Answered: A 98% efficient ESP follows the Deutsch…

A 98% efficient ESP follows the Deutsch equation. If the gm flow rate changes and the efficiency drops to 94%, calculate the ratio of the new gas flow rate to the old gas flow rate,

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter3: Fossil Fuel Resources And Use

Section: Chapter Questions

Problem 20P

See similar textbooks

Related questions

Q: MA VA W Ve M₂

Q: 2. What is the moment of Inertia of the following cross section. Please give the moment of inertia…

Q: maximum height (in m, round off to two decimal places) reached by the stream above

A: Given, Velocity of a water stream is,V= 50 m/s Angle above the horizontal,θ=450Acceleration,a=9.81…

Q: What is the double differencing technique?

A: Whenever two types pf single differences are coinciding, that makes up the double difference in the…

Q: What are point positioning equations?

A: Point positioning are used for positioning with GPS. In point positioning, a GPS receiver which…

Q: Constant

Q: 24.01 Stresses in a Soil Mass For the state of stress as shown, determine the inclination of minor…

A: Draw the Mohr's circle corresponding to the given state of stress. The angle required can then be…

Q: (c)

A: For truss SI=m+r-2jm==membersj=jointsR=reactions

Q: Find reactions first then make a shear and moment diagram (no integration).

Q: A strip footing is resting on the ground surface of a pure clay bed having an undrained cohesion c.…

A: Bearing capacity of soil is defined as the capacity of soil to support the applied loads over the…

Q: What is the difference between earthquake magnitude and earthquake intensity? Also how is the…

A: Earthquake Magnitude- Earthquake magnitude measure the size of earthquake . Magnitude remains…

Q: The centre of gravity of a (10x×15×5) cm³ T-section from bottom will be 10 cm ㅓ 5 cm 5 15 cm

Q: Calculate the total collection area for a 98% efficient ESP that is treating 10,450 m2/min of air.…

A: Q=10450 m3/min w=6m/min To find collection area of ESP

Q: For the given vectors V₁ and V₂, determine V₁ + V2, V₁ Assume V₁ = 12, V₂ = 17, a = 2, b = 3,0 = 25°…

A: as per our guidelines we slove only 3 subpart

Q: How about force in member GF

Q: In a stream line steady flow, two points A and B on a stream line are 1 m apart and the flow…

A: Given- Velocities-VA=2 m/s,VB=5 m/s,distance-s= 1 m, It is needed to find the acceleration of the…

Q: 50KN A M = 60kN.m 3.0m B 10kN/m 6.0m C COLL

Q: 16. Determine the angle 0 for which the uniform bar of length L and weight W will be in equilibrium.…

Q: Problem 3. Calculate the maximum depth, h, behind the concrete dam below that maintains a factor of…

Q: Problem. An 8-meter simply supported beam is loaded with concentrated loads as shown. If the weight…

Q: 1. Two plates each with thickness 7=160mm are bolted together with 6-22 mm dia. bolts forming Bolt…

A: Given: t = 16 mm db = 22 mm dbo = 22+2=24 mm s1 = 40 mm, s2 = 80 mm, s3 = 100 mm d = 25 mm fu = 483…

Q: What is meant by relative positioning?

A: In geography, a coordinate system is one that uses a predetermined set of integers to identify each…

Q: An airport has 4 gates which are available for all the aircraft it serves, an aircraft having…

A: Given- Number of gates G = 4, Average gate occupancy time T = 42 minutes. Utilization factor V =…

Q: A solid circular shaft of diameter 100 mm is subjected to an axial stress of 50 MPa. It is further…

A: Given- dia d=100 mm,σx=50 MPa,σy=0,T=10 kN-m=10×106 N-mm. It is needed to find the maximum principal…

Q: The gradient for a B.G railway line such that the grade resistance together with curve resistance…

A: given- degree D=4o,ruling gradient= 1 in 150,

Q: Investigate the flexural adequacy of the beam sections of figures 1 and 2 to carry the given loads…

A: Solution:-The given diagram is shown below, To Determine.To Investigate the flexural adequancy of…

Q: What will be the required number of sleepers for 2 cm railway track, if sleeper density is (M + 5)…

A: Given data: A 2 cm railway track. Sleeper density = M + 5 Length of one rail, M = 13 m

Q: Q.21 A shaft is made up of partly solid section and partly hollow section as shown as figure. b b…

Q: 1. Find the stresses members AB and AF. Also find the change in length of each member if both are…

Q: O Calculate Lateral movement and Maximum moment of a 12" by 12" precast concrete single pile which…

A: Given: ϕ = 32o B = 12 in For sand: λ=1 For square section: R1 = 1.7 ε50=0.002

Q: A soil sample has a moist unit weight of 18.02 KN/m^3 and a water content of 22.50 %. Determine the…

Q: 15. Compute the reaction forces at the supports. Ans. RA= 2121.32lb up left, RE = 6500lb up 1500 lb…

A: Given:- A truss is loaded with point loads The magnitude of the vertical load = 8000 lb The…

Q: HAMMA A steel bar 100 mm long is subjected to a tensile stress o. If change in length of bar is 0.05…

Q: 13) A subgrade is ready for finishing when the slopes have been trimmed and compacted and the…

A: Answer - Geotextile has been placed onto the soil surface.

Q: A 100 mm concrete wall is to be used to make a cold storage. The floor and ceiling is to use the…

A: Solution:-

Q: Problem 3. Calculate the maximum depth, h, behind the concrete dam below that maintains a factor of…

Q: List the Dilution Of Precision (DOP) factors the are mostly concerned by surveyors?

A: The phrase "dilution of precision" (DOP) is employed in satellite tracking and geomatics technology…

Q: Derive an expression for the maximum value of deflection for the simply supported beam

A: Given:A simply supported beam carrying concentrated load at a distance 'a' from hinge support and b…

Q: The system in Fig. 1 is in equilibrium with the string in the center exactly horizontal. Find (a)…

A: To find out the tension in T1, T2 , T3 and also find out the θ.

Q: 3. The average rainfall rate in a watershed with an area of 50 mi² in the upstate of South Carolina…

A: Given that, Watershed area = 50 square miles Average rainfall= 62 inches/year Average stream…

Q: 11.89 A ball is thrown so that the motion is defined by the equations x = 5t and y = 2 + 6t - 4.912,…

Q: What is a geocentric coordinate system?

A: to know about geocentric coordinate system

Q: For the beam shown in Fig. (5) construct the influence line for the shear force at C and moment at…

Q: PACES ALONG LINE AB WHOSE BEARING IS S 18 E AND MAKES 1520 PACES ON LINE BC WHOSE BEARING IS N 82 W,…

Q: Using double integration method derive an expression for the maximum value of deflection for the…

Q: Find the angle through which this conduit has been bent.

A: Given conduit: We need to find the angle theta.

Q: 10. A beam is loaded and supported as shown. Determine the components of the reactions at supports A…

Q: Q for the shown in Fig (5), find the force in members "a and b" using approximate analysis. 20N A…

Q: Re 53.3 P

Q: The gradient for a B.G. railway line such that grade resistance together with the curve resistance…

A: GIVEN :- Degree of curve = 4° Rolling gradient = 1/250 Broad Gauge railway line TO DETERMINE :-…

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

A 98% efficient ESP follows the Deutsch equation. If the gm flow rate changes and the efficiency drops to 94%, calculate the ratio of the new gas flow rate to the old gas flow rate,

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A certain gas initially at 0.050 L undergoes expansion until its volume is 0.50 L. Calculate the work done (in joules) by the gas if it expands (a) against a vacuum and (b) against a constant pressure of 0.20 atm. (The conversion factor is 1 L ⋅ atm = 101.3 J.)
A storage vessel for gasoline (sg=0.68) is a vertical cylinder 1.5 ft in diameter. If it is filled to a depth of 37 inches, calculate the weight of the gasoline in pounds.
A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 Nper cubic meter enters the bottom of the tank with a uniform velocity of—assume values with decimals between 3 to 4 m per second—enters thestack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Please add the figure , thank you!
Determine the amount of coagulant required per day (kg/day).• Assume that the optimum dosage of alum at 25 mg/L was used and that the density of alum was 600kg/m3, Power = 1736.3 watt, Volume= 10.83 m^3 , water temperature is 20 oC, and velocity Gradient is 400 1/s.• Amount of alum = ? (kg/month)• Volume of alum = ? (m3/month)
You have been contracted to determine the characteristics of raw water at 20°C. You complete a chlorine dosing experiment to aid in designing your chlorination process (Figure Below).a. What is the breakpoint chlorine dosage?b. What is the chlorine demand at a chlorine dosage of 1.2 mg/L?c. For a plant that processes 10 m3/hr, how much chlorine should I add per day to reach a constant residual chlorine concentration of 0.7 mg/ld. Design a chlorine contact tank that would achieve the required Ct value for a 3 log deactivation of Girardia (Ct = 54 mg/l min).
Dusty air at a fertilizer plant flows through a 70%-efficient cyclone and then through an ESP. The inlet air to the cyclone has a dust loading of 50 grains/cubic foot. The outlet air from the ESP actually contains dust at 0.50 grains/cubic foot. Calculate the efficiency of the ESP.
A volumetric tank 1.20 m in diameter and 1.50 m high was filled with oil in 16 minutes and 32.4 seconds. What is the average discharge? a. 100.5 L/min b. 102.5 L/min c. 103.6 L/min d. 108.7 L/min
A sample of gas occupies 3.75 L at 1.15 atm and 25 °C. At what temperature will it occupy 4.00 L at 1.00 atm? Initial: Final: Effect:
V.3 Q4. A municipal wastewater treatment plant has an aeration basin that is 1000 m3 in volume, with a mixed liquor suspended solids (MLSS) of 2000mg/L . If the mass of BOD5 entering the aeration basin each day is 1100 pounds and the VM ratio is 0.65 , what is the F:M ratio? (Answer F:M ratio is 0.38)
A cylindrical tank 3 m long and 2 m diameter is used for oil storage. How many days can the tank supply the engine having a calorific value of 44 899.2 kJ / kg and a consumption of 60 kg / hr?
You are treating 10 million gallons per day (MGD) of water with alum at a dosage of 50.0 mg/L. Alum is available as a hydrated salt Al2(SO4)3.16H2O. Determine:(a) The monthly alum dosage required in metric tons/month (1 metric ton = 1000 kg)(b) If you assume that each equivalent of alum added to the water consumes 1 equivalent of alkalinity, determine the alkalinity consumed by alum addition in milliequivalents/L (meq/L)(c) Given that the raw water contained 30 mg/L as CaCO3 of alkalinity, is the alkalinity sufficient? What would happen if the alkalinity is inadequate?
The figure below shows a pump delivering 0.014 m3/s of crude oil (SG = 0.85) from an underground storage drum to the first stage of a processing system. (a) If the total energy loss in the system is , calculate the power added by the pump in kW. (b) If the power input to the pump is 16.5 kW, what is the mechanical efficiency of the pump?