Answered: 9. The instantaneous values of two…

9. The instantaneous values of two alternating voltages are given as: v1=60sine and v2=40sin(0 - T/3). Find the instantaneous difference.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.24P: A source supplies power to the following three loads connected in parallel: (1) a lighting load...

See similar textbooks

Related questions

Q: For an n-channel JFET, IDss=3 mA, VGs(om)=-6V. Determine the forward transconductance for VGs=-4V.

Q: Follow up questions.. (b) Pick a pair of values for parameters α and β such that the closed-loop…

Q: Find the resistance in k between nodes A and B (RAB) in the following circuit. Given: R₁ = 4,7 ΚΩ R₂…

Q: Electrical equipment in an office takes a current of 13A from a 240V supply. Estimate the cost per…

Q: J-KL (K+LM) + (M+LM)

A: Given here a expression and asked to reduce the expression and drawing the circuit.

Q: Verify that the closed-loop transfer function T(s) = C(s)/R(s) in terms of parameters a and pressed…

A: Given that: The block diagram is shown below. A continuous time, linear, time-invariant feedback…

Q: Q2.) A CRT has deflecting plats of 4mm longs, and 2000μm a part. The screen is 500mm away from the…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 14 A circuit of resistance 402 dissipates a power of 16W. Calculate (a) the current flowing through…

Q: Given shows the mutual characteristic for a junction gate field effect transistor. When the…

A: We need to find out the drain current and conductance from given graph .

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

Q: Prove the following relationship mathematically between the steps of the solution in detail: N=N₁…

A: Given: Proof of N=NCexp-Eg2kT.

Q: A GaAs laser operating at 800nm has a 500-μm length and a refractive index n=3.7. what are the…

A: SOLUTION GIVEN--> Wavelength of LASER λ…

Q: x(t)e-12nft dt X (f) = Find the Fourier transform of x(t) = 2 sin (5 πf, t)

A: Here the properties of fourier transform are used to solve it.

Q: Attenuation, distortion, and noise contribute to transmission impairment. What is the solution, or…

A: Attenuation:- The loss of signal power in networking cables or connections is known as attenuation.…

Q: The impulse function is denoted by: оооо Oh(t) u(t) or 8(t) O 8(t) Ou(t)

A: Given here a question and asked to find the correct option.

Q: 2. Using nodal analysis, find V₁, V₂ and V3 2 SA 5A(1 V₁ € 452² 92 32 V2 62 W 422 V3 &82 (±) 12V

Q: Find the Laplace transform of 6 sin 3t − 4 cos 5t.

Q: In the circuit shown, a 5 V Zener diode is used to regulate the voltage across load R.. The input is…

A: Solution !!

Q: Measure the voltage across each resistor, and record your readings in Table 1.

A: Given

Q: A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is…

A: Given a transmission line has, Reactance, X=1 pu. Sending end voltage, Vs=1 pu. Receiving end…

Q: Determine the total resistance at points a and b of the circuit shown below. a www 6Ω ww 3Ω www 292…

Q: -Find the Fourier transform of x(t) = 2 sin (5 πfet) Plot the signal of x(t) in the time domain and…

Q: 4. If the total current is equal to 10A, find the total voltage. VT 1032 M M 52 M 150 2022 4032

A: We need to find out the total resistance and total voltage for given circuit ,. We will find out the…

Q: The Laplace's equation in Cartesian coordinate is equal to (a^2 V)/(x^2)+(3^2 V)/(y^2)+(3^2 V)/(dz^2…

A: We need to tell about Laplace equation , whether the given statement is true or false

Q: The magnetic field intensity outside the ? coaxial cable is H = 00 H = NV/DO H = 1p/2 pi a^20 H =…

A: Given The magnetic field intensity outside the coaxial cable is.....

Q: The Fourier transform of a continuous-time function x(/) is X () = -Find the Fourier transform of…

Q: how many stable states does a latch has?

A: In this question we will write about Latch... Note :- as per our guidelines , I will answer first…

Q: The Fourier transform of a continuous-time function x(t) is X (f) = Find the Fourier transform of…

A: Given: xt=2sin5πfct and fc=4 kHz. Required: Fourier transform of xt=2sin5πfct and fc=4 kHz.

Q: it is a logic circuit that is known for being time

A: In this question we will write about logic circuit which are time independent.... Note :-as per…

Q: Hand calculate the phasor voltage for VR1 and Vc₁ using the 50 2 source resistance. Compare the hand…

A: Given RC series circuit Source voltage Vs=Vin =2.5 V at f =500 Hz R =390 Ω C =1 μF Internal…

Q: x(t) = e-3tu(t)

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

Q: Attenuation, distortion, and noise contribute to transmission impairment. What is the solution, or…

A: Attenuation Attenuation is the broad term for any reduction in a signal's intensity. Any signal,…

Q: 100V 322 2Vx + + Ux_ W 452 W 82 W 105 9 + 15V

A: Given here a circuit and asked to find voltages.

Q: 3. Determine Vx. 60V/ 25. M 400 1252 M +V+- 24.0 ში. :240 =240 ÚJA

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: Given: Required: Base current at VBE=0.65 Volts, Static resistance, dynamic resistance.

Q: 1. Find the values of I1, I2, V₁ and V₂. 12/0° V + 3 Ω + V₁ 1:4 Ideal + W 4Ω V₂ -j10 Ω 24/0° V +

Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…

A: We need to find out power as energy and cost of energy for given current and time and resistance .

Q: Consider the three circuits (a)-(c) below. Vo (a) R SWI Voutr Vec (b) R SW2 Vout2 Vec H (e) SW3 R…

A: Given: Three switch circuits. To do: For each circuit, we have to draw a truth table that relates…

Q: 3. Determine ₁ and ₂ using current division. 20A (1 10n³ an tilin four plait 200 1522

A: Given: A network with a current source of 20 A and some parallel combination of resistances To do:…

Q: Compare the sum of the current passing through R1, R2 and R3 with the total current. What have you…

A: Given- Source voltage = 12 V To find- Current through R1, R2 and R3 and total current= ?

Q: Using current divider for the below circuit 5 mA R₁ 14 2 ΚΩ 0₁ R₂ 13 ΚΩ

A: Given data, Circuit diagram is given as,

Q: Calculate the noise current for a diode W/a bias current of 5mA observed over 75Khz bandwidth. also…

A: According to the question, we need to calculate the noise current for a diode with a bias current of…

Q: Electrical equipment in an office takes a current of 13A from a 240V supply. Estimate the cost per…

A: Given: Current, I=13A Supply voltage, V=240V Time for equipment use, t=30 hrs Cost, A=13.56p/kWh

Q: 1. The total inductance for this circuit is mh. 4h 2h 3h 1h

A: Given data, L1=4HL2=2HL3=3HL4=1H

Q: The Insulator has a very small energy gap ? True O False O

Q: 5A V3 O a. 5v1 Ob. 201 www O c. 5v₁ - 492 202 w www Pi V2 2v3 = -2 5v₂ + 2V3 ww = V2 - 2v3 = 4 Od.…

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: Capacitance, C=10 μF. Loss angle, δ=10°. Frequency, f = 50 Hz.

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38. The…

A: We need to find out unknown value of k .we will use final value theorem to find out value of k .

Q: Q2: Answer the following 1- Find the final expression of the output F for the following circuit. 2-…

Question

Difference

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
In an alternating current circuit, the voltage is given by v = (4sinωt) and the current is given by i = 20sin (ωt – π/6). Using compound angle identities, find an expression for the instantaneous power, p, at time, t, given that p = vi. Give your answer as a sum or difference of two sines or cosines.
Electrical load that draws current whose impedance varies throughout the cycle of the input ac voltage waveform is known as nonlinear load. True False
An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a sine wave voltage of 100sin(10t). Calculate the total impedance, total current, voltage drop of the resistor, inductor and capacitor. also the plot phasor of the current and voltages
Alternating Current In Europe, the voltage of the alternating current coming through an electrical outlet can be modeled by the function V = -30 sin (100pt), where t is mea-sured in seconds and V in volts. What is the frequency of the voltage?
An alternating voltage is given by e= 200 sin 2π 50t . Then find the time taken to + 60 V for the first time after zero and the instantaneous value of emf at 12 ms.
The voltage applied to a coil having R-2002 ohm, L-638 mH is represented by e=20 sin 100 ? t. Find a corresponding expression for the current and calculate the average value of the power taken by the coil.
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS
The values of the elements for the given circuit are given below.What is the maximum average power that can be transferred to the ZL load?R1 = 400 OhmsL = 500j OhmsR2 = 100 Ohms
Understand ac power concepts, their relationships to one another, and how to calculate them in a circuit The periodic triangular current shown , has a peak value of 180 mA. Find the average power that this current delivers to a 5 kΩ resistor.
Suppose for designing a diesel engine power plant you have brought a diesel engine & an 8 pole Alternator which have flux per pole of 0.045Wb. Turn per phases of the alternator is 150. The engine is so run that the speed of the engine which is coupled to the Alternator is 750 rpm. Determine the frequency and value of induced voltage/phase.
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by π/3 radians and the total line current is 23.4 amp. (rms), determine the current in B.