A charge of +3.0x10^-5 C is 10cm from a charge of +50x10^-6C. Calculate the magnitude of the repulsive force between the charges

Q: 1. Simplify the following expressions in Sum of Products (SOP) and Product of Sums (POS). a ii+ yz +...

A: In this question,  We need to simply the given expression in the form of SOP and POS.  We know  A+A'...

Q: the minimum number of overload unit(s) required for a three-phase, alternating current motor

A: Overcurrent protection is generally accomplished by separating the overload protection from the shor...

Q: 4. Find N-point DFT for the signal h: hy = 8[k – 1] + 1.9 8[k – 6].

A:

Q: determine the regulated d.c output voltage for the LM317

A: The LM317 voltage regulator circuit diagram is shown below, The values of the resistors are,R1=240Ω...

Q: 18.a. When working with a pole-mounted splice enclosure, where should the excess coiled cable be  mo...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Question 1 Not yet answered Marked out of 1.00 P Flag question A company has 3 machines. You need to...

A: Given: 3 machines Need to turn on 2 machine

Q: R, = 20 R2=30 P4= 22 Is Rg 2n In 州 丰 Riy: 3n I13 RiS-20 RG = 55 IG Pra Refeence In RIS :50 I = GQ RI...

A:

Q: Given:, 21, -6= 31, 21, -6= 41, %3D 3. I-1, -I, = 0 || Use Cramer's rule to cal

A:

Q: Can somebody help me how to read the voltage of this? We’re given 5V/Div Thank you!

A:

Q: 12.a. How many splice losses are introduced when a section of damaged cable is replaced with a new  ...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: 1) For the Circuit Shown , Find the Current through the 1n resistor using SuPerPosition theorem. Usi...

A: The given circuit is:

Q: Construct the circuit below on breadboard. 2K Ohm RS 3KOhm R1 R3 V1 1.5K Ohm 3.3KChm 10V R2 R4 1.5K ...

A: To find current in all the branches we will first determine the current supplied by battery. For tha...

Q: 21. Referring to problem 18, determine 14. O 1.299 A O 1.216 A 1.259 A O 1.265 A

A:

Q: Q.1. If an RMS current of 5 A at 60 Hz flows through an inductor of 10 mH, what is its average power...

A:

Q: Determine the reverse voltage and reverse current for the diode in the Figure below  for each of the...

A: Note: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost ...

Q: Given the sinusoidal voltage v(t) = 60 cos (37t + 10o) V, find the period T (in seconds)

A: frequency  w = 2πf = 2πT rad /sec .  Where T is the time period 

Q: What is the noise density for a receiver with an input bandwidth of 20 MHz and an equivalent noise t...

A: We need to find out noise power density .

Q: If f(t) F(w), find the fourier Transform of a. f(4t) b. f(t-9) c. t*f(t/2)

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: A three-phase star-connected alternator

A:

Q: If you use a Kalman filter, explain when you should do so.

A: Kalman filter is an Iterative mathematical method to quickly calculate the true value of uncertainty...

Q: If a power lost a ratio of 0.01 represents -20 dB and a power gain ratio of 2 represents 3 dB. Solve...

A: power in dB = 10 log(power gain).    

Q: Solve for the value of current I in the circuit shown below. Your final answer must be in rectangula...

A:

Q: Find Vms (gen) if R1 = 496 ohms, R2 = 27 ohms and L3 = 5.2 mH. R1 VGEN 10 Vt (GEN 60 kHz L3 R2 Round...

A: In this question,  Find the rms value of the voltage Vgen  if  Peak to peak voltage= 10V We know rms...

Q: draw the logic diagram for F=YZ’ + X’Y’Z

A:

Q: One component that does not need to be installed in the correct orientation is a: a. Resistor b. Di...

A:

Q: A three-phase star-connected alternator is rated at 1.6MVA, 13.5KV. The per phase armature effective...

A:

Q: . Consider a device connected to an ac power supply. The current leads the voltage by 90°, with the ...

A: (a) Since the current leads the voltage by 90° the given device is capacitor. (b) The angular freque...

Q: dt 2nd order ODE madel for the RLC circult. 8.1. Write current Ict) in this

A:

Q: Which of the following capacitors is polarized and must be connected in the correct orientation? Ele...

A:

Q: 1 Determine the total resistance, current and the voltage across R1 R V 56 N Ω V RT Vs 1.5 1.5 V R2 ...

A: Consider the total resistance of the circuit is, RT=56 Ω+200 Ω200 Ω200 Ω+200 Ω+27 Ω=183 Ω

Q: HE R2 Xc GEN V GEN : 15 Vpk-pk 20 kHz

A:

Q: Find i1.

A:

Q: 05 Please help me answer this problem. Choose the correct answer from the given choices. NOTE: Show ...

A:

Q: A rectifier voltmeter uses a full wave rectifier. The meter has an internal resistance of 50 N and r...

A:

Q: 2. KI K2 relle M1 a beve mechanical system

A:

Q: band gap of Germa is 7.32ev at room temperature. Find the maximum wavelengin of excitation light sou...

A: Given thatEg=7.32evh=6.62×10-34j-sc=3×108m/s1eV=1.6×10-19j

Q: What is the color code for a 8KQ, tolerance + 10% resistor? Find the nominal value of the resistance...

A:

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1062 ohms and Xc = 2221 ...

A:

Q: 2 0.5 1 1.5 2.5 t (seconds) 2. (1)×

A:

Q: solve V6 or the voltage drop across R6. * R1 = 80 2 R4 = 39 N VT = 120 V R2 = 150 N R5 = 2 kN R6 = 1...

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's current law , oh...

Q: Question 4 Solve for the Vrms (magnitude only) across the resistance if R2 = 1063 ohms and Xc = 2160...

A: We need to find out the voltage across resistor.

Q: 6Ω. 2Ω 2 A 4Ω

A: Please refer the attached images for the complete answer..

Q: Find the Thevenin equivalent circuit of the circuit in Fig. 4.34 to the Practice Problem 4.9 left of...

A: Given circuit shown 

Q: Solve for the value of the capacitance (in nF unit) if R2 = 1035 ohms and Xc = 2132 ohms.   Round y...

A:

Q: Find the equivalent inductive reactance if the frequency is 61 Hz. L, 3 6 H 4 H 2 H 3 H Round your a...

A:

Q: Determine the current 11, 12, and 13 in the network using a simplified model. 1, 3.3 ka ww D. E= 20V...

A: This question belongs to analog electronics . It is based on the concept of analysis of diode in the...

Q: What does the high resistance reading in both forward and reverse-bias directions indicate?

A:  high resistance reading in both forward and reverse-bias directions indicate the model of an  Open ...

Q: Design a self–bias network using a JFET transistor with IDSS = 8 mA and VP = –6V to have a Q-point a...

A:

Q: In the circuit ( delta to wye connection)...Compute for the Total resistance (Rt), Total current (It...

A: Resistance: It is a property of a material that resists the flow of current. Its unit is the ohm.

Q: 1. Silicon dioxide can sustain 10 MV/cm electric field. Calculate oxide thickness range for CMOS ICs...

A:

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.