A 400v series motor working with unsaturated field is taking 60 A and running at 840 rpm. The total resistance of the motor is 0.1 ohm. At what speed will the motor run when developing half-full load torque.

A 400v series motor working with unsaturated field is taking 60 A and running at 840 rpm. The total resistance of the motor is 0.1 ohm. At what speed will the motor run when developing half-full load torque.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 13RQ: A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is...

See similar textbooks

Related questions

Q: For the network of Fig. 170, sketch v, and determine Vae- 2k V; = 120 V (rms) Ideal % (Vác) FIG. 170…

A: Considering input wave to be sinusoidal the output is drawn. Plotted output waveform using transfer…

Q: . A 5-ohm load is connected to the secondary o! a 1100/110-v power transformer. The effective load…

Q: Ex: a) Write the Meshequations in matrix form for the circuit shown in figure. b) Write a MATLAB…

A: Given the circuit, as shown below: a) We need to write the mesh equations in matrix form for the…

Q: A continuous time signal x(t) is given by : x(1) =8+2et sin(21)u(t)+2cos (4t) Calculate the…

Q: + 30 V Rc Rt るRE8.2Ke Find zi and zo and Av and Vo

Q: 4. A DC voltage of 80 volts is applied to a circuit containing a resistance of 80 ohms in series…

Q: Question#1 i) Prove the following Boolean theorems algebraically: (a) X(X'+ Y) = XY (c) XY+XY' X (b)…

Q: 7. A 1:2 ratio transformer has secondary winding resistance of 1/2 ohms. What is the total…

A: We need to find out resistance on primary side of transformer and VA rating of transformer.

Q: 14. Severe burns, lung damage, eye damage, and hearing loss are all effects of what event? 8 am…

A: In this question we need to choose a correct option

Q: 7. A system operates at 220 kVA and 11 kV. Using these quantities as base values, find the base…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: three-phase, five-pole alternating current generator that runs at a speed of 1440rpm has a total…

Q: In the circuit below, Vpp = 5V, R, = 300kn, R2 = 200kn, R3 = 1.5kn and R, = 2kn. The n- channel MOS…

A: The solution is given below

Q: (d) In the cicuit shown in figure 6 find the currents I, and I2, express your answer as phasors.…

Q: Consider the figure below, design the minimum value for the emitter capacitor with the amplifier's…

A: Given: Consider the given circuit: To find: Design the minimum value for the emitter capacitor with…

Q: 6Z60°S I2 16245°A 4Z30°S Figure 6

A: In this question we need to find the currents I1 and I2.

Q: 2420°v -j20 20 j20 ll I2 12430 A 214 -j407 20

Q: NOTE: Average of periodic signal f (x) of period T is given by: t0+T 1 f(x)(ave) = 7 f(x) dx T to D1…

A: The solution is given below

Q: Impedances. In alternating current, the resonance frequency is defined as the frequency that would…

Q: Find the Thevenin equivalent

Q: Question#2 Simplify the following Boolean equations. i. xy + xy' ii. (x + y).(x + y')

A: Given, To simplify the Boolean equations.

Q: Compute for Zo. Vcc = 12V. %3D oVcc 4.7 k2 1 ΜΩ B= 90 To=002 O 1 Mohms 4.7 kohms infinite 2.8 kohms

Q: Solve for Zo. Vcc 2.7 k2 330 k2 Zo hie 1.175 k2 hoe= 20 µAV he = 120 I 2.56 kohms 330 kohms 50 kohms…

Q: 11. As motor speed increases the current pulled by the motor will decrease, which is cause by an…

Q: 4. Find I, and R, for the circuit below

Q: shunt motor takes 40 ampsat full-load when connected to a 115-volt line. At no load, the motor…

Q: On no-load, the motor takes 4 A at 96 V and at 0.25 lagging power factor. The no-load friction and…

Q: 22. A circuit has a real power of 250 W and a reactive power of 150 VAR. Is the circuit more…

A: In this question we need to choose a correct option

Q: Speed control of induction motor explain full theory fast

Q: 9. A transformer with a ratio of 12:1 has a primary current of 5 A. What is the secondary current?…

A: given here a transformer ratio is 12 : 1 and primary current is 5 A. here we have to find the…

Q: 9. The armature of a relay working on 200 V circuit operates when the current reaches 0.24 A. It is…

Q: if the feedback loop gain is small, the oscillation increase dies-out stays the same goes back to 1

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Questions: • Do these resistors satisfy Ohm's law? Explain your answer. • Is an ammeter connected in…

Q: The power input to a three phase, 50HZ induction motor is 50kW.The total loss is 80kW. Assuming the…

A: Given: A three phase induction motor with Input power, Pin=50 kW Frequency, f=50 Hz Total loss,…

Q: ven the Standard Equation the DE, Identify the roots d³y 3d²y + 4y = 0 dx³ dx² A) m1= -1 ; m2= 2 B)…

Q: Ex:. For the Following Circuit , Find is (Source Carrent ) ide and i2, assume no initial Current and…

A: We need to find Is,i1,i21

Q: Suppose one ammeter probe is placed on the low side of a component and the other probe is placed on…

A: As per the guidelines given ,we can only provide the solution of one question in multiple type of…

Q: Rp -OVOUT VIN O Rs Vss = -VDD а. Draw the small-signal model. b. Determine the small-signal gain…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: .What are methods can be used to detemine the carrier density in the

A: As per the honor code I will answer only question number 4. Kindly repost the other question again.…

Q: Q1: 1. An input signal is given by: Vin(t) = 5 + 2 sin(1600nt + 25º) + 5cos (10000nt) is applied to…

Q: O A 90e resistor, a 32 mH indactor and a SuF capaei tor an tonne eted in venes a sinusoidal ourw…

Q: Design a BJT differential amplifier to amplify a differential input signal of 0.25 V and provide a…

A: The differential amplifier is used to amplify the input signal with a gain of more than 10. This aim…

Q: 29. Determine v, and the required PIV rating of each diode for the configuration of Fig. 173. In…

A: We need to find out current and peak inversion voltage for given circuit

Q: how Complete Solution. No Shortcuts. Thank you! Suppose if the signal is about 0 - 12v and we have…

A: Solution- Given, signal is about 0-12 V 16 bit ADC ⇒n= 16 ADC…

Q: Question 2 5Ω 2F 10 3F Figure 2.1 Consider the system shown in figure 2.1 (a) (h) Obtain the…

Q: Question 1 Suppose one ammeter probe is placed on the low side of a component and the other probe is…

A: Solve the first question, unless the student has asked for a specific question to be solved,…

Q: If the base line-to-line voltage of a 3-phase system is 4kv and the base 3-phase MVA is 40 MVA, then…

Q: n solar nuclear fusion, each time a proton fuses with another proton, this amount of energy is…

A: In nuclear fusion, one proton is fused with another proton with very high velocity and very high…

Q: 4. At motor start-up, the current will spike as the motor begins to turn. This spike is know as?…

A: Synchronous speed is the speed at which synchronous machine works and it depends on frequency and…

Q: Design a Programmable Logic Array (PLA) with 3 inputs and 3 outputs. The binary output is two…

A: The truth table can be obtained based on the given condition and the reduced Boolean expression can…

Q: In measuring settling time from step response with five percentage tolerance, the tolerance band…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 400v series motor working with unsaturated field staking 60A and running at 840rpm the total resistance of the motor is 0.1ohm. At what speed will thr motor run when developing half full load torque.
A 400V series motor working with unsaturated field is taking 60A and running at 840 rpm. The total resistance of the motor is 0.1 ohm. At what speed will the motor run when developing half-full load torque.
A 10-hp (7.46 kW), 250-V. shunt motor takes a line current of 5 A. when runninglight. Calculate the efficiency when delivering full load output, if the armature andfield resistances are 0.5 Ω and 250 Ω respectively. At what output power will theefficiency be maximum?
A series-connected dc motor operates at 1400 rpm from a source voltage of VT=75 V. The developed torque (load torque plus loss torque) is constant at 25 Nm. The resistance is RA+RF=0.1 Ω. Determine the value of resistance that must be placed in series with the motor to reduce the speed to 1000 rpm.
A dc shunt motor rated at 250V, runs at 1000rpm draws a current of 25A. Determine the speed if the field is weakened by 3% for the line current of 50A. The armature and field resistances are 0.2 and 250 ohms respectively. Brush drop may betaken as 1V per brush.
A 10-hp (7.46 kW), 250-V. shunt motor takes a line current of 5 A. when running light. Calculate the efficiency when delivering full load output, if the armature and field resistances are 0.5 Ω and 250 Ω respectively. At what output power will the efficiency be maximum?
The starting current of a 3-phase squirrel-cage induction motor with 60 kW, 380 V, 120 A, 2900 rpm, coso = 0.78 written on the plate is 10 times the rated (full load) current and the overturning torque is 2 times the rated torque. It is known that the starting moment is 1.5 times the rated torque. If a voltage higher than 20% of the nominal value is applied to the motor, find the overturning torque (M2d) (torque) of the motor. Find the efficiency (u(full load)) and the reactive power drawn from the mains (Q(full load)) for the motor operating at rated load and nominal voltage.M2d=u(full load)=Q(full load)=
A DC shunt motor is producing EMF of 220V running with 500rpm. And producing EMF of 200V with the speed of 1000rpm by adding external resistance with shunt field resistance. The original shunt field resistance is 250 ohm.Find the external resitance added resistance with shunt field resistance at 1000rpm. a. 300 ohm b. 250 ohm c. 500 ohm d. 550 ohm
a 220-v dc motor is running at a full load speed of 800 rpm and draws 100 A. calculate at what speed the motor will run when developing half torque. the total resistance of the armature and field is 0.1 ohm
A DC Series motor, 500V, has a total resistance of 0.5 Ω. At plain load, the current is 100 A at a speed of 6 rev / s. At reduced load, the current is 50 A with a speed of 10 rev / s. Consider that the torque is proportional to the current on this scope. What is the current of the motor when the induced torque is 786 N·m? What resistance value should be added so that the speed is 6 rev / s at 786 N·m?
100V, 1kW DC shunt motor with an armature resistance of 1.2582 rotates at 600 pm. A variable field resistance draws a current of 1A at no load. Given that the field resistance is reduced by 50% at full load, Neglecting the mechanical and iron losses, calculate the following at full load Armature current Torque and speed Electrical efficiency
A 200V DC shunt motor with an armature resistance equal to 0.5 ohm run at 500 r.p.m. , when the armature current equal to 40 Amp . calculate 1- Back EMF 2- The speed if the torque is doubled .