Answered: A direct current shunt motor develops…

A direct current shunt motor develops 10 HP at 8000 RPM when drawing a line current of 40 A at 220 V. Find the efficiency at this load and the useful torque.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 13RQ: A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is...

See similar textbooks

Related questions

Q: Determine the current through R₁ in figure below if Vs = 50 V +0- Vs A www R₁ 560 Ω R₂ 330 Ω R₂ 330…

A: Given circuit: Source voltage, Vs=50 V.

Q: 1. A 16-bit Analog to digital converter has an input range of ±12 V. Compute the resolution error of…

A: Given data, Number of bit n = 16 Input range, ±12 V Full range of voltage, Vf=12--12=24 V

Q: Find the Req

A: The equivalent resistance of the given network can be obtained by reducing the parallel and series…

Q: T lines are designed for Digital data how they can be used for Analog Transmission?

A: Digital Transmission of analog information is possible if a minimum level of signal to noise is…

Q: 그 Clock D C e D e C B

A: P

Q: Using only 2-input totem-pole gates and as few inverters as possible, complete the logic to allow…

A: Given data: Inputs, Two LEFT systems, R1 & R2' One temperature sensor, H Output, Two RIGHT…

Q: F', (S) (2) a-Find a transfer function G(s) = V (s) the output. of the circuit shown below, where is…

A: Transfer function is ratio of laplace transform of output to laplace transform of input, keeping…

Q: QUESTION 4 What are the advantages of using high-density modules? O It allows for the possibility of…

A: Modules: Modules are manufactured by placing cells in a particular area or in other words when cells…

Q: Determine the Thevenin's equivalent resistance R TH as seen from terminals A and B. 3V tr 100 Ω Μ Α.…

A: Given circuit:

Q: 어 bo- 52 www 20 Q -10 2 40 2

Q: Consider the unity feedback system in figure 1 T R(S) Z.O.H 4 (s+2) C(s) Fig.1 Sampled data system…

A: Given: A system with Z.O.H., process gain 4s+2 and unity feedback. To do: 1. we have to determine…

Q: A 240 V. D.C. A shunt generator supplies a full load current of 60 A. The armature and shunt field…

Q: 4. Find io and V. 20 Ω Μ 30 Ω 10 Ω 500 40 Ω

Q: What is the relation between Fourier transform & Laplace transform? 5 comparison between Amplitude &…

A: A mathematical model known as the Fourier transform may be used to convert signals between two…

Q: Example 5.16. A square ABCD has each side of 1 m. Four point charges of +0.01 µC, -0.02 μC, +0-03 μC…

A: We have been asked to find the potential at point P which is center point of square which is being…

Q: Consider the circuit below containing two identical, p-n junction diodes D₁ and D₂: 2 ks2 www 5 V-…

A: Given, Threshold voltage VT=0.7V Ambient temperature=300K Reverse saturation current= IS=5μA Here,…

Q: Following are the results of a test carried out on a 230/600 V single phase, 7.5 kVA transformer.…

A: Solution: Given data; single phase transformer, KVA = 7.5 , V1=230 V , V2=600 V In short circuit…

Q: the figure below, where f 60kHz, 45kHz, 25kHz if ide

A: Given:

Q: 25 Ω 180 Ω 60 Ω 60 Ω

A: Given: Circuit diagram,

Q: Find the skin depth at a frequency of 1.6 MHz in aluminum, where o=38.2×10° S/m and μ, = 1.

A: Given: Frequency, f=1.6 MHz. For aluminum the conductivity σ=38.2×106 S/m. And relative permeability…

Q: Problem 2.4b: Sketch double sided and single sided amplitude and phase spectra of the following.…

Q: Line impedances for the power system shown in Figure 1 are Z12 = Z23 = 3.0 + j40.0 Ω, and Z24 = 6.0…

A: Any obstacle or measurement of the resistance of an electric current to the energy flow when voltage…

Q: An electromagnet consists of a coil with a laminated core assembly. This device takes 6 A when…

A: The electrolyte resistance, the current collector resistance, the active mass, and the transition…

Q: A 2H inductor has 500 turns. How many turn must be added to increase the inductance to 8H. O 500…

A: Given- 2H inductor, Number of turns, N=500, New inductance=8H. To Find- Number of turns to be added…

Q: 3- For the below block diagram the forward transfer function is while the feedback ratio is R(S) G3…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An energy meter makes 100 revolutions of its disc per unit of energy. The number of revolutions made…

Q: WHAT IS THE RELATION OF METASTABILITY TO MEMORY ELEMENTS?

A: To do: We have to describe the relation of Meta-stability to Memory elements.

Q: 12 A discrete relay type output module can be used to switch either AC or DC load devices. Why? OIt…

A: Relay:- An electrically controlled switch is a relay. It is made up of a set of working contact…

Q: (a) Calculate the synchronous speed of an eight-pole induction motor when supplied with power from a…

A: Given: An induction motor has following specifications, Number of poles P=8. Source frequency f=60…

Q: RN at terminals Fig. 3.191 (i). Find the values of in and ab for the circuit shown in

A: We have an circuit as shown in figure, We have been asked to find the values of IN and RN which are…

Q: Q3) a) What is the power of the signal below? x(t) = 5 cos(10t + π/2) TIP: use the trigonometric…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 4 Pole's DC generator delivers a current of 100 A at 230 V. It has 1500 armature carriers attached…

Q: Three resistance of 6 , 12 and 16 are connected in star connection. Find its equivalent delta…

A: We have been given three resistance with, R1 = 6 Ω R2 = 12 Ω R3 = 16 Ω This three resistance are…

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A: SOLUTION According to question input signal R(t) = r(t)…

Q: QUESTION 8 What electronic element can be used as the switching device for a 120 VAC discrete output…

A: Ans: Triac PLC outputs are of two general types: Relay and Solid state Relay outputs are…

Q: QUESTION 15 Compare the memory storage characteristics of volatile and nonvolatile memory elements.…

A: To do: We have to compare the Volatile and Non volatile memory for given points and to check…

Q: (i) An electrostatic field in xy-plane is given by (x, y) = 3x2y- y³. Find the stream function y…

A: Given- Electrostatic field in the x-y plane. ϕx, y=3x2y-y3, Complex function ω=ϕ+iψ, is an analytic…

Q: The maximum values of voltage and current in a circuit are 400 V and 20 A respectively. Both the…

Q: Find V₁ V₂ V₂ > 30V + v. Apply KCL 1.5+ V₂ System J 3.A and KUL I, I2, I3 J + 162 Omh's law J and of…

A: A circuit diagram is shown ab below. Find V1, V2, V3, and I1, I2, I3.

Q: A 250-volt resistance DC generator has an armature of 0.10, shunt field resistance is 500, and…

A: Given a DC long shunt generator with, Terminal voltage, Vt=250 V. Armature resistance, Ra=0.1 Ω.…

Q: 1. Find vo. Note that is the voltage across the 4-ohm esistor. 192 40 V 5A 292 www 892 www 40 20 V

Q: The signal flow graph of a system is shown below: U(s)o- 1/s 1/s -1 The transfer function of the…

A: Given- Signal flow graph of the system- To Find- The transfer function.

Q: 1- For a system with the transfer function Y(s) 2s³ - 12 U(s) 4s5 S3 + 4s 10 The state matix is…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: voltage is +80 V k. the time (2nd occurrence) after t = 0 when the voltage is –10 V Answers: a.…

Q: 1. Given a system with input x(t) and impulse response h(t) given by: x(t) = u(t), h(t) = u(t). Let…

Q: Compute the convolution x[n] *h[n] for all n ≥ 0, by using Graphical or Tabular method.…

Q: Choose the correct K-map for the given canonical form? F(A,B,C)= m(0,1,2,5,6,7)

A: Given canonical form, FA,B,C=∑m0,1,2,5,6,7

Q: 1-5. Minimize the function F = X+X+Y+XY

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Find the transfer function, 0₂ (s)/T(s), for the system below: Ra +-W eg(t) T (N-m) 150 J₁ = 4 kg-m²…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

A direct current shunt motor develops 10 HP at 8000
RPM when drawing a line current of 40 A at 220 V. Find
the efficiency at this load and the useful torque.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A dc shunt motor developes 10 HP at 8000 rpm when drawing a line current of 40 A at 220 V. Find the efficiency at this load and the useful torque.
A series motor takes 20Amp.at 400Volt to drive a fan at 200rpm.its resistance is 1Ω (field and armature) if the torque required to drive the fan varies as the square of the speed, find the necessary applied voltage and current to drive the fan at 300rpm?
A four pole DC shunt motor moves at 1000rpm on a 460v supply when taking an armature current of 45A. Annature resistance is 0,400hms, find the torque developed by the motor if the field circuit remains at 460V.
A shunt-connected dc motor has the magnetization curve shown with V_T = 20 V, R_A = 3 Ohms, and R_F+R_adj = 40 Ohms a) Find the no-load speed. b) Find the torque once a load is added that drops the speed to 20% less than the no-load speed.
A DC shunt motor is producing EMF of 220V running with 500rpm. And producing EMF of 200V with the speed of 1000rpm by adding external resistance with shunt field resistance. The original shunt field resistance is 250 ohm.Find the external resitance added resistance with shunt field resistance at 1000rpm. a. 300 ohm b. 250 ohm c. 500 ohm d. 550 ohm
A dc series motor takes 40 A at 220 V and runs at 800 rpm. If the armature and field resistance are 0.2 ohm and 0.1 ohm respectively and the iron and friction losses are 0. 5 KW, find the torque developed in the armature. What will be the output of the motor?
Calculate the torque in newton-meter developed by a 440-V dc motor having anarmature resistance of 0.25 ohm and running at 750 rpm when taking a current of 60 A.
A 440-V-rms (line-to-line voltage) three-phase induction motor runs at 1150 rpm driving a load requiring 15 Nm of torque. The line current is 3.4 A rms at a power factor of 80 percent lagging. Find the output power, the power loss, and the efficiency.
A DC series motor takes 40 A at 220 V and runs at 800 rpm. If the armature and field resistances are 0.2 Ω and 0.1Ω respectively and the iron and friction losses are 0.5 kW, find the torque developed in the armature. What will be the output of the motor?
440V shunt DC motor has an armature resistance of 1.2Ω and field resistance of 300Ω. find the back emf when giving an output of 10kW at 89% efficiency a) find the back emf mathmatically
A 40-HP, 230-V., 8-pole, 25 Hz three-phase induction motor is running at 355 rpm at rated load. The torque lost by friction is 24 N-m. If the stator losses amount to 1,000 W., calculate the efficiency of the motor at this load.
A 220V shunt motor develops a torque of 108 N.m at an armature current of 20 A. The torque developed when the armature current is 40 A is