A boy tossed the basketball at an angle of 28- degrees from the horizontal. The basketball is 1.4 m above the ground at the time of release and the basketball hoop is 9.4 m away and 3.9 m high. Neglecting the size of the ball in the calculation, determine the speed which the ball pass through the hoop.

A boy tossed the basketball at an angle of 28- degrees from the horizontal. The basketball is 1.4 m above the ground at the time of release and the basketball hoop is 9.4 m away and 3.9 m high. Neglecting the size of the ball in the calculation, determine the speed which the ball pass through the hoop.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 39P

See similar textbooks

Similar questions

the end of a cylindrical drum measures 30 inches in diameter. if the drum ,which measures 3 feet high,is completely filled with water , what'sthe total weight of the water in the drum?(assume water weighs 8 pounds per gallon.)
1. A 20lbm box is on an air balloon. The balloon has diameter of 10m with air with density of 0.04 lbm/ft3. Considering only the masses involved on this problem and buoyant force of the balloon, find the acceleration of the balloon in ft/s2. Sketch diagram and show pertinent solutions. Box your final answer and express numerical values in 2 decimal places.
1. In calibrating a 10-mL pipet, a measured volume of water was transferred to a tared flask and weighed, yielding a mass of 9.9814 g. (a) Calculate, with and without correcting for buoyancy, the volume of water delivered by the pipet. Assume that the density of water is 0.99707 g/cm3 and that the density of the weights is 8.40 g/cm3. (b) What are the absolute and relative errors introduced by failing to account for the effect of buoyancy? Is this a significant source of determinate error for the calibration of a pipet? Explain. 2. Repeat the questions in problem 1 for the case when a mass of 0.2500 g is measured for a solid that has a density of 2.50 g/cm3. 3. Is the failure to correct for buoyancy a constant or proportional source of determinate error?
A ball is thrown straight upward from the ground level. Its initial velocity is 30 m/s. 1. What is the maximum height it reaches in meters? a. 13.98 b. 45.87 c. 10.38 d. None of these 2. What is the total time in seconds when it goes back in the ground? a. 3 b. 6 c. 4 d. None of these
A rectangular tank 5m long, 2m wide and 2 m high is filled with water to a depth of 1.5m. It is mounted on a truck and accelerated along its length. If acceleration, a = 4m/s2, how much water will be spilled out? Do not write any unit in your answer, use 3 decimal places. Unit of Ans is m3
A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an orifice of diameter of 0.4 m at the bottom. Find the time for completely emptying the take Take Cd= 0.60 a.24.8 seconds b.47.8 seconds c.43.8 seconds d.84.7 seconds PLEASE INCLUDE FIGURE OR FBD
A liquid is flow throw Rotameter to a tank of size ( L x W x H ) and it is required to full the tank to level of H as shown in Figure . What time is required to full the tank by this liquid ? What time is required to drop the liquid in the tank to from level H to D by rectangular notch ?
Show complete solution. (2 decimal places) 2. Air is leaking from a spherical-shaped advertising balloon at the rate of 26 cubic feet per minute. Ifthe radius of the ball is 7 feet, how long would it take for the balloon to be fully emptied? 3. A hemisphere has a radius measurement of 8.3 cm. Find the surface area excluding the base.
Show complete solution. Units must be included in all calculations. All numerical values should be rounded off to the nearestthousandths. 2.If the velocity in a 12-in pipe is 1.65 ft/s, what is the velocity in a 3-in-diameter jet issuing from a nozzleattached to the pipe?
A stone was dropped from a balloon which is ascending at a rate of 6 m/s when the balloon was 70 m. above the ground. Which of the following gives the velocity of the stone after 3 seconds? b. Which of the following gives the time required for the stone to attain a downward velocity of 15 m/s.? How long did it take the stone to hit the ground?
a curious traveler asked this question on stack exchange: a flight from los angeles to albuquerque is about 2 hours but is approximately equal to 670.2miles. a flight from san jose to chicago is 4 hours but is approximately equal to 1859.0 miles. can anyone explain why the travel time from san jose to chicago is not longer and closer to 5.75 hours? if the distance increase by 2, shouldn't the time increase by a factor of 2 as well? a) write a linear model for this question. takeoff and landing will take a fixed amount of time. actual travel in the air will take time proportional to the distance traveled. identify the slope and intercept with their units. b) use the data in the quotation to estimate the two constants in your linear model.
Write your final answer in two decimal places in the unit of kN-m.