Answered: A 21 kW, 235 V DC long-shunt generator…

A 21 kW, 235 V DC long-shunt generator has an armature, series field and shunt field resistances of 0.01 ohm, 0.06 ohm and 83 ohms, respectively. Find the armature voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.3P

See similar textbooks

Related questions

Q: 1. A voltage transformer has 1500 turns of wire on its primary coil and 500 turns of wire for its…

Q: For single sideband (SSB) modulation a) Write the time domain equation XSSB(t). b) Explain the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: If the ratio of outer conductor diameter to inner conductor diameter of an air-insulated coaxial…

A: Given: The ratio of outer conductor diameter to inner conductor diameter, ba=7.39.

Q: R(s) = = = S G(s) s+3 s+4 C(s)

Q: If a microprocessor can perform 4 million instructions per second, how many nanoseconds are required…

Q: 1. A discrete LTI system has an input x[n] and impulse response h[n] shown below. Find the output…

Q: INSTRUCTION 1. Simplify the given logic equation then draw the final circuit. X- (AB + BC) + BC (B +…

Q: QUESTION 29 The value 1.2 x 10-6 can be expressed as O 1.2 μ or micro O 1.2 M or Meg O 0.00012 O 1.6…

A: Basic problem on representing number in electrical engineering.

Q: For the circuit shown, ICQ value is * input HH 10 µF Vcc=14V Ra 220kΩ Ict Re • 2.2 ΚΩ C₂ 14 10 µF…

Q: Determine the maximum current Iz if Vz=10 V Pzmax= 200mW * VIN 24 V All4 4 R www 47002 R₁ 34.75 mA O…

A: In this question, We need to choose the correct option We know Maximum power rating of diode Pmax…

Q: SOLVE FOR THE UNKNOWN CURRENTS AND VOLTAGES ASKED source: 208V balanced line to line Line 1:…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: he forward path and feedback transfer functions of a control system are given below: 1 G(s) = (s +…

Q: 4. Find the Laplace transform, zeros, poles and ROC of the following time-domain functions. a. x(t)…

Q: A 4-ohm resistor is connected to a 12-volt battery. What current does it have flowing through it? R=…

A: Given- Resistor = 4 ohm Battery source battery = 12 Volts To find- Current through it=?

Q: 4. Determine V₁ and V₂ using nodal analysis. Show complete solution using either elimination or…

Q: 1.) A storage register made up of six D flip-flops is storing a binary word. The flip-flop status…

A: The D FlipFlop is a device that stores one bit of data. The D FlipFlop is referred to as data…

Q: SOLVE FOR THE UNKNOWN CURRENTS AND VOLTAGES ASKED source: 208V balanced line to line Line 1:…

A: Voltage at a'' is not given. We can not solve the problem unless it is specified. Assumption : We…

Q: Electrons pass right through a wire cross section at the rate of 6.4 x 10²1 electrons per minute.…

A: SOLUTION GIVEN Number of electron pass through Wire cross…

Q: Write a short essay about the difference between an indoor and an outdoor substation. Compare each…

Q: Determine the electrical force of attraction between two balloons with separate charges of +3.5 x 10…

Q: What voltage will produce 0.45 A of current through a 4800-Ω resistor?

A: Resistance opposes flow of current. The voltage across resistor is obtained by ohm's law. The…

Q: A 3-phase motor is operating with and Vod gd0s = = [100 0 5] V Idos[10-50 1] A. Currents are defined…

A: Given- Three phase motor values- Voltage- Vqd0s=10005 V Current- Iqd0s= 10-500 A To find- Energy…

Q: * VODC for the following circuit is re 110 Vrms ellee 4:1 9⁰⁰ eetee D₁ D₂ R₂ 1.0 k 11.893V O 11.685V…

A: In this question, We need to determine the output dc voltage of the circuit. Assume forward bias…

Q: (3) In the following LTIODEs, find all values of B (if any) than produce a stable homogeneous…

A: The LTIODE is given asx....t+8x...t+Bx..t+96x.t+80xt=0Take the inverse laplace transform of the…

Q: O-A 400 V, 15 kW, pole, 50 Hz, Y-connected induction motor has full load slip of 4%. The output…

A: In this we need to determine the torque of the induction motor? Torque = power/wr Where wr =…

Q: Air at 227°C and 800 kPa expands to 200 kPa in a quasi-equilibrium process following the law PV1.3 =…

A: When a process changes at a slower rate than it takes for the system to attain thermodynamic…

Q: The numerical values for the voltages and the currents in the circuit of Fig. P1.9 is given in the…

A: Given:

Q: +1 16V (+ ww 202 type your answer... The circuit above is in DC steady state. What is the value of…

Q: Theoretical and experimental values of five resistors in the labora Industrial value (0) Measured…

Q: Four 4 AWG copper conductors with THHN insulation installed in EMT in a basement. All termination…

A: We need to Answer the question asked ampacity and maximum fuse or circuit breaker size of 5 AWG…

Q: 1.) Complete the truth table of a NOR gate D flip-flop shown below. 82 D efT GET hole w R Į Don Day…

A: Given:

Q: For the circuit shown, if R1=R2=Rc-10Kohm, RE=1Kohm. Rth as shown from the base is HH C₁ R₁ R₂ w Vec…

Q: A current of 1 A is maintained in a simple circuit with a total resistance of 2.5 0. How much heat…

A: It is given that: I=1 ART=2.5 Ωt=4.5 s

Q: 6. Determine Vo for each network of Fig. 2.176 for the input shown. +10 V Vin OV- -10 V t 1.0 ΚΩ…

A: This is a problem of analysis of diode. The detailed solution is given in the next step.

Q: A 30 MVA, 13.2KV synchronous generator has a solidly grounded neutral. Its positive, negative and…

Q: Q6) Find the following: 2. Simplify using Boolean algebra and DeMorgan's theorem y=(ABC XABC) 3.…

A: We need to find out the simplified Boolean expression for given function by using of de Morgan…

Q: 3. Find the energy of the signal x(t) 2sin(t) лt

Q: Write the mathematical description of the given signal below and perform the time-domain processing…

Q: Q5) Determine the following: A. find the equation of the following circuit in the figure Q5A, and…

A: We need to find out simplify expression for given logic circuit . And we need to find out simplify…

Q: Q) Two impedances Z₁-(10+j5) and Z₂=(8+j6) are connected in parallel across a voltage of V=200+j0.…

A: Given - Z1=(10+j5) ,Z2=(8+j6) , Voltage, V = 200 + j0 , To find- (i) Circuit current (I) , (ii)…

Q: 2. Find 1₁, 1₂ and 13. 552 M 20V +1 350 SI HI₂ 12 100 W W 12-2 W 150 Із 300 M 4052 2052

A: We need to find out the current for given circuit. We will simply the given circuit then we will…

Q: A 5.1 V zener diode has r.=792 and a current of 50 mA at 5.1 V. The V=15 V zener is powered by a…

A: According to the question, for the given circuit as shown below, We need to find load regulation…

Q: For the circuit shown in the figure below, find the output impedance. Assume V₁ < 0. Vcc RE VinoQ₁ -…

Q: In the circuit below, we have a Zener Diode circuit with a load, RL. Use the same measurements for…

Q: is often referred to as a(n) A pure semiconductor intrinsic semiconductor O extrinsic semiconductor…

A: Pure semiconductor is a type of material whose conductivity or electrical properties lies In between…

Q: Question The circuit in figure is used to measure the power consumed by the load. The current coil…

A: Given- current coil & voltage coil resistance- =0.02 Ω & 1000 Ω. To Find- The measured power…

Q: Two shunt generators rated at 200 kW and 400 V have full load regulation of 6% and 4% respectively.…

A: In this question we need to find a current share by two given shunt generator while operating at 800…

Q: A large residence consumes 1155 kWh of electrical energy over a billing period. Determine the total…

A: Given: Service charge=ℙ345 Energy chargeGovernment Taxes= 10.3% of total bill amountGeneration…

Q: 2. From the circuit below, Calculate A. Frequency of Oscillation B. Period of Oscillation 1000…

Q: Adding a capacitor in parallel with the load in the rectifier will the ripple 000 For the following…

A: output of the rectifier has large ripples . In order to reduce the ripples in the output voltage ,…

Question

Please include the equivalent circuit complete with labels for each problem in the solution as my guide. Thanks!

A 21 kW, 235 V DC long-shunt generator has an armature, series field and shunt field resistances of 0.01 ohm, 0.06 ohm and 83
ohms, respectively. Find the armature voltage.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A long shunt compound dc generator delivers a load current of 69 A at 396 V and has armature, series field and shunt field resistances of 0.096 Ω, 0.014 Ω, and 259 Ω, respectively. Calculate the armature current in ampere.
A 50 kW, 220 V, dc shunt generators has an armature resistance including brushes of 0.026 ohms. If the shunt field resistance is 52 Ω. Find the induced emf at rated load.
. When a self-excited compound DC generator supplies load, the terminal voltage is not the same as the generated emE Why? a) voltage drop across the armature resistance will reduce the voltage available at the load terminals b) where there is a series field, voltage drop across the series field resistance will reduce the voltage available at the load terminals c) both "a" and "b" d) neither "a" nor "b"
A short shunt compound DC generator supplies a load current of 10A at a voltage of 10 volts. If the resistance of armature, shunt field and series field windings are 0.001 ohm, 1 ohm 0.00 ohm respectively. a) Draw the the figure. And find the generated voltage.
The armature winding resistance of a long shunt connected DC generator is 0.4ohm, the resistances of the shunt and serial field windings are 125 ohms and 0.1 ohms, respectively. While the generator supplies 8KW of power to the load it feeds, which is the voltage it produces since the output voltage is 250V?
A short shunt compound DC generator delivers a load current of 30 A at 220 V and has armature, series field and shunt field resistances of 0.05, 0.3 and 200Ω respectively. Calculate the induced emf, the armature current and the voltage regulation. Allow 1 V per brush for contact dro
111/ The armature reaction of the DC generator reduces the generated EMF. Select one: True False
A long shunt compound generator delivers 100 A at 250 V. The armature, shunt field and series field resistances are 0.02 Ohms, 50 Ohms and 0.05 Ohms respectively. If the Break Horse Power (BHP) or the power developed by the shaft torque of the driving engine is 40, determine the stray loss.
A shunt generator has a no-load terminal voltage of 270 and a voltage of 245 when it delivers 180 amp. Assume a straight-line characteristic and determine the following: the voltage when the current is 120 amp and What is the equivalent load resistance under this condition?
Problem: A self-excited shunt generator has a field resistance of 52 ohms. When the generator delivers 7 kW, the terminal voltage is 6 V, while the generated emf is 7 V. Determine the armature resistance in ohm.
A compound DC generator has a series resistance divided equally and connected in series with the load and the armature. If this generator is rated at 720 V with an armature resistance of 0.1 Ω, shunt resistance of 240 Ω and a (total) series field resistance of 0.6 Ω, find the generated emf if it delivers 100 A?
A long shunt compound dc generator delivers a load current of 78 A at 466 V and has armature, series field and shunt field resistances of 0.077 Ω, 0.04 Ω, and 290 Ω, respectively. Calculate the armature current in ampere (up to four decimal places).