a "loops" and the outer…
A: Given, The figure is shown below, Where,Inner radius = aNumber of inner loops =naOuter…
Q: Question A differential protection scheme is shown below 400/1 80 A fooo I, 00000 F I₂ The…
A: Given- A differential protection scheme as shown. To Find- The percentage bias.
Q: Determine the input impedance of the circuit at w 10 rad/s. Zin 2 mF 2002 www 2 H m 4 mF 50 Ω
A:
Q: 20V| Va 50Ω Vb 50Ω Vc • 25Ω + |10V
A:
Q: Part IV. Find the maximum peak-peak voltage output without clipping. Present all the results in a…
A: Given data Collector voltage, VCC=15 V Base resistance, RB=280 kΩ Current gain, β=120 Collector…
Q: Determine the ripple voltage across the load. 120 V 60 Hz 5:1 V/₂ 1N4001 +4 100 μF • 5 ΚΩ
A:
Q: 11) If the PSD of deterministic signal is given by [si]² where f is the frequency, what is the…
A: Given: The signal is sinff2.
Q: What is the total power of the circuit shown below? Enter a whole number, no decimal places, no…
A: In this question We need to determine the current in the each load. We know Power P= VI
Q: The diodes in Figure 1 both have VON=0.7 V. By using mesh analysis or otherwise, show that D, is…
A:
Step by step
Solved in 2 steps with 1 images
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCCThis circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor has a voltage drop of 740 V, and the capacitor has a voltage drop of 444 V. The circuit has an apparent power of 51.8 VA. ETITZVA51.8PFER185VIRRPEL740VILXLVARsLLEC444VICXCVARsCC
- If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfaradYou are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
- Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
- A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
