capacitor is preferred in the high voltage and i h frequency circuits.A4(a) mica(b) plastic(с) рарer( 1) air

OPTION A i.e Mica is correct Mica capacitor is preferred in high voltage and high-frequency…

Answered: _capacitor is preferred in the high…

Engineering

Electrical Engineering

_capacitor is preferred in the high voltage and i, h frequency circuits. (a) mica (b) plastic (с) рарer (1) air

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 34RQ: Which of the following is the capacitance of an 88-microfarad and a 108-microfarad starting...

See similar textbooks

Related questions

Q: Low-frequency communication signals are coupled with the electrical wiring originally A5 True/False…

A: The solution is given below

Q: In a Transistorised Hartley oscillator, the two inductances are 2 mH and 20 mH while the frequency…

A: Given the value of the inductance is 2 mH and 20 mH. Consider the value of frequency is 930 kHz and…

Q: Half split techniques involves visual inspection

A: Half split technique is a technique which is used for isolating the source of an issue…

Q: Passive filters need external power supply while active filters do not need external power supply.…

A: Passive filter uses passive components like resistor, capacitor and inductor to generate a signal of…

Q: A superheterodyne receiver has an IF of 455 kHz,

A: Frequency modulation-When modulation is done by taking frequency of information signal modulated and…

Q: 7) The following readings are obtained in the measurement of an inductor: 1.003,0.998, 1.001, 0.991,…

Q: The total reactance of the transmission system is reduced by installing a series capacitor. Select…

A: The total reactance of the transmission system which method is reduced total Reactance This…

Q: In a transistorized Hartley oscillator, the two inductances are 8 mH and 47 uH while the frequency…

A: For Hartley oscillator, we can find capacitor with the help of expression of resonant frequency.

Q: The radial distribution system is the simplest distribution circuit and has the lowest initial cost.…

A: A radial system is a system or radial distribution system This type distribution system…

Q: 5) In liquid insulation, the volume of the bubble remains constant during elongation: a. True. b.…

A: 5) The elongation of the bubble takes place either in presence of electrostatic force or the due to…

Q: Find the time frequency expression for the voltage across the capacitor in the circuit shown in…

A: To solve this question we redraw the given circuit in phasor domain.

Q: The series capacitors reactive compensation methods are attractive for decreasing the power…

A: Choose the correct option Whether the given statement is true or false?

Q: نقطة واحدة If A = ax + 3az and B = 5ax + 2ay - 6az, find the angle * between A & B 120.65 O 123.65…

Q: A TRF receiver is to be designed with a single tuned circuit using a 10 µH inductor. Calculate the…

Q: In a transistorised Hartley oscillator, the two inductances are 2 mH and 20 µH while the frequency…

A: We have an transistorized hartley oscillator with, Inductance (L1) = 2 mH = 2 * 10-3 H Inductance…

Q: If the Distance relay is connected through 400/1 CT, and 132kV/110 VT, the magnitude primary…

Q: Static Var compensators vary the real power output by controlling the reactive impedance. Select…

A: Static VAR compensators vary the real power output by controlling the reactive power

Q: An impedance coil having a resistance and inductance of 2 ohms and 1.5 mH, respectively, is…

A: In series RLC circuit at resonance XL = XC

Q: For the circuit shown below, determine the voltage of the-j10 n capacitive reactance. ILOA1 0.5-90…

A: We reduce the circuit as much as possible by using source conversion the we find the

Q: Homework 8 (1) A two-level VSC with the switching frequency 6kHz, the AC line frequency is 60Hz,…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: Ax = 2 N, Ay = -8 N , Az = 5 N Find: a) 4 ; b) A, ; and c) Au

Q: ) A short transmission line has a sending end voltage of VS and a receiving end voltage of VR. If…

Q: At high frequencies, the value of the propagation constant (y) is approximately :* y = (R + jw L ) (…

A: At High frequency, the value of w = 2πf will be very high as compared to R and G .

Q: A boost converter has the following parameters: L = 1.8 mH, V in = 50 V, V o = 120 V, R = 20 N, C =…

A: VoVin = 11-α [ αis the firing angle] ⇒12050 = 11-α ⇒α = 0.58 Io is the current flowing through…

Q: Select an answer 8. In a digital FM receiver, the heart of FM demodulation is performed by the block…

Q: The solar panels use the full solar wavelength to produce electrical supply True False 00

A: Solar cells works on a phenomenon called the photovoltaic effect. when a particular wavelength light…

Q: For the following mixer circuit, let the input signal be (V; = Vsinw,t). The output voltage can be…

A: According to question: a) The Fourier coefficients are calculated as…

Q: Determine the reactance of a coil of capacitor 0.5 F when it is connected to a 12 KHz supply. O a.…

Q: If a ramp signal is applied to a type - 2 system, the value of steady state error is infinity.…

A: for a type-2 system, if Ramp signal is applied, then steady state error constant is given Kv=…

Q: Test time left: 01:29:35 Determine for the parallel network shown in Fig. 2 the values of inductance…

A: Circuit is given as :

Q: x(t) h(t) → y(t) A pure sinusoidal signal is applied to a system. The resulting output signal is…

A: Given Input as pure sinusoidal signal,we need to find the THD factor . Please find the below…

Q: It refers to the mixing of frequencies in a nonlinear device or the use of nonlinear mixing to…

A: In this question we will write about heterodyne....

Q: The input current in a matched transmission line is 75 mA while the load current is 3 mA. The line…

Q: A coil having an inductance of 50 mH and resistance 10 ohms connected in series with a 25 microfarad…

A: At resonance imaginary part of impedance is zero I.e, XL=Xc. Current at resonance…

Q: wel 75 mH 72Mf 2572 Crez 5218V 50 Hz

A: According to the question we have to find the value of Crez.

Q: The received power and noise power measured at a receiver is 0.5 mW and 150 nW, respectively.…

Q: y how to covert impedance

Q: A coil with R=5.2 Ohms and L=36.3 mH, is in parallel with a 2.91 mF capacitance. Calculate the im…

Q: The self admittance is the sum of all admittances connected between the buses. Select one: O True O…

A: The self admittance is the sum of all admittance connected between the buses.

Q: tal Laser Based Interferometers are used to measure air velocity and pressure. O a. False O b. True

A: According to our expert policy only one individual question is to be answered kindly repost the…

Q: becomes to analyze electronics circuits. a. Not all the time b. True c. False d. In some cases only…

A: There are few questions related to the basic understanding of microwave amplifier and it's basic…

Q: A coil of 15 Q resistance and 0.3 H inductance is connected in parallel with a variable capacitor…

A: At resonance, capacitor reactance = inductive reactance from this we will calculate capacitance…

Q: The gain margin of the system will be Img for the polar plot give below. -0.1 Real ) = 0

Q: Line code MANCHESTER 1.5 1 0.5 |-0.5 -1 |-1.5 2 4 8 10

A: Find the binary data for the given Manchester waveform ?

Q: Calculate Theoretical Impedance by formula Z

A: Determine the Theoretical Impedance by formula Z Impedance Z= √(R2 +(XL -Xc)2

Q: Hz Ga Cイ R Ha Hz

Q: he maximum frequency deviation for the FM signal v(t) = 10cos(6000πt+5sin(2200πt)) is ____ kHz.

Q: an independence coil having resistance and inductance 2 ohms and 1.5 millihenries respectively…

Q: If y[n] is the accumulation of the signal given bellow, y[5]= -4 20 Select one: О а. 0.5 О b. 1 O d.…

A: In this question we need to find a value of y(5)

Q: Q1 Calculate the oscillator frequency for an FET Hartley oscillator for the circuit values:C =250…

Question

capacitor is preferred in the high voltage and i h frequency circuits.
A4
(a) mica
(b) plastic
(с) рарer
( 1) air

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Assume the circuit shown in Figure 17-2 has an apparent power of 144 VA and a true power of 115.2 W. The inductor has an inductance of 0.15915 H, and the frequency is 60 Hz. ETITZVA144PFERIRRP115.2WELILXLVARsLL0.15915H
At 8.543 kHz, the reactance of a circuit capacitor is 9.0 uF. what is the value of inductor? i) 0.0000016 mH ii) 0.000039 uH iii) 0.0000039 mH iv) 0.0000016 H
16. Aresistor of 5.0 © an inductor of 22.0 jiH and a capacitor of 150 pF are in parallel. The frequency is 1.00 MHz. What is the complex impedance, R+ jX? = A510-/49, * B.510+/49. - C.462-ji40. = D.462+/149.
A 3µF capacitor is connected to a supply of 1 kHz and a current of 2.83∠90◦ A flows. Determine the value of the supply p.d.
If A 20-µF capacitor is connected in parallel with a 1.2-mH coil to form a tank circuit, what would be the resonant frequency of the tank circuit? 324.87 Hz 10.27 kHz 1027.34 Hz 32.49 mHz
Computed value of r:R = 8.449
Determine the total impedance as the frequency approaches 1) infinity 2)zero 3) 159.15 Hz (resonant, impedance turns into a real value) When does LC act as an open and short circuit
A 20 μF capacitor is in parallel with a coil with resistance of 7 Ω and inductance of 1 mH. Find the resonant frequency of the parallel circuit.
The oscilloscope has an input capacitance of 50 pF and a resistance of 2 MΩ and the voltage divider ratio (k) of 10. What are the parameters of a high-impedance probe?(a) C1 = 5.55 pF and R1 = 9 MΩ.(b) C1 = 5.55 pF and R1 = 18 MΩ(c)C1 = 3.33 pF and R1 = 9 MΩ(d) C1 = 1.11 pF and R1 = 18 MΩ
Without the bypass capacitor CE find Zi, Zb, Zo
An impedance coil having resistance 28.8 Ohm and inductance 0.024H is connected in series with a 0.008micro farad capacitance. Calculate :i. Q of the circuitii. Bandwidthiii. Resonant frequencyiv. Half power frequencies
Define how to calculate the angle theta (Power Angle).