A compound curve has the following characteristics:  I1= 24°        D1 = 6° I2= 36°        D2 = 4° Stationing of P.C. = 10 + 420 Compute the stationing of P.C.C.

Q: 2. Using Superposition, find Vo. 2 ΚΩ ΣΚΩ ww συ ww 4 mA 51 ΚΩ 12 V ΣΙΚΩ ΣΙΚΩ Vo

A:

Q: Example: Delta-connected load consists of 10-Ohm resistance in series with 20-mH inductance. Source…

A:

Q: Find the total resistance if R1 = 200 ohms and R2 = 200 and R3 = 800 ohms are all connected in…

A: Given here three resistance values and asked to find the total resistance when they are connected in…

Q: t" 151 4,7кл А R₁ 6.8k.№ kn =E₂ Tov 15K₂ -R3

A: Given: Required: Using KCL or Nodal analysis to find the voltage VA.

Q: 4. Find Vx using Kirchhoff's Law. 20 I FIND Vx 3Vx Vx: F5 F15

A: We need to find out unknown voltage for given circuit .

Q: What is the value of critical frequency (MHz) if a signal radiated from transmitting antenna has an…

A: Given here MUF=10 MHz and angle of elevation = 33° we need to find the critical frequencyin MHz.

Q: g(t)=sinc(t) g(t)=2t^2-3t+6/1-t Find: Odd and even part

A: Given signals are i) g(t)=sinc(t) ii) g(t)=2t^2-3t+6/1-t We need to find even and odd parts of the…

Q: A network containing 100 buses in which 10 are the voltage control buses, 5 are fixed shunt…

A: Given, Total number of busses, n = 100. Voltage control bus = 10. Fixed shunt capacitor bus = 5.…

Q: 188. A DC shunt generator supplies 450 A at 230 V. The resistances of shunt field and armature are…

A: Given a DC shunt generator with, Supplied armature current, Ia=450 A. Terminal voltage, Vt=230 V.…

Q: าร 3.3k .Ii 3.312 Iz {tok

A:

Q: πι Determine the equivalent resistance: Rab. Rbc. Rcd. Rde. Rbd and Rae. Ε 6Ω 38 www Μ 38 32 452 www…

A:

Q: (0 0 350-0 0 (a) Complete the following truth tables by simulating the 3-input circuits implemented…

A:

Q: A motor draws 576 W at 143 Vrms 60Hz. The motor is operating at a lagging power factor, with a power…

A: Given data: The active power, P1=576 W The angle, ϕ1=45°. The frequency, f=60 Hz The angle, ϕ2=15°.

Q: Find the voltage between the adjacent lines of a balanced six-phase star-connected system with a…

A: Given: A balanced six-phase star connected system A phase voltage, Vph=132.8V

Q: What is the radiation resistance of a dipole antenna A/20 long approximately equal to?

A: Given, Length, dl=λ20. Radiation resistance of dipole, Rr=?

Q: 6. Consider the following system 0 il com J k m (a) Find the transfer function (s)/T(s) (b)…

A: In this question,  We need to determine the transfer function of the given system.  We are solving…

Q: In the circuit shown in this figure, what is the mesh current 1₁? R₁ R₂ 8V O1₁-3.4 mA Ol₁=3.0 mA.…

A: Given,

Q: A positive-sequence balanced three-phase wye-connected source with a phase voltage of 242 Vrms…

A:

Q: An ACSR conductor has a diameter of 2 cm has internal inductance of 0.05 mH/Km. If this ACSR is…

A:

Q: (0)) (a) Is the logical circuits built in Step3 (b) working without errors? Yes/No (0,1 input error)…

A:

Q: A 240-V shunt motor has an armature and shunt field resistances of 0.20 and 120 Ohms respectively.…

A: Given, Voltage, V=240 V Armature resistance, Ra=0.20 Ω Field winding resistance, Rf=120 Ω Rotational…

Q: Determine the equivalent resistance: Rab. Rbs. Red Rds. Rbd and Rae. Μ ww 6Ω 32 6Ω Μ 32 be 32 ΦΩ ΖΩ…

A:

Q: Sketch the following continuous time signals. 1. x(t) = u(t-1) + u(t-2) 2. x(t) = 2u(3t - 9) 3. x(t)…

A: We need to draw the following signal ,

Q: 1. Find the voltage between Vout and GND in the right picture. 12V R₁ - Ry R4 O Vout

A:

Q: 1. (10%) For the circuit shown in Figure P4, find the current i. Ο 10 Ω 12 1A (1) ΤΑ www • 20 Ω 351…

A: Given, The circuit diagram,

Q: Construct a truth table for the Boolean equation: F = A’B’ C + A’B C + A B’C’ + A B’C +A B C’ +…

A: Given here a equation and asked to draw the sop form of function and asked to minimize the equation.

Q: The circuit shown in the figure is equivalent to:

A: Given data, finding equivalent circuits across load terminals a and b is done using Thevenin…

Q: In the network given (Figure 2), determine the current flowing through the branch of 4 ohms…

A:

Q: The load on a given station consists of 2,000 KVA at 0.866pf inductive. Two alternators each of…

A: load on the station = 2000 KVA at 0.866 inductive  P/S= power factor total load power P= S*power…

Q: The Boolean expression (Ā + B) · (A + C) · (B + C) simplifies to A) (A + B) C B (A+B)C C (A + B)C D…

A: Given Boolean expression, A+B.A+C.B+C.

Q: Do the polarities of the sources in Figure 1 matter as to the resulting voltages? Will the…

A: The above question is based on the superposition theorem. The superposition theorem states that the…

Q: 3A 402 160 Find R₂ for max. Find Pmax. $502 d 20V power transfer.

A:

Q: The transistor has a scale current of 1.5 x 10-¹4 A and VCEsat = 0.2 V. It is operating at 300°K. a.…

A: a) The circuit diagram is given as Transistor will be turn ON,…

Q: Determine if logical notation is tautology, contradiction, or contingency a. (pVq) (pr)^(q →r) → r…

A: Tautology: If the all the final outputs are true then this notaion is Tautology. Contradiction: If…

Q: 2. Express the following numbers in polar form. a. 1+j b. j

A: Consider a number in rectangular form z=x+jy. The polar form of this number is given as z∠θ. Where…

Q: For the following circuit, G(s) = 1/s and H(s) = 1/(s+a) otet sosia 10-3H20-mo ►Y(s) X(s) + G(s)…

A: Given block diagram: The transfer functions are, Gs=1s,Hs=1s+a.

Q: Draw the complete logic diagram from the given logic equation, maximum of 2 inputs per gates used.…

A:

Q: [Q1] If the signal 4 cos 4750Tt Volt is used to modulate 12 cos 245600nt Volt carrier via the DSB-LC…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: (a) (b) (c) Answer the following questions Evaluate: Find and plot z(t) if z(2t - 1) = Find the…

A:

Q: b) (3y+-- X x dy TA y²dx +(5x+ 1 y y x =0

A:

Q: An ACSR conductor has a diameter of 2 cm has internal inductance of 0.05 mH/Km. If this ACSR is…

A: Given an ACSR conductor has, Diameter, d1=2 cm. Internal inductance, Lint1=0.05 mHkm. If ACSR…

Q: The Silicon transistor circuit shown ensures a constant current of 100 mA is delivered to the load…

A:

Q: E2.7 Find I, and I, in Fig. E2.7. Figure E2.7 4₂₁ 6 mA 1mA 1.51₂

A:

Q: The lengths of two discrete time sequence x₁ [n] and x2 [n] are 1 and 6 respectively. The maximum…

A: We need to find out the length of output for given convolution .

Q: 2. What is the current through R2? VS1 15V R1 68 22 VA R2 30 22 VB R3 100 Ω VS2 8V

A: Given data, Circuit diagram is given as,

Q: Q5 Two baseband signals m, (t) and m₂ (t) are to be transmitted simultaneously over a channel by…

A:

Q: 2. Determine the value of RL that can deliver the maximum power by reducing the network to a single…

A:

Q: 2. For the circuit, find R such that maximum power is dissipated in R, and calculate the value of…

A:

Q: Fig. 3-17 Applying Thevenin’s Theorem 1 ΚΩ + 80 Μ 2 ΚΩ +51 § 2 ΚΩ 1 ΚΩ (b) (a) Α 2 ΚΩ 1 ΚΩ +55 2 ΚΩ…

A:

Q: A student wraps 100 turns of wire on a pencil that is 7 mm in diameter as shown in Figure 13-46. The…

A: Here we have to find the inductance of the coil formed.