Answered: A 5 kW 125 V shunt generator operates…

A 5 kW 125 V shunt generator operates at 1800 r/min If the field current is 1.8 A and the armature resistance is 0.5 Q find the generated voltage.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.29P

See similar textbooks

Related questions

Q: a question by considering the annual load time curve for an electric station as a straight line from…

A: Total capacity of Substation is the sum of power rating of each plant connected to that Substation…

Q: V₁ 12 mV R₁ RF1 A R₂ M R3 www V₂ 18 mV RF2 V₂

A: it is asked to find the value of Vo in given op-amp circuit

Q: 24 V 3Ω 1=0 4Ω 4Η at t=1 stored energy in inductance? 8 Ω

A: Given circuit diagram is,

Q: C Solve where C=15235° and D=3/50°. D

A: It is given that:

Q: Problems 9-11: Please refer to the system below G(S) R(s)- 5 (s + 10) (s+5) →→→Y(s)

Q: 8. A 10 power transformer supplies a load 8 kW of power at a power factor of 0.77 lagging at full…

Q: Identify the correct transfer function H(s): V₁ L C ww R V₂ = of the circuit shown in the figure.

Q: In the given system; Va, Vb, Vc effective value is 220V, Ly=300 mH and Ry=22 Ohms. It was observed…

A: Given data:RMS value of Supply voltage Vs=220VThree-phase half-bridge rectifierRY = 22 OhmsLy = 0.3…

Q: + Vs Z1 1:2 Z2 Z3

Q: The switch in Figure opens at t = 0. Find v, for t>0 2 ΚΩ ww 6 V (+ +501 Vo t=0 www 4 ΚΩ 3 mF

A: Circuit is given as,Switch opens at .

Q: What is the equivalent resistance in kOhm if three resistors of 4.3 kOhm, 1.4 kOhm, and 2.2 kOhm are…

A: Resistances are given,

Q: The switch in the circuit shown has been closed for a long time before it is opened at t = 0. 6V R₁…

A: Given:A circuit,To find:The current through the inductor I(0) at t=0 if the switch in the circuit…

Q: A heater with a rating of 10W, with an applied voltage of 46V, has a resistance of Q. (Give the…

A: Time rate of change of charge is called electric current. Ohm's law states that voltage across…

Q: Q1) A) negative feedback system has a loop transfer function L(s) = K (s+2)/(s²+4s +9) (25 (a) Find…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: AC electric field between +40 to -40 kV/cm is applied to an unpolarized ferroelectric material whose…

A: Ferroelectric materials are a class of dielectric materials that exhibit spontaneous electric…

Q: A periodic signal X(t) has the density spectrum) X (w) = S(w+4) + 28 (w + 3) + 28 (w-3) + S(w-4).…

A: The above question is based on the Fourier transform of continuous signals.The Fourier transform of…

Q: ▪ Determine the maximum and minimum frequency of oscillations of a Wien Bridge Oscillator circuit…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Which of the following liquids has highest breakdown strenght? A. Mineral Oils B. Silicone Oils C.…

A: Breakdown strength refers to the ability of a liquid to withstand high electric field strength…

Q: Question 6: a) Find the closed loop transfer function:... b) Determine the range of k. c) what is…

A: Solution:Given Data:Find:here find Steady state Errors at K=22 When r(t)=1.5tu(t)Step input is…

Q: C.13 Indicate whether the following statements are correct or not then correct the incorrect…

A: C.13 Indicate whether the following statements are correct or not then correct the incorrect…

Q: 4) Assuming perfect symmetry and VA <∞o, calculate the voltage gain of the amplifier below left.

Q: QUESTION B A long vertical wire le partially placed in a uniform magnetic field B-53 mT. The B-field…

Q: A lossless single phase inverter is connected to AC bus. The real power of AC load is 20 kW and the…

A: Real AC power of the load is kW.The efficiency of inverter is.The decoupling reactance is ohm.The…

Q: 1. PV systems with reference to the PV system diagram explain the operation of the control systems

A: The given diagram of the PV system is shown below.We need to explain the operation of the control…

Q: capacitor current,

Q: Questions in the Operations Amplifier Q1- Calculate the output voltage (Vout). Rf Vout Vin Ri = Av=-…

Q: A 10-ohm resistor and a 40-ohm resistor are in parallel, and the combination is in series with a…

A: Given dataThe parallel resistors are and .The series resistor is .The supply voltage is .To find…

Q: 1. Let J=-10^-4 (ya(x) + xa(y)) A/m^2 Find the current (I) that crosses the plane y = 0 in the -a(y)…

A: Current density

Q: Equal but opposite currents / travel in the inner and outer wires of a coaxial cable. As a function…

Q: The state transition diagram for the logic circuit shown is 5 (C) A=1 Q=0 A=0 Q=0 A=1 A=0 A=1 D CLK…

Q: A = BC + DE +F) X÷0 Q2. Use a Karnaugh map to minimize the following SOP expression: 1. ABCD - ABCT)…

Q: 12 V + i(t) www elle Xt=o 0 0.75 H 3N 3 Ω

A: Inductor doesn't change current flowing through it instantly It behave as open circuit at starting…

Q: Shunt aumeter has a PMMC instrument with an internal resistance of 990 and Full scale deflection…

A: Shunt ammeter has PMMC instrument internal resistance =99 ohm ,shunt resistance=1 ohm, We need to…

Q: please solve question number 2,3,4,5

A: Step-2->

Q: 7 mA (4 900 Ω . 3 μF Χο t=0 1 ΚΩ t=0 1 mA

Q: Assuming silicon with completely ionized dopants, compute n and p for the following case.…

A: It is given that:

Q: ▪ An ac amplifier has a midband voltage gain of 200. If the cutoff frequencies are fl= 20 Hz and f2…

A: 1) An ac amplifier has a mid band voltage gain of 200. If the cutoff frequencies are , To find the…

Q: A ruby laser contains a crystal of length 4 cm with a refractive index of 1.78. The peak emission…

A: L=4 cm=0.04 m,n=1.78,λ= 0.55 μm

Q: What is the advantage and disadvantages Static and Dynamic characteristic of measuring instruments.…

A: Step-1->Static and dynamic characteristics are two important aspects of measuring instruments.…

Q: QA- Three arms of Wheatstone bridge have resistance of 1000, and the fourth arm 1010 A galvanometer…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: Post a reason why hydropower might NOT be a viable energy resource in some cases.

A: We need to explain why hydropower might not be a viable energy resource in some cases.

Q: When computing values of voltage and current for a three-phase transformer, should the line values…

A: When computing values of voltage and current for a three-phase transformer, should the line values…

Q: A current of i= -6 + 8 √2 sin (wt + 30) is passed through a centre zero PMMC meter and a moving iron…

A: A current signal:Passed through PMMC meter and moving iron meter.

Q: FOR THE GIVEN SIGNALS( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOT

A: x(t) = e-3t cos 4t u(t) y(t) = e-3t sin 4t u(t) As given x(t) and y(t) it is known that the Laplace…

Q: The op-amp in the following circuit is ideal Calculate V, if V₂=1V and v₂=0V

A: It is given that:

Q: Impulse response of a discrete time system h[n] and an input x[n] has been given for a linear shift…

A: given signals are to plot the sequence and find the convolution of the…

Q: In the circuit in the figure, R = 3.8 kQ, R₁ = 82 km, R₂ = 22 kn, Rc = 5.6 kQ, R = 1.5 KQ and R₁ =…

Q: A) State superposition theorem. B) Use superposition to determine the current i2 if vs=10V, is=2A,…

Q: a) To the non-inverting input of an opamp v=5sin(wt) a.c. voltage is applied. Plot this Opamp by…

Q: in the yo area: μ=4x10-6 H/m and B= 2â -3â, +â¸ mT. in the yo area: µ= 7x10-6 H/m and Since it is J…

Question

...dc motor...please...

A 5 kW 125 V shunt generator operates at 1800
r/min If the field current is 1.8 A and the armature
resistance is 0.5 Q find the generated voltage.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation :

VIEW

Step 3: Calculation of generated voltage :

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A 230V, 50Hz single phase motor takes 70A and operates at a power factor 0.75 lagging. If a capacitor of 160uF is connected in parallel with the motor. Find the new current and new power factor.
A shunt generator with a capacity of 200 kW and a voltage of 220 V has a shunt field resistance of 50 and constant losses of 1500 watts. Calculate the half load efficiency if the full load efficiency is 88 percent.
21 In a DC generator, if the core loss constant and the copper loss is increasing, then the efficiency will be maximum. Select one: True False
A 30kW series generator has an efficiency of 88% when operating at rated load. If the stray power loss is 15%of the full load losses, calculate the maximum efficiency of the generator. Assume that the stray power loss isconstant and the other losses vary as the square of the load,
The ohmmeter registers the value of the resistances as follows: Ra= 0.02 ohms; Rf= 80 ohms; Rse=0.03 ohms. The emf induced by the generator is 510 V while the terminal voltage is 500 V. Determine the load current delivered assuming that the generator is a short shunt compound generator.
A 25cps single-phase, 8-pole, alternator with 725 mWb flux per pole has 288 slots. The machine coil has 2 turns per coil. In the winding of the armature, the ratio between the chording angle to the fractional pitch is 1/8. Find the voltage between two terminals.
Since the generated power at 4% slip in a 3-phase induction motor is 15 kW, which of the following is the rotor copper loss? a.600 Wattb.700 Wattc.675 Wattd.625 Watte.650 Watt
An 8-pole lap-wound d.c. generator has 120 slots having 4 conductors perslot. If each conductor can carry 250 A and if flux/pole is 0.05 Wb,calculate the speed of the generator for giving 240 V on open circuit. Ifthe voltage drops to 220 V on full load, find the rated output of themachine.
A 25-kW shunt generator is delivering full output to 400-V bus-bars and is driven at 950 r.p.m. by beltdrive. The belt breaks suddenly but the machine continues to run as a motor taking 25 kW from the busbars.
A 25kW series generator has an efficiency of 85% when operating at ratedload. If the stray power loss is 20% of the full load loss, calculate theefficiency of the generator when it is delivering a load of 15kW.
c) Compute the no load line voltage of a star connected 4-pole alternator for the following data:• Flux per pole = 0.12 weber• Slots per pole per phase =4• Conductors/slot = 4• Two layer winding, with coil span = 1500