A boom hinged at the base of a vertical mast is used to lift a 2000 load. Find the tension in the cable and the reaction R the end of the boom. The angle of the boom is 40 degrees with the horizontal and the cable is 60 degrees with the vertical mast. Show complete solution including FBD

A boom hinged at the base of a vertical mast is used to lift a 2000 load. Find the tension in the cable and the reaction R the end of the boom. The angle of the boom is 40 degrees with the horizontal and the cable is 60 degrees with the vertical mast. Show complete solution including FBD

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.84P: The cable supports three 400-lb loads as shown. If the maximum allowable tension in the cable is 900...

See similar textbooks

Related questions

Q: Problem 6d: Find all forces acting on member ABC. The cylinder weighs 80 lb. 3 ft E 4 ft 1 ft A B 4…

A: Given data Weigh of the cylinder = 80 lb

Q: Sample Problem: Calculate the tension T in the cable which supports the 1000 tbload with the pulley…

A: Consider, Load =1000lb. We need to find the tension in cable which carries 1000 lb load and the…

Q: A simplified crane is shown in Figure 9 lifting a 400-kg load. The crane is supported by a pin joint…

A: given load weight = 400 kg crane is supported at A with a pin joint, so applying equilibrium…

Q: E Find the Reactions at pont A where the tensile force in cable CB is 300 KN. Neglect weight of AB.…

A: Consider the Free Body diagram:

Q: A man raises a 10-kg joist with a length of 4 m by pulling on a rope.Find the tension T in the rope…

A: Given Data: The mass of the joist is M = 10 kg. The length of the joist is L = 4 m. The tension in…

Q: Q4. A Cylinder 1m diameter and 10kg mass is lodged between cross pieces that makes an angle of 60o…

A: x= tanθ=0.5x=Rxx=0.5tanθx=0.5tan30°=0.866m∑Fy=0N1+N2=mgdue to symmentry N1=N2=mg2=50N…

Q: Find the Vertical and Horizontal Support Reaction at A

Q: Problem # A) Assuming it can ONLY take tension, find the Tension in the cable "AC“: B) Calculate the…

A: For the given figure To determine (a) tension in cable AC (b) Reaction at C and B

Q: A cylinder with a radius of 1.5 m and a weight of 40 kN is held by the rod AD. Find the force at CD…

A: The free-body diagram of the cylinder Applying equilibrium conditions: ∑Fy=0REcos300-40=0RE=46.188…

Q: Q5) for the equilibrium figure below if the tension in the cable AD and AC are 450 N and 60O N…

A: Given data: Tension in cable AD, TAD = 450 N. Tension in cable AC, TAC = 600 N. Draw a force…

Q: A uniform 0.40 kN boom is supported as shown. Find the tension in the tie rope and the components of…

A: Consider the free body diagram shown below for the given system.

Q: The cylinder C in the figure below weighs 1000lbs. Determine the tension in the cable , and the…

Q: An electric light fixture weighing 15 N hangs from a point C, by two strings AC and BC. AC is…

A: Given: The magnitude of the weight is W=15 N. The free-body diagram of the body is shown below,…

Q: Qg: If the weightless half- cylindrical gate, show in figure below, is in equilibrium, what is the…

A: Given data: The density of the fluid in the left part is, γ1 The density of the fluid in the right…

Q: In the figure below, the boom AC is supported in a ball and socket joint at C and by the cables AD…

Q: A) A mass of 15.0 kg 10 pc suspended by wires in two sides as shown in the figure. Find the tension…

A: Given : Mass = 15kg Acceleration due to gravity g = 10 m/s2 its weight = ( m * g) = 15*10=150 N we…

Q: A uniform brass plate with area of 18 m?, has weight of 51 kg which is hold by three cables in the…

Q: A boom hinged at the base of a vertical mast is used to lift a 2000 lb load. Find the tension in the…

Q: A bucket, weighing 375 N, is hung from strings CAD, BA and EA, as shown in the image. Determine the…

A: Given data, Weight of the bucket, W = 375 N Since, CAD is a single string. So, tension in CA and AD…

Q: Compute the forces in each member of the Warren Truss. What is the Reaction at A in Newton? * 2000 N…

Q: the roof truss in Fig. 3, is supported by a roller at A and B. Find the value of the reactions.

A: Solution:

Q: Q1/ A 30 kg mass is supported by cables as shown in figure bellow. determine tension in each cables.

A: Given: 30 kg mass To find: Tension in each cable.

Q: The frame below is used to support the distributed load as shown. 12) a) Find the reactions at C and…

A: Given data Given force system

Q: The homogeneous 200-lb sign is suspended from three wires. Find the tension in each wire.

A: Weight is 200lb sinθ=45 cosθ=35. ∑Fy=0 T1 is completely horizontal and Due to symmetry T2=100 lb…

Q: Assume all four objects attached to a string of length L are in equilibrium in the above figure.…

A: Draw the free-body diagram of the system. Consider joint 1, apply Lami's theorem to calculate…

Q: Q4) Calculate the force T in the cord at C needed to support the loaded truss. Also, find the forces…

A: The Joint Method. The joints technique is a methodology that is used to solve unknown forces…

Q: A crane boom which weighs 200 lbs and which is 10 feet long is supported so that it makes an angle…

A: Diagram Considering the FBD of whole from AB=10ft AO = ABsin40 = 10sin40 = 6.43 ft OB = ABcos40 =…

Q: Q4) Calculate the force T in the cord at C needed to support the loaded truss. Also, find the forces…

A: Force Force is vector quantity which has magnitude and direction. Force is a rate of change of…

Q: Draw F.B.D then find reactions at supports A and B take AB weight 25Kg

A: Given data; Mass of the rod AB, m = 25 kg. Draw a free-body diagram of the rod AB. Calculate the…

Q: Find the Reactions at point A where the tensile force in cable CB is 300 KN, 35 Neglect weight of…

Q: A rope extends between two poles. A 90 N boy hangs from it as shown in Fig. 1. Find the tensions in…

Q: Example: A 3000kg crate is being unloaded from a ship as shown in the following figure. A rope BC is…

Q: Find the smallest value of P for which the 400-lb crate in the figure below will be in equilibrium…

Q: For the rigid body below, Draw the Free Body Diagram and find the Reaction Force of pin support at…

A: Consider the free body diagram shown below for the truss.

Q: Q4 Find the reactions in supports 50 KN 20 kNm B D A 3 m 1.5 m

Q: in the figure shown weighs 420N an Lion in the cable and the reactions at t 420N G cable

Q: The knotted cords in the figure is in equilibrium. Find the tension in each cord that supports a…

A: Given data: The magnitude of the weight, FW = 800 N. Draw a free-body diagram of the bottom knot.…

Q: The pole is subjected to the two forces shown in Figure Ql. Determine the support reaction A with…

Q: Draw FBD (Free Body Diagram) of the structure shown in the figure below. What type of structure is…

A: FBD of the given structure can be drawn as below: Here, MA = Reaction moment at A VA = Vertical…

Q: Ecample The figure shows a laterally loaded beam which is supported by two rollers and in…

A: From the given information,

Q: A truck of mass 2 tonnes runs into a buffer stop having three buffer springs each of 10 kN/cm…

Q: Q3 Find the reactions in supports 40N/m 4m إضافة ملف

A: Find the reaction at fixed support

Q: necting W and point B passes over a frictionless pulleys. Fin Dlat noint A

A: given:

Q: The homogeneous 100-kg sign is suspended from three wires. Find the tension in each wire.

A: Given Mass = 100 kg To find Tension on the strings

Q: A beam has a pin support at A and a roller support at B. Given the load forces, find the support…

A: Given, The total length of the beam is 9 m.

Q: FIND THE PIN REACTION FORCES AT C

Q: Q4) Calculate the reactions at supports. 400 N/m 400 N /m

A: Given

Q: (a) Draw a FBD for the beam. (b) Find the tension in the cable. (c) What is the magnitude of the…

Q: A traffic light of mass 5 kg hangs from two lightweight cables, one on each side of the light. Each…

Question

Show complete solution including FBD.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Find the magnitude of the pin reaction at B caused by the weight W=80lb. Neglect the weights of the members.
The uniform bar of weight W is held in equilibrium by the couple C0. Find C0 in terms of W, L, and .
Compute the tension TAE in Sample Problem 5.7 using one scalar equilibrium equation.
In Sample Problem 5.4, determine the tension TAC using the equation MDB=0.
Compute the magnitude of the pin reaction at B. Neglect the weights of the structural members.
Given the T shaped structure show below, find the tension in cables BE and DG if the tension in cable CF is 120N.
The 400-kg precast concrete section is hoisted by a vertical force 'T' from a crane. Find the tension in cables AB, AC, AD.
A man raises a 10-kg joist with a length of 4 m by pulling on a rope.Find the tension T in the rope and the reaction at A.
the roof truss in Fig. 3, is supported by a roller at A and B. Find the value of the reactions.
A boom hinged at the base of a vertical mast is used to lift a 2000 lb load. Find the tension in the cable and the reaction R at the end of the boom. The angle of the boom is 40 degrees with the horizontal and the cable is 60 degrees with the vertical mast. Pls include given, formula, fbd, and solution.
The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached to the wall 3m above the foot of the boom. If the load lifted is 45000N, find the tension in the wire and the compression force in the boom Neglect the weight of the boom. May I also ask mam/sir for the Diagram and explanation?