A carrier with a frequency of 20 MHz and amplitude of 20V is amplitude modulated y an audio signal of 10KHz frequency and 5V amplitude Estimate the depth of modulationWhat is the upper side frequency (in MHz)What is the amplitude of the lower side frequency in (volts) 12:28161 .95% DKB/sEdit8818$ASSIGNMENT FIVE1.A carrier with a frequency of 20 MHz and amplitude of 20V is amplitude modulated y anaudio signal of 10KHZ frequency and 5V amplituđea. Estimate the depth of modulationb.What is the upper side frequency (in MHz)What is the amplitude of the lower side frequency in (volts)2.A double sideband AM radio transmitter gives an output power of 20 KW when the carrier ismodulated with a sinewave tone to a depth of 80%, Determinea. The carrier power (in KW)b. ,The carrier current (in amps), if a load resistance of 20 is assumed.The peak current of the modulated wave3. An AM signal given by s(t) = 10[1+0,45sin4rx10't|sin?nx10't is to be detected to extract theinformation signal, If a synchronous detector is useda.What is the required local oscillator frequency (in KHz)b.What should be the minimum bandwidth (in KHz) of the low pass filter required for theextraction of the information signal,4. If the AM signal of Question 3 is passed through a full wave bridge rectifier, followed by alow pass filter, in an envelope đetection process and the rectifier and filter is assumed tointroduce an attenuation factor of K=0,65a,Estimate the value of the dc, component at the output of the filter (in volts)b. What is the amplitude of the modulating signal at the output of the filter (in volts)5. A communication system consists of five cascaded sections A, B, C,D and E, Measurementscarried out to đetermined the gain of each channel yielded the following results,ChannelVin (volts)Vout(volts)3,015.0B2,010,05,01,0D1,010.04,00,5DOפםToolsMobile ViewShareSchool ToolsO

A carrier with a frequency of 20 MHz and amplitude of 20V is amplitude modulated y an audio signal of 10KHz frequency and 5V amplitude Estimate the depth of modulation What is the upper side frequency (in MHz) What is the amplitude of the lower side frequency in (volts)

A carrier with a frequency of 20 MHz and amplitude of 20V is amplitude modulated y an audio signal of 10KHz frequency and 5V amplitude Estimate the depth of modulation What is the upper side frequency (in MHz) What is the amplitude of the lower side frequency in (volts)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

-The modulating signal 2cos (2 π×103 t) is used to modulate a carrier signal 40cos (2 π×104t). Evaluate the modulation index, percentage modulation, frequency of side band components and their amplitudes .What is the bandwidth of a modulating signal.
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
In an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495MHz, 1200 times/sec by a 5V sinusoid. a. determine the carrier frequency and intelligence signal frequency b. calculate percent modulation c. determine the amplitude of the modulating signal necessary to deviate the carrier between 103.507 and 103.493 MHZ, calculate the intelligence signal amplitude
Question 1. Select the correct statement(s) regarding amplitude modulation (AM). a. If the AM Index is greater than 1 (i.e., µAM>1), then over modulation occurs leading to signal distortion b. With AM, the message is captured as amplitude changes to the carrier’s amplitude. c. The AM modulated carrier bandwidth is dependent upon the baseband signal’s frequency bandwidth d. All of the above are correc
The equation of an angle-modulated voltage is v = 10 sin (l08t + 3 sin 104,). What form of angle modulation is this? Calculate the carrier and modulating frequencies, the modulation index and deviation, and the power dissipated in a 100-ohm resistor.
You have an FSK transmitter using a mark frequency of 500 kHz, a space frequency of 380 kHz, and sending 10 kbps. A) How much bandwidth do you need for your transmission? B) if you are to design the system with continuous phase shift keying in mind, what would be the value of the space frequency if the mark frequency remains the same?
An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHza. Find the output frequency for an instantaneous value of the modulating signal equal to150mV. b. If the carrier signal is modulated by a 2Vrms sine wave. Calculate the peak frequencydeviation. c. Using the given in the previous number, also find the bandwidth using the Bessel table below for thePM signal when the message frequency is (a) doubled, (b) halved, but all else remains constant.
(a) For an AM DSBFC wave with an unmodulated carrier voltage of 18V and a loadresistance of 50Ω. If the modulation percentage is 75%, determine:(iii) total sideband power(iv) total transmitted power
Q2. An FM transmitter is modulated with a single tone 13cos (2(pi)28041t) and a carrier amplitude of 55 volt. The output resistive load for no modulation is 114N and the modulation constant k, = 14624Hz / volt. For the given parameters, determine the following: 1- The average power in all sidebands. 2- The carrier power if the amplitude of modulating signal is reduced by 5 volts.
A sinusoidal carrier voltage of frequency 1 MHz and amplitude 100 volts is amplitude modulated by the sinusoidal voltage of frequency 5 kHz producing 50% modulation. Calculate the frequency and amplitude of lower and upper sideband terms. Draw the AM Spectrum.
FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The frequency deviation constant kf = 25 Hz/V, the carrier is a cosine sign with an amplitude of 10V and a frequency of 2000Hz. What is the bandwidth of the FM modulated signal based on Carson's Rule? a)120Hz b)240Hz c)40Hz d)80Hz
Calculate the first two pairs of sidebands for an FM signal, if the carrier frequency is 107MHz, and modulating signal frequency is 3kHz