A cable lowers a 1050 kg elevator so that the elevator's speed increases from zero to 4.0 m/s in a vertical distance of 5.9 m. what is the force that the cable exerts on the elevator while lowering it? (Assume that the system is the elevator man)
Q: For a particle in a box of length L sketch the wavefunction corresponding to the state with n = 1 an...
A: ANSWER: The wavefunction for the one dimensional asymmetric potential well of length L is The corr...
Q: A horizontal force F pulls a 20-kg carton across the floor at constant speed. If the coefficient of ...
A: Given: The mass of the cartoon is m = 20 kg The distance the cartoon should move is d = 3 m The coef...
Q: A pion of positive electric charge (n*) and mass m, = 139,6 MeV/c², resting in the laboratory, decay...
A:
Q: The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached to...
A: Let R be defined as the compression force, and W be defined as the weight of the load. Then, R=tanθ
Q: One liter of crude oil weighs 9.6N.Calculate its density, specificweight and specific gravity a liqu...
A: Given: To find the density and weight with the given values as,
Q: 4.75 For the circuit in Fig. 4.141, determine the value of R such that the maximum power delivered t...
A: In the given circuit calculating the Thevenian voltage, Vth-1R+Vth-2R+Vth-3R=0⇒3VthR-6R=0⇒Vth=2V C...
Q: the x-axis at x = -3.0 m and x = 3.0 m. What charge q must be placed at the origin so that the elect...
A: Electric Field The electric field is a region around a charge or a group of charges that if a test c...
Q: An initially (t= 0) stationary 2.0 kg object accelerates horizontally and uniformly to a speed of 10...
A:
Q: What is the instrument used in Faraday’s experiment? a) Galvanometer b) Ammeter c) Voltmeter d) Mete...
A: A
Q: which component boosts the strength of the system in ultrasound
A: Given: A ways to boost the ultrasound as,
Q: Block "A" of weight 500 N is rests on wedge "B" of weight 200 N as shown in the figure. Knowing that...
A: Consider the following diagram,
Q: Consider the rotational kinematic motion profile indicated below. t: 0 → 5 s P = 6 deg/s , Q = 0 deg...
A: Given: The rotational kinematic motion profile t:0→5sP=6deg/s , Q=0deg/s , R=0deg/sΦ(0)= 0 deg/s ,...
Q: Identify the significance of energy consideration from the following. a) Energy consideration provid...
A: Answer: As per the given statement, Correct option: a) Energy consideration provides a link betw...
Q: Calculate the temperature, hydrostatic pressure, lithostatic pressure, and the effective pressure fo...
A: Given: Surface temperature Ts=600. Temperature gradient is ∆T=1.450F100 ft. Depth of the layer z=800...
Q: A point charge of Q located near an infinite, grounded conducting plane as shown in figure. Calculat...
A: Given data: Distance of charge Q from x=0 plane = d1. Distance of charge Q from y=0 plane = d2. Magn...
Q: Q5:- In the epicyclic gear train shown in the Fig. below the pinion B and the internal wheels E and ...
A: Given: the values are given in the question as follows: TB=15TC=30TD=25 let TE and TF be the numb...
Q: A mass A of 0.8 kg moving to the right with a speed of 5 m/s collides head-on with a mass B of 1.2 k...
A: in this given situation, linear momentum before and after collision will remain conserved as no exte...
Q: Q3 / The following relationship represents a particle path (r = i cos (wt) + 2j sin (wt) Find the an...
A: Given, the path is given as r=cosωti+2sinωtj
Q: P5555 Please solve Part(c). Note: 39.3 & 0.124 are proven to be wrong answers for part(c)
A: Given: The area of the parallel plate capacitor is 25 cm2. The distance between the plates is 1.41 c...
Q: In reference to the figure, the plank is uniform and weighs 500 N. How large must W be it T1 and T2 ...
A: From the given figure 2T1=500+W ⋯⋯1 Taking moment about the point 1 500×0.2 L+W×0.4 L=T1×0.4 L100+0....
Q: A potential difference of 75 mV exists between the inner and outer surfaces of a cell membrane. The ...
A: The work done to move a charge q through a potential difference of V is equal to the gain in potenti...
Q: A professor designing a class demonstration connects a parallel-plate capacitor to a battery, so tha...
A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...
Q: A 200-kg cart is pushed slowly up an incline. How much work does the pushing force do in moving the ...
A: The work done by a force on a system is equal to the change in mechanical energy: W = ∆E The potenti...
Q: Find out the correct relation from the following. a) 1 Wb = 1 G cm b) 1 Wb = 1 Tm c) 1 Wb = 1 G cm2 ...
A: D
Q: At what distance from the dry leaves will you place the eyeglasses for the dry leaves to burn immedi...
A: The eyeglasses are made up of either convex lens or concave lens or both. The convex lens is used to...
Q: An object of mass m, = 4.30 kg placed on a frictionless, horizontal table is connected to a string t...
A:
Q: A projectile is fired with initial velocity vo = 95 m/s at an angle θ=50°. After 5 s sit strikes the...
A: Given values : Initial velocity v0 = 95 meter/second given angle θ = 500 Afte...
Q: If the 0.190 mm diameter tungsten filament in a light bulb is to have a resistance of 0.122 N at 20....
A:
Q: Answer Qn 3
A:
Q: What is the velocity of a particle if it's momentum and kinetic energy are equal
A:
Q: 2-What is specific fuel consumption of an engine?
A: what is specific fuel consumption of an engine?
Q: A 1380 N was applied to a 271 kg block, find the normal force if the angle 0 = 85.5 degrees. %3D F S...
A: The force applied to the block is F = 1380 N The mass of the block is m = 271 kg The force is applie...
Q: Frem the tensile stress-strain behavier For the brass specimen ,0 the diameter is 12-8 mm Calcalate ...
A: Modulus of elasticity, =stressσstrainε=200-150 MPa0.1-0.064=1388.88 Pa
Q: A 1.5-kg circular disk rotates about a vertical axis through its center and perpendicular to its pla...
A: The angular momentum of a rotating body is related to its moment of inertia and angular speed as: L ...
Q: A 20-g bullet moving horizontally at 50 m/s strikes a 7-kg block resting on a The bullet embeds in t...
A: In a collision, the total linear momentum of the system remains conserved. Thus Pi = Pf Where Pi = T...
Q: A mass A of 0.8 kg moving to the right with a speed of 5 m/s collides head-on with a mass B of 1.2 k...
A: Given: The mass of A is mA = 0.8 kg The initial velocity of the A is uA = 5 m/s The mass of B is mB ...
Q: A 1.0-kg steel ball 4.0m above the floor is released, falls, strikes the floor, and rises to a maxim...
A: The total change in momentum of the ball and the floor, before and after the collision must be zero.
Q: A ball is thrown upward from the top of a 35-m tower, as in the figure below with initial velocity v...
A: To solve this question we will use the concepts of projectile motion. When a projectile is launched ...
Q: A particle moves from A to B along the x-axis at 40 m/s and then back to A at 60 m/s. What is the av...
A:
Q: Which type of physical quantity is magnetic flux? a) Scalar b) Vector c) Isotropic d) Isentropic
A: A
Q: DYNAMICS OF RIGID BODIES problem 1.A ball was thrown downwards at a velocity of 4m/s from a height o...
A: Given data, Height = 40 m Downward velocity of the ball = 4 m/s
Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for...
A: Impedence matching : impedance matching is the practice of designing the inputi Impedence of a load ...
Q: The figure below shows an overhead view of two horizontal forces pulling a box along the floor. How ...
A: The horizontal force given on the left side is, F1 = 60 N The angle between the horizontal force on ...
Q: What capacitance is needed to store 6.90 µC of charge at a voltage of 110 V?
A:
Q: Two forces, F, = (-4.00î – 3.95j) N and F, = (-3.95î - 4.95j) N, act on a particle of mass 1.90 kg t...
A: Solution: Given F1⇀=(-4.00i ⏜-3.95j⏜) NF2⇀=(-3.95i ⏜-4.95j⏜) Nmass m=1.90 kgcoordinates =(+1.95 m...
Q: lace a raisin or marshmallow on the end of a stick of spaghetti. Shake your hand back and forth to m...
A: AS per the given information, Let us consider we place a marshmallow on the end of a stick of spaghe...
Q: (a) Find the voltage drop in the first extension cord having a 0.0360 N resistance and through which...
A: Ohm's Law The potential difference between a conductor is directly proportional to the current flowi...
Q: Two rockets are launched at a fireworks display. Rocket A is launched with an initial velocity v0 = ...
A: Given: To find the time and velocity is given as,
Q: There is a long cylinder magnet with radius of R, and length of L and magnetization of M = M,9pp for...
A: Given, R is the Radius,L is the length,M is the Magnetization,ϑ angle M0 is constantI is currentA is...
Q: A 2.0-kg block rests over a small hole on a table. A 15.0-g bullet is shot from below through the ho...
A: mass of block M=2kg mass of bullet m=0.015kg rise of (block+bullet) h= 1.3m let say velocity of bull...
Trending now
This is a popular solution!
Step by step
Solved in 3 steps with 3 images
