A coil of wire (N = 70) carries a current of 3A and has a radius of 8cm. The current is decreased at 0.3 A/s. Inside this coil is another coil of wire (N = 10 and r = 3 cm) aligned so that the faces are parallel. What is the average emf induced in the smaller coil during 6s?

A coil of wire (N = 70) carries a current of 3A and has a radius of 8cm. The current is decreased at 0.3 A/s. Inside this coil is another coil of wire (N = 10 and r = 3 cm) aligned so that the faces are parallel. What is the average emf induced in the smaller coil during 6s?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: A tube has been wounded with a solenoid of 700 mm length. Calculate the number of turns necessary…

Q: 08: Prove the capacitance of the coaxial cable of internal radius is a and external radius is b is…

A: Let a Coaxial cable having inner radius a and outer radius b. Having length L and line charge…

Q: A flashlight beam has an exit power of 100mW, an exit diameter of 3.8cm, and a divergence of 1.1…

A: Given, A flashlight beam has an, Exit power = 100mW, Exit diameter = 3.8 cm, Divergence = 1.1 degree…

Q: An air-core toroidal ring with a mean diameter of 4 cm is wound uniformly with 500 turns of a wire…

Q: A flat circular coil with 40 loops of wire has a diameter of 32 cm. What current must flow in its…

A: Gven Data N = 40 B = 3 x 10-4 Wb/m2 r = 32/2 = 16 cm = 0.16 m

Q: A conductor of radius a is bent into a circular loop of mean radius po (see Figure If p, = 10 cm and…

A: Two conductor are inductively coupled when change in current in one conductor induce voltage in…

Q: A flat circular coil with 40 loops of wire has a diameter of 32 cm. What current must flow in its…

A: In a current carrying coil, the magnitude of magnetic field produced at the center of the coil (B)…

Q: Determine the maximum voltage which can be applied across the parallel plate air capacitor having…

Q: 3. A coil of 40 turns is wrapped around a long solenoid of cross-sectional area 7.5 x 10³ m². The…

Q: At room temperature (300 K) with the Fermi level located exactly in the middle of the bandgap, if…

A: We need to find out the probability of state is empty .

Q: Two coaxial conducting cylinders of radius 5 cm and 9 cm have a length of 4.56m. The region between…

A: Formula for calculating capacitance is provided in the answer. Answer after rounding to two decimal…

Q: An inductor in the form of a solenoid contains 420 turns and is 16.0 cm in length. A uniform rate of…

A: We need to find Radius of solenoid. We are given number of turns , length , rate of current change…

Q: 3. Two circular metal plates of radius 0.610 m and thickness 7.10 mm are used in a parallel plate…

A: Given, Radius, r=0.610 m Gap between plates, d=2.10 mm Half of space between plates is filled with…

Q: Determine the value of self inductance of a 6 cm long air cored solenoid, if the coil has 240 turns…

Q: 3. What value of capacitance is required to produce 50 V of reactance at 450 MHz?

A: Capacitance reactance Xc= 12π× frequency × capacitance Given capacitive reactance = 50 ohms and…

Q: Determine value of capacitance of a spherical capacitor whose inner and outer radius are 2m and 4m…

A: Given values are =

Q: How can self inductance be defined? What will happen to the self inductance of the coil if the…

A: When charges move with a constant velocity, the charges produce a static magnetic field. A current…

Q: 10.10 The capacitance of a capacitor with a dielectric of air is 1360pF. When a dielectric is…

Q: An electric generator contains a coil of 100 turns of wire, each forming a rectangular loop 50.0 cm…

A: Given: N=100A=50cm×30cm=0.15 m2B=3.5 Tω=1000 rev/min=1000×2π60 rad/s

Q: A. A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter…

A: we have given;number of turns in coil=1000the cross seectional area of coil =4cm2=4×10-4m2mean…

Q: Q₁: An electron starts from rest at the negative plate of a plane- parallel capacitor separated by 2…

A: One volt energy of Potential difference is equal to one joule of energy of Potential difference…

Q: A spherical capacitor having a radius of 5cm and 5.5cm for positive and negative conductor…

Q: · (a) A parallel plate capacitor consists of two metal sheets of copper foil, each of area 0.5 m²,…

Q: A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds,…

A: The current flowing through the coil is given as Differentiating the current i(t) with respect to…

Q: coil has a mean diameter of 2 cm having 60 turns is placed co-axially at the center of a solenoid 50…

Q: 19. Two metallic plates seperated by 9.8 cm. If a plastic material is inserted between the plates of…

A: Take the ratio of capacitor with plastic material as a dielectric and without dielectric to find…

Q: Q1. The distance between the plates of a plane parallel capacitor is 1 cm. An electron starts at…

Q: A spherical capacitor consists of a conducting sphere of radius a on the inside and a sphere with a…

Q: Design a spherical shell to give a capacitance of 40 pF. You can use an insulator having a…

A: Given Capacitance of the spherical shell is 40 pF The radius of the out shell is 40 cm Insulator…

Q: Determine the value of capacitance required to produce 50 Q of reactance at 450 MHz. (round-off your…

A: In this question we will find capacitance value with given reactance..

Q: An air-filled capacitor is formed from two long conducting cylindrical shells that are coaxial and…

Q: A coil has 240 turns and is wound on an air-cored bobbin 4.5 cm long and 0.2 cm in diameter. Given…

A: Given a coil has 240 turns and is wound on an air cored bobbin 4.5 cm long and 0.2 cm in…

Q: 11.) A tube has been wounded with a solenoid of 700 mm length. Calculate the number of turns…

Q: A parallel plate capacitor consists of two metal sheets of copper foil, each of area 1 m, separated…

A: A parallel plate capacitor consists of two metal sheets of copper foil, each of area 1 m, separated…

Q: (Just a question, not an experiment.) In figure 5, at which of these two points, X or Y, is the…

A: Electric field Intensity- Electric field intensity is the force per unit charge when a charge is…

Q: A. Two inductors whose self-inductances are given as 75mH and 55mH respectively, are positioned next…

A: In this question ,inductance related questions are given......We have to find out mutual inductance…

Q: Q9. Which of the following is one means by which energy or electrical noise can couple from one…

A: Coupling capacitors are used in electronic circuits to pass the desired AC signal and block unwanted…

Q: A solid dielectric specimen of dielectric constant of 4.00 has internal void of thickness 0.05 mm.…

Q: 元。 Coil 1 Coil 2 (も)

A: The equation for induced emf across the two inductors is as follows: When there is change in I1…

Q: What will be the mobility of holes if the drift velocity of holes is 3 m/s and the applied electric…

A: Given data: The drift velocity of the holes is vd=3 m/s The applied electric field is E=3…

Q: Q1. The distance between the plates of a plane parallel capacitor is 1 cm. An electron starts at…

A: We will equate the forces to find time taken to reach the positive plate.

Q: A coil with a self-inductance of 16 mH and a resistance of 6 Ω is connected to an AC source whose…

Q: QUESTION 24 The insulating material, in a capacitor, which cannot conduct but can store a charge, is…

Q: alculate the capacitance between a 50V conducting wire and its image if the wire has a diameter of…

A: It is given that: D=10 cmr=D2=102=5 cmd=3 cm

Q: Q26. There are three electric field lines as shown here. At which position has the lowest field…

A: In this question they have mentioned the electric field pattern for electric field lines…

Q: N 11. Consider a piezoelectric capacitor shaped like a slab 1 mm thick and 3 mm² in area.…

Q: 2. As frequency decreases, how does the reactance of a coil vary? 3. What is skin effect, and how…

Concept explainers

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds, is placed next to a second coil, end to end. At t = 0.720 s, a lab tech measures the emf across the second coil, and the result is −3.50 V. What is the mutual inductance (in mH) of the coils?
A cylinder whose radius is 2cm and altitude of 100cm is uniformly wound with 2500 turns of wires in a single layer. A second layer of 100 turns and of much finer wires is wound over the first near its center. Calculate the mutual inductance of the coils.
A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter is 20cm. The cross-sectional area of the coil is 4 cm2. Determine the self-inductance of the coil.
A. A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter being 20 cm. The cross-sectional area of the coil is 4 cm2. Determine the selfinductance of the coil.
Calculate the capacitance between a 50V conducting wire and its image if the wire has a diameter of 10cm and the distance between the wire to a nearby conducting plane is 3cm in free space. *
A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Do the required calculations and select a core material for the coil from the table below. Your answer will be given over the following series of questions. A. H = 0.12566 oersted B. H = 12.56637 oersted C. H = 1.25664 The relative permeability of the manufactured solenoid from the previous question is: A. μr = 15.916 B. μr = 15915.964 C. μr = 1.2665e10 D. None of the mentioned/ Geen van die genoemde
A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Do the required calculations and select a core material for the coil from the table below. Your answer will be given over the following series of questions. A. H = 0.12566 oersted B. H = 12.56637 oersted C. H = 1.25664
ELECTRICAL TRANSIENTSA certain precision 1 microfarad capacitor has very high resistance material used between its conducting surface. The capacitor is charged to 1 volt at t = 0 and disconnected from the source. It is found that the voltage drops to 0.80 v in 1 hour. What is the insulator resistance?
A uniform magnetic field B is perpendicular to the circuit surface of a copper wire Radius 5cm, Wire Radius 1mm Find the value of dB /dt to allow current to be generated An electrician in a wire of intensity 10A .
A coil with 120 turns effected by variable magnetic field which is decreased by 40µwb per second, the magnitude of the induced emf is ?
A tube has been wounded with a solenoid of 700 mm length. Calculate the number of turns necessary over the solenoid to produce a field strength of 400 AT/m at the center of the coil. The current through the coil is 0.5 A.
5 Assume that you have been tasked with evaluating a new inductor. The inductor has a Q of 1454 at 50KHZ; a 0.1mm diameter, and is fabricated by wrapping a 10meter length copper wire wound around a magnetic core. Assume the following parameters for copper wire wound around a magnetic permeability of copper is 1. A. what is the inductance of the inductor? B. Assuming that the skin affect does not affect the Q at 50KHZ at all, determine the Q at 50MHZ.