Answered: A capacitor carries a charge of 0.1 C…

Engineering

Electrical Engineering

A capacitor carries a charge of 0.1 C at 5 V. Its capacitance is O 0.02 F O 0.5 F O 0.05 F O 0.2 F

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PP: Two capacitors having values of 80 F and 60 F are connected in series. What is the total...

See similar textbooks

Related questions

Q: Under the condition that Ra = R, in terms of V1, derive or solve for an expression for V0 usinng cir...

Q: Find the poles and zeroes of the functions and mark these on the s-plane. K(s + 2)(s + 10) G(s) s(s ...

Q: For the cascaded binary symmetric channels shown below, find the maximum amou information transmitte...

A: The cascade binary symmetric channels are shown below,

Q: 1. Design a weighted summing amplifier to obtain the output given below. Show your work explicitly. ...

Q: A complete circuit is shown (see figure), Determine the terminal voltage Vab on the 5.0 V battery. 1...

A: Apply Kirchhoff's voltage law in the loop.Let assume I is the current flowing in the circuit -12+1.4...

Q: 7. Show a PLD fuse mapping for the following function using ONLY the below schemalle. O= !(MS!G # !M...

Q: 5. Decompose the following signals into even and odd parts (a) x(t)= cos(2t) + sin²(3t) (b) x(t)= u(...

A: The even and odd part of the signal x(t) is given as: xe(t)=x(t)+x(-t)2xo(t)=x(t)-x(-t)2 (a) x(t)=co...

Q: Home Work In the figure below, the switch has been open for a significant period of time. The switch...

Q: A piece of crystalline silicon is doped uniformly with phosphorus atoms. The doping density is 1x 10...

A: Given, A piece of crystalline silicon is doped uniformly with phosphorous atoms. Doping density, n=1...

Q: Calculate the voltage across the 2-ohm resistor. Express it in polar form. Show your complete solut...

Q: A 4-bit pulse code modulation (PCM) modulator is used with a 0-2 V signal. How many quantization lev...

Q: What is the equivalent resistant between point A & B? All the resistors are the same and each of the...

A: Given circuit, All the resistors are the same and each of them has resistance, R=48.5 Ω

Q: Identify whether the following DT systems is causal or not. Explain why. 1) y[n]-x[n+4] =5x[n] 2) x[...

Q: O A 30 60 2A 4A 6A OB The value of the equivalent voltage source at the AB ends of the circuit in th...

A: Given circuit,

Q: resistors. Use Rf = 1 MQ in all cases a) V1 = 1V, V2 = 2V, V3 = 3V, R1 = 500 kN, R2 = 1MN, R3 = 1 MN...

A: Given that a. Rf=1MΩV1=1v,V2=2v, V3=3vR1=500kΩ, R2=1MΩ, R3=1MΩb V1=-2v,V2=3v, V3=1vR1=200kΩ, R2=50...

Q: What size branch circuit THW conductors would you need (bare minimum) for an AC 3 phase 40 horse pow...

Q: In order for a méasüring instrufffent to relationship with the circuit output resistance Rs: Rin >> ...

A: When the output of the some circuit has to be connected to some measuring instrument , impedance m...

Q: The figure below shows a combination of six resistors with identical resistance R. What is the equiv...

A: Given

Q: Find the Fourier Series of the function f(x) f(x) = { (1 - t/2 -2 <t<0 (1 +t/2 0 <t<2

Q: In the circuit below, v,(t) = A · cos(25 · 10* - t). The switch is closed for t<0, and opens at time...

Q: W17.4 We are given a periodic function f with period 2a and such that f(x) = -f(-x+n) for all r. (a)...

A: We are given a periodic function f with period 2π and such that f(x)=-f(-x+π) for all x. a) We need ...

Q: Q.6) Simplify the circuit shown in Figure Q.6 using appropriate resistor combinations and iterativel...

A: Given

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt a-c source, an...

A: GivenEA=EB=EC=E∠EB=∠EA+90°∠EC=∠EA-90°

Q: 7-8 In a step-up converter, Va 20 kHz. Calculate AV, (peak-peak). 12 V, V. = 24 V,1, = 0.5 A, L = 15...

Q: Find the current Io in the circuit shown. Note: The current Io required is in MAGNITUDE on...

Q: Find the root locus for following the T. F

A: In this question, We need to draw the root locus of the given transfer function.

Q: The screw eye is subjected to two forces, F, and F2. Determine the magnitude and direction of the re...

Q: Base on the picture, find the power dissipated in each resistor

Q: How to calculate the resistance

A: In an electrical circuit, resistance is a measure of the resistance to current flow.

Q: explain what happened as the lamp load increasing through shunt generator

A: The ammeter displays the load current readings, while the voltmeter displays the end voltage value. ...

Q: 3 V + ww 6Q 6ΩΞ 3ΩΕ 2 A ww- www

A: The solution is given below

Q: Evaluate: L, (6(1+3) +46(1)–58(t–4))cos(r t+T)dt Show complete solution.

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a cap...

Q: 18 reting R2= 2K ohms R3=8K ohms V = 40 v V2 R;= 2K ohms At a. What will the voltmeters and ammeters...

Q: 7-13 In a buck- boost converter, Va = 12 V, V, = 15 V, I, = 250 mA, L = f, = 20 kHz. Calculate AV, (...

A: According to guidelines we are allowed to do only first question. Please post again for remaining qu...

Q: 2-Explain the difference between a Wound and a squirrel -cage motor.

A: Given that we need to find the differences between wound and squirrel cage type induction motor. Do ...

Q: a) Y(ω) = 1/(5+jω) The expression above defines the frequency domain signal Y(ω) from a time domai...

Q: When inductors are added in parallel, circuit impedance decreases circuit impedance increases ...

A: The detailed solution is provided below.

Q: A 60 horsepower rated 230 V shunt motor has an armature circuit resistance of 0.052 ohm. The field r...

A: It is given that: PL=60 hp=60×746=44760 WV=230 VRa=0.052 ΩRf=48.7 Ωnmax=90.9 %

Q: (b) Determine the inductance per km/phase of a double circuit three-phase line as shown in the given...

Q: a 20 2420°v A I1 Iz -j1Q j10 le b 20 -ji0 30 A I4 Is

A: Given

Q: 4. The voltage difference between the two terminals of the series equivalent resistance? 5. The powe...

A: We are authorized to answer only three subparts at a time since you have not mentioned which questio...

Q: 1. What is the formula for torque production in a single-phase induction motor? Draw a vector diagra...

A: "Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 1. a) Explain parity method for error detection for 8-bit data transmission using necessary circuit.

A: When a message or signal is forwarded, it may be resolved by noise or data is corrupted. To avoid th...

Q: dentify and describe the basic functional elements that could be used in closed loop control for the...

A: Closed-loop Control system - A closed-loop control system, also termed a feedback control system, i...

Q: Use NODAL and MESH ANALYSIS. Please write properly the solution. Make sure to recheck.

A: The voltage and current can be calculated by using the nodal and mesh analysis.apply kirchhoff's vol...

Q: R = 50 kN , = 10 V C = 0.04 µF

Q: Q-4) Find the number of poles in the left half-plane, the right half-plane, and on the jw-axis for t...

A: Transfer function- It is define as the mathematical terms which shows the relation between the outpu...

Q: 4. Determine l, and V,. 0.5 1. Vo 42 ЗА

A: Given circuit,

Q: dy d d'x d²x d² :+y=本 +5+ +&x + &r dt

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A capacitor carries a charge of 0.1 C at 5 V. Its capacitance is
O 0.02 F
O 0.5 F
0.05 F
O 0.2 F

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
This circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor has a voltage drop of 740 V, and the capacitor has a voltage drop of 444 V. The circuit has an apparent power of 51.8 VA. ETITZVA51.8PFER185VIRRPEL740VILXLVARsLLEC444VICXCVARsCC