Answered: 9. Determine the voltage at capacitor,…

9. Determine the voltage at capacitor, current through inductor and the energy storage in C and L under DC condition. (3A, 6V, 72J, 27J) 0.25H

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: 1. A 741 op amp has an open-loop voltage gain of 2x105, input resistance of 2 MN, and output…

Q: The switch in the following circuit is closed at t= 0. Find v(t) and i(t) at any time. Note that…

Q: Q.The electric current flowing in a resistor is given by I = 20 sin(100t) where I is in Amperes and…

Q: A 460-V, 25-hp, 60-Hz, four pole, Y-connected induction motor has the following impedances in ohms…

Q: Within the cylinder ρ = 2, 0 < z < 1, the potential is given by V = 100+50ρ+150ρsin ϕ V. Find V, E,…

Q: (a) Figure Q1 (a) shows a 85 turn's coil of wire wrapped around an iron core. If the flux in the…

Q: 15 (2 25 0 12 v 15 V 18 V후 12 20Ω 30 0 10 0 30 0 50 0 13 E 14 V 80 8 V 15 0

A: Given:

Q: Q1) for the signal that is shown in the figure below A) plot the amplitude spectrum X(t) 1 1 B)…

A: It is given that:

Q: Create a circuit diagram for the given armature: (4 poles, 26 conductors, double layer, simplex…

A: 4 poles26 conductors-double layer-simplex wave winding

Q: What is the maximum value of a sine wave AC voltage which will produce heat in a resistor at the…

Q: Enter the following data patterns and record the outputs. Input Switches D. 14 +5V 7495 B • 2 4 Bit…

A: The Parallel-In Parallel-Out shift register is a type of data storage device. This is commonly…

Q: The phase lag for the transfer function 2/(s+2) for w = 2 is ______degrees. Final answer in whole…

A: The solution is given below

Q: Determine the critical frequencies of an RC circuit 0.1 µF 1.0 k.

A: The solution is given below

Q: 3 A complex low-pass signal has a bandwidth of 500 kHz. Identify the minimum sampling rate for this…

A: Given, Bandwidth of a complex low pass signal is fm = 500 KHz

Q: The current in a load impedance of Z = 15215° Q is I = 2440° A. Calculate the voltage drop over the…

A: Given, Current in al load, I=2∠40° A Load impedance, Z=15∠15° Ω

Q: 9) In the circuit in below, find i, for t > 0. Let R1 = R2 = 1 k2, R3 = 2 k2, and C = 0.25 mF.…

Q: 2 Determine the Torque and a no-load speed of a DC shunt motor has full load rating of 11 kW, 220…

Q: Determine the lower cutoff frequency of this network.

A: Small-signal modeling of the amplifier will be Cutoff frequency due to…

Q: PIC16F877A microcontroller has--- * .kinds of interrupts 15 14 18 16 O O

Q: Find the current l in the circuit shown in Figure 1 by applying Thevenin's theorem. 100 202 100 24P

A: The solution is given below

Q: Consider a bandpass filter to be implemented by a series RLC circuit where the lower (fc1) and upper…

A: Consider a bandpass filter to be implemented by a series RLC circuit where the lower (fc1) and upper…

Q: Q2)) Find the equivalent resistance between A & B in the given network. A 42 42 B.

A: Given circuit,

Q: which type of power electronic conventor for ac drive has the greatest influence on the power grid…

A: Among the four options, the combination of the AC drive which has high influence on the power grid…

Q: Q.2. Four- Terminal RLC-Network : Sct) Find output voltage Vit) R= 20, L= 1, C = l04 Input voltage s…

A: We need to find voltage across capacitor in series RLC circuit .

Q: f(t) 12 c) 2.

Q: In the full-wave rectifier circuit of figure, the transformer has a turns ratio of 1:2 The…

A: In this question, We need to choose the correct options What is peak to peak ripple voltage?

Q: Given the value of E at a given point P(p=2, 6=40°, 2=5) is given as dn equa tion E= 100 ap -2006 +…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Problem 3 - A 500-kV, 300-km, 60-Hz three-phase overhead transmission line, assumed to be lossless,…

Q: Question a. A differential amplifier can be used to reduce interference by canceling out similar…

A: The solution is given below

Q: 3) Find the Thevenin equivalent circuit looking into terminals a-b in the circuit below.

A: The thevenin's equivalent circuit can be calculated by using the nodal analysis method. The…

Q: )) Find the equivalent resistance between A & B in the given network. A 82 B

Q: -1, 1, 0, 1<n<4 SInl, 0, -3 < n< 3 x (п) y(n) -4 <n< -1 — elsewhere elsewhere

Q: Q4. By using Karnaugh map, reduce the combinational logic circuit in Figure 1 to a minimum form. А в…

A: By using karnaugh map method, reduce the following given logic circuit diagram to a minimum form.…

Q: 5. How much electrical energy is transferred to thermal energy in 2.50 hrs by an electrical…

A: Electrical energy transmitted to thermal energy is calculated from the given formula: E= (V^2/R)*t…

Q: If the applied ac power to a system is 5 microW at 100 mV and the output power is 48 W, determine…

A: The solution is given below

Q: 5. The switch in the circuit has been closed for a long time, and is opened at -0. Find v(t) for t2…

Q: 50Ω resistor, a 20mH coil and a 5uF capacitor are all connected in parallel across a 50V, 100Hz…

Q: If we have a D'Arsonval movement with 100 Q internal resistance and 100 mA FSD current. This…

Q: (b) Consider the magnetic circuit shown in Figure Q1 (c). The circuit parameters are shown in the…

Q: What is the difference between cascode and cascade configuration

A: In this question we will write the difference between cascode and cascade configuration...

Q: Q1)) Determine voltage across R2 and R4 using voltage division rule. Assume that: Vj= 220V, R=1002,…

Q: Q2) Non – sinusoidal voltage applied on 102 resistance with consumed power 521.25 watts and the…

Q: How do you know this is a direct coupled 2-stage voltage amplifier?

A: We need to find out coupling of given amplifier .

Q: Consider a bandpass filter to be implemented by a series RLC circuit where the lower (fc1) and upper…

A: Consider a bandpass filter to be implemented by a series RLC circuit where the lower (fc1) and upper…

Q: Find the individual currents using the following methods. Show your complete solution. Mesh…

A: P

Q: A sequential circuit with 2 D flip-flops, A and B; 2 inputs, x and y; and 1 output, z, is specified…

Q: Determine the current x in the 4-2 resistance of the circuit shown in the figure. 2 6A 10 10 V T 1 3…

A: In this question, We need to determine the current in the 4 ohm resistance? We are solving this…

Q: signal transmission line which has a source impedance of 75Ω is to be connected to a signal strength…

Q: Find F(1). sin (2t) + cos (2t). use 2 decimal places. Answer: 0.33

Q: Q1 a) For the following system: s+ 4 (s + 2)(s + 4) i) What are the poles and zeros of this system…

A: We need to find out pole and zeros of given transfer function and state transition matrix for given…

Question

9. Determine the voltage at capacitor, current through inductor and the energy storage in C and L under
DC condition. (3A, 6V, 72J, 27J)
0.25H
30
4A
2F

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Q1 (True/False): A) The current through the capacitor is inversely proportional to the derivative of the voltage across it: Is it true or false? B) In a typical electronic circuit the capacitor blocks DC and couplest he AC to the next stage of the circuit: Is it true or false? C) The more the value of the stray capacitance , the better it is: Is it true or false?
Find the equivalent capacitance of given circuit between the point A and B) if the applied voltage across A-B, equal =5 VRMS , 1000 Hz. Note: Take the capacitance of each capacitor as C=680µF)
What is your understanding about inductors and capacitors? References: https://www.youtube.com/watch?v=vZXT4A7lmhE
a. find the total capacitance of the circuitb. tind the charge (Q) acting on the circuit
8. A pure inductor has a reactance value of 675 Ω. If this inductor is supplied with a frequency of 60 Hz and the induced e.m.f. of 45 V, find the rate of change of current. Rate of change of current =
The unit of capacitance is in Farad (F). One farad is equal to one coulomb per volt. If the capacitor is rated 10pF and is connected to an 8V dc battery, how much energy can it store? Enter in your answer in two decimal places and in pJ.
Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages across the resistor and inductor for 10 kHz and 60 kHz. Show the step-by-step computation. Express the voltages in polar form.
a. State the peak, angular frequency, ω, and phase values for voltage source, VS b. Express the voltage source, VS , as a phasor c. Calculate the reactance, XL1 , of the inductor, L1
The given circuit has Vth=30V and Rth=30K Ohms. If the inductor will be short circuit and the switch will be closed, what will be the current i (in mA)?