Answered: A Carnot engine uses nitrogen as the…

A Carnot engine uses nitrogen as the working fluid. The heat supplied is 53 kJ and the adiabatic expansion is 16:1. The receiver temperature is 295 K. Determine network.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 14RQ: The compressor amperage of a 3-ton system operating on 230 V is approximately -A.

See similar textbooks

Related questions

Q: Two Carnot engines A and B are operated in series between a high temperature reservoir at 1200…

A: Given Data QHA=600 kJ TH=1200 K TL=450 K

Q: In an absorption refrigerator, the energy driving the process is sllPplied not as work, but as heat…

A: Consider the figure given below showing various energy transfers in a vapour absorption…

Q: Explain the principle of operation of a refrigerator (include a simple diagram).

A: Refrigerator is a device which gives refrigerating effect by consuming work.

Q: In a 20KVA, 2000 / 200 V power transformer, the iron and full load copper losses are 360W and 425W…

A: Answer:

Q: 1. A Carnot engine requires 35 kJ/sec from the hot source. The engine produces 15 kW of power and…

A: Given Data Qh=35 kW P=15 kW TL=26°C=299 K

Q: The Reversed Carnot Cycle is used to run a food production company's refrigeration system. The…

A: Given Data Tc= -14°C TH= 52°C Qc= 24 Ton

Q: In a 15KVA, 2000/ 200 V power transformer, the iron and full load copper losses are 360W and 400W…

A: Solution is given below.

Q: An experimental UAV is to be equipped with two engines with ideal cycle efficiency of 95% and 90%.…

A: Given: Let us consider the given, η1=95%η2=90%W1=W2=1800 watts-hour To find: a) The heat supplied b)…

Q: In a winter season when outside temperature is -4°C, the inside of house is to be maintained at…

A: Data given - Outside temperature (T2) = -4°C = 269 K Inside temperature (T1) = 22°C = 295 K…

Q: rigerator has a coefficient of performance equal to 5. If the refrigerator absorbs 120 J of thermal…

Q: An Otto cycle has a clearance of 8 % and heat added of 1000 kJ. Find the heat rejected. ANSWER:…

A: Clearance= 8% Heat added, Qadded= 1000 kJ To find: Heat rejected, Qrejected

Q: It is required to feed an industrial ventilation system at a rate of Q = 23,000 ft3/min that demands…

Q: 1. A Freon-12 refrigerator producing a cooling effect of 20 kJ/s operates on a simple cycle with…

A: Given data as per the question cooling effect =20 kjsP1=1.509 barP2=9.607 barConsidering properties…

Q: The name plate data of three-phase induction motor has the following data: 25 H.P., P= 4, 50 Hz, Y ,…

A: The given values are:…

Q: In an absorption refrigerator, the energy driving the process is sllPplied not as work, but as heat…

A: Draw the schematic block diagram of the refrigerator. Here, Qc is the heat from the refrigerator,…

Q: In a cascade refrigeration system,the compressor power in the low and high pressure loop are 12 kw…

A: To find : The tons of refrigeration. Given : The Compressor power in low pressure loop is W1=12…

Q: Power Station – 12000kW Substation A- 6000kw Substation B- 9000kW Feeder 1-1700kw Feeder 1-620kw…

A: We need to find for in substation A all the individuals feeders value sum. Then for B substation all…

Q: A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a maximum…

Q: A basic requirement for a themal electricity generation to work is a heat source and cold reservoir.…

A: Thermal electricity generation - The generation of electrical power by using thermal energy of a…

Q: In a 15KVA, 2000 / 200 V power transformer, the iron and full load copper losses are 370W and 415W…

A: Given Data Power output = 15KVA Ans(i) At full load 0.8 PF Copper loss = 415 w Core losses = 370W…

Q: 5. A Carnot engine uses nitrogen as the working fluid. The heat supplied is 53 kJ, and the adiabatic…

A: Given data: r=16:1QS=53 kJTL=295 K Need to determine the thermal efficiency, heat rejected and net…

Q: 12 Q.10 A cyclic heat engine operates between a source temperature of 723°C and sink temperature of…

A: As per given question Source temperature =723°c Sink temperature =23°c We have to determine net…

Q: 6.3 A gas/diesel engine cogeneration plant has a useful heat output of 4.8 MW and heat-to-power…

Q: An engine works with two reservoirs: Ta at 400 degrees Celsius and the other Tb at 200 degrees…

Q: During January, at a location in Alaska winds at-20°C can be observed, However, several meters below…

A: A series of repeating thermodynamic processes along a closed process path, while heat is converted…

Q: Ericsson Cycle: Derivation of the following according to the PV andTS Diagram: Volume at the…

Q: A turbo-generator has the following specification: Steam input temperature = 244 °C Steam input…

A: Given that, Steam input temperature=244 °C,Steam input pressure=0.8 MPa,Steam output temperature=74…

Q: A food department is kept at -7129 by a refrigerator in an environment at 30°C. The total heat gain…

A: Given Data Environment temperature, Tamb=30C Food refrigerator=-12C Heat rejection in the condenser,…

Q: Thermal sensing station has an installed capacity of 15MW and supplies a dairy load of 10MW for 12hr…

Q: The compressor amperage of a 3-ton system operating on 230 V is approximately ________A.

A: Refrigeration is the process of maintaining a place at a lower temperature compared to surrounding…

Q: Problem No 1 A Carnot engine operates between temperatures of 1000°K and 300°K. The engine operates…

Q: Define a cycle ΔE = 0, thus Q = W.

A: The first law of thermodynamics is also known as law of conservation of energy which states that…

Q: In a 20KVA, 2000 / 200 V power transformer, the iron and full load copper losses are 355W and 405W…

Q: Following is a GLHP installed in a gymnasium. The gym needs cooling and the swimming pool water…

A: Write the given values using suitable variables. Here Q2 signifies heat absorbed from the system,…

Q: • Question #I • An office is to be maintained at 22°C dbt and 50% Rh in summer. The sensible heat…

Q: What is the power plant maximum demand if the demand factor is equal to Plant Load Factor with…

Q: A generation station of 6 kw has a load factor of 0.7 and plant capacity factor of 0.8. The plant…

A: Given Data: The average load of of the power plant is, Pavg=6 kW. The load factor is, L=0.7. The…

Q: a student, observed that she can focus more in her lessons if the air conditioning unit in her…

Q: Heat rejected by condenser is 1000 W. If the COP is 4, find the power input of the refrigerator?…

A: To find: The power input. Given: The heat rejected by the condenser is Q1=1000 W. The COP of the…

Q: Which of the following is used as starter for a gas turbine a. A compressor b. Low pressure turbine…

A: Given Gas turbine To find Starter for gas turbine

Q: What is the final temperature after compression of a Diesel cycle if the initial temperature is 32°C…

A: clearance ratio is the ratio of clearance volume to that of swept volume. Clearance volume is the…

Q: 14. During the summer the lempera temperature is a constant 95 F. When the driver gets into the van,…

Q: A nuclear-power station with a life of 25 years produces 750 MW per year as useful energy. The…

Q: The maximum temperature attain from Cylindrical Parabolic trough Concentrator collectors is: Tmax =…

A: The maximum Temperature attained by cylindrical parabolic through collector is 200-400°C

Q: In a winter season when outside temperature is -4°C, the inside of house is to be maintained at…

Q: a student, observed that she can focus more in her lessons if the air conditioning unit in her…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

A Carnot engine uses nitrogen as the working fluid. The heat supplied is 53 kJ and the adiabatic expansion is 16:1. The receiver temperature is 295 K. Determine network.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a student, observed that she can focus more in her lessons if the air conditioning unit in her spacious room is opened. She usually set the temperature to be maintained in her room at 10 C. The temperature outside of her room is 40 C. The refrigerant of her AC unit is HFC-134 a. What is the coefficient of performance of her AC unit if it is operating on a Vapor Compression refrigeration cycle? The compressor efficiency is 0.7.
Define a cycle ΔE = 0, thus Q = W.
a student, observed that she can focus more in her lessons if the air conditioning unit in her spacious room is opened. She usually set the temperature to be maintained in her room at 10 C. The temperature outside of her room is 40 C. The refrigerant of her AC unit is HFC-134 a. What is the coefficient of performance of her AC unit if it is operating on a Carnot refrigeration cycle? The compressor efficiency is 0.7
Draw the reliability block diagram with blocks representing the first and second blocks of a refrigerator sub- systems
Thermodynamics (Carnot Cycle) An Ocean Thermal Energy Conversion (OTEC) power plant produces 25000 kW of ouput using warm surface water temperature of 29°C and a cold deep-water temperature of 12°C. Assume it is a carnot cycle and density of cold water to be 1000 kg/m3.If the temperature of the sink is maintained and the efficiency is doubled, what is the new temperature of the hot source? Options: a. 38.16% b. 48.16% c. 58.00% d. 32.09% e. None of the above
In an absorption refrigerator, the energy driving the process is sllPplied not as work, but as heat from a gas flame. (Such refrigerators commonly use propane as fuel, and are used in locations where electricity is unavailable. *) Let us define the following symbols, all taken to be positive by definition: Qf = heat input from flame Qe = heat extracted from inside refrigerator Qr = waste heat expelled to room Tf = temperature of flame Te temperature inside refrigerator Tr = room temperature Explain why the "coefficient of performance" (COP) for an absorption refrigerator should be defined as Qc/Qf.
What is the final temperature after compression of a Diesel cycle if the initial temperature is 32°C and the clearance is 8%
Explain the principle of operation of a refrigerator (include a simple diagram).
The compressor amperage of a 3-ton system operating on 230 V is approximately -A.
Explain the essential factors that influence the choice of site for a hydro-electric plant
In an absorption refrigerator, the energy driving the process is sllPplied not as work, but as heat from a gas flame. (Such refrigerators commonly use propane as fuel, and are used in locations where electricity is unavailable. *) Let us define the following symbols, all taken to be positive by definition: Qf = heat input from flame Qe = heat extracted from inside refrigerator Qr = waste heat expelled to room Tf = temperature of flame Te temperature inside refrigerator Tr = room temperature Use the second law of thermodynamics to derive an upper limit on the COP, in terms of the temperatures Tf, Te, and Tr alone.
Thermodynamics (Carnot Cycle) An Ocean Thermal Energy Conversion (OTEC) power plant produces 25000 kW of ouput using warm surface water temperature of 29°C and a cold deep-water temperature of 12°C. Assume it is a carnot cycle and density of cold water to be 1000 kg/m3. Calculate the efficiency. Options: a. 9.44% b. 3.68% c. 5.63% d. 58.62%