A cylindrical rod of steel having a yield strength of 310MPA is subjected to a load of 11,100N. If the length is 500mm, what must be the diameter to allow an elongation of 0.38mm? The Young's modulus for this steel rod is 207GPA.

Q: Find the cetane number of a liquid fuel if the Orsat analysis of the stack gas yields 7.5% CO2, 3.92...

A:

Q: In a piston-cylinder arrangement, energy is added and the piston is withdrawn in such a way that the...

A:

Q: A gas-vapor mixture consisting of benzene and N2 at a total pressure of 800 mm Hg and 45°C has a % s...

A: The vapor condenses when the partial pressure of benzene will be equal to saturation vapor pressure ...

Q: Explain the relationship between the decay formula N=N0(1+r)t and the formula for determining half-l...

A: Dear User ! The formulae for decay and half life given along with the question seem to be incorrectl...

Q: A 50.0 g iron ball (sp ht = 0.473 J/goC) is heated to 35oC and is placed in a calorimeter holding 10...

A:

Q: 26.6.2 How does an engineer compare the contacting patterns of se state operations of various high a...

A:

Q: 2.1 If the half-life time, t'2, of the initiator AIBN in an unknown solvent is 22.6 h at 60°C, calcu...

A: The rate is dependent on the concentration. The rate constant is obtained from the rate of reaction....

Q: Exercise 1 MW=200lb/lbmole НC oil L2=L'=? X2=0.005 Gas Out A benzene-air mixture is to be scrubbed i...

A: Given: Gas Flow Rate, V1 = 600 lbmolh Benzene fraction, y1 = 0.05 Liquid Benzene mole fraction, x2 =...

Q: Water is used in a heat exchanger (figure below) to cool 5 kg/s of air from 400°C to 200°c. Calculat...

A: Given that For hot fluid Thin  =400 CThout =200 Cmh=5 kgsFor cold fluid Tcin =20 CTcout =30 C

Q: Water boils at 100°C at atmospheric pressure, that is, at sea level (To-15°C). The boiling point is ...

A:

Q: . You are about to sail a Great Circle from A (12°20’N, 25°22' W) to Port B (55°19' S, 75°17'E). Fin...

A: A = (12°20' N , 25° 22' W) B = ( 55° 19' S, 75° 17' E) LatA = 12° 20' N LatB = 55° 19' S D.LongAB = ...

Q: The exothermic reaction of stillbene (A) to form the economically important trospophene (B) and meth...

A:

Q: Question 11 ts 100 Kg mol of a gas mixture input is given to a membrane with 30% O, and 70% N, the w...

A:

Q: The internal energy of water at its liquid phase under the temperature of 453.15 K and pressure of 1...

A:

Q: calculate the heat flux (per unit depth) through a composite wall section as shown in the figure, th...

A:

Q: Water condenses on the surface of an industrial reactor. An endothermic process in the reactor absor...

A: Given data: Rate of energy absorbed by the reactor = 50 kW Temperature of condensate = 5 0C Temperat...

Q: A 1g cube of metal A at 80 °C is placed in 100 cm³ of water and causes a 0.333 °C rise in water temp...

A: For metal A: Given, mass of the metal A, mA = 1 g The initial temperature of the metal, TA,0 = 80 °C...

Q: The following exothermic, reversible, gas-phase reaction is to be carried out in a CSTR: A =B The re...

A: Given that A↔B ∆HR  =-20kcalmolCPA =CPB =50 calmol K T1 =298 KT2 =300 K

Q: II. The adiabatic exothermic irreversible gas-phase reaction 2A + B→ 20 is to be carried out in a fl...

A:

Q: Problem 1: A mixture of n-heptane (03%), Benzene(45%), xylene(50%) and Ethyl-Benzene is fed into a d...

A: (1) Given, The composition of the feed is mole fraction of n-heptane, xF,1 = 0.03 mole fraction of b...

Q: 2) Please calculate the A,H"„(T) of C(s)+02(g)=CO(g). (1) C(s)+O2(g)= CO2(g) A„H (298K) = –393.3kJ[m...

A: By Rearranging the Equation,     C (s)     +    O2 (g)    =  CO2 (g)                                ...

Q: A steam pipe 200mm in diameter passes through a large basement room. The temperature of the pipe wal...

A:

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the...

A:

Q: Yennah needs saturated steam at 100C with a flowrate of 550 kg/h from an ice block using the steam ...

A:

Q: How many phases does a mixture of these liquids have? what are the composition of the phases? If the...

A: The ternary diagram defines two phases and single phases of a three-component mixture. The component...

Q: Q4b.A single-effect mechanical vapor compression system has the following design data. Mass flow rat...

A:

Q: Water at 25°C flows though a piping system with Y configuration as shown in the figure with their co...

A:

Q: Water is used in a heat exchanger (figure below) to cool 5 kg/s of air from 400°C to 200°C. Calculat...

A: Here, "a" represents air And "w" represents water Cpa is the specific heat of air CpW is the specifi...

Q: → _òn + 139 Ba + 56 94K 36 d. 23U + ¿n 137Te → 2;n + + '327 235 e. in + 2U f. 23PU He + 94

A: Given that :There is follwoing reaction given we have to complete the following reaction

Q: Direction: Answer the following guide questions: 1. What is the importance of considering viscosity ...

A: 1. Viscosity checks consistency of the end product to meet customer's expectations. Measurement of t...

Q: The equilibrium constant of the reaction 2 X (g) = Y (g) + Z(g) is found to fit the expression Ink =...

A:

Q: calculate the transmembrane fluxes in kmol/m2-s.

A:

Q: For a fuel with the following composition, 0.142 C2H(2*2+2) + 0.071 C6H(2*6+2) + 0.212 C5H(2*5+1)OH ...

A: Given data: Composition of the fuel is as follows: C2H6= 0.142 C6H14 = 0.071 C5H11OH = 0.212 C8H18= ...

Q: An experiment is conducted to determine the variation of the diffusion coefficient as a function of ...

A: Given data is- T1= 1410 C = 141+ 273 K = 414 K  T2= 5800 C = 580+ 273 K = 773 K  T3 = 3170 C = 317+ ...

Q: Discuss the diffusion through stationary non diffusing gas film.

A: Movement of molecules from high concentration to low concentration known as molecular diffusion. Dif...

Q: The pressure of steam at a temperature of 500°C and a density of 11.57006 kg/m3 in kPa is O 4500 O 4...

A: Given:   Density = MassVolume = 11.57006 kg/m3 Temperature = T = 500 C = (500 + 273) K = 773 Kelvin ...

Q: 6) Which of the following has the greatest effect on solid-state sintering? (a) Time (b) Temperature...

A: The treatment of powder compacted with heat at high temperatures is called sintering. There are thre...

Q: note on shale oil exploration from Paleocene-early Eocene sequence in Cambay rift basin, India

A: A shale may be defined as fine-grained, soft stratified sedimentary rock, which is formed as a resul...

Q: g. Li + ¿n → je + 소He + h. 1K 37 + je i. 235U + in _ồn + 31 + 39Y

A: Given that :there are 3 reaction given we have to complete the following reaction 

Q: Use your integrated rate equation to calculate the amount of time that would be required to have you...

A:

Q: Just answer D AND E PLEASE   The analysis of a flue gas from a fuel gas containing no nitrogen is 4....

A: The atomic balance on nitrogen gives moles of air. The atomic balance on carbon and hydrogen and oxy...

Q: 6) For a perfect gas, the AA of its isothermal change is_ (a) > AG (b)<AG (c) = AG (d) not sure

A:

Q: Action and reaction forces are equal in magnitude, oppositely directed and concurrent in action. A T...

A:

Q: How many grams of oxygen are in 65 g of C2H2O2? A 18 (В) 29 (c) C) 9 D 36 E) 130

A:

Q: Natural Gas with an analysis as follows: CO2 = 0.4 %, , CH, = 97.3 % , N2 = 2.3 % is burned in a fur...

A:

Q: Assuming the validity of modified Raoult's Law Equation, make a DEW P calculation for T=343.15 K, y1...

A:

Q: Substance A is 15.5 percent dissociated at 1646 K. and 1.00 bar. in the equilibrium: A(g) = 2 B (g)....

A:

Q: 2. Calculate the molar volume of saturated liquid (use SRK equation) and the molar volume of saturat...

A: The SRK compressibility factor correlation is used for saturated liquid to obtain the compressibilit...

Q: 7) At certain temperature and pressure, for a chemical reaction, which function can be used to judge...

A: We know that,  ΔG=R*T* ln Q K R is gas constant  T is Temperature  Q is the Reaction Quotient   If Δ...

Q: 3.) The vapor pressure of water at 25 °C is 23.76 torr. If 1.50 g of water is enclosed in a 2.0 L co...

A: Given the vapor pressure of water=23.76torr To find if there is any liquid present when 1.50g of wat...