Answered: A 100 kN block is on a plane inclined…

A 100 kN block is on a plane inclined at an angle of 30° with the horizontal. Find the parallel component of the weight of the block with the plane. .

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.71P: The tensions in the cable at points O and B are TO=1200N and TB=1800N. Determine the weight W of the...

See similar textbooks

Related questions

Q: A jet propelled airplane in a steady flight has a forces acting as shown in the figure. Find the…

A: Given data: Moment=3000 lb.ft Need to determine the lift force.

Q: Q3. Determine the force with the drawing free body diagram and also for each dimensions as shown in…

A: Free body diagram A free body diagram is defined as the diagram in which the action and reaction of…

Q: Find the compression length of a spring if a 100 pound weight if dropped from 8 ft onto a spring…

Q: A force of 460 N is exerted on level AB as shown. The end B is connected to a piston which fits into…

A: A piston is a gas-tight moving disc contained in a cylinder by piston rings. Pistons are an…

Q: 1. A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight…

A: Diameter of ram, D1=30cm⇒0.3m Diameter of plunger, D2=4.5cm⇒0.045m Force applied at plunger, F2=500N…

Q: The quarter circle gate BC in Fig. is hinged at C.Find the horizontal force P required to hold the…

A: Let's consider the gate has unit length. The data given is Radius of the gate, r = 2 m width of…

Q: Find the internal forces as a function of θ.

A: As the load acting in downward direction take the sign convention of the downward force as negative…

Q: QI:For the force system as shown in figures below ,Find the magnitude of the equivalent concentrated…

Q: Find the work done if a force of 2 N displace crate of box by 2 m

A: Given data : Force=F Displacement=d To find : Work done

Q: 3. The top of the circular table shown to the-bide is 1.2 meters in diameter and weighs 26 kg. If a…

A: Calculated wide the base so that the table not to flip over.

Q: the surface. Find the weight of scrap iron that should be inside the buoy in order that the force on…

Q: A storage vat has vertical ends 3.6 m apart, of which one end is shown below. Oil (s=0.84) is stored…

Q: In the given picture, the weight of the bar AC is 300lb and the weight of the bar DB is 200lb(the…

A: Given data Weight of the bar AC is 300lb Weight of the bar DB is 200lb To determine the normal…

Q: When a car is parked in a parking space, the value of resultant force acting on the car is

A: Answer This statement is (FALSE)

Q: Consider a rectangular plate of mass 7 kg. Calculate I. Assume a = 3.7 m, and b = 1.3 m. %3!

A: Product of Inertia Ixy =∫dIxy = ∫Ax y dAx = centroidal X coordinate of elementy = centroidal Y…

Q: a) Draw the hydrostatic pressure distribution on the gate, b) calculate the resultant force acting…

Q: If the gravity is 9.65 m/s² , find the weight in Ibf of a 3 Ibm object placed in that location.

Q: A block weighing 500N rest on a ramp inclined at 25° with the horizontal. Determine the force…

A: Given: To determine the force tending to move the block down the ramp.

Q: (a) The wooden rod AB supports the roof ADC. If the mass of roof is 70 Kg and its weight acting at…

Q: 1) The centroid of the submerged plane surface and the center of pressure are at the same location.…

A: 1. The centroid of the submerged plane surface is located above the center of pressure. The center…

Q: Find the work done if force of 2 N displace the object by 1.8 m

Q: Neglecting the atmospheric pressure, compute its center of pressure position X. m. The center of…

Q: Resolve the forces shown in the Figure below to two components Fx and Fy

A: The expression for the angle made by force F2 with the horizontal can be written as below,…

Q: face of a dam adjacent to the water has the shape of an isosceles trapezoid of altitude 20 m, upper…

Q: Q2) for the given gate find the force and it center of pressure, If H=2 m and K=3 m. an em

A: Given - Diameter of gate d=90 cm Disc is below the free surface of water at distance of H=2 m…

Q: In a forklift,cylinder has a bore area of 377 mm² and pressure 389 N/mm2. Calculate the mass weighed…

A: Bore area (A) = 377 mm2 Pressure (P) = 389 N/mm2

Q: 2- A tank containing water is shown in Fig. Calculate the total resultant force acting on side ABCD…

A: Given Data Width of the plane surface is: w=20 ft Depth of the water on the plane surface is: d=6…

Q: 4 3 ft 3 (1 -2 ft 2 ft 300 lb

A: So there is a truss given in the question with knife-edge support at end 3 and roller support at end…

Q: The input piston and output plunger of a hydraulic car lift are at the same level, as shown in the…

Q: A 100 kN block slides down a plane inclined at an angle of 30° with the horizontal. Neglecting…

A: Given data as per question Mass of the block =100 kg Inclination angle =300

Q: 4. Find the total force on a dam shaped like an upside down triangle with base 20 ft and depth 30 ft…

Q: A ladder 12 m long leans against a vertical frictionless wall with its lower end 3 m from the wall.…

A: W = 40 N L = 12 m

Q: Determine the following for the 2m diameter cylinder shown weighing 60KN and 3m long: d.) total…

Q: How do you solve for the resultant forces?

A: The component of forces in x-direction, Fx=20cos70+50cos20=53.825 lbs The component of forces in…

Q: Find the weight of a person of mass 75 kg when he in airplane of a height of 5000 meters . use…

A: Given that, Mass of the person, m=75 kg,Height of the airplane, h=5000 m, Consider, Mass of earth,…

Q: A cylinder suspended by a rope rests against an inclined surface as shown. If the cylinder weighs…

Q: Given: P, = 200 lb, P2= 500 lb Find: The forces in each member of the truss. P2 4 ft 3 ft 4 ft

A: The free body diagram of the truss is as follows: The moment about point A is as follows:…

Q: Find the magnitude of force if a body of 12 kg is accelerated by 5 m/s2 due to that force.

A: Given, Mass of the body = m = 12 kg Acceleration induced by the force = a = 5 m/s2 As per Newton's…

Q: If the object below has a uniform mass distribution,a=2m,b=4m and c= 8m,find the center of gravity…

A: The free-body diagram of the structure is given as,

Q: to hold the loaded wheelbarrow, our force applied to the handle is ___ the load weight 1. equal to…

Q: Q4. A 50 cm steel rod (cylinder) used for reinforced concrete has a radius of 0.46 cm and it has a…

Q: 11. Find the force exerted on one side of the annular disk shown in Fig. and also locate the center…

A: Given data as per question Distance between free surface of water and center of plate =3m The outer…

Q: Resolve the horizontal 600-lb force in Fig. 2-12a into components acting along the u and v axes and…

A: F = 600 lb find the component of force on u and v

Q: Two spheres, each 1.20 m in diameter, weighs 4kN and 12kN respectively. They are connected with a…

A: Diameter of sphere, d = 1.2 m Weight of first sphere, W1 = 4kN Weight of second sphere, W2= 12 kN

Q: Calculate the mass of a body that weight 600lb of the surface of the earth

A: Given Data The weight of the body is: W=600 lb When the weight of any object or the body is…

Q: Find the maqnitude omt difection of the resultant forces? عره لعدم too

Q: Three cable tensions T1, T2, and T3 act at the top of the flagpole. Given that the resultant force…

Question

A 100 kN block is on a plane inclined at an angle of 30° with the
horizontal. Find the parallel component of the weight of the block with the plane. .

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the magnitude of the pin reaction at B caused by the weight W=80lb. Neglect the weights of the members.
The inside surface of each thin shell carries a uniform normal pressure of intensity p0. Compute R, the magnitude of the resultant force for each case.
Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.
If PCD=6000lb and PGD=1000lb (both compression), find P and Q.
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
The tensions in the cable at points O and B are TO=1200N and TB=1800N. Determine the weight W of the cable.
The plane region A is submerged in a ï¬‚uid of weight density . The resultant force of the ï¬‚uid pressure on the region is R acting at the point C (called the pressure center) located at the distance h below the surface of the ï¬‚uid. Show that R=Qa and h=Ia/Qa, where Qa and Ia are the first and second moments of A about the axis a-a.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
The parametric equations of the plane curve known as a cycloid are x=a(sin) and y=a(1cos). Use integration to find the coordinates of the centroid of the cycloid obtained by varying from 0 to 2 rad.
Determine the horizontal force P that would keep the uniform 12-kg rectangular plate in the position shown.
Determine the force F required to pull up the 3.54m stopper from the drain of a sink if the depth of water is 10 in. Use =0.036lb/in.3 for water and neglect the weight of the chain.