A doubly reinforced concrete beam has a max. effective depth of 630mm and is subjected to a factored moment of 1062 kn-m (including its own weight). fºc=27.58 MPa, fy = 413.4 MPa. Use 62.5 mm steel covering. 1. Determine the width of the beam. 2. Determine the reinforcement for compression. 3. Determine the reinforcement for tension.

Q: Aerial photography is to be taken of a tract of land that is X-mi square. Flying height will be H ft…

A: The dimension of the tract of land = 9 mi×9 mi The flying height, H = 4100 ft  The focal length, f =…

Q: A soft saturated clayey soil tested unconfined gave an axial stress of 50 KM mat failure. The shear…

A: Shear strength of the soil is defined as the resistance of soil offered to shear stresses and shear…

Q: 3.15 A footing with an embedment of 2 m is embedded in a sand with a unit weight of 125 lb/ft³ and a…

A: GIVEN DATA: Embedment length =2m angle of internal friction ϕ=36∘ unit weight of sand =125…

Q: Determine the dimensions of a rectangular key for a 2" diameter shaft. The elastic limit in…

A: The key is used to transmit torque from the shaft to the connected component, and it must be…

Q: If AC is a two-force member and the magnitude of the reaction at A is 4.63 kN, determine the…

A:

Q: The results of two drained triaxial tests on a saturated clay are given next: Specimen I: Chamber…

A: Chamber confining pressure of specimen I is σ3=15 lb/in2. Deviator stress at failure of specimen I…

Q: Q2.) The cable supports a uniform load of 1000 N/m below points C and D. The cable is supported by a…

A:

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ftft) and closed on…

A: BM Hydrant = 5869.31 ft BM Rock = 5830.03 ft

Q: b) Determine the rotation and deflection at point B and D by double integration method. c) Determine…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Draw the shear and moment diagrams for the following beams

A:

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A: BC=CD To find Force in member BE and CE

Q: The following data pertain to a sewage sample: Initial DO = 9.5 mg/l, Final DO = 2 mg/l, Dilution =…

A: Initial DO=9.5 mg/L, Final DO=2 mg/L, 1% dilution factor=100/1,

Q: Given: The beam from Problem 3 is a W24x146 and is braced at the ends and 10-ft from the left end.…

A: W24x146 braced at the ends and 10 ft from the left end calculate Cb and calculate the adequacy of…

Q: 3 rows SW TX_HV 24 columns HV transmitter Second stage ADC Digital Processing FIL SW

A: A MEMS (microelectromechanical system) piezoelectric fingerprint sensor is a type of fingerprint…

Q: en below are the pertinent data of a reinforced concrete beam. Beam Width, bw = 300 mm Tension…

A: Given:- bw = 300 mm Tension Reinforcements = 8 – 25 mm dia. d = 512mm  dt = 537mm  f’c = 42 Mpa  fy…

Q: A sample of metal having a rectangular cross-section; a width of 10.00 in. and a thickness of 0.25…

A:

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A: BC=CD To find Force in member BE and CE

Q: Determine the moment of mertia (1x) of the following built-up sections show your calculations. 3/8"…

A: To determine the moment of inertia Ix of the following built up sections .

Q: A soil sample has a natural water content of 22.5% and it is known to have a specific gravity of…

A:

Q: A massive, concrete dam spillway has been instrumented with a series of piezometers, A through E, to…

A: Find: (a) Elevation head of all piezometers A through E (b) Pressure head of all piezometers A…

Q: The cantilever beam shown in Figure P15.15a is subjected to concentrated loads Px = 18 kips and Py =…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: draw shear and bending moment diagrams for the loaded beam

A:

Q: Question 1 The following data pertains to a sewage sample: Initial D O. 15 mg/l Final D O. = 4 mg/l…

A: Initial DO=15 mg/L, Final DO=4 mg/L, 2% dilution factor=100/2,

Q: Determine the force in member BE of the loaded truss. The force is positive if in tension, negative…

A:

Q: A massive, concrete dam spillway has been instrumented with a series of piezometers, A through E, to…

A: Find: (a) Elevation head of all piezometers A through E (b) Pressure head of all piezometers A…

Q: Create a spreadsheet for the analysis of dams including hydrostatic force

A: Parameters Value units Dam Name     Dam Type     Dam Height   m Dam Width   m Reservoir…

Q: 6. A differential manometer is attached to a pipe, as shown in figure below. Calculate the pressure…

A:

Q: A sewage has a suspended solid contents as 250 mg/litre. The sedimentation tank removes 55% of the…

A: Suspended solid content =250 mg/litre The sedimentation tank removes 55% of the suspended solids and…

Q: A new cast iron pipe must carry 5.942 m3/s at a head loss of 18 m per 16 km length of pipe. Compute…

A: Discharge in cast iron pipe = 5.942 m3/s Head loss = 18 m Length of pipe = 16 km = 16000 m C = 179…

Q: Q/ Using the method of consistent deformation, find support reaction of the frame shown; assume EI=…

A: Of Reactions at Supports using  method of consistent deformation or force method of Analysis  Hence…

Q: Compute the azimuth from north of the line CD (Azimuths of AB are also from north) Azimuth AB = 101…

A: we have to compute the azimuth from north of the line CD

Q: Situation 4: Draw the shear and moment diagrams of the given beam. Take note that all of the…

A: Draw shear and moment diagram and Maximum shear force and moment.

Q: leg angles only and choose the most economic section) the following loa connections are welded and…

A: Given:- Dead load:- P1=79kN P2=126kN Live Load:- P1=221kN P2=285kN To find:- design truss member

Q: gravity of mercury=13.6h What is h in the said answer

A: Specific gravity of mercury, G= 13.6

Q: A cast iron pipe having a diameter of 100 mm is used to fill the empty cylindrical tank with water…

A: Diameter =100 mm T=25° C Length =50 m f=0.025 Power output =4.5 kW

Q: Determine the force in each member of the Warren bridge truss shown. State whether each member is in…

A:

Q: A reinforced concrete beam has the following properties: b=300 mm d:=450 mm f'c= 28 MPa fyt:= 275…

A:

Q: A soft saturated clayey soil tested unconfined gave an axial stress of 50 kN/ m at failure. The…

A: Unconfined compressive strength- UCS=50kN/m2

Q: Zm 150 kN B B 30 kN 12m T2m 4m 10 kN/m D

A: a b To find Support reaction of the beam

Q: A rectangular simply supported beam of span 4 m is 300 mm x 700 mm in cross-section and is…

A: A rectangular simply supported beam- Span l=4 m, Width B=300 mm=0.3 m, Depth D=700 mm=0.7 m,…

Q: Draw the 1ft contour lines across the 2-lane road with 12ft lanes and 5ft wide shoulders. The…

A: Longitudenal slope= 5%cross slope=3% accross pavement                      =3% accross…

Q: How do civil engineers manage the costs and budgets associated with large-scale infrastructure…

A: Civil engineers are responsible for designing, constructing, and managing large-scale infrastructure…

Q: Situation 6: For the simply-supported beam, properly illustrate the load and moment diagrams given…

A: Shear force is defined as the force acting perpendicular to the longitudinal axis of the beam, which…

Q: What are the different types of promissory notes?

A: A promissory note is a legal financial instrument in which one party (the issuer) makes a written…

Q: . The velocity and depth of flow in a 3 m wide rectangular channel are 2 m/s and 2.5 m,…

A:

Q: 7-33. Use the conjugate-beam slope at C and the displacement A C method and determine the at B. EI…

A: The slope at one point in the real beam equals the shear at the corresponding point in the conjugate…

Q: Homework: Determine the forces in all members for the truss shown below. 20 KN B N 10 KN E 5 KN A 3m…

A: Determine the force in each members of the truss.  Let's solve using method of joints.

Q: 1. Using an 8"x8" wood post, illustrate the wood post connection to a 12"x12" concrete pedestal.

A: Since 3 different questions are asked, as per our policy, the first question will be answered.…

Q: • Example: 32/2 A reinforced concrete pile 30ft long and 15 inches diameter is embedded in a…

A: we have to find the net pullout capacity

Q: Water is filled between two parallel plates of infinite length, a distance d apart. Find the…

A: