A current of 3.6 A transfers a charge of 375 mC. How long would this take?

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at co = 50…

A:

Q: An accelerometer of sensitivity 10 mV/g is used to measure the acceleration of a vibrating beam. A…

A: Given, Sensitivity=10mV/g number of bit=12 bits sampling frequency, fs=25KHz cpacitance C1=1 nF

Q: For the following circuit, G(s) = 1/s and H(s) = 1/(s+a)olest osig 40-520-mio -Y(s) X(s) + G(s) H(s)…

A: The given system is, Here, Gs=1s,Hs=1s+a.

Q: What benefits do digital systems have over analog ones?

A: Benefits of digital systems over analog system: Digital systems are using digital signals to…

Q: 2.25. A linear time-invariant system has impulse response h[n] = u[n]. Determine the response of…

A:

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: Note: We have considered Half wave electric dipole antenna. According to the question, if power of…

Q: An 800 kV transmission line has a maximum power transfer capacity, P, it is operated at 400 kV with…

A: Given- 800 kV transmission line, Maximum power transfer capacity=P, 400 kV operation voltage, To…

Q: a: e C D f

A: given are the two AND gates.

Q: A low pass filter is designed to ___. A. attenuate high frequency signals B. generate low frequency…

A: We need to select correct option for law pass filter .

Q: 1. Determine the spectral components of the FM signal below. VFM 100 [sin (204.6mx106) t+…

A: According to the question, we need to analyze the equation of the FM signal.

Q: Ques Determine 12 in mA.

A: Use nodal analysis to find node voltages Vab . Now using ohms law calculate current I2.

Q: 4. The portion of the flux that goes through one of the transformer coils but not the other one is…

A: We need to select correct option for given statement regarding transformer and induction motor

Q: Simplify the following expression to a minimum sum of products. (c) ((A + B')C)'(A + B)(C+ A)'

A: Given Boolean expression F = ((A+B')C)'(A+B)(C+A)' Asked to represent in minimum sum of products

Q: Compute for the resistance value. Show your solution

A: Color coding is a method used to identify the value of resistors. The number of the color bands may…

Q: The power consumed for the circuit shown below is 20Ω ww 30Ω OVO 15Ω 3A

A: Given circuit,

Q: G₁ H₂₁ G₁ H₂ G₂

A:

Q: When the number of poles of a low pass filter circuit is increased, the ___. A. frequency response…

A: We need to select correct option for given low pass filter .

Q: or a uise litude modulated (PAM) transmission of voice signal having maximum frequency equal to fm =…

A:

Q: 4. Find the power dissipated in each lamp to prove which lamp shines brighter than the other when…

A:

Q: 24V + 25 lons 30.n W 402 602 202

A: This is solved using the properties of star delta conversion.

Q: ܕܒܓ ܝܘ c(t) =1=e7r cos @at 1-g -sin out

A:

Q: The effectiveness of a data communications system depends on four fundamental characteristics:…

A: The effectiveness of a data communications system depends on four fundamental characteristics.....

Q: For the circuit shown below. Find ib 9V 1 ΚΩ + www 3 ΚΩ ww • 2 ΚΩ + Ava

A: In this question,  We need to determine the current ib  as shown the circuit.  We are solving this…

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: Introduction: A two-terminal passive electrical device used to limit or regulate the flow of current…

Q: 2. Find Ix. O Is 2 A R₁ 292 ww R3 1Ω R₂ 452 V₁ 4V Rs 292 www ww R₁ 30 R6 5Ω ww Is₂ 4 A O 2

A: The given circuit is shown below. Find current Ix.

Q: Determine minimum sampling frequency x(t)=4.5cos(194.53t)

A: As per guidelines i have to answer first question only.please ask remaining again.

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A:

Q: i₁ VR. + R₁ 24 R₂ e₂ s + Vi + in | Va R₂

A:

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Torque = 12π×flux×number of armature conductors×armature current×number of polesnumber of parallel…

Q: In your own words, how does the Philippine Electrical Code contribute to the electrical designs,…

A: It is asked to describe the contribution of Philippine Electrical Code to the electrical designs,…

Q: Determine the Thevenin equivalent circuit seen by the inductor on the circuit below. 101A + IL 300…

A:

Q: AF ADM system is designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz…

A:

Q: A single-phase power system consists of a 600-V 50-Hz generator supplying the circuit shown in…

A: The given circuit diagrams (1-a) and (1-b) are shown below: It is given that: V=600 Vf=50…

Q: determine the range of K to ensure stability. Problem #5 Repeat problem # 4 if G(s) K(s + 2) (s² +…

A:

Q: Draw a block diagram given the function shown below: a. F = A B + C b. F=XY+X'Y + Y' Z C. (A + B')…

A: This is a basic problem of logic gate function. The solution is given in the next step

Q: Given the discrete signal below, determine x(n/2) x(n) = n+1, -2 <n<5 0, otherwise

A: Given: xn=n+1,-2≤n&lt;50otherwise Required: xn2

Q: A telephone signal with a cutoff frequency of 5 kHz is sampled at a rate 60 percent higher than the…

A: Cutt-off frequency f = 5 kHz We have to determine the sampling rate.

Q: P1.43. We know that va = 10 V, vb = -3 V₁ vf = 12 V, and vh = 5 V, solve for the other voltages…

A: Given that: The figure is shown below. Va=10, Vb=-3, Vf=12 V, Vh=5V. Find Other voltages in…

Q: For the circuit shown below. Find ib 9V 1 ΚΩ W + 3 ΚΩ www • 2 ΚΩ +1 40a

A: Given circuit diagram, ib = ?

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: We need to find out modulation index for given AM signal .

Q: Solve for VDS round off your answer with 1 decimal value. VG=0V www lp 5 mA +1₁ RG 10 ΜΩ VDD +15 V Q…

A: Apply KVL in drain source loop to find drain to source voltage . According to kvl sum of the voltage…

Q: A 1.2-kW toaster takes roughly 4 minutes to heat four slices of bread. Find the cost of operating…

A:

Q: Two shunt generators and a battery are all connected to common bus-bars. The open circuit voltage of…

A:

Q: 2 52 Req R14.0 R33.13 www. R14.0 R2 3.0 R45.0

A: We need to find out the equivalent resistance for given circuit , we will do star to delta…

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: In this question,  We need to choose the correct option We know , the Active power is dissipate…

Q: Consider continuous standard telephone channel, with bandwidth 3100 Hz perturbed by bandlimited…

A:

Q: A 250V series motor draws a current of 40A. The armature resistance is 0.15 ohm and the field…

A:

Q: Solve for all the currents by Mesh Current Analysis. 10 Ω 220 V www 40 Ω 20 Ω 30 Ω 50 Ω 240 V

A:

Q: 4.33 Three single-phase, 10-kVA, 2400/120-V, 60-Hz transformers are connected to form a three-phase,…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: for the following circuit fill in the blanks (answer in phasor form ): V = 5 sin 10t a) i=.........…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.