80 V a 40 2 3 A "O 20 Q 7 605 100 V 120 (2

Q: 1. Given the measurement value of VD in Figure 1, determine: 14 V a. lp b. VDS C. VGS d. VGG 1 ΜΩ…

A: Given Data: A  JFET circuit having Drain Resistance RD=1.6 kΩ Drain Input voltage VDD=14 V Drain…

Q: Q4. Using the Routh-Hurwitz criterion, verify if the system is stable? Explain why or why not? Ris)…

A:

Q: I did not understand the answer not accurate please solve it again

A: “Since you have posted a question with multiple sub parts,we will provide the solution only to the…

Q: In the circuit shown, the switch is open, and the capacitors are uncharged. At t=0, the switch S is…

A:

Q: Which of the following is the magnitude of the force acting on the dipole?

A: In this question we need to find the force acting on dipole

Q: A causal system is represented by the following difference equa y(n)= x(n)+0.5 x(n-1) 75…

A: Given: Difference equation of causal system,  y(n)=x(n)+0.5x(n-1)+0.75y(n-1)-0.125y(n-2), To find:…

Q: 2. Plastic kayaks are manufactured using a process called rotomolding. Molten plastic is injected…

A:

Q: An LTI system has an impulse response: h(t) = e¹u(t+1) This system is: Select one: Causal but not…

A:

Q: Given first order LCCDE y(n)=ay(n-1)+x(n) 1) find the transfer function. 2) find impulse response.…

A:

Q: P.6-4 In Fig. 6-10 assume a constant current i, = 1o, but that the rectangular loop moves away with…

A:

Q: 17. Solve the initial value problem using Laplace transform y" + 4y = u2 (t) sin(t-2π), y(0) = 0,…

A:

Q: Use the node-voltage method to find the steady-state expression for vo(t) in the circuit in (Figure…

A:

Q: Question 3 Calculate Vx in the circuit of Fig. 3 using the method of source transformation. 5Ω 4Ω -…

A: A voltage source in series with the resistance or reactance can be transferred into the current in…

Q: Convert the following block diagram to Signal Flow Graph and apply Mason's Rule to calculate the…

A: We need to find out transfer function by using of Mason's gain formula.

Q: onvert the following signals from the domain shown on the left to that shown on the right. Show all…

A:

Q: Q2. This question is on laboratory work and half wave rectifiers. (a) When setting up circuits and…

A: The question is based on the concept of ground in an electrical network.

Q: The cost of a single phase overhead transmission IS RS a + 1500) per km where 'a' is the area of…

A: We have an 3-phase overhead line which has, Cost of transmission line = 25000 a + 2500 Rs/km a =…

Q: 8p50) In the figure, a block slides along a track from one level to a higher level, by moving…

A: The given figure is shown below, Where,Initial speed, v0=7.7 m/s.Height, h=0.98m.Kinetic friction…

Q: Rank the systems in terms of how quickly they reach their steady-state values.

A: According to the question, for the given graph as shown below We need to rank the systems in terms…

Q: A) An energy meter whose constant is 1500 reVolutions per KWh makes, 20 reVolutions in 30 seconds.…

A: In this question we need to find the following A) Calculate the load inKW. B) meter constant and  If…

Q: A synchronous generator is connected to an infinite bus by a transmission line as shown in the…

A: Given system: Synchronous generator is synchronized with infinite bus for IF=900A   To determine:…

Q: Problem 3. Design a digital Butterworth low pass filter with that meets the specifications below…

A: For a digital Butterworth low pass filter, the following specifications are given ωc=0.12 rad/s,…

Q: A shunt motor is rotating at 1500 rpm and is powered by a 120V voltage source. The current line…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Given a PNP transistor in the figure below, determine Vc and IB -22 V

A: In the given questions we need to do the DC analysis of the given circuit and need to calculate…

Q: Sketch poles and zeros, then find the stability of the following transfer function. H(z) H(z) = =…

A: The question is based on the stability of discrete transfer functions.For stability, the poles must…

Q: A single-phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu…

A:

Q: Determine the transfer function for the system shown in Figure Q3. R(s) G₁ + H₁ H3 G₂ Figure Q3 G3…

A:

Q: Design a 2-bit multiplier with 2 2-bit inputs (X1X0 and Y1Y0) and gives out a 4-bit product…

A: According to the question, we need to design a 2-bit multiplier with 2 2-bit inputs (X1X0 and Y1Y0)…

Q: Q-1) There exists a conducting ABC triangle wire given in Figure 1. Corners of the triangle have the…

A: The above question is based on the magnetic field due to a current flowing wire of finite length.…

Q: An input signal x(t)=e-3t u(t) is applied to an LTI system with impulse response h(t) = 38(t) + e -2…

A:

Q: For R1=5000 2, R2=8000, R3-9000, R4-8000 , C1=0.008 F, C2=0.002 F & I1=0.002 A in the shown circuit,…

A:

Q: 4) A binary On-Off ASK communication system is using the below s1(t) and s2(t) signals to transmit…

A:

Q: The voltage across a 1 μF capacitor is given. What is the sinusoidal expression for the current? a.…

A: C= 1×10−6FVc1=30sin(200t)Vc2=60×10−3sin(377t)

Q: The schematic shows a balanced three-phase system. Find: to. The complete three-phase power triangle…

A:

Q: 4. In a certain conducting region, the magnetic field is given by 2 H: Ì = ô −[1 − (1 + 3r)e-³r Find…

A: Given Data: A conducting region with, A magnetic field  H→=ϕ^2r1-1+3re-3r Conductivity =σ To Find:…

Q: A solenoid has an inductance of 0.1 mH. The same solenoid has a resistance of 0.1 Ohm. At a…

A: L=0.1 mH, R= 0.1 Ohm, f=100 Hz, Reactance of Solenoid.

Q: In the given figure are pole-zero plots of transfer functions of the systems of the general form H()…

A: In this question we need to choose a correct option

Q: Example Sketch each of following signals from x(t) y(t) = x(2(t+3)) x(t) -1- 0 0 1 -3.5

A:

Q: 5) For the following circuit, use nodal analysis to find the voltage across the resistor4 2…

A: We need to find out voltage across 4 ohms resistor for given circuit.

Q: THEVENINS EQUIVALENT BETWEEN a and b .( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).

A: In this question we need to find Thevenin equivalent circuit between the terminal a-b

Q: Can you provide a written description of a scene featuring a dinosaur using a full-bridge Wheatstone…

A: Can you provide a written description of a scene featuring a dinosaur using a full-bridge Wheatstone…

Q: Determine the impulse response for the system + y(n) + 4 y(n_l) + 3y(n=2) = X(n-1).

A: In this question we need to find the impulse response of the given system

Q: An 11 kV, three-phase, star-connected alternator has a synchronous impedance of 10∟80° Ω/phase and…

A: Given data: Voltage (line voltage), Vph = 11 kV Phase impedance, Zs = 10∟80° Ω/phase Current, I =…

Q: Homework D2.2. A charge of -0.3 μC second charge of 0.5 μC is at (b) P(15, 20, 50) cm. is located at…

A:

Q: Problem 2. If the signal, x(n), shown below is bandlimited to @Max-π/10 rad, what is the maximum…

A: The above question is based on Nyquist's sampling criterion. It states that the minimum sampling…

Q: 3 Answer the following two separate parts: (a) Draw the Miller equivalent circuit for assuming No to…

A:

Q: a) This question is about discrete-time convolution. Use the Table Method to solve this question.…

A:

Q: d. Determine A, (with r = ∞). e. Repeat parts (c) and (d) including ro = 50 kn in all calculations…

A:

Q: WΞΩΤ Problem 2. If the signal, x(n), shown below is band limited to @Max=π/10 rad, what is the…

A: Given w_max = π/10 rad X(w) bounded to [-π  to π] Decimation factor = M

Q: A 4 pole 3-4 induction motor develops maximum torque at 1500 rpm when operated from a 60 Hz supply.…

A: A 4 pole 3-ϕ induction motor- Maximum torque=1500 rpm, Frequency f=60 Hz, Rotor resistance per phase…

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.