A coil of inductance 0.1H and a resistance of 4 Ohms is connected in series with a condenser of 70.4 microfarad capacitance across a 60HZ, 240 V line. How much current will flow on the circuit?

Q: Laplace transform Home work 1 D Fined the trans form of eaeh Cosh at and Sinh at at at if Cosh at =Ź...

A: Given data, cosh at=12eat+e-atsinh at=12eat-e-at

Q: Sketch the output waveform of vo given vt. Assume al diodes are ideal (vD = o v). 20 V 2V + (a) 10 k...

A:

Q: Determine the resistance value (including tolerance) for each of the following resistors. a. (yellow...

A:

Q: Determine the voltage across 68kohms resistor for the shown network below if vi = 0.5Vdc Si Imax Vi ...

A: Silicon diode starts conduct when anode voltage is greater than cathode voltage by 0.7 volts.

Q: A 5-Ohm resistor is in parallel with a 20-Ohm resistor, is s current at the 5-Ohm resistor. O 1.6 A ...

A:

Q: Use the current divider to calculate the current flowing down through the 33(ohms) resistor

A: If two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  If two res...

Q: 4- If the input signal is 100KHZ, can we make sampling for this signal when it applied to the analog...

A: It is given that input signal is of frequency of 100 KHz and needs to be fed to analog pin of Arduin...

Q: 2. Using KCL, find the unknown currents shown in the figure 2. 2 A 7A I4 4 A 3 A Is

A: Given circuit,

Q: z2+3z Find inverse Z-transform of (z-1)²(z²+1)' 1

A:

Q: a) If a switch or circuit breaker serves as the disconnecting means for a permanently connected moto...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: 11 KVA single phase transformer has a voltage of 13.8 kV on the primary and 230 on the secondary det...

A: We need to find current on secondary side of transformer .

Q: To test a diode using analog multi-meter, you should use what function? a. dc voltmeter O b. ohmmete...

A: 1.Answer:a. Dc voltmeter  To check whether diode is working or not we wil connect to Dc voltmeter mo...

Q: Convert 2.6μJ to eV and MeV

A:

Q: How does a multimeter identify BJT terminals?

A: Bipolar junction transistor is a current controlled Device in which base current control the mode of...

Q: 9.3. In the circuit of Fig. 9.39, we have cho- sen Rc = 1 k2 and Vcc = 2.5 V. Estimate the maximum a...

A:

Q: A phase modulator has kp =2 rad/V. What RMS voltage of a sine wave would cause a peak phase deviatio...

A:

Q: Give the Fourier coefficients, a0 of the waveform below. f(t) A 14. -2 -1 1 2 3 1 0. 1. -3

A: Fourier coefficient has general formula  They are generally represent by Cn for exponential Fourier ...

Q: The value of resistance in insulators is O a. small O b. large O c. can not be determined O d. zero

A: The electrons in the insulator's atoms are strongly bonded and cannot travel easily. Other materials...

Q: Two current i, and iz are given by the expression i, = 10 sin (314t +4) and iz = 8 sin (314t + Find ...

A:

Q: Answer the problem below on your templated paper. Show your complete solution. 40/60° V V1 4Ω V2 ww ...

A:

Q: Using Fourier integral representation, show that 0, ifx 0 -o cos xw+w sin xw dw 1+w2

A:

Q: N-MOS transistor shown in Figure below has (W/L)CoxHn=3.1 mA/V2,2=0, and Vth=1.2 V. V1=9.1V V2=10.1 ...

A: Given data, N-MOS transistor W/LCoxμn=3.1 mA/V2λ=0Vth=1.2 VV1=9.1 V, V2=10.1 V, V3=2.1 V  

Q: Convert the following sum-of-products Boolean expression into product-of-sums : 'A·B+A'·B A'+B').(A+...

A: Given, Boolean expression Y=A·B+A'·B  

Q: 5- Use 3-bit integrated comparators to compare the magnitude of two 6-bit binary numbers. Show the c...

A: Answer -

Q: A 5-Ohm resistor is in parallel with a 20-Ohm resistor, is supplied by a 4-A current source. Calcula...

A:

Q: Qz findd L'of these fanctions 55+1 0-25 +1-8 2- S2-25 5 324

A:

Q: Q3/ A/ A3-phase, 5.5kW, 440V, S0HZ, cylindrical rotor S.M has synchronous reactance of (0+j2) 2/phas...

A:

Q: Describe the different types of Memories and their applications

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: A battery pack contains a number of battery cells in 2 modules wired in series. Each module contains...

A: To design a high AH capacity of a Powerpack, Modules are connected in mixed connection of series and...

Q: How the transistor can be used as an amplifier in CE configuration?

A: Thyristor comprises of three terminals, Base, Emitter and collector.  in the CE ( common emitter) co...

Q: Vtotal = 92 R = 286   What is the reading of voltmeter?

A:

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge. B...

Q: Find VCB?

A:

Q: D1 is programmed to be a logic D3 D2 D1 DO Select 1

A: D1 is programmed to logic 1. Because there is a connection bewteen select and the D1 through a diode...

Q: A 11 KVA single phase transformer has a voltage of 13.8 kV on the primary and 230 on the secondary d...

A:

Q: findd ľod these fanctions 228 12 5- 54 8- (Sta)(5+b)

A:

Q: 5 A , 2ix או(!) 7 A

A:

Q: In the circuit shown in Fig. 7, find the potential difference Vx – Vy 122 12Ω 12Ω ww 0.5A 122 12 Q 1...

A:

Q: Determine: a) dc transistor terminal voltages b) hie c) Rin d) vo iL e) Ais = is f) R, (to the left ...

A:

Q: Given a 4-bit signed input P=P3P2P1P0 and a control input Z, use a 4-bit adder and any logic gates ...

A:

Q: Introduction of Geothermal Energy and Geothermal PowerPlant

A: Geothermal Energy   It refer to the energy that is derived from the natural bheat of the Earth.They ...

Q: A uniform plane wave of frequency 5MHZ is propagating along the positive direction of the z-axis. Th...

A:

Q: A 1-hp, 220 V, 60 Hz capacitor-start motor has main and auxiliary winding impedance at starting of 3...

A:

Q: For triangle half wave symmetric signal with 8V peak value is used as modulating signal of AM modula...

A:

Q: In the following figure, the coordinates (x, y, z) of the lattice point B with respect to the origin...

A: Answer -

Q: Determine the resultant internal loadings acting on the cross section at C. 300 b/t -2t

A: FIND:  the resultant internal loadings acting on the cross section at C  

Q: Figure Q2 shows a BJT amplifier circuit. Assume VA = 150 V, B = 130, VT 25 mVand VBE = 0.64 V. The s...

A: Brief description : In the above given question they have mentioned a bipolar junction transistor ci...

Q: . Design a voltage regulator that will maintain an output voltage of 20 V across a 1-k load with an ...

A: Here Source resistance  should be less than load resistance  to maintain  required  voltage drop at ...

Q: D RL C es

A: The given circuit is cebter tapped full wave rectifier. In this we do analysis in two parts one for ...

Q: Two single-phase loads are connected in parallel. The first load is SOMVA with 0.8 lagging power fac...

A: The solution is given below