I need the answer as soon as possible Situation:A curved surface is described in the problem statement.L = 1m.Surface is 1 mlong (normal to page)BWaterFind:(a) Vertical hydrostatic force.(b) Horizontal hydrostatic force.(c) Resultant force.

Given:L=1 mTo determine the vertical force, horizontal force and the resulatnt force.

Answered: A curved surface is described in the…

Engineering

Mechanical Engineering

A curved surface is described in the problem statement. L= 1m. %3D Surface is 1 m long (normal to page) Water

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.113P: Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels...

See similar textbooks

Related questions

Q: 1- The effective porosity is the value that is used in a gas reservoir engineering calculations.

A: Disclaimer: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: The value of surface tension is more at ______________________ . 50 oC 80 oF

A: So option (b) 80 oF is correct option.

Q: 2.6 In fig. Solution: 2.6, if h = 25.5 inches, determine the pressure at A. The liquid has a…

A: Pressure is the intensity of force exerted on a unit area. Here, the force is the weight of the…

Q: net buoyancy force су

A: Given; An aluminium alloy ;Density=2600 kg/m3A cylindrical hole of ;Diameter, d=100 mm=0.1 mLength,…

Q: b) A cylindrical tank contains water at a height of 55 mm as shown in Figure 1. Inside is a smaller…

A: The gauge pressure PA and height of kerosene in the smaller tank is required to be calculated as…

Q: A mercury barometer at the base of the mountain reads 620 mm. At the same time, another barometer at…

A: Given Mercury manometer reading, x1 = 620 mm…

Q: A fl oating body will be stable when its( a ) center of gravity is above its center of buoyancy,( b…

Q: Ice in an iceberg has a specific gravity of 0.922 . When floating in seawater sp. gr 1.03. its…

Q: for a clear solution

A: As per Bartleby policy if multiple questions asked then only first 3 parts need to solve hope you…

Q: In Tinyland, houses are less than a foot high! The rainfall is laminar! The drainpipe in the figure…

Q: Water 80F at 10 ft/s through a 6 inches sch 40 steel pipe with lenght of 1000ft The Reynolds number…

Q: Question 15 Calculate the gage pressure at the bottom of a water tank with a depth of 1m. 1000 Pa…

A: Gage pressure due to depth of water is given by Pascal's law.

Q: PIPE A and B contain water under pressure 276 Kpa and 137895 Pa, what is the h (in) of the mercury…

A: Guage Pressure: The pressure that is measured relative to the atmosphere is known as gauge pressure.…

Q: water will be supported to wh

Q: A trough is 6 feet long and 11 foot high. The vertical cross-section of the trough parallel to an…

A: Given trough is 6 feet long and 11 foot high.Assume vertical section of through is represented by…

Q: Madde P (kPa) T ('C) Faz tanımı H,O 10000 100 300 Dovmuş sıVI

A: From the steam table, At P=10000 kPaTsat=310.997 °CAnd the given T=100 °C,T<TsatHence At P=10000…

Q: 1,500 mm (1) 900 mm (2) (2) A C

Q: A piece of lead (sp. Gr. 11.3) is tied to a 130 cc of cork whose specific gravity is 0.25. they…

Q: 13) What does Pascal's theorem (wedge proof) state about the pressure at a single point in a fluid ?…

A: Applications of Pascals Law Hydraulic lift When lifting the high load body like a car by applying…

Q: Explain in detail c the soil layer. Use

A: At a point inside a soil mass, stresses will be created as a result of the soil lying over the…

Q: How high could the water shoot if it came vertically out of a broken (Assume that the atmospheric…

A: Find How high could water shoot if it came vertically out of a broken pipe.

Q: installed to enjoy the countryside views and is insisting on it, regardless of the cost. You have a…

A: Disclaimer from Bartleby: Since you have posted a question with multiple sub-parts, we will solve…

Q: Unlike gas, liquid does not form a free surface, and it expands to fill the entire available space.…

Q: List 5 criteria of a windmill.

A: A windmill is a mechanical device or a engine that is used to converts the winds energy into…

Q: ore than cohesion (b) cohesion is more th

A: Adhesion is the tendency of two or more different molecules to link together, whereas Cohesion is…

Q: Design and study of floating Roofs for Oil storage tanks. Case study : *100 mm of rain above the…

A: In case of study should have practical knowledge floating Roofs for Oil storage tanks.

Q: A solid wood cylinder has a diameter of 2.0 ft and a height of 4.0 ft. The specific gravity of the…

A: Given data:D= 2 ft = 0.6096 mH = 4 ft = 1.2192 mSw = 0.6So = 0.85

Q: PROBLEM # 4 Wells A, B, and C are all filled with mud that has a density of 10 ppg. TVD = true…

A: Given, TVD = true vertical depth (h) = 15000 ft The inclined segment of well B = 12000 ft The…

Q: Delamine fereoune at depth g25m unside a liquid Jn swmmingpool

A: Given data : Density of water ρ=1000 kg/m3Acceleration due to gravity (g)=9.81 m/s2Depth (h)=25 m

Q: . Sand is a cohesion soil

A: we have to decide of sand is a cohesive soil or not

Q: An aquarium 7 m lc the hydrostatic pre the hydrostatic for

A: Solution: 7x5x4 aquarium full of water To determine: hydrostatic pressure on the bottom force on…

Q: A1 of 50 cm2 , P1 = 100 kF %3D steadv, one-di

A: Given at inlet A1= 50 cm2 T1= 300 K V1=100 m/sec P1= 100 kPa A2= 40 cm2

Q: Distilled water stands in a glass tube of 9 mm diameter at a height of 24 mm. What is the true…

A: The forces of adhesion, cohesion, and surface tension cause the liquid to rise. When the adhesive…

Q: WARITHA een points below? Note:, Kerosene Air IT Troen 10cn 21cm 9cm 15 cm Benzene UNIVERSITY

Q: kinetic energy a

A: Ek=0.2521 MeV

Q: OIL Sp. gr. 0.8 30 сm 100 cm 50 cm EB

Q: Wet material containing 220% moisture

Q: A spherical buoy is moored to a river bed. The river flows from left to right. Because of flow, the…

Q: B. Answer two only of the following equations: 1. If the pressure of a substance in increased during…

A: Dear student, As you mentioned that you need only two solutions and you didn't…

Q: Because of a break in a buried oil storage tank, ground water has leaked into the tank to the depth…

Q: upper end flush with thế water surfācê? 7. In fig. fluid A is water, fluid B is oil(s= 0.85).…

Q: The surface tension is created by force in fluids Pressure Force Adhesive force cohesive force Shear…

A: given; the surface tension is created by ....force in fluid.

Q: viscosity and density of olive oil at 20C. use perrys table

A: To find Olive oil at 20 deg c

Q: How many barrels of oil are contained in 100 kL ofoil? One barrel (petroleum) equals 42.0 gal.

A: 'x' barrels of oil are contained in 100 kL = 100 x…

Q: Will It Float? Ship Specifications: Weight = 300 million pounds Dimensions = 100' (width) by 150'…

Q: /m2, how high is the water tank?

A: To find the height of tank.

Q: Covert 15.14 poises to kinmetic viscosity in square feet per second if the liquid has a specific…

Q: Will It Float? Ship Specifications: Weight = 300 million pounds Dimensions = 100' (width) by 150'…

A: Given Weight of Ship W=300×106 lbs Dimension of feet Width w=100 ft height h=150 ft length l=800 ft…

Question

I need the answer as soon as possible

Situation:
A curved surface is described in the problem statement.
L = 1m.
Surface is 1 m
long (normal to page)
B
Water
Find:
(a) Vertical hydrostatic force.
(b) Horizontal hydrostatic force.
(c) Resultant force.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Atmospheric pressure at sea level under standard conditions is ______inches of mercury (Hg) or_____ pounds per square inch absolute (psia).
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
Diagram of the problem, necessary formulas, clearance and numerical solution A cylindrical container with a surface area of 150 cm2 contains 1 liter of water and 2 liters of mercury. What is the pressure at the bottom of the container?
A closed vessel 1 m in diameter is completely filled with water. If the vessel is rotated at 1200 rpm, what increase in pressure will occur at the top of the tank at the circumference? Ans. 1970 kPa
Compute the hydrostatic force acting on surface ABC exerted by water. Given wall width as 2 m.
A wooden buoy of sp gr 0.75 floats in a liquid with sp. gr 0.85 What is the percent of the volume above the liquid surface to the total volume of the buoy?
15- What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00221 N/cm2 greater than the outside pressure? (Take surface tension as 0.075 N/m)
What is the absolute pressure at a point 4 meter below the free surface of liquid of specifc gravity of 1.53, if atmospheric pressure is equivalent to 750 mm of mercury.
If possible please draw figure. [Answer must Be in Handwritten Format Only] A tank of water (SG=1.0) has a gate in its vertical wall 5 m high and 3 m wide. The top edge of the gate is 2 m below the surface of the water. What is the hydrostatic force on the gate?
How far below the water surface should a vertical square 1.22 m on a side with two sides horizontal, be immersed so that the center of pressure will be 76 mm below the center of gravity?
Pressurized water fi lls the tank in Fig. . Compute thenet hydrostatic force on the conical surface ABC .