Answered: A Chopper circuit is operating at a…

A Chopper circuit is operating at a frequency of 2 kHz on a 460 V supply. If the load voltage is 350 volts, calculate the conduction period of the thyristor in each cycle.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Related questions

Q: State the Method of connection of different field coils

A: The field coil connection is based on the type of excitation that is given to the coils. The first…

Q: . A 5 HP, 3-phase induction motor draws a current when connected to 230-V. Determine the current…

Q: Which is the first equipment seen in the substation while coming from transmission system: a)…

A: A lightning arrester (also known as a lightning isolator) is a equipment is the first device…

Q: A 500 KVA,3.3 KV,50 Hz,600 rpm,3 phase salient pole alternator has 180 turns/phase. Calculate the…

Q: Calculate the efficiency (Pou/Pim) of 3-phase induction motor? (1 HP=74C

Q: The motor takes 11 HP at an efficiency of 86%. The voltage at the terminals of the motor is 220…

A: Given data: Efficiency (η)=86%=0.86Voltage (V)= 220 VPower (P0)= 11×746=8206 W

Q: h) What is the function of condenser in steam power plant?

A: Condensor is generally an integral part of the steam power plant. in the steam power plane, steam at…

Q: A 400 V, 3phase Induction motor has a power output of 30 HP and operates at a power factor of 0.8…

A: Given 3phase induction motor with Line Voltage=400 v power output(P out) =30 HP power output in…

Q: The power output of the geberator is 20Hp. If the losses were itemized as follows: hysteresis loss=…

A: Given: Power output of the generator, P0=20 Hp Hysteresis loss = 305W, Eddy current loss = 272W,…

Q: Why the efficiency of large size alternator should be larger than that of small size?

A: Large alternator have more efficiency than a small size alternator, these efficiency gain are mostly…

Q: series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the power…

A: We need to find out the value of capacitance

Q: A single phase motor is rated 5hp, 75% pf lag,220V. What is the approximate size of capacitor is…

A: It is given that:P=5HPP=5×746P=3.730 kWV=220 Vpower factor,cosϕ1=75%cosϕ1=0.75Required power…

Q: Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this…

Q: Draw the developed diagram for the stator winding of a 3-ph, 2-pole 1.M. The winding is double layer…

A: Here, The stator winding is a double layer with a full pitch coil. The number of slots is 2 per…

Q: 10. A 3.3 kV, 3-phase, y-connected alternator has a full load current of 100A. On short circuit a…

Q: A single phase alternator gives 250 A at 1200 volts. What is the output of the machine in kVA?

Q: A 3-phase 440V 50hz wye connected SM takes 7.46 kW from the three-phase mains. The resistance per…

A: Given:P=7.46kWV=440Vf=50Hz3-phase, Wye connected Synchronous motorpf=cosϕ=.75Mechanical…

Q: A 3-phase 440V 50hz wye connected SM takes 7.46 kW from the three phase mains. The resistance per…

A: The solution is given below

Q: A single-phase 230V, 1kW heater is connected across I-phase 230V, 50Hz supply through an SCR. For…

Q: Auxiliary winding winding Main Parameters Applied voltage in volt Current in Ampere 23 23 4 1.5…

A: The given table is shown below:

Q: . Thyristor switched reactor(TSR) for power factor improvement

A: As per the guidelines, we need to solve only first question. we used thyristor switched rectifier…

Q: A dc series generator is supplying power to a 60 kW, 600 V lighting load, through a two-wire feeder…

A: The above question is based on DC generators; the major classifications of DC generators are:…

Q: Given field excitation at 10A in an alternator that exerts current of 150A (short circuit) and a…

A: The solution is given below

Q: How to measure high alternating currents and high alternating voltages during the transmission and…

A: The device that is used to measure the high alternating current is known as the current transformer.…

Q: Define three (3) advantages of alternating current (AC) for long distance power ransmission compare…

Q: What is the phase sequence of the voltages induced in the three coils of an alternator shown in the…

A: From the given figure, the phases/windings are displaced by the 120o. Assuming the windings are…

Q: To get the armature resistance of 10 MW, 13.8kV and 90% power factor generator, two terminals are…

A: To find the DC resistance per phase of the generator Given : ratings of the generator And current…

Q: volt, 50 Hz supply, the secondary is open circuited. If the power absorbed 72 watts, find (a) iron…

Q: A 3 phase IM develops 4 kw at 1170 rpm. It has a 6 pole, 60 Hz. Neglect the friction and windage…

Q: Q4 (a) Define three (3) advantages of alternating current (AC) for long distance power transmission…

A: “Since you have asked multiple question, we will solve the first question for you, here it is Q4. If…

Q: 2. A burst controlled triac is feeding a 200 ohm resistive load. The AC supply providing 240 V rms…

Q: Calculate the current taken by a 1.7 kW 230 volt single-phase motor working at full load with a p.f.…

A: We have a 1.7 KW single-phase motor at full load with, Pf = 0.8 Efficiency = 75 % We have been…

Q: Define three (3) advantages of alternating current (AC) for long distance power transmission compare…

A: For longer distances DC transmission is preferred but There are advantages of AC over DC 1. For DC…

Q: The power input to an electric motor is 8.8kw when operating normally from 230 volt ac source. If…

A: According to question: The power factor is calculated as…

Q: A 2,500 kVA, three-phase, 60 Hz, 6.6 kV wye-connected alternator has a field resistance of 0.45 ohm…

Q: 4.2 For a step up d.c.-d.c. chopper with an input d.c. voltage of 220 volts, if the output voltage…

A: Given a step up DC-DC chopper with, Input DC voltage, Vs=220 volts Required output voltage, Vo=330 V…

Q: C1 (ii). Three lIdentical capacitors are connected in star to 415 Volts, F = 50 Hz, 3 phase supply.…

A: Given:-IL=12AVL=415voltF=50Hz

Q: Q. A 10 kV, Y-connected,6-pole,50HZ alternator has 36 stator slots ,each slot contain 10…

A: For the 10kV, Y-connected, 6-pole, 50Hz alternator has 36 stator slots and each slot contains 10…

Q: E. Calculate the voltage output by the secondary winding of a třansformer if the primary voltage is…

A: According to the question we have to find the value of secondary voltage.

Q: A polarity test is performed upon 1150/115-volt transformer. If the input voltage is 120 V,…

Q: The output of the 3-phase, 425 V induction motor is 15 kW and operates at power factor of 0.8…

Q: The output of the 3-phase, 435 V induction motor is 17 kW and operates at power factor of 0.75…

Q: The generator convert from PV to PQ if the active power of the generator exceed the * maxinum and…

A: The genrator convert from PV to PQ bus if genrator reactive power out of range limit. It doesn't…

Q: A 210- volt 50- cycle source is connected to a coil of wire that has a resistance of 10 ohms and an…

Q: Given the bellow Arduino command: analogWrite( 8, 200); What is the duty cycle? What…

A: analogWrite function will write an analog value to the pin mentioned inside the function. The first…

Q: A 100 kVA, 1000 V / 300 V, 50 Hz, single-p nsformer has an iron loss of 550 W and a fu d copper loss…

Q: An impedance coil takes 10 A and absorbs 250 Watts when connected across a 220 V, 60 Hz source. What…

A: This question belongs to circuit theory . It is based on the concept of power consumed across the…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

A Chopper circuit is operating at a frequency of 2 kHz on a 460 V supply. If the
load voltage is 350 volts, calculate the conduction period of the thyristor in each cycle.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this source is in series with a load of 22 Ω?
M:07) 1.) What size of wire is needed for a 5 hp single phase motor locate 12 m from the source? Assume aluminum, UF insulation, and cable underground 2.) what size copper wire would be needed for a branch circuit 0.75 hp 240 V motor located 75 feet from the service entrance? 3.) what size of copper wire would be needed for a branch circuit to a 7.5 hp 240 V motor on the vacuum pump located 25 feet from the service entrance?
Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a) Exciting current (ii) Ic (b) Magnetizing Current (iii) Ie (c) core loss current
The meter constant of a 245 volt, 70 ampere, single phase energy meter is 1650 revolutions per KWh When tested at quarter load, rated voltage and 0.8 power factor, the meter is found to make 100 revolutions in 65 seconds. Determine the percentage error at quarter load
Can you explain the given questions in an original way? Voltage (Voltage) Regulator Alternators without Excitation Machine (Constant Voltage Generators) Thyristor regulators
Draw and explain a power supply diagram of 12V?
A single-phase 230 V, 1 kW heater is connected across a single-phase, 230 V, 50 Hz supply through an SCR. For firing angle of 45° and 90°, calculate the power absorbed by the heater-element
Two shunt generators and a battery are working in parallel. The open circuitvoltage, armature and field resistances of generators are 250 V, 0.24 ohm, 100ohms and 248V, 0.12 ohm and 100 ohms respectively. If the generators supply thesame current when the load on the bus-bars is 40 A. Calculate the e.m.f. of thebattery if its internal resistance is 0.172 ohm.(Ans. 248
The table gives data for open circuit and short circuit tests on a 6 pole, 440 V, 50 Hz, 3 phase star connected alternator. The effective ohmic resistance between any two terminals of the armature is 0.3 ohm. Field current (A) 2 4 6 7 8 10 12 14 OC Vltage (V) 156 288 396 440 474 530 568 592 S.C current 11 22 34 40 46 57 69 80 Find the regulation at full load current of 40 A at 0.8 power factor lagging, using emf method and mmf method.
Calculate the open circuit voltage (in Volts) of a 3-phase, star-connected alternator, 4-Pole, 60Hz, 120 slots each having 6 conductors. The machine running at 1800 rpm with a flux per pole of 125mWb. the coil span was 12.
Discuss the principles of operation of the following circuit breakers i) Oil circuit breaker ii) vacuum circuit breaker iii) Air blast circuit breaker iv) Sulphur Hexafluoride circuit breaker v) Air Circuit Breaker
Consider hydro-electric, thermo electric, and nuclear electric generating methods. Explain one (1) advantage and one (1) disadvantage of each.