A 100N load is supported by a strong bar. The tension in the cable is 200N. The value of the axial force in the strong bar in N Computer the angle A in degrees Compute the value of angle B if it is twice the value of angle A in degrees

A 100N load is supported by a strong bar. The tension in the cable is 200N. The value of the axial force in the strong bar in N Computer the angle A in degrees Compute the value of angle B if it is twice the value of angle A in degrees

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 2. The uniform cable weighing 15N/m is suspended from points A and B. The force in the cable at B is…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The hanging structure in the figure below is homogeneous. Its weight (40 kg) is acting at the center…

Q: 4. A cable 800 m long weighing 1.5 kN/m has tension of 750 kN at each end. Note: Treat this as…

Q: A cable and pulley system at D is used to bring a 210 kg pole (ACB) to a vertical position, as shown…

Q: the cable reel is in contact with the ground at A and wall B with a weight of 100 kg. If the static…

A: f= friction force on ground A=μW=0.3×1009.81=3.06 ND' alemberd principal for…

Q: The 53-kg uniform triangular plate is supported by two small hinges A and B and the cable system…

Q: The 580 N load is suspended on the cable by a pulley at A. The length of the cable is 1.5 m. long.…

Q: The mass of the suspended bucket is 15 kg. Resolve the forces acting on all cables attached to…

Q: Situation 6 - Given the following data for the frame shown in Figure 16-3. a= 2 m, b= 0.8 m, c= 1.5…

Q: The tension in cable AB is 150 N. The tension in cable AC is 100 N. Determine the sum of the moments…

Q: Q.1.14 The equivalent uniform distributed load acting on the suspended cable with three hinged…

A: Maximum tension acting on cable is.

Q: The Catenary 1. The cable is attached to a fixed support at A and a moveable support at B. If the…

A: As per guidelines we are supposed to answer only first question so please repost rest questions…

Q: A 100 N weight W is supported by cable ABCD. There is a frictionless pulley at B and the hook is…

Q: Calculate the tension in the cable, and the reactions at A and C 100 mm 100 mm 300 mm 400 N C 400 N…

Q: Find sag Yc and determine the largest force, F, that can be sustained by the cables if the maximum…

A: NOTE - Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: The 580 N load is suspended on the cable by a pulley at A. The length of the cable is 1.5m long.…

A: The tension in the cable will be same throughout. It is also given that pulley is friction-less and…

Q: d. d/2 d/2 0.2 m 30 2 m M cable c 2 m 0.2 m- The gantry shown in the above diagram is made of two…

A: Cable tension=2.5 kN=2500 N Vertical member weight=200 kg Horizontal member weight=200 kg Length of…

Q: A weighs wA and has the dimensions shown. The coefficient of static friction between the cable and…

A: Given:- μA = 0.45wA = 104lbμP = 0.23α = 32°h = 7.1 To find:- The maximum weight of block B to…

Q: Solve for the Tension Force in kilonewton for the cable supporting the inclined gate. The cable is 6…

Q: enter of gravity of the 50kg spool is at G. A cable would around the hub of the spool is attached to…

A: Given:- m=50kg coefficients of static friction are 0.15 under the spool and 0.20 To find:- Co

Q: Calculate the tension in the cable, and the reactions at A and C 100 mm 100 mm 300 mm 400 N C 400 N…

Q: Q.12.3 The equivalent uniform distributed load acting on the suspended cable with three hinged…

A: Maximum tension on cable is

Q: A 100N load is supported by a strong bar as shown in the figure. The tension in the cable is 200N.…

Q: 11 A cable is suspended through simple support at the same level. The equivalent weight on the cable…

A: Given, Equivalent weight= 10kN/m Distance between support =50m Sag of the cable = 5m

Q: The 118-kg spool has a radius of gyration about its mass center of kG = 300 mm If the couple moment…

A: Given: Mass of Spool = 118Kg, kG= 300mm, μk = 0.2 Determine = Angular acceleration of the spool,…

Q: Q.12 The equivalent uniform distributed load acting on the suspended cable with three hinged…

A: Uniform distributed load acting on the suspended cable is 5kN/m. Span of the cable is 10 m. Sag of…

Q: A cable is supported between two points 30 m horizontally apart. The left support is 3 m above the…

Q: SITUATION. The tension in the supporting cable BC is 600lbs

Q: Pole AB is 12 m long and its weight, W = 35 kN. It is being lifted using cables BC and BD. When the…

A: Solution Given Data Length of AB= 12 m W= 35 kN Angle= 600

Q: The 1635-lb uniform plate ABCD can rotate freely about the hinge AB. The plate is supported by the…

A: The weight of the plate will be concentrated at the centroid. Since the plate is symmetrical, the…

Q: A cable ABCD is pulled at end E by a force P as shown in Q. 2. The cable is supported at point D by…

A: My dear Given data UDL Cable shape and its deflected co ordinates Horizontal reaction at F =0 We…

Q: he cable of a suspension bridge, shown in Figure, runs over a frictionless pulley on top of each of…

A: The bridge, an interfacing structure, makes holding between various detached pieces of a country,…

Q: A cable is suspended through simple support at the same level. The equivalent weight on the cable e…

A: Solution is in step 2

Q: ow that the tension acting at a point in a catenary cable varies with the y-coordinate of the point…

A: Given , Force at B TB = 500 N . Wo = 15 N/m…

Q: The tension in cable AB is 10 kN. Replace this force as it acts on point A by an equivalent…

A: Given:- The tension in cable AB = 10 kN Point B is located at the center of the container top…

Q: A beam ABCD with a vertical arm CE is supported as a simple beam at A and D (see figure). A cable…

A: This question is related to Strength of Material or Mechanics. In this question we calculate value…

Q: The slender bar is pinned at point A and held in the horizontal position by a cable as shown in the…

A: Concept: Angular velocity refers to the velocity rate at which a particle or an object is rotating…

Q: block B. The coefficients of static friction are 0.15 under the spool and 0.20 under the block.…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Q: A bar ABC which partially carries a uniform load of W = 15 kN/m is being supported by two cables BE…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: A cable is suspended between two supports at the same elevation 300m high and 500 m apart. The load…

A: Given data, Length = 500m Load per metre length = 600kg Sag of cable = 50m To find out the maximum…

Q: For W = 360 lb, determine the tension in each cable and the reaction at C The tension in cable DAEIS…

A: For the given problem, the FBD can be drawn as shown below:

Q: 250 mm A lever AB is hinged at C and attached to a control cable at A. If the lever is subjected to…

A: To find tension in cable AD

Q: The uniform cable weighing 11.25 N/m is suspended from points A and B. The force in the cable at B…

A: The cable is a structural member used to support load between two supports. The cable transmits…

Q: In the force system, determine (a) The component of the force F acting along the cable AC. (b) The…

A: We will first write the coordinates of the points A, B and C in the form (x,y,z). Coordinate of O =…

Q: Two cables BG and BH are attached to frame ACD as shown below. y (G) (A) |G H (F) (B) D (E) (C) В…

Q: Problem 1. The uniform rod in the figure shown weighs 2.0 kN and has its center of gravity at G.…

Q: A 100N load is supported by a strong bar as shown in the figure. The tension in the cable is 200N.…

A: Data Given: Tension in the cable = 200 N ∠B = 2∠A Asked: The value of angle B

Question

Rs twice the value of
10 m
100N
200N
ZB
LA
10 m
20.86
42.94
83.44
D 25.48
E 21.47
F 85.88
G 41.72
H 12.74

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

P VALUE 167.5
Assigned P Value P=167.5
Gs is assumed to be 2.72
Convert 48°15'26" to centesimal units (Ans.: 53.6191)
SUBJECT: static of rigid bodies 1.lxx(centroidal) choices a. 1642.67 b. 1752.5 c. 1987.6 d. 1612.7 2. Lyy(centroidal) choices a. 784.98 b. 832.5 c. 1012.27 d. 958.77
Geometric space, i need solutions in 15 minutes please. MCQ/ If Ø = 0.987643 rad. Find Ø in degrees. A-56º 35' 16'' B-45º 42' 16'' C-52º 04' 26'' D-54º 30' 16'' E-35º 25' 25'' F-65º 25' 13''
Select one: a. 0.73 m b. 0.54 m c. 0.39 m d. 1.01 m
How was this 0.68 V2 calculated? And also 40.77 f V2 because I am not getting that..
Q=7 n=0.017 v=1.7 z=1.7
Bearing or Azimuth of Line AB: ____________________ Sta Occ Sta Obs Dist (m) Mean Dist Observed Interior Angle Corr Adjusted Interior Angle Direct Reversed Mean A E 11.55 102°57 B 13.20 B A 13.20 C 17.42 C B 17.42 D 10.00 D C 10.00 E 13.90 E D 13.90 A 11.55
Suppose that L = 12 in.
A tacheometer fitted with an anallatic lens was used to observe the following:InstrumentStation W.C.B Staff Station VerticalAngle Staff Readings(m) C 320 0 A -12 0 0.906, 1.728, 2.550C 50 0 B + 10 0 0.744, 2.199, 3.654The value of the constant was 653and the staff was held vertically. Determine thelength R.L of A & B and gradient of AB