A az /B

Q: If the datum is located at the leading edge of the wing and the weighing point is at the landing gea...

A: given data; If the datum is located at the leading edge of the wing and the weighing point is at the...

Q: Consider a spring mass fldamper syatem with the parameters m= 100 kg c= 20kg/s k= 1000 N/m It is kno...

A: Given: m=100 Kgc=20 Kg/sK=1000 N/mF0=500 Nt= 20 ms

Q: Assuming clockwise moments as positive, compute the moment of force P=361lb about points A, B, C and...

A: Given data: P=361 lb Need to determine the moment about the points A, B, C and D.

Q: The uniform rectangular panel ABCD has a mass of 33 kg and is hinged at its corners A and B to the f...

A: Given Mass = 33 kg To find Magnitude of T and B  

Q: Given the force in spring AD (150N), final length of spring EC (0.8m), spring constant k = 9 N/cm, a...

A:

Q: Given the distributed loads, determine the reaction force at point A. Fi = 20 kN/m %3D F = 31 kN/m A...

A: Given data: F1=20 kN/mF2=31 kN/m Need to determine the reaction force at A.

Q: A gas turbine uses two compression and two expansion stages, each stage having a pressure ratió of 4...

A: Given data,   Pressure ratio-4 Air enters the turbine at 100KPa and at a temperature 17° degree We h...

Q: Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is...

A: Given: To determine the moment about Point O.

Q: A 600mm diameter pipeline (A) conveying water splits into two smaller pipelines (B) and (C), 375mm a...

A: The flow rate (QA) in pipe A is - QA = π4×0.62×2QA =0.565 m3s QA =QB +QC let QC = Q , then QB = 2QQA...

Q: The maximum force in a rivet in a riveting group under eccentric loading

A: Given: The maximum force in a rivet in a riveting group under eccentric loading

Q: The homogeneous 300-kg cylinder is pulled over the 100-mm step by the horizontal force P. Find the s...

A:

Q: INDICATE THE CORRECT MISSING VIEW THAT WILL COMPLETE AN ACCURATE ORTHOGRAPHIC REPRESENTATION OF THE ...

A:

Q: 2. The shear stress developed in lubricating oil, of viscosity 9.81 poise, filled between two parall...

A: Given, Oil viscosity = μ = 9.81 poise = 0.981 Pa-s Distance between parallel plates = dy = 1 cm = 0....

Q: 2. A thin, homogeneous perimeter of the figure shown to the left. Locate the center of gravity of th...

A:

Q: 60 kN 40 kN 50 kN D. E B |C -1.5 m--1.5 m--1.5 m--2 m - FIG. P4.26

A: Given:- Simply Support beam To Draw :- SFD and BMD 

Q: 4. Determine the moment of the force [-600i+200j-300k]N about the line AB, that tends to rotate the ...

A: The force vector is

Q: 2. Below is shown a cantilever with load also shown in the diagram. It is supported at A and B throu...

A:

Q: 3. The two-dimensional velocity field in a fluid is given by V 2ri+ 3ytj. (i) Obtain a parametric = ...

A:

Q: A two stage cascade refrigeration system uses R-12 in the high pressure loop with a condenser temper...

A:

Q: Problem # 3. Determine the force in each member of the truss and state if the members are in tension...

A:

Q: Determine the reactions at the pin support and the applied moment if the bar of Figure 3 has a mass ...

A:

Q: A defibrillator passes a brief burst of current through the heart to restore normal beating. In one ...

A: Given:C=36.4 μFVo=6 kVt=1 msR=240 Ω

Q: coupte acting on the pipe

A: moment of couple -the result of multiplying either of a couple's forces by the perpendicular distanc...

Q: Water is being cooledd in a closed container while being stirred by a paddle wheel. During this proc...

A:

Q: Determine the moment of the couple acting on

A: given:

Q: water plpellne a where: a = 12" b = 3.2' C = 4.0' d = 12" mercury density (16 300 kg/m?) water pipel...

A: Given :-  Differential manometer To Find:- Pressure difference between ‘m’ and ‘n’       

Q: Water at 20°C flows steadily through the box as shown in the figure, entering station 1 at 2 m/s. NO...

A: Given: V1 = 2m/s D1  = 5 cm D2 = 3 cm

Q: Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is ...

A: Given: To determine the moment about Point A.

Q: Problem I From the pigure, F, 108N , Fe= 35KN 6 m Find the Resultant of the Forces Find the moment a...

A:

Q: 9. When a dolphin glides through air, it experiences an external pressure of 0.75 m of mercury. The ...

A: When dolphin glides through air, it will experience atmoshpheric pressure. Hence, we are given atmos...

Q: Having the coefficient of frictions (μs = 0.40 and μk = 0.30), Determine whether the block is in equ...

A:

Q: A rectangular plate 1.1m x 1.75m is submerged in water and makes an angle of 30° with the horizontal...

A: Solution:

Q: i. 10hp engine is equivalent to. Ans. 7.46 kW ii. 20 hp engine is equal to. Ans. 1522.45 kg-m/sec

A: To find : i. 10 hp engine is equivalent to KW ii. 20 hp engine is equal to kg-m/sec  

Q: 2.22 Consider à ône fect gas with friction. Air enters a circular duct of diameter at Mach 0.5 and a...

A:

Q: Q 1(c): Consider a case in which the air inside the pressurized cabin of a jet transport flying at s...

A: given; ⇒pressure (P)=0.9atm                       =0.9*101.25KPa                       =91.125KPa⇒⇒(...

Q: If the atmospheric pressure is 1.01325 bar, what will be the height of the mercury column in a barom...

A:

Q: Using the skew-t diagram, calculate the relative humidity for two air parcels at two different press...

A: Relative Humidity (RH) is defined as the ratio of partial pressure of water vapour, in a mixture to ...

Q: pherical pressure vessel designed using steel nches, allowable yield stress of 50000psi, mo f0.25. c...

A:

Q: P1-23 A horizontal rigid bar ABCD shown in Fig.Pl-23 is hinged at A and supported by steel wires BE ...

A: In this question we need to calculate tension in each steel wire and deflection at point D

Q: A spherical gas tank has an inner radius of r = 1.5m, if it subjected to an internal pressure of p =...

A: r=1.5m Ap=300kPa

Q: Calculate the specific weight, specific mass, specific volume and specific gravity of a liquid havin...

A: Given:Volume,V= 6 m3weight= 44 KN

Q: 2000 Ib 2000 Ib 250 lb/ft D 16 ft - FIG. P4.28

A:

Q: pipe carries deion is capped (Figure ed to the end of t

A: given:pressure P=50psid=0.75int=0.5in

Q: Item 2 B 200 WA-300b 2. The body starts from rest in the position shown. Determine its velocity afte...

A:

Q: A hydraulic motor is directly coupled to the drum of a belt conveyor. The drum diameter is 0.75 m, t...

A:

Q: A diesel engine four-stroke cycle with three cylinders has a cylinder bore of 89 mm and a stroke of ...

A: Given data,  diesel engine four-stroke cycle , bore d= 89 mm  stroke L= 130 mm The compression ratio...

Q: 1. Condensation streams through an outlet at a mass movement rate of m3D0.2kg/s with a heat loss of ...

A:

Q: (ANS: -130) Ibft) 7. Determine the moment of the couple acting on the pipe assembly. 25 b 6in

A: Given answer should be in lb.-in because in figure all units are in lb. and in. It cannot be lb-ft. ...

Q: 11.21 A concentric tube heat exchanger for cooling lubricating oil is comprised of a thin-walled inn...

A:

Q: Sketch the following  Isometric view  Orthographic  Top view  Right Side view  Front view

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional. ...