A circular pipe with inner diameter of 0.02 m has its inner surface covered with water at 303K. Dry air is flowing inside the pipe at the velocity of 10 m/s. The temperature of air is 303K and its pressure is at 1 atm. Calculate: a) Mass transfer from the 0.01 m length pipe b) Rate of heat transfer from pipe to air by mass convection and heat convection

A circular pipe with inner diameter of 0.02 m has its inner surface covered with water at 303K. Dry air is flowing inside the pipe at the velocity of 10 m/s. The temperature of air is 303K and its pressure is at 1 atm. Calculate: a) Mass transfer from the 0.01 m length pipe b) Rate of heat transfer from pipe to air by mass convection and heat convection

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter9: Heat Transfer With Phase Change

Section: Chapter Questions

Problem 9.26P

See similar textbooks

Similar questions

Hot atmospheric air (373 K) is forced through a 2 meter long pipe having a diameter of 5 millimeters at a rate of 0.135 g/s. There is heat transfer from the pipe to the air at a constant flux and where the air exits the pipe the surface temperature is To = 433 K. Find the heat rate in units of Watts. Use fluid properties at 400 K.
A centrifuge bowl is to separate two immiscible liquids, one with SG 1.1 and the other with SG 0.9. The inside diameter of the bowl is 20cm, and it is rotating at 11000 rpm. The liquid-liquid interface is located 7cm from the axis of rotation, while the free liquid surface is 4cm away from the axis of rotation. Using the equations below, estimate the radial distance from the rotational axis to the top of the overflow dam.
Air at a temperature of 95 F and a velocity of 20 ft/s flows over a hot flat plate, maintained at 482 F. Find the rate of heat transfer form this 1ft by 1 ft square plate. [Ans. ~ 423 Btu/hr].
Subject : Thermofluid Question : A wind turbine four 10 cm diameter cups with a center-to-center distance of 40 cm, as shown in Figure 4. Due to a malfunction, the pivot is suddenly stuck, and the cups stop rotating. If the wind speed is 12 m/s moving at the described direction and air density is 1.25 kg/m3. Determine the maximum torque this turbine applies on the pivot.
Air flows inside a tube 60 mm in diameter (d) and 2.1 m long (l) at a velocity w = 5 m/sec. Find the heat-transfer coefficient α if the mean air temperature tf = 100oC. Note: Write your answer in space provided without the unit (the answer is in kcal/m2-hr-oC, one decimal places)
In a gas manufacturing plants, they presented a horizontal tube in which a gas assumed to be ideal is flowing steadily. It was identified that no heat and work interaction was done. Also, there is a significant changes in the pipe diameter as well as velocity. If in case we select N2 as the flowing gas at 761.67 R at a velocity of 5.6 m/h, Calculate the temperature where the velocity us 180 km/h? Assume cp=7/2 R.
8.9A fire releases 100 kW in a room with a floor area of 100 m2and a height of 4 m. Theroom has a door which is 1 m wide and 2 m high. At the moment when the smoke layerreaches the top of the opening, the gas temperature is found to be 300°C. Ignoring anyheat losses to the boundaries, calculate how long the fire has been burning.
Most automobiles have a coolant reservoir to catch radiator fluid that may overflow when the engine is hot. Such a radiator, made of copper, is filled to its 12-L capacity when at 10.0°C. -What volume of radiator fluid, in liters, will overflow when the radiator and fluid reach their 99.5°C operating temperature, given that the fluid’s thermal coefficient of volume expansion is 400.0 × 10-6 / °C? The coefficient of volume expansion for copper is 5.1 × 10-5 /°C.
A 1.5m diameter spherical balloon containing air at (K + 10) kPa is cooled such that the volume is reduced by 25%. For the process, the pressure is proportional to the square of the sphere’s diameter. What is the work done by the surrounding? K=162
The actual velocity of a gas entering in a chimney is 8 m/sec the gas temperature is 25 C and pressure of 98 Kpa with a gas of 0.287 KJ.kg-K . Determine the chimney diameter in meter if mass of gas is 50000 kg/hr.
In a reservoir system with a very large accumulation volume for the ideal fluid (water),a) Since the diameter of the ABCDEF outlet pipe is D = 20 cm, the flow rate through the pipe,b) Calculate the velocity, velocity height, relative pressure and pressure heights in the ABCDEF outlet pipe.c) Draw the relative energy and piezometer lines of the system.d) If the relative evaporation pressure of water is pv = -98.5 kPa, what can be z maximum?e) Determine how much the diameter of the outlet pipe can be reduced at most without causing cavitation, with the relative evaporation pressure of water pv = -98.5 Pa and h = 6 m.f) Calculate the critical velocity value for cavitation.
Provide the answers with clear explantion and images. Coolant flowing through a radiator at the rate of 3 kg/s are cooled from 105 0C to 81 0 The specific heat capacity of coolant and air are 4.19 kJ/kg K and 1.13 kJ/kJ/K respectively. Th overall heat transfer coefficient from gas to water is 140 W/m2 K. Calculate the surface area required for the radiation if the vehicle speed is 100 km/h. Consider the density of air as 1.225 kg/m3.