A 230-V, 1 000-c/s voltage is applied to a resistor in serieswith Ccapacıtance 0 06 µF, the reading is 100 V. Find the currentwhen the voltmeter is disconnected.860 05 µF. When C is shunted by a voltmeter of[0 0527 A.]

Given Voltage V=230 vFrequency f=1000 HzCapacitance C=0.05 μFThe shunted capacitance Csh=0.06 μF

A 230-V, 1 000-c/s voltage is applied to a resistor in series with C capacıtance 0 06 µF, the reading is 100 V. when the voltmeter is disconnected. 66 0 05 µF. When C is shunted by a voltmeter of Find the current [0 0527 A.]

A 230-V, 1 000-c/s voltage is applied to a resistor in series with C capacıtance 0 06 µF, the reading is 100 V. when the voltmeter is disconnected. 66 0 05 µF. When C is shunted by a voltmeter of Find the current [0 0527 A.]

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter13: Heating Control Devices

Section: Chapter Questions

Problem 28RQ

See similar textbooks

Related questions

Q: 7) The 6 k2 and 10 k2 resistors are connected in series and they are connected across a 20.0-V…

A: The resistors are 6kΩ and 10kΩ are connected across 20V battery.

Q: What are the expected readings of the following in the figure below? (R = 7.30 N, Av = 5.90 V) R AV…

A: For the above-given circuit Voltmeter and Ammeter, reading is calculated as shown below

Q: Non-ideal voltage sources such as batteries are modelled as an independent DC voltage in series with…

A: Find the internal resistance of the battery ?

Q: A multirange ammeter was designed using direct method to give three scales with Rsh1%= 0.001285989…

Q: Determine the DC currents (1s. Ic and le) and dc junction voltages (VBE, VCE and Vca) In-Blank 1 mA,…

A: Given, VBB = 3 VRB = 5 kΩRC = 232 ΩVcc = 18 VβDC = 65

Q: 14. Determine the values as indicated for the following parallel circuit Vt R1 R2 R3 R4 5V 360ohm…

A: In the parallel circuit, the total resistance seen by the source is calculated by: The source…

Q: An incandescent lightbulb rated at 100Wwilldissipate 100Was heat and light when connectedacross a…

A: To determine the power dissipated by each bulb when three bulb are connected to 110 V supply. Given:…

Q: For a Darsnival device with a moving coil prepared to read the electrical resistance, calculate the…

A: The device resistance Rm and the shunt resistance Rshare in parallel. The reading in the meter is in…

Q: BE +10V R1 20k Q1 Ve R2 15k RE 1k

A: Here i have solved it using thevenin equivalent model and kvl.

Q: A battery is comprised of 12 cells connected in Series, each cell has an EMF with Ecell = 1.5 V and…

Q: (1) A moving coil nstrument whose resistance is 10 2 and has a full-scale deflection when the…

Q: The circuit shown in Figure P1.75 contains a voltage-controlled current source. Solve for v s.

A: Given circuit is =

Q: The following figure shows: +2lx Oa. A dependent current controlled current source b.A dependent…

A: It is a dependent current control voltage source, because it acts as a voltage source. But that…

Q: A PMMC instrument has internal resistance of 0.77 ko and gives full scale deflection for 35 mA. The…

Q: can you create a diagram of this circuit? resistance:220 ohm diode 1N4007 BC548B Transıstor 1.5…

A: Given data: Resistance = 220 Ω Diode : IN4007 Transistor: BC548B Coil Battery : 1.5 V Capacitor =…

Q: The circuit shown below is an example of a simple voltage regulator. Determine the current through…

Q: A coil of copper wire has a resistance of 90 N at 20°C and is connected to a 230 V supply. By how…

A: The value of resistance increased will demand more voltage drop for the same amount of current flow…

Q: Find the value of Vs that will cause the 22 resistance to conduct a current of 3A flowing downward.…

Q: 5. A PMMC instrument gives 25mA at full scale reading when a potential difference across its…

A: The solution can be achieved as follows.

Q: rear-window defogger

A: Resistance Resistance is the measure of opposition to the current flow in an electric circuit. The…

Q: A PMMC instrument gives 25mA at full scale reading when a potential difference across its terminals…

A: Given: Full scale deflection current, Ifd=25 mA Potential difference applied, Vm=75 mV

Q: Each of three insulators forming a string has self-capacitance of "C" farad. each cap of insulator…

Q: Avample: Also, calculate the value of R that will limit the initial level of discharge I uF.…

Q: The following are the readings taken while conducting an experiment on a wind turbine. what will be…

A: The solution to the given problem is attached below.

Q: A PMMC instrument gives 29 mA at full scale reading when a potential difference across its terminals…

A: Given: For PMMC Im=29 mAVm=41 mV So, meter resistance Rm=VmIm=4129=1.414 Ω

Q: An industrial battery is charged over a period ofseveral hours at a constant voltage of 120…

A: Given that industrial battery is charged over a period of several hours, The current from t = 0 to t…

Q: Derive the mathematics of a circuit A series of 5 units of insulators Extract V5 in detail

Q: A So m aluminum wire has a ooss sectional area diameter oF 8. the conductivi vy or the wire- mm. It…

A: The solution is given below

Q: the following Current voltage (IV) curves are for 35 an ideal solar cell and a solar cell with the…

A: Given, Dark saturation current, Io=0.1×10-9 Light generated current,IL=0.5 A Ideality factor n=1…

Q: The charge cycle shown in Figure is an exampleof a two-rate charge. The current is held constant…

A: (a) Consider the battery current graph. The charge transferred to the battery in the first 5 hours…

Q: Find the current in the 17 ohms resistor by using Wye/delta conversion. Provide a clear solution.

Q: QUESTION TEXT A potentiometer consisting of a wire of length = 10 cm has a source of emf, ɛ = 15V…

Q: A resistor R is connected in parallel with a 10-ohm inductive reactance. The combination is then…

Q: ESSAY. Explain in your own words and discuss the significance One of the most important parameters…

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: Each of the six real batteries in the figure has an emf of 19.5 V and a resistance of 4.21 2. (a)…

A: Given a circuit with six practical batteries and a external resistor Practical battery contains…

Q: 4. The figure below shows the thermistor voltage vs. current characteristic for a thermistor in air…

Q: Determine the I in the circuit below, assuming the circuit is in steady state 10 1ng 10 mil 25 a 100…

Q: An ideal voltmeter V is connected to a 2.0 Ω resistor and a battery with electromotive force emf 5.0…

Q: 1) According to the figure given below: a) Determining the de resistance at 2 mA. b) Determining the…

Q: The circuit shown below is an example of a simple voltage regulator. Determine the current through…

A: We will find out the voltage across resistor by virtual ground property of opamp them we will find…

Q: 3. Suppose an automobile battery is modeled as an ideal 12-V battery in series with an internal…

A: Battery delivered current I =E/(Ri+RL) Output voltage VL=I×RL

Q: (a) Use Ohm's Law to derive an expression relating Vout to Vin using the values of the two…

A: Circuit diagram is given as,

Q: 1KN 10 ΚΩ 10KO -5V

A: Here we have done kvl analysis assuming thar the transistor is in active region but we found that…

Q: 4. From the figure shown which is series-parallel, the following values are: ID ohms in series with…

A: For the given electrical circuit by designing the given circuit diagram with reference to the values…

Q: V1 S1 82 24VDC 30mH V2 A Time = 0 Time = V1 = V1 = %3D V2 = V2 = %3D A = A = 3 Amps

Q: For the figure below, calculate the value of the resistance Rp, knowing that the value of the…

Q: Two metallic terminals protrude from a device. The terminal on the left is the positive reference…

Q: QI) For the circuit shown in Figure, determine is to is. 30 200

A: The obstruction offered to the flow of current is called resistance. The electrical element or the…

Q: DC Circuits 2.00 N 4. You are helping to design a simple circuit for an experiment. The circuit so…

Q: Choose the correct option. 1) Semiconductor materials have a) Positive temperature coefficient b)…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

A 230-V, 1 000-c/s voltage is applied to a resistor in series
with C
capacıtance 0 06 µF, the reading is 100 V. Find the current
when the voltmeter is disconnected.
86
0 05 µF. When C is shunted by a voltmeter of
[0 0527 A.]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the unit of real power? a.V-ohmb.VAc. V/ohmd. none of these
Consider the following circuit and design the values (that is, decide the values) of the electrical elements (including the value of the constant k) so that VR1 = 6V and VR2 = 4V. The power dissipated by the resistive elements must not exceed 0.5 W.
consider the following circuit composed of four resistors and an ideal battery. each resistor has a resistance of 2.00 ohms. the battery has a terminal voltage of 30.0V. a.) what is the equivalent resistance of this circuit? b.) what is the equivalent current passing through this circuit? c.) what is the voltage drop across R1? d.) what is the current passing through R2?
A) Find the equivalent resistor of the circle between points a and b?B) If a constant voltage source (15V) is placed between points a and b, calculate a valueCurrent iS
A resistor with a 15.0 V potential difference across its ends develops thermal energy at a rate of 327 W. a) What is its resistance? b) What is the current in the resistor?( explain in sentence on how to solve)
The values of the circuit elements are given below. accordingly, find the current i at t=34.6 sec.
1.) Which of the following statement is not correct? -voltage source is an active element -current source is a passive element -resistance is a passive element -conductance is a passive element 2.) A battery produces a current of 0.6 A when the external resistance is 2 ? and 0.2 A when the external resistance is 12 ?. Find the emf of the battery -3 V -6 V -9 V -12 V
The circuit below(left) displays a schematic diagram of a battery. The voltage measured by U1 is called the terminal voltage given R1 = 1 ohm. In the circuit below(right), the terminal voltage of each of the battery-resistor combination is VT = 1.5 volts. Find the current passing through R1, R2, R5
A rear-window defogger in a car consists of 13 resistive wires connected in parallel to a 12-v battery. Assume that the defogger can melt 2.1 x 10-2 kg of ice at 0C to liquid water at 0C in two minutes. Each wire has a length of 1.30m. What should the resistance/ length of the wires be? Your answer should be in ohms/m.
A circuit with a shunt resistor (R_s) and a load (R_L) is shown in the following figure: Assume that V1=5V. If the voltage drop across the 100mΩ shunt resistor is measured as 50mV, what is the power dissipated by the load? Assume units of watts and round to 2 decimal places.
The circuit below(left) displays a schematic diagram of a battery. The voltage measured by U1 is called the terminal voltage given R1 = 1 ohm. In the circuit below(right), the terminal voltage of each of the battery-resistor combination is VT = 1.5 volts. Find The percentage of power dissipation loss due to the four resistors R1, R2, R3, and R4.
Consider the circuit below. The battery has an emf of ℇ = 30.00 V and an internalresistance of r = 1.00 Ω.a. Find the equivalent resistance of the circuit and the current out of the battery.b. Find the terminal voltage of the battery. c. Find the current through each resistor. d. Find the potential difference across each resistor. e. Find the power dissipated by each resistor. f. Find the total power supplied by the battery.