A 5 degree/step stepper motor rotate 40 steps counter clockwise, stop for a minute and rotate 55 steps clockwise. How many degrees does is the resultant angular displacement.

Q: Using Voltage division, find the voltage across the 100 Ohm resistor. V1 U-10 V R1 R=100 Ohm R2…

A:

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT In the following exercise use the model of the ideal diode plus…

A: Given diode circuit as follows.

Q: x [n] = 0.25^n(u[n]) and  h[n] =(n+1)0.75^n(u[n]) Find the DFT of the output signal y [n] = x [n] *…

A: The DFT of a discrete‐time signal xn is given by X(k)=∑x[n]e∧(-j2πkn/N)where k is the frequency…

Q: Use the node-voltage method to find the power developed by the 20 V source in the circuit attached

A: Given, The circuit diagram is shown below,

Q: (a). For each of the circuits shown below, determine the current I, and the voltage V. Use the…

A: We need to find out current through given diode and voltage for the given circuit.

Q: B-6-18. Consider the system shown in Figure 6-108. De- sign a compensator such that the dominant…

A:

Q: QUESTION 18 Suppose that the value of input voltage is such that the diode is conducting in the…

A: Given data, Circuit is, The diode is conducting in the circuit.

Q: The plot in the figure below shows the magnitude frequency content of a signal. Determine the…

A: According to the question, the magnitude spectrum of a sinusoidal signal is shown below If the…

Q: Question No. 1 The value of Z in Figure, which is most appropriate to cause parallel resonance at…

A: Given- Frequency f=500 Hz, To Find- The value of Z for parallel resonance at 500 Hz.

Q: Q6. Determine the total amount of power in the series. circuit in Fig. 502 50 V 202 10

A: Given data, Circuit diagram is given as,

Q: Consider the circuit in the diagram, with sources of emf listed below. Variables E₁ +1² 0.1002…

A: Given data ε1=25 Vε2=44 Vε3=2.5 Vε4=29 V We have to determine the value of I1, I2 and I3.

Q: For a new version of processor, suppose the capacitive load remains, how much more power will the…

A:

Q: Show all complete solutions. A filter has a frequency response given by -14-12-10-8-6-9 |H(w)| ZH(w)…

A:

Q: A resonant circuit has a BW of 363 rad/s and a quality factor of 39. What is the resonant frequency…

A: Given data Band width B.W=363 rad/sec Quality factor Q= 39  Resonant frequency fr = ?

Q: Question 3 Answer the safety questions accurately below. You should never [Select] [Select] You…

A: The question is about properties of inductor and capacitor.

Q: ellee D₁ Vost D₂ Figure 4-2. Full wave (center-tapped) rectifier circuit.

A: 1(a).given that center-tapped full wave rectifier circuit To draw schematic foe the given condition…

Q: An energy meter connected to an immersion heater (resistive) operating on an AC 230 V, 50 Hz , AC…

A: Given- AC 230 V, 50 Hz, 2.3 units kWh single phase source, Time t=1 hour, Peak square wave source…

Q: 9 For the circuit shown in Fig. 9.46, find Zeq and use that to find current I. Let ω = 10 rad/s. w…

A: Given an electrical circuit ω=10 rad/sec To find (a) Zeq=Z equivalent              (b) Current I

Q: Chapman 3.4 3-4. A single-phase power system is shown in Figure P3-1. The power source feeds a…

A:

Q: A series RL circuit connected to a 110-V ac source. If the voltage across the resistor is 43 V, the…

A: Given,AC voltage source, Vs=110 VandVoltage across resistor, VR = 43 V

Q: B-6-4. Show that the root loci for a control system with K(s² +65 + 10) s² + 2x + 10 G(s)- are arcs…

A:

Q: (c) For the RLC circuit: 1. What frequency (in Hz) will make the inductive impedance cancel the…

A: Expressions of Inductive and Capacive reactances are given below.

Q: Q3: For a binary symmetric communication channel, compute the overall probability of receiving a bit…

A: Given binary symmetric channel having  P(0) = 0.3 Error probability, p = 0.2  We need to determine…

Q: Q: Compute the Z-transform of the signal ??[?].

A: Signal: An electromagnetic or electrical current known as a signal is used to transfer data from one…

Q: Determine the input impedance. j2 Ω 16/0° 4Ω Μ j5 Ω Ο 4tjs Ω Ο 6.538+j4.308 Ω ○ 4.308+j4.538 92 Ο…

A:

Q: (3) Det. VBB to ensure that transistor is saturated. Let Re-100k2, Re-3k2, Vcc=+10V, B=100 and…

A:

Q: Determine Vs for the network. RB 470 ΚΩ G B Rc Rs C - 16 V 3,6 ΚΩ S D. E VD B=80 DSS = 8 mA Vp = -4…

A: In this question We need to determine the value of voltage Vs  We know drain current ID = IDSS…

Q: 5. A single phase full converter connected to 230V, 50Hz is feeding a load R=1002 in series with…

A: Given data, single phase full converter , Vrms=230Vm=2302 RL load ,  R=10 Ω Firing angle, α=45∘

Q: What if power is transmitted to everyone at 200 V instead of using a 9,000 V transmission line? By…

A:

Q: You have been hired by a company to connect an outside lighting system to a panel box located 55 ft…

A: Given Length, L=55 ft P =20 kW V= 240 V Conductor = copper type of insulation =THWN 2 continuous…

Q: Determine Vs for the network. RB 470 ΚΩ G B Rc Rs C - 16 V 3,6 ΚΩ S D. E VD B=80 DSS = 8 mA Vp = -4…

A:

Q: 1) Consider the circuit below where the drain current through M1, M2, and M3 is designed to be 1mA.…

A: We need to find out the W/L ratio and voltage for given circuit .

Q: How did you get 1/2 & 1/3?

A:

Q: 1. Find the transfer function and the corresponding poles for the following state-space system: [8…

A:

Q: Determine the suitable unit protection scheme for the following faults/probems: Fault Inter-turn…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Y(s) Find the transfer function for the systems represented by the block diagrams below. Do this by…

A: The given block diagram can be reduced by considering the series and parallel connected block…

Q: 2.19 From the circuit in Fig. 2.83, find I, the power dissipated by the resistor, and the power…

A:

Q: Consider the circuit in (Figure 1). Suppose that vs = 26V. Figure Vs 6Ω www 12 Ω 4ΩΣ 9Ω ww 752 Part…

A: By combining the resistors in series and parallel calculate equivalent resistance of 4, 9 , 7 ohms…

Q: Find the steady-state difference between the input f (t) and the response x(t), if f (t) = 6t. ẍ +…

A:

Q: In Fig. A10, the current I is: 2 A 9 A 4 A 5 A 6 A 4

A:

Q: An energy meter connected to an immersion heater (resistive) operating on an AC 230 V, 50 Hz , AC…

A: Given: Immersion heater operating on 230V, 50Hz. Single phase source is 2.3units in 1 hour. To find:…

Q: Determine current I in the circuit below. VS1-12 V.VS2-5 V, IS1-6 mA, IS2-1 mA, Is3-6 mA, R₁-3…

A:

Q: (a) Consider the circuit shown in Fig. 22(a). 10A 552 I Fig. 22(a) (i) Write down the node-voltage…

A:

Q: • Draw the circuit diagram to implement the expression x= (A+B+CB + CD)

A: It is given that: x=A+B+CB¯+CD

Q: 3. A single phase half-wave converter is operated from 230V, 50 Hz source and the load R=1202. For a…

A: Given data Supply voltage, Vrms=230 V Supply Frequency, f=50 Hz Resistance, R=12 Ω Firing angle,…

Q: (a) Find Vy in the network below. V + - 10 ΚΩ 25 V + V₁ ww 5 ΚΩ +1 4

A: In this question We need to determine the value of voltage V1.  We are solving this problem using…

Q: Figure P.2.7-4 2.7-4 For each of the periodic signals shown in Fig. P2.7-4, find the exponential…

A:

Q: 3. Use Venn diagrams to prove whether or not x(y + 2) = xy + xyz.

A: The venn diagram is solved below.

Q: A series RLC network has R = 1.5 kQ, L = 50 mH, and C= 1 microF. Calculate the impedance (in ko) at…

A: Resonance is the condition at which the impedance of the capacitor is equal to the impedance of the…

Q: Question 3 From the convolution of the sequences, what is term at n = -1 (Hint: use ^ raise to and w…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.