A critical communications relay has a constant failure rate of 0.1 per day. Once it has failed, the mean time to repair is 2.5 days (the repair rate is constant). Calculate the steady-state availability.

A critical communications relay has a constant failure rate of 0.1 per day. Once it has failed, the mean time to repair is 2.5 days (the repair rate is constant). Calculate the steady-state availability.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.19P

See similar textbooks

Related questions

Q: 11- To increase the transfer power in a 230 kV transmission line, we plan to use a series capacitor…

A: Given - Length of the line= 100km Line X = 0.0911pu

Q: followed,disaster often * occure;these disaster are loss of human life O huge monetary costs O all…

A: When ethics is not followed, disaster happen it may be human life loss,it may be Environment impact,…

Q: How can we calculate the safe distance (horizontal and vertical) of the transmission line 11kv?

A: A transmission line is a network of wires used to transport electrical impulses from one location to…

Q: Determine the following a) time constant, and b) settling time of a first order system with a rise…

Q: External effects causing short circuit include insulation failure due to lightning surges,…

A: Actually, short circuit is a uncertain condition in a power system. When the phase and neutral wires…

Q: If the transient response of a given system settles within 5% in 9.6 Sec then the extra time…

A: Given A given system settles within 59% in 9.6 Sec then the extra time required to settle within 2%…

Q: 4=4 Disceuss of a Lontrol system, for differe 7ypes input , 9 static the steady state behar with the…

A: In this question we will find steady state behaviour of control system using static error…

Q: QUESTION 1 True or false? A Type 0 system can track a unit ramp with finite and non-zero…

Q: You’re on the moon, skipping around, and your radio breaks. What would be the best way to…

A: Longitudnal wave is a form of wave which propagates and needs a medium to transfer its energy…

Q: Hybrid electric car engines are fueled by gasoline but can also run from a battery that's recharged…

A: Answer: True

Q: YouTube Gmail M Co Harmonics generated due to the presence of switching power electronic devices are…

A: Harmonics generated due to the presence of switching power electronic devices

Q: Q2. 30, 220 kV, 50 Hz, 115 km long transmission line consisting of three conductors each of 20 mm…

Q: Problem 3: Consider the single generator connected to the infinite bus system with two transmission…

A: The transmission line equation may be used to determine the length of a line that provides the most…

Q: Hybrid Coupler ODU (Out Door Unit) Antenna RF Frequency e.g. 7GHZ Waveguide Intermediate Frequency…

A: Diversity in Microwave: Diversity refers to an improvement in reliability for the transmission and…

Q: Problem 3: Consider the single generator connected to the infinite bus system with two transmission…

A: In the given question, it is given that there is a single generator that is being connected to the…

Q: For a STABLE LTI system, all the poles of the system function H(z) must lie inside the unit circle.…

A: The LTI system is considered as stable when the bounded input provide a bounded input.

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm…

A: The correct answer can be achieved as follows.

Q: negligible only if the length of the Transmission Line does not exceed how many kilometers? A. 240…

A: In this question, we will write shunt capacitance effect...

Q: Problem 2: Consider the single generator connected to the infinite bus system discussed in class.…

Q: Q5. Assume that the following permanent outage data has been given for the system shown below:…

A: (a) In the given figure each parallel line consists of 138kV breaker, 138 kV line, Transformer and…

Q: calculate power flow for IEEE 30 bus manually using NR method Please hand written solution

Q: Take €°= 1/(36π×10^9) A single core concentric cable is to be manufactured for a 100kV, 50Hz…

A: Given information, The maximum permissible safe stress is gmax=10000000 V/m. The working line…

Q: A distribution zone substation has a fault level of 400 MVA on the 11 kV bus. A 2 MVAR capacitor…

A: Given data, The value of system voltage is Vs = 11 kV. The value of capacitor bank is C = 2 MVAr.…

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of diameter…

A: The solution can be achieved as follows.

Q: Several natural processes can interfere with the proper functioning of a transmission line, such as…

A: It is given that several natural processes can interfere with the proper functioning of a…

Q: Electromagnetic Induction type relays are widely used to protect the DC network True False

A: False. Given statement is false.

Q: Bus bar system which ensures continuity supply during maintanence is O duplicate bus bar O single…

A: The explanation is as follows.

Q: Choose the correct Answer: The difference in the propagation delay between the fastest and slowest…

A: delay skew is the difference between the propagation delay on the fastest and slowest pairs in a…

Q: 1- The 66 Ky lines use (pin insulators/suspension insulators). 2- The self-capacitance of string…

A: 1). The 66 KV lines use suspension type insulators. Upto 33 KV pin type insulators are used. 2).…

Q: Q2. 30, 220 kV, 50 Hz, 115 km long transmission line consisting of three conductors each of 20 mm…

Q: Q1. In the system segment shown in Figure-1 below, if the system inductance and capacitance are…

A: Fig: Given power system Given that L= 74.80 mH C=0.265 μF Vph=1003 V

Q: Most communications satellites are in a geosynchronous orbit. True O False

A: Choose the correct options Check the given statments is correct or false? most communications…

Q: 02. 30, 220 kv, 50 Hz, 115 km long transmission line consisting of three conductors each of 20 mm…

Q: For the cirouit shown below, draw the d.cA load line and defermine the oferading Point. 530 ka Ic

Q: 1. The EMF of a generator of 377 ohm internal impedance is a 2 us long pulse of 12 volt amplitude.…

A: Given: The EMF of a generator of 377-ohm internal impedance is a 2 µs long pulse of 12-volt…

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm…

A: The solution can be achieved as follows.

Q: RMS VALUE OF MAXIMUM AND MINIMUM STRESSES IN INSULATION OF SINGLE CORE CABLE Emax=50kV/cm AND…

A: The maximum and minimum stress in the insulation of 1-core cable is related to the radius of the…

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm…

A: The solution can be achieved as follows.

Q: a) Design a MOD-12 synchronous counter using the Detect and Steer method.

A: Due to the fact that all flip-flops receive clock input simultaneously, synchronized counters are…

Q: A complex communication satellite has an inbuilt microwave repeater unit, having a mean time to…

A: According to the question, a complex communication satellite has an inbuilt microwave repeater unit.…

Q: Note: Answer the question by Poles and Zeros of the System "Function H(z)" & Comments on System…

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmission line consisting of three conductors each of 10 mm…

A: The solution can be achieved as follows.

Q: Examine the function of contemporary wireless communication technology in the Smart Grid's rollout.…

A: Here we discuss about wireless communication used for smart grid technology.

Q: A single core concentric cable is to be manufactured for a 100kV, 50Hz transmission system. The…

A: Given data, The maximum permissible safe stress is gmax = 10,000,000 V/m. The working line voltage…

Q: For the system shown below, determine its stability

Q: Imagine that you're told to install a grounding electrode conductor to the TMGB. Based on this…

A: As per BARTLEBY GUIDELINES, For Multiple Questions, we have to answer only first question. So I…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Note: Answer the question by Poles and Zeros of the System "Function H(z)" & Comments on System Causality and Stability. Also, please explain the answer with the drawing.
For a STABLE LTI system, all the poles of the system function H(z) must lie inside the unit circle. Select one: True False
• Zh = 100 ohm • Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If the 33 kV busbar voltage is kept constant at 30 kV and 0.8 inductive 50 MVA power is drawn from this bus, what is the voltage at the synchronous machine ends?
Determine the range of k using the bilinear transformation method, for which the system remains stable, from the calculated range, evaluate a stable and an unstable value of 'k' and verify its stability
A generating plant containing three identical 40 MW generating units is connected to a constant 82 MW load. The unit failure and average repair times are 3 failures/year and 8 days respectively. Develop frequency, duration and probability risk indices for this system.
Power system protection and control: Developing advanced protection and control systems that can detect and respond to faults and disturbances in the power grid in real-time. Describe how this problem will affect the world in 100 years
An operator expects the system load to be constant for the next few hours at 360 MW. a) How many identical 60 MW thermal units must he commit and spin if the failure rate o each is 5 f/yr, the lead time is 2 hours and the unit commitment risk must be less tha 0.005 b) How should these units be dispatched in order to minimize the 5 minutes respons risk if the response rate of each is linear at 1 MW/minute c) Evaluate the response risk if the system requires a minimum of 35 MW to respon within 5 minutes. d?e?nfinutes.
Over-reliance on renewable energy sources is the main cause of energy crisis. Select one: True False
Calculate the propagation delay and RTT for a 100 m copper link.
a-the system is stable if region of convergence (ROC) b- the system is causal if region of convergence (ROC)
Hi, How to obtain Vth? thanks
Explain the principles behind economic dispatch and optimal power flow in power system operation, including the challenges associated with minimizing generation costs while ensuring grid reliability.