A drying gas in cross-flow enters at one end of a stack of trays at 90°C and leaves at 70°C. The temperature of the drying surface of the solid is 33°C. What is the number of heat transfer units? (i) 4.3 (ii) 0.43 (iii) 0.27

Q: fugacity

A:

Q: 2 км from 1 A Petrolum fraction is Pumped take through distillation Plant to storage a mild Steel…

A: Given, The diameter of pipe line = 150 mm Volumetric flow rate = 0.04 m3/s Efficiency = 50% Specific…

Q: 100 mol/h of gaseous ethane is burned with excess air. The fuel is mixed with air before entering…

A: Given data: Molar flow rate of ethane = 100 mol/h Composition 0f stack gas is as follows: CO2 = 5.32…

Q: discharge coefficient

A:

Q: The homogenous, liquid-phase, and irreversible reaction A => B proceeds at constant temperature with…

A: Given data: Rate constant; k=0.15Conversion; xA=70%=0.7CAO=10 Mol/LitVo=3 Lit/min

Q: (a) What is the relation between grain size and creep resistance? In your answer you can use…

A: Creep resistance is a used in substances science that refers to a strong material's capability to…

Q: Solve the laplace transforms for: L[cos²3t+ Sin2t Sin5t]

A: L[Cos23t + sin2t sin5t ]  =  L[Cos23t ] + L[ sin2t sin5t ]       ------(1)  therefore,    L[Cos23t ]…

Q: A mixture of 40 mol% benzene and 60 mol% toluene is fed in the form liquid in a flash vessel. The…

A: A mixture of benzene and toluene is flashed vaporized.

Q: A certain separation process recovers 50% of a desired component A from a mixture containing A and…

A: The part of the product stream is diverted back to the feed stream. This stream is said to recycle…

Q: Suggest and discuss 1(ONE) example of hard materials that is suitable for improving abrasive wear…

A: Hard materials are particularly suited for challenging circumstances like ploughing, mining, rock…

Q: Q4: Using table B.3 and equation 101, to determine the vapor pressure at a temperature of 400 K for…

A:

Q: Using the K-value charts estimate the bubble point temperature of a mixture of propane (50.0 mol %)…

A: we know that,  yi = Ki * xi     Given:  ypropane  = 0.5 yn-butane  = 0.5

Q: e each of the following ents figure and the ents that make them up.

A: I describe all the term in shorts words . 1. ANFO A minimal mixture of porous Ammonium Nitrate pill…

Q: A stream containing 50% ethane and 50% propane by volume was heated from 0 °C to 400 °C. Calculate…

A:

Q: 2. Consider the following reaction: CO(g) + O2(g) = CO₂(g) s) Find AH (kJ/mol) of the reaction at…

A:

Q: → tion requires critical thinking. B has a unimolecular reaction rate constant of 0.0 P5-15 The…

A: Hello User ! As per our authoring guidelines, we have solved the first of the questions posted here…

Q: Using a constant temperature and ideal continuously stirred tank reactor, a reversible rxn is done…

A:

Q: Silver is used in different applications that result in contact with skin and mucosal surfaces…

A: Given  Mass of Cu = 5.804 Mass of AgNO3 = 5.804 Molecular weight of Cu = 63.546 g/mol Molecular…

Q: 1. The reported¹ Margules parameter for a binary mixture of methanol and benzene at 60 °C is A=0.56.…

A:

Q: A closed vessel contains moist air at 41°C and 1.27 bar. If the mole fraction of the water vapor in…

A: Given, The temperature of moist air, T = 41 °C = 41+273 K = 314 K The pressure, P = 1.27 bar The…

Q: 3. Consider the activity coefficients at infinite dilution for a mixture of 2-propanol and water at…

A:

Q: Find the minimum reflux ratio, Rmin.

A:

Q: Chemical energy is O a. a. The portion of the internal energy of a system associated with the change…

A:

Q: For the mix 40% acetone, 40% benzene and 20% ethanol at 60 degree Celsius, what is the dew point…

A:

Q: Dry Matter Caiculations (Show your work) if corn is 88% DM (as-fed) and has 8% CP as-fed), what is…

A: Dry matter is the component having 0% of moisture. It is denoted as DM. CP stands for Crude protein.…

Q: sing only DePriester charts, find the vapor pressure (mmHg) of the following substances: (a)…

A:

Q: A Petrolum product is Pumped at rate of 2.525 * 13 m³/s from réservoir under atmospheric Pressure to…

A:

Q: provide the handwritten solution because I can't understand it

A:

Q: If the amount of carbon fed into the atmosphere is ‘X,’ of which 7.5 percent steadily remains in the…

A:

Q: Briefly explain solid and liquid separation in leaching process in hydro metallurgical Engineering

A: A compound can be extracted from a solid material that has been dissolved in a liquid by the process…

Q: In a mixture of water(1) and ethanol(2), the mass percent of ethanol is 52.5%, while its partial…

A: Given that- Mixture contains= water (1) + ethanol (2) Mass percent of ethanol= 52.2 % Partial molar…

Q: the rate of flow of water in a diameter Pipe is measured with a Venturmeter with a loom 200mm throat…

A:

Q: Suppose that an initial volume (V1) of 8.764 mL of NaCl solution was diluted to V2-15.480 mL to…

A:

Q: An autocatalytic reaction occurs as shown: A+R → R+R The reaction is first order in A and second…

A: Write the autocatalytic reaction as follows: A +R → R +R   Given, The initial concentration of A,…

Q: Given air which is assumed a mixture of O2 and N2, calculate the fugacity and fugacity coefficient…

A: Given, The air is a mixture of oxygen and nitrogen.   The temperature of the mixture, T = 113.15 K…

Q: do you understa phas e Gibbs rule.- ate the mathematical expression to determine engineering and…

A: 1. The Gibbs phase rule p+n=c+1, where n is the number of thermodynamic degrees of freedom in the…

Q: has A quantity of 0.850 mole of an ideal gas Cv.m 1.50R initially at a pressure of 6.2 atm and 300 K…

A:

Q: Consider the following reaction below AB4 + C₂ AC + BC If we start with 9.503 mole of AB4 and 9.679…

A: Given  AB4 + C2   -> AC + BC Initial mole of AB4 = 9.503 Initial mole of C2 = 9.679

Q: A sample of metal with a mass of 28.5 grams is heated to 95.0, and placed in a calorimeter…

A: Pp

Q: The homogeneous and irreversible reaction A → B obeys the following rate law: -Ak₁C₁ where k = 0.63…

A:

Q: 2. Consider a mixture of ethane, isobutane, n-pentane, and n-hexane at 150 psia with the following…

A: From Antoine equation WE HAVE,  Log10Psat/mmHg = A - BT/(Co )+ C Given: P = 150 Psia  = 7757 mmHg…

Q: ing te 2(g) 2(g) 3(g) feed contains 72.23% H2, 18.38% N2, and the balance being argon (inert).…

A:

Q: 15. Identify the equilibria that are directed to the left, favoring the formation of the reactants?…

A: As per Le-Chatelier's principle the equilibrium shifts to left or right direction to nullify the…

Q: microemulsion

A:

Q: Skim milk is prepared by the removal of some of the fat from whole milk. This skim milk is found to…

A: Given data: Composition of water=90.5%Composition of protein=3.5%Composition of…

Q: A 100-gal tank initially contains 25% dye solution. A 40% dye solution is allowed to enter at a rate…

A: Given Initially   V=100 gal(25% dye solution) 40% dye solution Rate=10 gal/min Mixture removing…

Q: Determine the following: a) Composition and amounts of the distillate and bottoms streams for a feed…

A:

Q: (4) Air at 1 MPa and 500°C enters a converging.nozzle, with a velocity of 140 m/s. Determine(a) The…

A:

Q: The products of combustion flow inside the exhaust ducts at the rate of 3.4 kmol/s. The products of…

A: Given:  rate of Products of combustion  = 3.4 Kmol/s  Composition of carbon monoxide in mixture =…

Q: Julia discovered a value for the activation energy that is 29,695 Joules/mole for a certain rxn…

A: Given Data  The activation energy discovered by Julia using desnity function = 29695 J/moles Julia…