A balanced three-phase source supplies a balanced delta load having 39 angle -40° Q per phase. The wire connecting the load and the source has a 4 Q resistance each. If the line voltage is 480 V-rms, find the magnitude of the line current.

Q: 2. R,=_Q R, = 50 n R2 = 50 kn

A:

Q: 3. Determine the kind of damping and the value of q for the arrow refers to number #1 in the figure ...

A: The above response is equivalent to mechanical response of spring mass system stretched from a dista...

Q: Which part of a DC Machine that produces the magnetic flux when the field winding is excited? a. Yok...

A:

Q: Consider the elrouit below, given that Z1 is a 2H inductor, 22 is aBohm resistor, 23 is a 12 ohm res...

A:

Q: 3 In the voltage-divider circuit shown in Fig. P3.13, find the voltage v, for R2 = 10 N. Also find t...

A: Apply nodal analysis in each case and find the output voltage Vo. According to kcl , sum of the curr...

Q: reactive power must this capacitor

A: Capacitor- This circuit element absorbs lagging power from the source or we can also that it deliver...

Q: What is the name of the gadget that can determine the distance between a cable's damage and where it...

A: Name of the gadget which is used for finding the cable damage and its location is "Cable Fault Locat...

Q: 57. A 2200/200 V transformer has a primary resistance of 2.4 2 and secondary resistance of 0.02 Q. W...

A:

Q: The diode starts to conduct when the voltage across it is 0.6 V. Vin is a variable DC voltage source...

A:

Q: 1. Design a capacitor set-up that can give at least 1 Farad. You can focus on the design by finding ...

A: Note: We are authorized to answer one question at a time since you have not mentioned which question...

Q: Find Vo in the network using Norton's Theorem. 220°A 1220°v (A 12 12 Ix 2Ix -j127 Vo

A:

Q: = 2 + j2 N, z, j3 2, = 4 E. = 24230° v, For the circuit below, = 10 j10 N, and Z, j12 N. Calculate 6...

A:

Q: EXERCIS E 5.9 Consider a family of logic gates that operates under the static 1.5 V, VOL discipline ...

A: Given,The thresholds voltages are,VIL=1.5 VVOL=0.5 VVIH=3.5 VVOH=4.4 V

Q: Problem 2 An AM signal has the form JaM(t) = [50 + 40 cos(1000rt)] cos(2nf.t) where f. = 5 kHz. (a) ...

A:

Q: Eddy currents can be induced only in metals that are not ferromagnetic, for example, copper and alum...

A: In this question,  We need to choose the given Statment is true or false?  Eddy currents can be indu...

Q: R Vin Vout KH 4V

A:

Q: Determine the maximum voltage that can be applied across the series combination of a 150 ohm, 2 watt...

A:

Q: 12.10 Draw the Bode plot for the nelwork function H(ja) = (jo + 1)(0.1jw + 1)

A: In this question,  We need to plot the bode plot.i.e magnitude plot and phase plot.   

Q: When a 71.09 Hz sinusoidal voltage is applied to the input of a half-wave rectifier, the output freq...

A: For a half-wave rectifier, the output frequency is equal to the input frequency.   For a full-wave r...

Q: A power station is to supply four (4) regions of loads whose peak values are 10 MW, 7.5 MW, 8 MW, an...

A:

Q: Draw a 2 bit counter that counts in the UP count sequence (00,01,10,11) employing NGT triggered RS f...

A: The two bit counter can be designed by using the excitation table and k map.

Q: 3.6 For each of the circuits shown in Fig. P3.4: a) Find the equivalent resistance seen by the sourc...

A: In these questions,  Find the equivalent resistances across the sources and find the power developed...

Q: 2. A short shunt compound generator has an armature, shunt field and series field resistances of 0.0...

A:

Q: Ro 3302 +. E lov Rz = 2202 Rie4ア

A:

Q: +Vcc RC Rg VE RE

A: We need to find out current and voltage for given circuit

Q: Directions. Solve the following problems. Show your complete solution. 1. What best describes the ci...

A:

Q: A long – shunt compound generator delivers a load current of 50A at 500V and has armature, series fi...

A: The solution is given below 

Q: (b) Find the Q-point (VcF,Ic) if given Boc =150 for the BJT circuit shown in Figure Q3(b). Vcc +10V ...

A: In this question,  We need to determine the Q point of the BJT.  If dc current gain = 150 Assume for...

Q: 220N + 330N 470 L R 91Ω ET 15 V Ern, RTh

A: Thevenin's Resistance   It is the open circuit resistance across the load when all the independent s...

Q: Example: Find the flux crossing the portion of the plane due to current filament of 25 Ampere along ...

A: We need to find flux Passing through the given surface for given current carrying wire

Q: EXPLAIN THE CIRCUIT AND IT'S APPLICATION IN ESSAY FORM

A: In this question, We need to explain the circuit and its application.  

Q: A balanced three-phase source having a line voltage of 208-V rms is supplying two parallel-connected...

A: The solution is given below

Q: The diode in the circuit is Silicon with a forward voltage of 0.65 V. Determine the value of vOUT if...

A: This question belongs to analog electronics . It is based on the concept of behaviour of silicon dio...

Q: Calculate the dc and ac resistances for the diode of Fig. 15 at a forward current of 10 mA and compa...

A:

Q: Digital multimeters in an AC mode measure average values of voltage and current. Select one: True F...

A: As we know that a digital multimeter can measure both dc and ac current.

Q: 3. A4-pole, 50-Hz induction motor has a full-load slip of 5%. Each rotor phase has a resistance of O...

A:

Q: A lottery system consists for 4 different numbers combination. Following are different winning combi...

A: The truth table can be obtained by considering the given three cases and make one for the eligible c...

Q: a) SkeTth r, u,, hっましん If the power sopplies are 10v. (6) what is the oscillation freauenng 1S Vo R....

A:

Q: O Determine the smallert height that an infinitertinal dipole must be ploce above PEC with null occu...

A: We need to determine the smallest height that an infinitesimal dipole must be placed above PEC with ...

Q: Use nodal analysis to solve the circuit complete soolution

A: In this question,  We need to determine the Use nodal analysis to solve the circuit.  We know I= V/Z...

Q: ЕСЕТ-3440 Homework 7 (Full AM) NOTE: Complete/Solve all following problems using paper/pencil. Make ...

A: As per company guidelines we can solve only first question kindly post another question separately 

Q: The trigger level for an input signal is set to 5V.  What is the voltage that will be seen at t= 0s ...

A: Digital oscilloscope is an electronic instruments which is having two axes. Horizontal and vertical ...

Q: An inverting summing amplifier has input resistors equal to 1 kn and a feedback resistor equal to 2 ...

A:

Q: 9. The effective voltage across a circuit element is (20 + j10)V and the effective current through t...

A:

Q: 5. R,=_Q R, = 1.2-kn R2 = 1.2 ko Rg =1.2 kn

A:

Q: The armature of a 6-pole separately excited dc generator is triplex wave wound with 534 conductors. ...

A:

Q: A three-phase motor takes 10 kVA at 0.6 lagging from a source of 230 volts. It is in parallel with a...

A: Find active and reactive power of each load then add individual active reactive power to get total a...

Q: The per-phase line loss in a 40 km long transmission line is not to exceed 60 kW while it is deliver...

A:

Q: 27. Determine the static or de resistance of the commercially

A: From data given forward current 4mA from figure the voltage VD=0.7v

Q: E, = 120/-30° and E, 120/30°, and 6. The following particulars are given for the T-network of Fig. 1...

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.