A cube of a material of side 1 cm has a resistance of 0.001 Q between its opposite faces. If the same volume of the material has a length of 8 cm and a uniform cross-sectional area, what will be the resistance of this length? Use three decimal places. *

Q: Write any 5 Home appliances which has temperature sensors.

A: The temperature sensor is an electronic device that measures the temperature. There are number of th...

Q: Two conductors carrying 60 A and 75 A, respectively are placed 10 cm apart. Find the force between t...

A:

Q: 4. Given Vcc=100V, R,=2002, R;=1002, B=100, VBB-5V. Flip the switch to CC close 1) Determine Ip. 2) ...

A:

Q: · For the series circuit shown, use the laws of circuit theory to calculate the following R1 3 kQ - ...

A: The solution of the following questions are

Q: FNo ho Qnd thu Maaimum Bwen then Cror Bo Trois kred.

A:

Q: Assume, there was a daily cost of 10 cents/day per kW for the mitigation (repair) of the total envir...

A: Given that daily cost=10cent/day-kW

Q: A unity feedback system has been operated for 5 years and need to be evaluated. It has an open loop ...

A: Solution-                     Gs =Ks(s+1) (s+3) a) for 4.32% overshoot ,                      e-πξ/1...

Q: 1. The current in the 12 2 resistor in the following circuit is 1 A, as shown. a) Find vg b) Find th...

A: The solution is given below 

Q: What is armature reaction, and how its effect can be overcome.

A:

Q: ExplainWhat makes signal communication advantageous in an infrantry operation? Write in 200 words.

A: Communication system is a collection of individual communication networks, transmission systems, tra...

Q: Voltage Peak value RMS value Average value Peak-to- peak value O v Time

A:

Q: a. What is the magnitude of the electric force between two protons separated by 2 x 10° m?

A: As per bartleby guideline for more than one question asked only first is to be answered please uploa...

Q: Two straight parallel wires 5 m long and 2 mm apart carries currents of 8 A in opposite direction. F...

A:

Q: QUESTION 2 A function is represented by the following Karnaugh map. АВ 00 01 11 10 00 x 01 CD 1 1 X ...

A: Given a function is represented by following Karnaugh map,

Q: Three identical capacitors are connected in delta to a 408 V, 50Hz, 3-phase supply. If the line curr...

A:

Q: The volts per unit of a 60Hz,13800/460V transformer is 6.57 (a) calculate the number of primary turn...

A:

Q: E1 +22 V 三 R, 340 V R1 R3 18 N E, = +22 V +

A:

Q: do Vout 22 21 R 2R ao 2R 2R 2R Vout 2R Vout a1 + ao R 2R Schematic of a 2-bit DAC (left). Equivalent...

A:

Q: Consider the following canonical form of a Boolean function F(W ,X ,Y ,Z) F(W ,X,Y, Z)-(1,3,4,5,6,7,...

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: Select the correct answer. In a Y-Y system, a phase voltage of 100 V produces a line voltage of: 100...

A: Given, In a Y-Y system, Phase voltage, Vph=100 V  

Q: 3. A factory's separately excited DC generator has an armature resistance of 0.250. The machine is d...

A: Separately excited DC generator- Machine whose field winding is energize by an external DC supply so...

Q: Given the following circuit, solve for I,. Must use Super node.

A:

Q: 1) An analog signal x(t) = cos(320nt) + 2 cos(480nt) – cos(960zt ) is sampled with sampling frequenc...

A: Note- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: Calculate average voltage of the given pulse waveform for the frequency of 50 Hz for the shown fi7. ...

A: Average voltage = duty cycle × time period.  Duty cycle =pulse width/time period.   

Q: What current will be needed to produce a voltage of 520 V cross a 12 kΩ resistor?

A:

Q: How to make a circuit drawing diagram of an energy saving switch for a kettle?

A: KETTLE Kettles are one of the most basic kitchen gadgets. When you lift the lid and look inside, you...

Q: A circuit is operated at its resonant frequency, which is designed to be 240 Hz. The circuit contain...

A:

Q: A 1,000-kw three-phase converter delivers full load at 600volts. If the efficiency is 94percent and ...

A:

Q: For the circuit shown in Fig. 6, please answer Q6, Q7, and Q8. Q 6. The Thevinen's equivalent voltag...

A:

Q: 3. A conductor 120 cm long and carrying a current of 10 A, lies at right angle to a magnetic field o...

A:

Q: 2 Efud inductoniee pes km per phace.

A:

Q: Subject: Electrical Apparatus and Devices The percentage resistance and reactance of a transformer a...

A: The solution is given below

Q: R1 Sie R2 b In the circuit above, R1 is 35 n and R2 is 30 0. What is the equivalent resistance betwe...

A: Given data:     R1=35 ΩR2=30 Ω  

Q: Calculate the slip of a 6-pole induction motor with a rotor speed of 960 rpm at 口 0.05 口 0.06 0.04

A:

Q: A 400V, 3-phase Induction motor has input power of 12 KW and operates at power factor of 0.87 laggin...

A: Let W1 be one wattmeter reading and W2 be another wattmeter reading.  Input power W1+W2. Reactive po...

Q: When two identical resistors are connected in series across a battery, the power dissipated is 10 W....

A: Given: Two identical resistor are connected in series across a battery, the power dissipated is 10 W...

Q: Determine the exponential Fourier series for the impulse train shown below. x(t) 1 -2T -T 0 T 2т. 3п...

A: The solution is given below 

Q: A battery has a terminal voltage of 10 V when connected to the 20 resistance, but produces an open c...

A:

Q: Q3/ The following data was obtained from an investigation into th Y /\ voltage /current characterist...

A: Resistance of lamp is given by R=V/I Here the voltage is increasing and current is also increasing i...

Q: clectVon rakceis a Jubsta-

A: Solution Definition of free electron 1 : an electron within a conducting substance (as a metal) but ...

Q: Q1/ Form graph shown below. Drive the energy as a function of time. If the resistance 10KQ Charge (µ...

A: The graph is given for charge vs time. For calculation of energy, power calculation is required and ...

Q: In PCM system, the signal produced at the receiver output is the signal reconstructed from the quant...

A: 1 Explanation: A pulse code modulator produces a succession of binary integers, each of which is rep...

Q: 5.1.6 When the input to a given audio amplifier is (4 cos 8007t + cos 2000rt) mV, the measured frequ...

A: It is given that:ei=4cos800πt+cos2000πt mVf=1kHzV=1V

Q: 2. Circle the critical combinational path through this circuit, and calculate the propagation delay,...

A:

Q: ck Submit to complete this assessment Question 6 of 6 Save Answer wer input to a 306V, 3. 50 Hz indu...

A:

Q: A three-phase star connected six-pole induction motor has the following parameters. R, =0.294 2; R, ...

A: Polyphase induction motor Polyphase winding is present in the laminated stator and a conductive squi...

Q: 1... Why do we use round-shaped coils (I.e., Round shaped turns in the coils) in both the primary an...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Network for BJT Problem 30 V 6.2 kN 470 kN 220 kN 10 µF :5 μF 10 μF B Vi. B = 100 E 1.5 kN 5 µF

A:

Q: A generator develops 200 V and has an internal resistance of 100 O. Find the power delivered to the ...

A: Given: A generator develops voltage, Eg = 200 V Internal resistance, Rint = 100 Ω Load resistance, R...

Q: Resistor Value Identification from Color Coding and Verification by Measurement

A: The resistor value can be calculated by using the resistor color coding table and the sam can be ver...

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.