(a) Express the transmit power in units of dBW (decibel-watt) and dBm (decibel- milliwatt). (b) If the transmitter's power is applied to a unity gain (i.e., G=1) antenna with a 100- MHz carrier frequency, what is the received power in dBm at a free space distance of 200 meters? Assume that the receiver's antenna has a unit gain too.

(a) Express the transmit power in units of dBW (decibel-watt) and dBm (decibel- milliwatt). (b) If the transmitter's power is applied to a unity gain (i.e., G=1) antenna with a 100- MHz carrier frequency, what is the received power in dBm at a free space distance of 200 meters? Assume that the receiver's antenna has a unit gain too.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1.) A communication system is defined below:Transmitter Power: = 45 dBm; Frequency = 1 GHzTransmit Antenna: Gain = 12 dB, height above ground = 50 meters;Receive Antenna: Gain = 6 dB, height above ground= 2.5 metersFind the received power (in dBm) at a range of 4 kilometers:a. using the free-space range equation b. using the near-earth range equation Using the results of the calculations in a & b above: c. determine the best prediction of the received power (in dBm) at the 4 kilometer range. 2.) A transmitter operating at 80 MHz has an output power of 1.5 kW which is fed to an antenna with a gain of 20 dB. Determine the "keep-out" distance (in meters) required to meet the safety standard. clear and easy to understand. Thanks
The transmitter and receiver antennas used in a long range microwave communication system operating at 9 GHz are identical and separated by 10km from each other. The receiver power must be at least 10?? to meet the receiver's signal to noise ratio. Assuming that both antennas are aligned for maximum reception and are polarization compatible, what should be the gain of the transmit and receive antennas in dB when the input power of the transmitter antenna is 10W
2.) The power density is 4 mW/m² at some distance R from an isotropic antenna. The isotropic antenna is replaced with a different antenna and the power density measured is now 60 mW/m² at the same distance R. What is the gain (in dB) of the second antenna? 3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
1.) A communication system is defined below:Transmitter Power: = 45 dBm; Frequency = 1 GHzTransmit Antenna: Gain = 12 dB, height above ground = 50 meters;Receive Antenna: Gain = 6 dB, height above ground= 2.5 metersFind the received power (in dBm) at a range of 4 kilometers:a. using the free-space range equation b. using the near-earth range equation Using the results of the calculations in a & b above: c. determine the best prediction of the received power (in dBm) at the 4 kilometer range. answer should be a) -41.15 b) -39.1 c.) near FS
Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequency.a) What is the effective area Ae of the antenna? b) What is the antenna power gain in ratio and in dBi?
The transmitter and receiver antennas used in a long range microwave communication system operating at 9 GHz are identical and separated by 10km from each other. The receiver power must be at least 10*10-6 W to meet the receiver's signal to noise ratio. Assuming that both antennas are aligned for maximum reception and are polarization compatible, what should be the gain of the transmit and receive antennas in dB when the input power of the transmitter antenna is 10W
AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what is the path loss in dB of the signal if the operating frequency is 3 GHz.
A 10 GHz Microwave link is designed to connect two points which has 10 km distance. The transmitter effective radiated power is 50 dBW. Calculate the received signal power, PR , and voltage, VR , if the receiving antenna gain is 10 dB and the input impedance is 50 ohms.
AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what is the path loss in dB of the signal if the operating frequency is 3 GHz. (Use two decimal places for the final answer)
2. If a transmitter with a power output of 30W has a gain of 30dBd with respect to an isotropic radiator, what is the power density at a distance of 6km from the antenna?
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
Consider a communication link with a geostationary satellite such that transmitter receiver separation is 30,000 km. Assume the same transmitter and receiver. If a 100-mili-watt transmitter at 4 GHz is used with transmitting and receiving antennas of 0.5-m2 effective area, what is the received power level in dBm? What implications does this power level have on the receiver design? With a land-mobile satellite terminal, the typical antenna gain is 10 dB or less. What does this imply about the data rates that may be supported by such a link?